Ford 7.3L Power Stroke (1999-2003) :: Oil Leaks - Lots Of Slop While Turning Steering Wheel?
Steering wise, it seems very likely that I'm due for a steering box. Lots of slop when I turned the wheels back and forth. Also, as per the seller, it seems like the the wheel bearings and ball joints are in good shape.
The sway bar end link bushings are smoked, so those need replacing. As for oil leaks. I'm thinking it would be best to pull the motor. It looks like this engine has had the pan off, but I do believe I have a front pain leak. The crank case breather is going into the intake which is annoying. And I believe the intercooler is full of oil, explaining the mystery oil leak by the passenger side intercooler boot.
Couldn't see any oil in the valley of the motor but I see oil coming down the down pipe of the exhaust, out the bell housing of the motor and dripping from a weep hole maybe 8 inches down the transmission as well? Seeing as to how I'm not sure what clutch I have, it make sense to pull the trans. And If I have the dreaded oil pan leak and a intercooler full of oil, why not just pull the motor? I'd also like to trim out the front panel for 05+ head lights and clean up the wiring on this thing. Found a cheesy electric compressor for a small horn. Sounds like a clown horn, no kidding.
Ford 6.0L Power Stroke Diesel :: 2004 - Steering Wheel Won't Turn With Brake Pedal Down?
I have an 04 6.0 psd and if I am stopped in drive with the brake pedal down I can't turn my steering wheel at all. If the truck is in park and my foot off the brake pedal I can turn the steering wheel both ways just fine. When I am driving I don't have any problems with the steering. I have checked the power steering fluid and it is full. This makes it kind of hard when I am trying to pull in and out of parking spots. What could be causing this and what the solution would be to fix it?
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: Whine Coming From Front Wheel Bearings?
I have some whine coming from my front wheel bearings so I'm going to replace them both. I'm not sure if this had been done on my truck before, but I'm thinking so since I have Moog greaseable ball joints.
Truck has 250k miles on it. I'm going to check the pads, rotors and slide pins. Anything else that might need work? I'm sure the half shaft could use a once over, but I don't keep my hubs locked so they don't turn much in regular driving.
Ford 7.3L Power Stroke (1999-2003) :: Steering Will Whine Only In The Morning When Pull Out Of The Driveway
So when driving my tuck the steering on it would sorta lock up like it wanted to push the truck to one side then it would free up and the steering would be real loose it just felt like it had no power steering to one side it's not the same side each time and it pulses when I'm at a stop if I move the the tires Erving the motor doesn't seem to work so far I have replaced ball joints and all tie rods they needed done anyways it would still do it got an alignment done last week and it almost seems worse now could just be coincidence.
I'm thinking power steering pump but when the steering locks up to one side I'm also wondering if it's the steering box it's kinda hard to explain it what's going on and there is no popping noise or anything when the steering frees up. It's kinda scary on the freeway when I go around a corner the steering gets real loose and wonders back and forth not all the time but quit a bit but when going strait it will feel like it wants to pull to one side then the steering will loosen up again. The steering will wine only first thing in the morning when I pull out of the driveway then it's fine
Ford 7.3L Power Stroke (1999-2003) :: Pedal Sink When Brake Depressed After Brake Line Replacement?
03 F250 7.3. I busted a brake line last week somehow, Got it replaced and fixed up, Bled that line and everything was somewhat good.
Now, when i hit the brakes hard, I have pressure. If I let off even a little, My pedal will start to sink till i apply more pressure. I am gonna fully bleed my brakes when I'm home to see if this could solve the problem.
Ford 7.3L Power Stroke (1999-2003) :: Hydroboost - Vibration In Brake Pedal
So I have my 2000 F250 in the shop because I was feeling a funny vibration in my brake pedal. (isn't warped rotors, I know what that feels like). It also felt like the brakes were on, then would release a little, lengthening my stopping distance.
I took it to a small local shop and the guy said it sounds like the hydroboost. I told them to fix it. Next day, before they start to fix, they call and say they can't guarantee it's the hydroboost and may be the Power Steering pump.
My question is; is there a way to test it to know for sure which part is failing? How do I figure out which one is causing the problem?
