Ford Escape / Hybrid :: Replacing Power Steering Pump Pressure Line
I need to replace my pressure line on my 02 Escape 3.0L. Looking for a DIY for doing this same job?
View 1 RepliesFord Escape / Hybrid :: Steering Column Replacement?
Steering column recall ? The ford sites don't have much info yet. What is involved steering column replacement ? Computer reprogramming to sove the issue of the steering ?
View 1 RepliesFord Escape / Hybrid :: 2005 - Fuel Pump Not Turning On
A friend has 2005 escape 3l. He called me yesterday saying that he needed replacing his fuel pump.
Before I got to his place he had already replaced the fuel filter...
We got the pump replaced, and when we went to start the vehicle, it still wouldn't start.
We double checked to make sure everything was connected and plugged in and it was. We checked all fuses, and they were all good.
This morning I am going to try jumping the relay and see if that does anything. What else to check?
Ford Escape / Hybrid :: 2009 - Power Steering Losing Power
Our escape recently started loosing its power steering, once the engine is shut off the power steering is ok. Also some times you can feel a pulsing in the steering wheel. I've been doing some googling and it looks like the dealers are replacing the steering columns to fix the problem.
My question : is this the only fix or if something like some contacts being cleaned or maybe replacing a steering sensor of some kind is the fix.
Ford Escape / Hybrid :: Power Steering Wheel Jerks When Turning Left
Have an 03 Escape / 3.0 and the steering catches when turning left. Steering wheel jerks. Replaced the pump about 2 mo. ago and seemed to work, but now it is back. Is there something else I should look at?
View 3 RepliesFord Escape / Hybrid :: 2005 2.3L - Loss Of Power / Struggles On Hills
So my wife's 2005 escape has been slowly losing power over the past 6 months or so. I regularly change the oil, tried new spark plugs, new air filter and still it's lazy. I know it's not a race machine but it struggles on hills.
This winter it was having problems starting unless the accelerator was pushed to the floor. After a cleaning of the Idle control valve all was well again. It has roughly 72,000 miles on it and uses .5-1qt of oil between changes.
Ford Escape / Hybrid :: 2002 V6 - Check Engine And Low Oil Lights Come On And Power Steering Lost
Ive got an 02 2wd escape with the v6. Its been an excellent truck until here recently. The wife has had a weird problem twice now, that I have been unable to reproduce. She says the check engine light and low oil light come on and she loses power steering. Shutting it off and restarting fixes the issue.
Took a 400 mile road trip with it last weekend and never had an issue. Only thing I noticed , the readiness meters never went ready. Even after that trip, It still shows a systems not ready code.
Tonight the wife had the issue again. Shutdown and restart fixed it. Battery cables are clean and tight, several grounds were freshly cleaned a couple months ago.
Ford 6.0L Power Stroke Diesel :: 2006 - Power Steering Pump Replacement
When replacing the power steering pump on my 2006 should I go OEM on the pump or save some money and get a Napa or aftermarket remaned unit with the pulley installed? Also, whar is the fluid capacity of the power steering system?
View 14 RepliesFord - Explorer :: 2003 - Power Steering Pump Removal / Replacement
I have a 2003 Ford Explorer with Power Steering problems. I have read and tried all the solutions I found here, except replacing the pump. Seems like it is the pump. Oil was burnt, I flushed twice. I checked the rack and lubed as identified in another post, same jumpy hard to steer issue. Anyway, now I am trying to remove the Pump. I have removed the reservoir and am trying to remove the pump. I have the top two bolts out, but cannot get to the bottom tow bolts. How do you access them? Do I need to remove the lower radiator hose, and / or the oil filter?
View 10 RepliesFord Aerostar :: Power Steering Fluid Leaking - Pump Replacement?
Proud owner here of a '96 3.0L RWD Aerostar Utility Van with about 138k miles, and leaking power steering fluid. At this point I'm replacing fluid from zero every time I have to drive it which is about once a week. I've located the leak and it seems to be coming from the pump/reservoir around the pressure hose. The hose is loose as in i can move it around a bit, but from what I've read, this is normal and the hose is supposed to be like that. I figure that at this mileage, with so much air going through the pump, all the crazy squealing and whining it does even when full, at this point it probably makes sense to replace the whole pump while I'm in there, as opposed to just doing the reservoir. Anyway, I'm planning to do this in a couple of weeks, and have some questions...
1) The pump - I've read on this forum that the best way to go on brand of the pump is Motorcraft.
2) Hoses - I'd like to replace the hoses coming out of the pump while I have this thing all taken apart, but I'm not exactly sure what parts to get. I know one is the pressure and one is the return, but there are variations of each based on the research I've done. The parts on the Napa site have different descriptions like "with switch port", "without switch port" "56in hose" "26in hose", and so on. Which ones I need, specifically the ones connecting directly to the pump? I havent been able to find anything in my research online, in Haynes, or Chiltons manuals.
3) Washers - Whether or not I replace the hoses, should I replace the washers at the connection point? Chilton's seems to recommend replacing them. Will they come with the new pump?
My local auto parts shop has the pulley remover/installer for me to rent so I've already got that squared away. I'm pretty sure I've covered all of my bases otherwise.
