Ford Super Duty (1999-2016) :: 2005 - Replacement Of Lower Seat Bottom?
What is the part # for this bottom for an 05' F250 supercab?
I swapped these seats into my OBS truck, but the driver's seat bottom has the typical wear/tear on it and its getting worse.
I have been searching for three days for a replacement bottom cover. I have found them for F150s and the pattern is close but not right. I cannot find them for F250s or F350s as I cannot find the proper part # for the gray DS cover.
This is the tan one: 4c3z-2562900-eaa
How can I pull this up?
Phaeton :: Driver Seat Bottom Does Not Elevate To Full Extent
It seems that the seat bottom does not elevate to the full extent. I like to have the front of the cushion a little higher than the rear, but the front doesn't seem to elevate as much as the passenger seat does. I've noticed a couple of threads about the fore and aft resetting, but nothing about height or angle adjustment. I've driven several other Phaetons and this one definitely has an issue with the bottom cushion elevation.
View 13 RepliesCamry :: 2009 CE Driver Seat Replacement With Power Seat?
I would like to know if its possible to replace the regular driver seat with power seat in my 09 camry. I do see some cables lying in the bottom?
View 2 RepliesPrius (Gen 3) :: 2010 - Driver Side Seat Bottom Heated Leather Seats
Prius four with heated leather seats noticed especially on the drivers side seat bottom on the side bolster just as you slide in not the center section. I noticed it when new, it looks like a maybe wire between the leather and seat foam.
View 4 RepliesFord Aerostar :: Driver Side Front Door Window Glass Replacement?
Did some searching but didn't find anything on how to replace the driver's side front window glass. Someone decided they liked my GPS unit more than I did while I was at work. Smashed out my driver's side window and took it. Now to replace that window. I did manage to find a replacement window.
Pulled off the door panel and now I'm trying to install the glass. Anything I try though, I can't seem to get the glass back into the tracks. Does anything inside the door need to be removed before I can install the glass back into the tracks? Such as the window motor/regulator assembly? On the left side of the drivers door towards the bottom, there is also another small alignment track. Does this need to be removed as well?
Ford Excursion :: 2004 - Driver Seat Belt Replacement
I love my Ex and I love my dobermann, but the two did not mix one day. In a matter of seconds, he almost chewed completely thru the driver's seat belt. Guess he thought I was taking too long to get out. It's basically hanging on by a quarter inch of fabric and seriously needs replacing.
I figure it can't be that hard to replace myself, but I cannot see how to remove the molding/housing that hides the mechanics of it all. I've been searching for videos, but none of them are for the Ex. :
How I can remove the housing and change the belt myself. Looking for a video or pictures.....
Ford Aerostar :: Clock Spring Swap?
I have a 1992 Aerostar Sports edition. My clock spring went bad like 6 months ago. I couldn't find a replacement anywhere. Not even at the Ford. I went to different junkyards and couldn't find the same exact one. Since I wanted to change the steering wheel anyway, i got the steering wheel and the clock spring from a 1999 Ford Explorer Sport at the junkyard. The clock spring fits perfectly and so the steering wheel. My only problem is that clock spring harness is different. I have no problem with the steering wheel side since both the steering wheel and the clock spring came from the same car. But under the dash is a different story. I have the manual for my Aerostar with the wiring schematic for the speed control system (cruise control) and horn but i just can't find the one for the 1999 Explorer. I got one for a 1996 Explorer and have the same wire colors than the clock springs i got from the 1999 Explorer. But i want to make sure I got the right schematic to feel confident I'm doing the job right. I can also use another version for the 1992 Aerostar because mine is a little confusing.
My old clock spring had two harnesses. One for the airbag which I am not going to use (i don't like airbags) and a second one for the cruise control/horn. This harness had four wires. One thick black one that goes to the casing of the ignition switch, and three smaller wires (BK, LB/BK, and Y/LB). The clock spring from the 1999 Explorer has six wires on that harness. One thick black that goes to the ignition switch and five more smaller ones (BK, LB/BK, DG/O, Y/LG, and R/BK). Going by the two schematics i have them figured out (i think), but want to make sure.
Ford Aerostar :: Axle Swap - 66-77 Bronco 9 Will Work?
