Ford 7.3L Power Stroke (1999-2003) :: F250 - Steering Wheel Really Loose
Just bought a 1999 F250 7.3 cab and a half standard 266k miles. The steering wheel is really loose. Not loose as in turning the wheel to turn the tires but like moment up and down and side to side. Are there bearings to replace?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 F350 Truck Started To Loose Power And Eventually Stalled?
While headed back to town my 2000 f350 7.3 with 444,650 miles (I'm original owner) and have performed maintenance and repairs since mile 3. Truck started to loose power and eventually stalled, was able to restart several times to limp home 7 miles in one hell of a snow storm. Very confused, replaced cam position sensor ( keep one in jockey box ) replaced fuel filter truck starts then stalls out. Don't know if a bad HPOP would allow start up at all. Fuel pump???
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Oil Leaks - Lots Of Slop While Turning Steering Wheel?
Steering wise, it seems very likely that I'm due for a steering box. Lots of slop when I turned the wheels back and forth. Also, as per the seller, it seems like the the wheel bearings and ball joints are in good shape.
The sway bar end link bushings are smoked, so those need replacing. As for oil leaks. I'm thinking it would be best to pull the motor. It looks like this engine has had the pan off, but I do believe I have a front pain leak. The crank case breather is going into the intake which is annoying. And I believe the intercooler is full of oil, explaining the mystery oil leak by the passenger side intercooler boot.
Couldn't see any oil in the valley of the motor but I see oil coming down the down pipe of the exhaust, out the bell housing of the motor and dripping from a weep hole maybe 8 inches down the transmission as well? Seeing as to how I'm not sure what clutch I have, it make sense to pull the trans. And If I have the dreaded oil pan leak and a intercooler full of oil, why not just pull the motor? I'd also like to trim out the front panel for 05+ head lights and clean up the wiring on this thing. Found a cheesy electric compressor for a small horn. Sounds like a clown horn, no kidding.
Ford 7.3L Power Stroke (1999-2003) :: Whine From Steering Wheel When Turning / Brake Pedal Is Mushy
2001 F350 XL... Fitting on PS pump broke and I lost PS and PB with fluid everywhere. Replaced the hose with a new one from Autozone and I have no noticeable leaks.
I know I lost more than a quart but I could only add less than a quart (Mobil 1 Synthetic ATF). I'm also getting a whine from the steering wheel when I turn stop to stop. The power steering is back and there are no leaks (that I see) but the brake pedal is mushy. I've pumped and turned stop to stop for a while. Do I have to bleed the system like I'm doing a fluid flush? I hate to waste the synthetic fluid that I changed about two years ago.
Ford Super Duty (1999-2016) :: 2001 - Loose Power Steering When Step On Brakes And Turning The Wheel
Starting about a year ago, "sometimes" when I step on the brakes and am turning the steering wheel, I loose the power steering. I took it to Ford and they said that this is a a known issue but they didn't say what it would take to fix it. Because this problem is intermittent it is very hard to get this fixed unless the mechanic can experience and verify the problem for himself...
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 F350 Turning Over Longer Than Normal Before It Fires Now No Start
I got a friend of mine that owns a 2000 F350 7.3 with around 280,000 miles. He said that the past 2 days its been turning over longer then normal before it fires. Once started, engine runs same as it always has. No sputtering or hesitations, idles fine, etc. However today, he drove to work, shut it off, then went to start it back up 10 or so mins later and now it will only turn over. Said he's getting fuel and compression is good. Unfortunately i dont know much about Diesel engines.
