Ford Excursion :: 2000 V10 - Rough Idle - P0304 Code / Cylinder 4 Misfire
I recently bought a 00 Excursion v10 2wd everything looked right no major problems. I noticed it has a rough idle and i thought it could be the EGR i went under the hood and there's no EGR in sight. I plugged the OBD reader to see if it would give any codes since the there was no check engine light on and wanted wanted to make sure it worked, It showed a P0304 code its Cyl4 misfire i checked plugs/coils and i noticed there's a little insert inside Cyl4 plugs hole in the head that it has the plug screwed on. I decided to change all the plugs and the coils and i still have the rough idle and code i can hear a ticking noise around the engine in the passenger side.
View 7 RepliesFord F-150 - 1997-2003 :: Got Error Code P1000 - Idle Rough - CEL On?
What that means? The check engine light is NOT on but I looked for a code because my truck is idling rough, and when driving, when the overdrive kicks in, it vibrates really bad. As if a bad U-joint on your drive shaft. The truck has been in a field for about 5 months broke down so any clue? Haynes manual says nothing about P1000.
View 13 RepliesFord F-150 - 1997-2003 :: Rough Idle And Poor Performance - Code P0401
97 4.6.. So it would appear that I have the wild goose chase of codes. The major symptoms are rough idle and very poor performance. I started off by cleaning the egr valve and ports. Then I checked the egr valve itself and watched the valve open and close under a vacuum. I was suspecting the DPFE sensor but I wanted to trying something else first. I was under the Impression that if at idle you apply a vacuum to the egr valve it would cause the engine to "stumble and stall". I did this and there was no change in the way the engine was running. So now I'm lost as to where to go from here.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Rough Idle - Intermittent P1118 Code
For the last couple months I've been messing with a P1118 code. Started a few months ago when I noticed my fuel mileage was down 1-2MPG. Also sometimes a rough seeming idle (hard to tell with the diesel). Then it threw a P1118, so I replaced the temp sensor under the turbo. The code went away for a while then came back, fuel mileage didn't change. So I replaced the temp sensor in the air filter box.
The code went away AND my fuel mileage seems to have come back to normal. Now, code thrown again. Search on P1118 hasn't been super useful. Seems like replacing the sensor under the turbo is the trick. Also seems to come up in combination with a bunch of other codes with battery problems. I suppose it's possible I have some sort of electrical gremlin. It throws the code on startup and stays on until I shut it off. Doesn't come on every time, is off more often than on.
Ford Excursion :: 2003 - Rough Idle - Puff Of White Smoke On Cold Startup - Slight Exhaust Leak
I've been chasing a problem all summer. Began with crappy batteries dying intermittently. I replaced the batteries, FICM, finally cleaned EGR valve and replaced ICP with pigtail. The problem is still persistent. Basically a rough idle, puff of whit smoke on cold startup, rough running at around 1500 rpms( driving at 50 mph). The ICP was soaked in oil so i was confident replacing it would finally cure my issues. It actually got worse with the rough idle turning to a surging idle and quite rumbly at 50 mph speed. I guess its time to look to injector issues but i thought id check if after replacing icp/ cleaning egr. I also have a slight exhaust leak at turbo out that i can see. The clamp is not seated properly. This after turbo connection to exhaust.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Shaking While Accelerating Between 45 And 60 Mph And Rough Idle - P0284 Code
I got a p0284 code and have some symptoms such as shaking while accelerating between 45 and 60 mph and a rough idle.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2003 F350 - Rough Idle / Cylinder 4 And 5 Contribution Balance Code
2003 f350 dually. Fully bulletproofed about 10k miles ago. Everything was running great for about 5k miles. A friend of mine got stuck and I went to pull him out. Got him out but got on it really hard...never overheated or anything.
Next day truck throws a cyLinder 5 contribution balance code. Ran ok but idled rough. Pulled injector and put a used one from a running truck in it. Code went away and runing fine for a few weeks. Took a long trip from FL to Texas, and on the way home same code occurred but idle was not as bad. I would clear the code and it would be fine for a few hundred miles, then would show up again. Made it home, still was driving around town a little with the code only showing sometimes. A couple blocks away from home taking off from a stop sign lost all power and motor shut off. Turned out the Injector o ring blew and hydrolocked the motor.
