Ford Excursion :: 2003 V10 Shift To Reverse Only?
It is a 2003 Excursion with V10, 4WD. When I start up and shift to reverse, the gear selector shows it moving, but the truck will not move. It just sits there and revs up. I have to shift back to park and then to reverse again, then you can feel the transmission dropping into reverse. It doesn't do this all the time. There is no pattern to it, just whenever the transmission feels like messing with me.
View 1 RepliesFord Excursion :: 2003 - Transmission Would Not Shift Past Second
I have a 2003 excursion with the V10. at the hunting camp I drove it into some water without knowing my neighbor had gotten stuck and left a BIG hole. It took an hour to pull it out with a tractor. The water was up to the floor boards. afterward the transmission would not shift past second. The OD light blinks. I left it for two days to dry out. Still no good. What I need to do to get it back going?
View 9 RepliesFord Excursion :: No Reverse Unless Shift To Drive First
Finished my flush, but now it won't shift to reverse unless i shift all the way to drive first. I thought it might be the hard shifting lever(i think something is up with the linkage), so i shifted to neutral, then reverse, but no success. It's still about 1/4-1/2" overfilled, I jsut ran to the hardware store and it's consistently still not shifting to reverse unless I take it all the way to drive first.
Really hoping I didn't break something in the process... I did do the shifting through the gears while it was flushing out the old coolant, could the valve be stuck due to that?
Ford Excursion :: 2001 - Won't Shift In 4th Gear?
I have a 2001 EX we did a little mudding and now its not shifting into 4th. We have flushed the trans and no shaving or anything. A few told us to change the speed sensor.
View 1 RepliesFord Excursion :: Hard To Shift Out Of Park?
What causes this? I have to mess with the brake pedal for a while for it to finally register that i have my foot on the brake and let me shift out of park.
View 5 RepliesFord Excursion :: 2004 - Shift On Fly / 4X4 Not Working
2004 Excursion 6.0 ... What might be cause of my "shift on fly" 4x4 not working? No lights on dash, no mechanical noise, fuse appears OK.
View 8 RepliesFord Excursion :: Won't Shift Into1st After Cooler Leak?
I had a minor front accident in my EX last week. Seemed fine to drive, AC worked radiator was oK. Shifted fine. Bumper was all jacked up. I took off the bumper and ordered a new one. In the meantime an employee of mine drove the EX on a short errand. Evidently there was a nick in the front tranny cooler hose that burst on the interstate. He put a few quarts in it and limped back to the farm where we fixed the leaking hose and refilled the tranny. As it is now, reverse works fine, but when shifted to drive it doesnt shift into 1st and could possibly be stuck in overdrive. If I turn off the overdrive button on the shifter, all gears work as they should except of course OD. if I'm at highway speed in 3rd gear, I can turn overdrive back on and it will shift into overdrive. If I stop, I have the turn off the overdrive button to use 1st 2nd and 3rd.
View 4 RepliesFord Excursion :: Fuse 27 Keeps Blowing As Soon As Shift Into Reverse
Fuse #27 keeps blowing as soon as I shift into reverse.
Prior to shifting, everything works as it should - I've unplugged the rear sensors, back up lights, trailer plug, and each time, fuse #27 keeps blowing.....
Where I should look? Also - looking for a 2003 excursion wiring diagram that shows what all fuse#27 controls?
Ford Excursion :: Reverse Sensor Turns Itself Off When Shift To R
What would cause the reverse sensing system to illuminate the "OFF" light on its own when I shift into reverse? I cannot turn it back on unless I shift out of reverse. This problem has come and gone on its own several times and there is no rhyme or reason as to when or why.
View 11 RepliesFord Excursion :: 2000 - Transmission Won't Shift From 1st Gear?
I have a 2000 Excursion w/ V10 and I have an issue with the transmission form time to time. some times it does not want to shift out of first. if I pull over and turn it off for a few minutes it will be fine for a while and it doesn't do this all the time. A few nights ago it did this so I pulled over and turned it off and it still did it but then it started shifting on its own just fine till we got on the high way which is started shifting in and out of over drive going around 60-65 MPH. didn't want to go too fast not knowing what it could or would do. it did this for a few miles then it started working fine. next day it did the same thing not wanting to shift out of first then started working fine. drove it around last night and it all worked perfectly. The CEL is on but I get a no communication text from the scanner so that is another thing I need to look in to. I'm guessing it is an electrical issue being when it works it shifts fine and it does not slip at all.