Ford 7.3L Power Stroke (1999-2003) :: New Caliper Now Loose Brake Pedal?
Ive had plenty of brake issues with this truck since I've owned it and I finally got to inspect a brake i knew was having issues. The outside pad was metal on metal. The inside pad was gone and the one piston was extended completely open while the other one was closed. So to the question. Ive bled it like i do any other caliper and no luck. I went an bled all the other calipers and still no luck. The brakes seem to be working ok even though i never really tested them super hard but the pedal is far lower then it was before.
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - Loose Steering While Turning - Alignment?
I started noticing a problem with my steering on my 2000 Excursion, a couple of days ago. when I make left or right turn, the wheels seem to want to continue in the direction of the turn even as I am straightening up the steering wheel. I have to over compensate on the steering wheel to straighten the wheels it seems. It does it when I make a left or right turn, but seems to be worse when turning left. Also I noticed that if I'm driving on pavement that has ruts from heavy traffic, the front end seems to pull to one side then the other.
I've had the truck for 7 years and this is the first time this has happened to it. Is it an alignment problem or is there something else that I need to consider? I jacked it up today to check the tie rods and drag link, everything seemed ok
Ford 7.3L Power Stroke (1999-2003) :: Brake Pedal Pulses In The First 1/2 Inch Of Travel
New to me 2002 F-250 PSD, done brakes all the way around for piece of mind.
Job went very well, replaced one caliper and its bracket, serviced all pins and replaced one set of pins as well, (different corner). Bled brakes all day via gravity, watching reservoir and filling as needed as to flush in new fluid. Truck is in great shape. Mileage 153,000 no rust, turned all rotors just to re-surface.
Now here is what's happened, my pedal is good but it pulses in the first 1/2 inch of travel and once passed that no pulse, got under and watched the pedal rod do this as I very easily touched it in that first 1/2 inch of travel, you don't even begin to get much brake started here if any! Truck running; yes-Truck not running no pulse action occurs.
I'll add this: fluid removed had a green tint to it but had no moisture or bad odor. Different fluid??? I didn't know. Used Dot 3 Off the shelf O'Reilly's.
Hydro-booster didn't like fluid? Air? Master cylinder? No leaks before or after this procedure.
Ford Super Duty (1999-2016) :: Power Steering - Louder Whine Or Squeak When Hit A Large Bump Turning
I am a recent new owner of an 06 f350 Powerstroke. Steering Box developed a leak so I decided to replace the box and go ahead and do the pump and hoses while at it. Pump would make some noise so i figured I'd just do it all and be done with it or so I thought. The job was a pain, much harder than the pump and boxes i've done on the older 7.3 powerstroke.
Anyways, used all OEM components (pump was a rebuilt rotorcraft, can't buy new anymore) and everything seemed great for about a day. I tried to bleed the air out per standard practice of turning the wheels with the truck off the ground. At startup and during the first day it had almost no noise at all and the steering felt much easier than the old pump.
Then the pump started to develop the standard annoying ford power steering whine that I hear all the time. Drove it over the weekend on a 160 mile trip and the noise just kept getting worse. As of tonight I can't turn the wheel if the truck is stopped even with my foot off the brakes.
I used synthetic ATF for fluid and there is absolutely no foam or aeration in the reservoir. Good news is I don't have any leaks but the bad is I now don't have power steering. It does make a much louder whine or squeak when I hit a large bump turning, I guess that's just the sound of the pump being stressed more. I am guessing the pump just crapped out but before I do it all over again.
Ford 7.3L Power Stroke (1999-2003) :: Steering Wheel Too Spongy?
I can take one finger and spin my steering wheel full left and right. There is no Resistance at all. Very scary to drive. Would it be the steering box. I am supposed to be at a military school tomorrow need to fix asap.
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - No Voltage At Plug When Brake Pedal Pressed?
Installed Tekonsha P3 on my 2000 F350 I used the recommend pig tail easy hookup when I press brake pedal no voltage at plug but when I move the manual lever I get voltage. I believe the stop light switch activates it. The fuses all check out. I did have a Banks engine brake installed by their people I don't know if makes a difference
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Leaking Power Steering Under The Wheel Arch On The Driver Side
Initially had indications of a leak under the wheel arch on the drivers side.