So now, ordered all new 155cc30% injectors , 58v ficm and new oem injector harness. Installed and Drove the truck to Illinois. After about 700 miles I noticed a little rough idle and had a cylinder 4 cont code. Made to Illinois and back to fl. At fl line I had cyld. 4 and 5 codes now. Cleared and cyld 4 was gone but 5 stayed. Got home and balance test showed 4 and 5 bad injectors. Sent them off to be fixed just got them back in. Truck started fine, smooth idle, ran for about 10 miles and cyld 5 code come back and so does the rough idle. I'm at a loss now.
Will be doing compression test tomorrow. Other than a rough idle truck runs flawless, will roast the tires and pull anything hooked to it. No hot starts, no symptoms of anything else. Possibly a problem with the oil rail feed on that cylinder? Main ficm harness? Bent pushrod?
Ford Excursion :: V10 Threw Fault Code - Dash Dim When Headlights Turned On
I got a check eng light and read the codes. Cam sensor, misfire 5 & 8. Replaced cam sensor. Got light twice more. Cam sensor. Cleared codes, now no light but, I lost bottom & mid range HP at a steady decline. Run like a scalded dog on top end. Replaced fuel filter on frame rail & air filter. No cure. Noticed dash dim when headlights turned on. Pulled pos battery cable engine died. Replaced alt old one tested good. Drove to parking spot no power damn near couldn't pull it self. Turned off wouldn't start. Before I turned off it would rev up perfect just no power to move. Had a camed up sound at an idle like a slight miss. No fault codes present. Ford claims crank sensor. Haven't replaced that yet. Have fuel in fuel rails. 10 coils could not have lost spark at once. Any part other than crank sensor?
View 14 RepliesFord Excursion :: 2002 7.3L With P0671 Code - Glow Plug Circuit Fault
I have have been getting a p0671 fault code every time I start my truck now that its cold. If I clear it and its warm it doesn't retrigger at least until it sits overnight again. Is this likely to be that the Glow Plug needs replacing on the #1 cylinder? Autolite Glow Plug is only $20 or so. Mechanic is recommending changing the bank and the harness but I'd rather just do the one GP myself if possible. I see on here that the valve cover has to come off. Which side is #1 on and do I need any gaskets etc? How big a job is it to remove the valve cover? I'd go and look myself but its cold out ...
View 1 RepliesCavalier - Chevrolet :: 2003 - Idle Rough And Jagged - Got Code PO440?
I have a 2003 Chevy Cavalier that I have owned since new. It has 340,000 miles and I want to get to at least half-a-million. My wife was driving it last week and it started with a very rough idle and ran rough for 5-10 minutes until it quit running for her in the bank line. I came to get her and the car and started it by giving it some gas, but the idle was rough and jagged. Feels like it missing and gasping for air. Running on the road home at 30mph it seems almost normal, until i slow to a stop. Went to have the codes read at Advance and Auto Zone only coming up with PO440 woe the EVAP system, which has been showing for 200K miles. Have a clean K&N filter but no other modifications. I've done a lot of work myself and also have a good mechanic, but I don't want to drop if off blindly. I'm thinking maybe the Fuel Pressure Regulator or the IAC Valve. Haven't looked at the throttle body yet. Where should I go from here?
View 19 RepliesYaris/Scion & Vitz :: 2003 Echo Throwing A Cylinder Misfire Code / Idle Rough
My friend has a 2003 Toyota Echo that is throwing a cylinder misfire code. Original code is P0302 and P0302PD. The car is idling rougher, kind of sounds like "put-put-put". Also, the car has no power at all. He lives on a hill and he can't even pull out of his driveway. Lastly, the smell of the exhaust is gassy.
We have changed out the spark plugs...no change. Next, we bought a new ignition coil for the number two cylinder...no change. So, maybe its the wiring. Put the new coil onto the number 3 cylinder and the number 3 coil onto the 2 cylinder. Low and behold, the misfire code changes to P0303 and P0303PD.
Thinking we might have gotten a dud of a coil, we bought another. Same thing...new coil on 2 code is P0302...new coil on 3, code is P0303. Could we just have gotten two bad coils? Oh, coils were a BWD brand coil and Duralast brand. Should we just go OEM from dealer? OR Denso from Advance Auto?