View 2 RepliesFord Excursion :: Steering Loose After New Tires And Alignment
My Excursion only has 74000 miles and I just replaced the original shocks with Monroe Reflex and combined with my Goodyear Silent Armor tires was running beautifully. Then after a "deal" from Ford, I replaced the Goodyears with LTX-MS2's and had the alignment checked since my Goodyears did have a little cupping after 45000 miles. They also checked all the front end components and said that everything was in good shape! Upon driving it home, the Excursion steering was extremely loose and I was ready to return the tires and get new Silent Armors, but I figured that there probably was something screwy with the alignment that they just did. So I brought it back, test drove it with the tech at 75 mph and he decided he needed to recheck the alignment. After the realignment, it drove beautifully, but after reading the posts on various forums regarding the proper toe-in on the front, I am questioning whether the alignment is set properly?
After the 1st alignment (in degrees):
LF Camber .3; Caster 3.0; Toe .01
RF Camber -.2; Caster 3.2; Toe -.03
Total Toe -.03; Steer Ahead .02
LR Camber .1; Toe .12
RR Camber -.03; Toe .16
Total Toe .27; Thrust Angle -.02
After the Realignment (in degrees):
LF Camber .3; Caster 3.0; Toe -.03
RF Camber -.2; Caster 3.2; Toe -.04
Total Toe -.07; Steer Ahead 0.00
LR Camber .1; Toe .13
RR Camber -.3; Toe .18
Total Toe .31; Thrust Angle -.03
Ford 7.3L Power Stroke (1999-2003) :: Dipstick Flange Nut Came Loose?
Heading back up to get the last load of antique tractors from the show and something seemed funny. 2 miles later turn into a side Road less power. Pull over. Oil everywhere. Shut it down. Nut completely unthreaded.
Get it on and tighten as best I could with a pair of channel locks one size too small. Dump in a gallon of oil. Now it is just on the stick. Start it and sounds good. Still leaking.
Called a buddy to see if he can get me. Yep sure but his wife is not happy. Something about him going to Texas at 7 am for work for a week..... Give him directions hoping he makes it since he has no sense of direction.
Obs 7.3 stops. Talk to him. He doesn't have anything better for tools on him but lives a mile down the road. Drop the trailer on the side of the road. Drive to his farm and got some better fitting pliers. Either I got too heavy handed or I cross threaded it. Stripped the nut. The flange threads look good.
Drive back to the trailer and sit intersection so my buddy doesn't miss it. Hook my trailer to his truck and get mine loaded. In the end it turned out as best as it probably could have. Pictures to follow when the sun comes up. Time to read up on the dipstick flange. Hoping a new nut and o-rings will fix it.
Ford 7.3L Power Stroke (1999-2003) :: New Caliper Now Loose Brake Pedal?
Ive had plenty of brake issues with this truck since I've owned it and I finally got to inspect a brake i knew was having issues. The outside pad was metal on metal. The inside pad was gone and the one piston was extended completely open while the other one was closed. So to the question. Ive bled it like i do any other caliper and no luck. I went an bled all the other calipers and still no luck. The brakes seem to be working ok even though i never really tested them super hard but the pedal is far lower then it was before.
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Turbo To Pedestal Bolts Really Hard To Break Loose
Are we supposed to put anti sieze on the turbo to pedestal bolts. They were really hard to break loose when I pulled it Cheater bar tight. 18 ft. lbs sound right ?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Loose Sounding Rattle In Front End And Thud During Braking?
I picked up a 2000 4x4 F250 on Saturday.
The truck rides pretty good but on bumpy roads there is a loose sounding rattle in the front end. Also when applying the brakes there is a thud in the front drives side. You can feel it in the drivers floor board a little. Once you start braking about halfway to complete stop is when the thud is, if that makes sense. I suspect bushings but how do I know which ones.
Ford 7.3L Power Stroke (1999-2003) :: 4r100 Transmission Loose After Warm Up Especially At 4th Shift Overdrive And Passing Gear
I have a 4r100 on in a 99 7.3 4x4. The shifting problem I have appears to be intermittant. it seems loose after warm up especially at the 4th shift overdrive and passing gear. possibly due to low presures ? sometimes (lately more often than not) hunts back and forth between 4th and o.d when passing or hill climbing. Under normal driving it shifts somewhat firm with 4th being an exeption.I have changed my crank position sensor filters and fluids which had turned dark and improved slightly. When I pulled the pan and replaced the filter the pan was spotless. No residue or signs of plates or debris. There is about 100,000 miles on the tranny and 350,000 on the truck. Questions: Is there a tcm for this transmission and if so could it cause these problems? I'm considering a purchase of an unlocked 1705 superchip to change the shifting but unsure if this will work for my issues...