I was thinking the other day, wonder if a 66-77 bronco 9" axle would work, width wise, on an Aero? Obviously, you'd have to grind off all the mounting brackets and add the Aero ones. Mostly just building the "ultimate Aero" in my mind,
View 5 RepliesFord Super Duty (1999-2016) :: 2006 F550 - Driver Seat Is Starting To Fall Apart / Replacement
My Dad has a 2006 F550 Lariat with the grey leather seats, and the drivers seat is starting to fall apart. So my Dad is wanting to replace it. My Dad thinks its from a lot of sliding in and out, and having all kinds of dirt and other stuff on it. It has a big spot torn in the lower left of it and then the armrest is starting to rip as well.
So I was wondering where a good place to get some replacement seats for it was. Definitely leather and grey to match the rear seats since its a crew cab. I don't think it necessarily has to be stock, but something that looks good and still at least somewhat matches the rear and rest of the interior.
Here's some pictures of the seat. Nice hole in the floor mat too. I think some nice plastic ones would work and look much better.
Ford Aerostar :: 1997 - Bottom Radiator Hose Connector Leak
I've noticed a spring of coolant shooting out of a connector that I'm assuming is connected to the bottom radiator hose via a smaller hose. Is there a hose that splits off the bottom radiator hose that is smaller. The leak is not coming from the hose, but the connector it's hooked to. Is this a replaceable part? What is it for?
97' Aerostar... 3.0 V6 with AC
Ford Aerostar :: Auto To Manual Trans Swap - Code P1744
My friend has a 97 Aerostar swb panel van. It's a 3.o with an automatic, with the code of death P1744. For the price of a rebuild, he would rather put a manual trans in it. What trans will fit, and what needs to be done as far as electronics goes?
View 8 RepliesLexus LS 2007+ :: Front Driver And Passenger Seat Replacement
I need to get my front driver seat and passenger seat replaced because they look so beaten down. The cushion is almost gone and looks very wrinkly.
I really need to come up with the excuse because i doubt they will let me change it if i tell them that its getting wrinkly and the cushion is gone.
Ford Excursion :: 2004 - Seat Swap In 2nd Row
I'm thinking about swapping from captains chairs to bench seats in the 2nd row of my 04 Limited Ex with tan leather. I'd like to mount an amp or 2 under it.
View 10 RepliesFord Excursion :: 2002 - Swap 2nd Row Bench Seat For One With Full LATCH System
What model year(s) 2nd row bench seats that have a factory LATCH system will fit in a 2002 Ford Excursion to replace the seat that is missing the anchors that are between seat bottom and seat back?
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2011 F250 XLT - Jumper Seat To Console Swap
I traded from a 2011 F-250 XLT recently with premium package to a 2015 F-350 Lariat, but the truck we found didn't come with a couple of the features that I loved in my last truck. I live in western Nebraska, and travel very regularly to western North Dakota and central Illinois for my business. The truck has 5200 miles (had the truck for 1 month ), but everything is still in great condition and would hope for the same in return.
View 3 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Front Seat Swap
After a 7 year love affair with our 2005 6.0L Excursion, we bought another 6.0L today - a 2006 F250 Crew Cab. It came with front buckets/console, and the used car lot (all diesel trucks...) was nice enough to let us swap the seats out with another 2006 F250 Crew Cab on the lot that had the front captains' chairs with the center seat.
Their upholstery guy did the work with the captains' chairs, but for liability reasons they wouldn't bolt the jumpseat in, since the truck we bought didn't have the studs in place. So, they sent it home with us and we're faced with putting it in. No problem, right?
Well... we found the place for the bolts to go, and thought we were home free. BUT... (see photo) - what have we done wrong?? The first photo (driver's side bolt of center seat) is fine, but the passenger side bolt hole is too close to where the front passenger seat needs to bolt in.
Ford Super Duty (1999-2016) :: Center Console For Jump Seat Swap
Looking to swap out my center console for a center jump seat in my 2014 F350 xlt. Mines has gray cloth interior. Can this be done? Need to swap their seat for a console?
View 5 RepliesFord Super Duty (1999-2016) :: 2008 - Center Console Swap For Middle Seat
I am considering the purchase of an 08 Super Duty, however the truck I am looking at has a center console between the front seat. I need seating for six and like to swap a leather middle seat with fold down armrest for the console that I can't use. I don't want to buy this particular truck if I can't somehow get the seating issue corrected. You can view the truck at this link. 2008 Ford F-250 ...
View 9 RepliesFord Super Duty (1999-2016) :: 2003 - Rear Bench Seat Swap To Captain Chair?
I have seen plenty of the king ranch models that have the rear Captains chairs. My question is, I have a 03 Lariat Crew Cab w/ a bench seat, however, I would like to remove the bench and put 2 captains chairs in the back. Is this possible without lots of interior body modifications?
View 14 Replies