Ford Escape / Hybrid :: 2005 Ford Escape Transmission Fluid Change
So I am changing my transmission fluid tomorrow and was wondering a few things.
1. I noticed some people pull off the transmission hose to the inlet and keep draining that until its clear. For a drain and fill do you do it like that or just pull the plug and refill?
2. When youre filling it back up you just measure how much you taken out and then fill the rest by the dipstick? Anything else i should know?
3. Since I havent changed my transmission fluid in 60,000 miles. I wanted to do a drain and fill. I was thinking I needed to drain and fill it 3 time to catch up to maintenance. How often would you do it to get it clear? Drain and fill then drive it for a week then drain and fill? Or do it all in one day?
Ford Escape / Hybrid :: Outside Door Handle Replacement
Had to get a replacement door due to a wreck. It's from a salvage yard, painted and ready to install except I want to swap my door handle over because of the key lock. I cannot for the life of me figure out how to remove this thing. I've got it unbolted and it'll move all around, just not slide out.
View 1 RepliesFord Escape / Hybrid :: Rubber Brake Hose Replacement?
Removing the old cracked rubber brake line hoses on my daughters 2003 Ford Escape. Front left no problem. Old off, new on in 5 minutes. All the other won't come free. Can break nut loose, but just spins & spins. What is going on here? Did search and should be very easy.
View 6 RepliesFord Escape / Hybrid :: 2008 V6 - How To Change Belt On Water Pump
How to change belt on water pump on my 08 V6 the hayness says there is a tensioner on the v6 well i am stumped cant find it so ....... Belt is tight I see no way to get slack in belt to change it .top pulley and pump pulley is all i see...
View 11 RepliesFord Escape / Hybrid :: 2003 - Ignition Lock Cylinder Replacement
I'm replacing the ignition lock cylinder on my 03 Escape. The factory cylinder has the little black "wings" that nestle around the key when inserted:
The locksmith says the replacement cylinder needs to have those same wings for him to be change it. Is this correct? The auto part stores have the regular cylinder (with no wings) readily available, but the one with wings is a special-order item and I need this sooner rather than later.
Plus, the wingless one includes keys while the other appears to have none.
Ford Escape / Hybrid :: 2008 - Flex Pipe Broken / Replacement
My flex pipe recently broke, and as a temporary fix I pieced it together using a universal flex pipe and some exhaust tape and clamps. When shopping around, I came across this:
Walker Exhaust Pipe 50465 - Read Reviews on Walker #50465
Is this an OEM part for a 2008 ford escape 3.0? It looks somewhat correct, although I do not remember seeing the other two fittings in that picture on it. (It looks like the end with the flex pipe is the end that connects to the catalytic converter, and the other two connect to the front and back headers on the engine, but I don't recall seeing a fitting like whats on the end of that flex pipe on my car (It could be that it was cut off, too).
If this is the OEM one, then perhaps the original exhaust shop cut off the fitting between the cat and where the flexpipe attaches. Is there a way that I can get parts to re-make this section of exhaust so that I can use this piece? The flex pipe they originally put in was too big and it came loose again forcing me to have to rig it again since I can't weld, and needed to get it fixed quickly.
I really do not want to replace the entire exhaust system if I don't need to, and hoping I don't have to.
Touareg :: Power Steering Pump Replacement?
Looking for instructions on how to replace the power steering pump? Dealer wants ~$900 to do it. Says it only takes 2.5 hours.
View 1 RepliesIntrigue :: 1998 - Power Steering Pump Replacement
How to replace the power steering pump in a 98 intrigue S113800?
View 3 RepliesFord Escape / Hybrid :: Water Pump Belt Squeaks For 15 - 20 Seconds After Cold Start
2 questions regarding my 2005 Mariner 3.0L, as follows:
1. After a cold start (in the garage, so not freezing cold) the water pump belt - not the serpentine belt - squeaks for 15 - 20 seconds; ambient temperature doesn't matter. I had put a new belt on about a year ago, then this began 6 or so months later. Thinking I may have a defective belt, I replaced it again about 3 months ago, but the squeaking has continued - starting immediately after the replacement. My analysis is that the water pump bearing is going south. I've noticed that it is taking a little longer for the squeak to go away in the past few weeks, so it's probably getting worse, altho no leaks at this point. So the question is, so any other reason this is happening?
2. Assuming I do need to replace the WP, I bought a new one from the local parts house. I have a shop manual for the car, which tells me to remove the thermostat housing, hose connection to the WP, etc., and then remove the WP by removing just 3 bolts. However, the replacement part is just the front of the housing with the impeller and pulley included, so there are a half-dozen or so bolts that hold this new part onto the WP housing. So, doing this change-out? Will the front of the WP housing come off by itself without disconnecting the hose, etc., or do I first have to remove the whole WP and then take it apart to replace the impeller and front cover? I can't really tell from the pic in the shop manual, and it doesn't address dis-assembly of the WP.
Also, I'd like to just remove the belt w/o cutting it and having to buy a new one. Can I do this by just loosening the WP bolts? (I know how to re-install, obviously.)