Ford F-150 - 1997-2003 :: P0307 Fault Code - Misfire On Cylinder 7
I have a 2001 King Ranch F150, which has a 2004 Lincoln Navigator 5.4 DOHC Intech engine installed. The engine was installed in 2005 and had less that 100 miles on it. The engine now has approximately 95000 miles and I have recently gotten a P0307 fault-miss fire on # 7 cylinder. I have installed a new spark plug, COP, and fuel injector. The fault has returned. What is the cause of my problem?
View 1 RepliesFord Excursion :: Rough Idle After Truck Has Been Idling For A While 5 Minutes Or So
2005 Excursion v10 137000 miles I am experiencing a rough idle only after the truck has been idling for a while 5+ min or so. On cold start warm start doesn't make a difference truck runs perfectly until it's been idling for a few min then starts a looping idle tach drops down to around 4-500 rpm motor sounds almost like a misfire I can press on the gas and it sputters up until it's running over 1200 rpm then smooths out and runs perfectly until it's allowed to idle for a few min then just repeats no codes are present no check engine light at all
I changed out plugs and coil packs at 100000 miles roughly year and a half ago (motorcraft parts) problem started just recently I have double checked all connections are good at plugs and at fuel injectors from what I've read up on from this forum it sounds like I could be experiencing an IAC issue or possibly an EGR issue I have checked all the rubber hoses associated with both systems and all are in good shape hold vacuum as they should are there any tests that I could perform on the IAC or the EGR to determine if it's one of those I'm trying to avoid throwing parts at it if possible, or is there anything else that I should be checking oh also cleaned the mass air flow a few days ago no changes
Ford Excursion :: Hesitation On Acceleration And Rough / Sporadic Idle
V-10 getting a weird hesitation on acceleration and rough, sporadic idle. Fuel filter is brand new, spark plugs only have 8000 miles on them. If im just cruising and give it just a little gas it gets real rough and wont smooth out unless I give it more gas. What else could it be? Coil packs?
View 14 RepliesFord F-150 - 1997-2003 :: Code P0161 Came Up - 2nd Bank Downstream Heater Circuit Fault
Just started the truck after not running for a few weeks and drove around fine. Looked down and suddenly a CEL was indicated. Checked it with my Edge Evolution diagnostic mode and Code P0161 came up 2nd bank downstream heater circuit fault. I've also have an exhaust leak in the right passenger side exhaust manifold for about the last year. I've been waiting to install my newer 03' used engine when time and funds permit.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: P0308 Fault Code / Misfire Detected On Cylinder 8
New to diesel trucks and wondered if this recurring code is a serious problem. I clear DTC and truck will run fine. Might stay off for 2 days or 2 months and same code comes back. Truck seems to run just fine even with service light on.
View 5 RepliesFord Excursion :: V10 Starts Missing From Idle Through To 80 MPH - Code P0358
Had a new V10 Gas engine put in the Ex about three years ago and Been running like a CHAMP....UNTIL.....I'm Driving Back from Halliburton today and my Excursion starts Missing from Idle through to 80mph.. Finally threw an SES Light pulled into the local Auto Parts store and they ran Diagnostic on it and stated P0358... Now I know where to start looking...Only thing is I don't know exactly which one ... What's a good process to eliminate each COP to find the culprit does the #8 at the end designate what cylinder is misfiring?
View 5 RepliesGolf IV R32 :: 2003 - Fault Code P0050
I got an error code today and I was going to ask you who know . What is this? What should I change to solve the problem and where in the engine is the error ? Is it dangerous to drive with this error?
My car is a Golf IV R32 - 2003.
Golf IV / Jetta IV :: 2001 - Transmission Has Hard Time Going Into 1st And Reverse / Rough Idle
2001 VW Jetta 1.8t automatic.
Transmission has a hard time going into 1st and reverse. Also some times hits hard going into third. I have a CEL for a vehicle speed sensor? Was wondering if it's not the VSS but maybe one of the other tranny sensors?
Separate question. Same car has a rough idle issue. Occasionally stalls but intermittently runs normal always has a low idle around 600 rpm. I have a code for an injector on cylinder three.
VSS code : P0725 - engine speed sensor circuit malfunction
Injector code : P0203 - injector circuit open cyl 3