View 14 RepliesFord Excursion :: 2000 - Truck Runs Bad And Don't Shift Right
It is a 2000 excursion its got codes # 135 155 443 743 755 1747 And overdrive light is flashing really....
View 14 RepliesFord Excursion :: Tightening Transmission Gear Shift Selector?
Fix a Loose Column Shifter on Ford Vehicles - YouTube
The first pic shows the torx screws that come loose, allowing the handle to get sloppy.
The second pic shows the black plastic adjuster wheel that centers the gear shift selector needle on the proper designated gear displayed in the indicator window.
Ford Excursion :: Hard To Shift - Transmission Lever Coming Out
As it turns out, my shift cable wasn't bad. The transmission lever coming out of the transmission doesn't want to move very easily. When in gear, it shifts fine as it should, so I'm thinking something is bad with the lever. Problem is, I don't know what could possibly be causing it.
View 8 RepliesFord Excursion :: 2000 Truck Would Not Shift - Fuse Blown
About three weeks ago driving. My truck would not shift come to find out it was a fuse that blew. Well I pull over and replace the fuse it starts right up I get about a mile from my house and it blows again so I shut off my x and then replaced the fuse. Will not start...
Now I am getting a Pats code 1:6 and my obd2 reader says no link on my x. It used to read it all the time. I am trying to figure out what I can check to fix this problem are there any relays. Oh also my check engine light does not come on when I turn the key but my truck does crank. does this mean there is no power to my ECU. I did replace my ecu and it did not solve the issue.
Ford Excursion :: Transfer Case Shift Motor Change
My TC motor picked today of course with the snow to go bad. Luckily I hobbled to advance right as they were about to close and got one. I laid in the snow and changed it. Needless to say I got soaked beyond belief. Anyways now it changes in and out well but still seems way to loose in the rear. Not sure if something else is malfunctioning or if these things are like that. Right now I don't feel nearly as safe as I did in my expedition and that was without even using 4hi or low just the A4WD. The excursion is sliding everywhere. My tires have great tread but are highway tires so maybe that's the issue. They are Dura Grapplers. I'm going to try throwing some weight in the rear to maybe gain some traction.
View 2 RepliesFord Excursion :: Overdrive Button On The Gear Shift Does Not Work
I have an '05 V10 with 74,000 miles. The overdrive button on the gear shift does not work and it keeps me in trailering mode. If I put it in park and jostle the shifter and steering wheel, sometimes it works. Also, the back-up sensors no longer work.
View 5 RepliesFord Excursion :: Hard To Shift From Park While Running In Cold?
As it's progressively grown colder (which may or may not be related), my truck has grown all but impossible to shift from park into reverse neutral or drive with the engine running when the truck is cold. I often have to shut the engine off, and once I do it immediately is very easy to shift out of park into neutral, and then I can restart the engine. Once the truck has been driven some, it's not hard to get out of park, but if it's shut off for some time (an hour maybe) it will be difficult to shift out of park again. I don't know how to begin troubleshooting this.
View 8 RepliesFord Excursion :: Shifter Won't Move / Need To Step On Brake Before Shift Out Of Park
So lately this has been getting worst. You have to step on the brake before you can shift out of park. Well lately I have to step on the brake a few times before the safety will let you get into gear.
View 7 RepliesFord Excursion :: Tranny Slipping And Engine Dies When Shift From One Position To Another
2000 X V10 4WD... 178K. Truck was not well maintained for most of it's existence. Drained both the TC and Drain pain and replaced the oil filter. Tranny oil looked like crude and a lot of tiny specs of metal - it shimmered in the sun... needless to say - I'm pretty sure it had never been changed.
Now - issues since I've gotten it done... Tranny has been slipping... I figured that I may not have filled it enough and after adding a few quarts, it seems to have stopped. Slipping was initially just when going from a stop.
Now it's having a problem where the engine dies when I shift from one position to another... For instance - from Park to Reverse, the engine RPMs drop as the clutch engages - but they drop from about 900 RPM down to about 500. And 50/50 chance the engine dies. Going from Park to Drive, the same thing but maybe drops to about 700 RPMs. Tried it in 2nd and 1st gear. Has happened in both. I've tried shifting to OD first before going to 2nd to 1st or vice versa and seems to behave better.
Should I flash the ECU and have it relearn the shift points? Did I overfill? Between the TC and Drain Pan - about 16 qts came out. I've been checking the dipstick - no frothing or bubbles. When running and in park - it actually shows low. Seems to drive fine once it's on the road. The engine cutting off when it's put into gear is really unexpected.