About 3-4 months back replaced both PS lines and the leak stopped - briefly (maybe a couple a weeks).
Now the leak is back, but what's interesting is I lose more ATF fluid on a single long haul run than I do running round town for 3 weeks. I can't work out where the leak is coming from to identify what else to replace - short of just buying a pump and reservoir and replacing them as I've already done the hoses.
My turbo cooler pipe was hard up against the old PS pipe where it entered the side of the reservoir until I did the replacement hoses. Now I have it out the way but I'm wondering if it's caused some unseen wear or damage.
If I just do the pump to see if that works are the reman units any good out of Autozone or O'reilly's?
Ford 7.3L Power Stroke (1999-2003) :: Airbag / Steering Wheel Removal
Having searched I believe that I need to remove two torx screws from the back of the wheel to remove the air bag. These have that damned protrusion in the middle so I'll have to find and buy a torx driver just for that job. What size is it?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: F250 - Steering Wheel Really Loose
Just bought a 1999 F250 7.3 cab and a half standard 266k miles. The steering wheel is really loose. Not loose as in turning the wheel to turn the tires but like moment up and down and side to side. Are there bearings to replace?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: F350 Lost Power - Fuse Panel Under Steering Wheel Shorting Out
So I have a 1999.5 F350 diesel and the fuse panel under the steering wheel is acting up. I was driving my truck home the other night and I lost power and my truck shut off. I have had a problem in the past with the #30- 30 amp fuse ( controls the PCM and glow plugs from my understanding) that is under the steering wheel, I replaced the fuse and everything started working normally again. Until the other night when my truck shut off, so I replaced the fuse the truck drove again for 20 feet died again, I was able to hold the #30 fuse and allow my truck to start up again but would eventually killed the PCM and shut off again and would not start up due to what I believe the fuse location shorting it out and killing the power to the PCM preventing me from starting it up again.
I had my truck towed home and charged the battery and it started up fine the next morning. If I push on the #30 fuse my truck the shorts out and kills the power, I do not know if this is normal? The fuse is sitting loose in the fuse holder is there anyway making it fit tighter to prevent it from being so loose? I have read every other post online about the problems and tried everything they have recommended but still can not figure out what was wrong with my truck. I disconnected the fuel filter heater, and also the wastegate solenoid to see if that would prevent the truck from shorting out if I pushed the fuse it did not work.
What the problem could be causing the #30 - 30 amp fuse to be shorting out preventing everything from working? Or how to test the fuse panel and all the relays?
Phaeton :: Audible Whine When Turning The Steering Wheel
My Phaeton has pretty audible whine when turning the steering wheel. Closer to lock- the louder the noise. Can I check the fluid myself or is this going to become a trip to the dealer?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Steering Wheel Wouldn't Return But Had To Bring It Back
Just recently i have noticed my truck acting up. the other day at about 10 to 20 mph i made a 90 degree turn and noticed my steering wheel wouldn't return but i had to bring it back. than this morning the same thing happened. I made a 90 degree left hand turn and it happened again. the truck wanted to keep going left but i kept turning right. it almost feels like my power steering pump is going out. The pump was changed about 4 years 90k miles ago. I'm curious to see what others have to say. What could it be????
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Hard Steering When Stopped While Stepping On The Brake
I posted last month that I have hard steering when stopped while stepping on the brake. Feels like there is no power steering boost at all. The dealer claimed it was a failure in the steering box due to a leaking seal. Replaced the box. Not fixed. Dealer now says it is normal; there is not enough pumping capacity or pressure at idle to operate both the brake booster and the power steering booster. Its true that when I ease off on the brake a little and let the truck roll even just a little bit, I get steering boost.
I need a handful of guys with trucks like mine (02, 250, PSD) to go check their trucks, and let me know if they behave the same way. Mine turns with steering boost as soon as I ease off the brake and let it roll a little, but at full stop is feels like no power steering; very hard to turn wheels, and pump makes a slight growl (more like a grinch) just as if it was at a full turn stop.