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Green Wire Located Above The Fuel Filter Assembly Knocked Loose?
I'm in the process of replacing my HPOP lines and fittings and after I got everything removed and started cleaning the threads before re-assembly I noticed this green wire (located above the fuel filter assembly) that apparently I pulled out of its socket.
What is it for? Can I just push it back in its sleeve right below the red wire??
Ford 7.3L Power Stroke (1999-2003) :: No Power - Truck Will Crank For About 15 - 20 Seconds Before Turning Over
I have a e99 f350 7.3 all stock. I have no power. The truck will crank for about 15-20sec before it'll turn over. I just purchased the*AE*but am fairly new to understanding it all. In idle its a little rough and when I drive I can only stay in the neighborhood because of fear of getting rearended due to very slow acceleration. Whats weird is that when i have no power while i am driving ill keep the pedal down throw it in nuetral and my rpms and*icp*pressure jump up right away. Things I've replaced:
Icp*sensor
Fuel pump
Pcm
Tps
Cps
Ipr
Dropped tanked and cleaned screens
When cranking my*icp*pressure climbs slowly to right under 500. I dont know what else to do ive been working on this truck dor two months some days 13hs straight, I am feeling defeated. Codes p1249 1211 1209....
Ford 7.3L Power Stroke (1999-2003) :: Truck Almost Died Turning Headlights On
On my way to work today it was raining so I turned my head lights on. All the dash warning lights came on and my truck had zero throttle response. I quickly turned my lights off. The truck went right back to normal. I turned my lights back on and nothing happened.
View 12 RepliesFord 7.3L Power Stroke (1999-2003) :: Rattle From Inside Exhaust Like Something Is Loose Inside The Pipe
I recently upgraded my exhaust from stock to a 4" Magna Flow Turbo back kit. After the upgrade, I noticed a strange rattle coming from the tail pipe. It sounded like the pipe was vibrating on something but I checked and it is free from anything touching it. There are no strange noises coming from the engine area. it is only herd at the end of the pipe. If I start the truck it makes a the loose rattle noise like something is loose inside the pipe like the sound you get when you have a bad muffler. About after 4 or 5 minutes I hear the exhaust noise change pitch and make a whooshing noise like a gate or something opening or closing and changing the exhaust flow. After a while it goes away and make the loose rattle returns. The truck has lots of power and preforms great. Where to look?
View 3 RepliesPassat - Volkswagen :: 2003 - Power Steering Leak After Wheel Alignment
I recently had a 4-wheel alignment performed on my 2003 VW Passat. A couple days after the procedure I noticed my steering wheel was stiff and a whirring noise when I turned the wheel. Come to find out my power steering fluid is now leaking. Is this just a coincidence, or could the garage have broken something. It was not leaking or making any noises prior to the alignment.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Extended Pitman Arm Rubbing When Turning Left
I have a 2001 F350 7.3 with a 6" lift..I have a extended pitman arm for the lift and I have just noticed that it is rubbing when I do a left turn....
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F250 Not Turning Over After Injectors Replacement
So I replaced all the rings on my injectors . After putting them back in turned the engine over 5-7 times by hand with the glow plugs out. Then I turned it over with them out as well with the valve covers off. After than I installed everything back in. Now is my problem. I've turned it over 5 times and no luck. Not even on turn over. The oil light keeps coming on?? The indicator doesn't move up at all. It will go up and come down ? Is something wrong with the hpop? Should I keep cranking? Gotta to charge the batteries now..
2001 f250 7.3