Ford 6.7L Power Stroke Diesel :: Clicking Sound Coming From Front Passenger Wheel When Turning
What would be causing this clicking sound coming from my front passenger wheel? Wheel bearing? It ONLY clicks when turning left.
[URL] ....
Ford 6.7L Power Stroke Diesel :: Clunking In Front Brakes After Replacing Brake Pads And Turning Rotors
Ok so we just replaced our front and rear brake pads and had the rotors turned. Our rear brakes are fine but both our front brakes now make a clunking/popping noise when we brake.
View 4 RepliesFord 6.7L Power Stroke Diesel :: Making Grinding Noise While Turning On Hill
a few times when making a tight turn on hilly terrain or a hill on a road, I've noticed a grinding sound in the front of the truck and a vibration in the steering wheel. I've so far chalked this up to the hill assist feature, but today I was on relatively flat ground in a parking lot with a dip in it. While crossing the dip in a tight turn, I noticed the same thing again.
I've checked the tires/wheel wells and there is no rubbing, etc.
Ford 6.0L Power Stroke Diesel :: Grinding Noise From Front End
I recently replaced the front wheel hub and upper and lower ball joints on the the driver side of my 2004 f250 CC SB 6.0 fx4. Now when I put into 4 wheel drive I get a grinding noise that sounds like a worn out break pad from that side only. It didn't do it before and it only happens in 4x4. I have replaced the wheel hubs before and it was fine. Also The needle bearing race on the axle is good.
View 4 RepliesFord 6.7L Power Stroke Diesel :: Strange Noise From Front Hubs
Coming home from a trip with my truck pulling the 5th wheel, we heard noises that seemed to be coming from the front hubs that sounded like stones in the hub caps. Once we got home I pulled the front lug covers to see if any came loose and were rattling around inside, but all were torgued properly. Everything drove strait and tight with no noticeable problems, should I be concerned....
View 8 RepliesFord 6.0L Power Stroke Diesel :: Humming Noise From Front Right Side When Hit A Bump Going 65 MPH
So with the hurricane coming to my house I did the balljoints on my drivers side yesterday to prepare to evacuate today. Everything went smooth with no problems. Now fast forward to the drive to Orlando, I hit a bump going 65 and my front right side (ball joint replacement side) starts humming. I pull over and it stops, get out see nothing obviously wrong and start back on my way with no noise to speak of. It happened again and again I just slowed to almost a stop and it went away. Yesterday after the repair I took it on a trip through some crappy roads, the freeway, and all that to ensure she was safe with no problems. Maybe it is the bearing failing all of a sudden (it looked fine when I took it off). I have had a vibration at 55 consistently i think is the tires now that I replaced the ball joints (was waiting to have the tire shop check balance until after the repair) maybe that could be it?
View 3 RepliesFord 6.7L Power Stroke Diesel :: 2004 F250 - Grinding Noise From Front End
Ok here goes. I recently replaced the front wheel hub and upper and lower ball joints on the the driver side of my 2004 f250 CC SB 6.0 fx4. Now when I put into 4 wheel drive I get a grinding noise that sounds like a worn out break pad from that side only. It didn't do it before and it only happens in 4x4. I have replaced the wheel hubs before and it was fine. Also The needle bearing race on the axle is good.
View 2 RepliesFord 6.7L Power Stroke Diesel :: Strange Noise After Shutdown Coming From Top Front Of Motor
The truck always made a few strange noises after shutdown, but this is new and annoying.
Here's the scenario: Truck is warm and no CEL. A few seconds after shutdown, I hear all the normal(?) noises and then a noise that sounds like a vacume pump running starts and continues for about 20 to 30 seconds. Cycling the key, but not starting the motor will cause the noise to happen again and again on each key on/off cycle.
The noise seems to be coming from the top front of the motor. Could this be fuel pressure bleeding off? Is there a check valve that is maybe not doing it's job??
Ford 6.7L Power Stroke Diesel :: Ticking Noise Coming From Front Of Transmission Where It Bolts Up To Engine
Got home from work this morning and noticed when I pulled in the drive and opened the door a ticking noise coming from under truck. Finally had time this evening to crawl under truck and investigate noise. It's coming from the front of the transmission where it bolts up to engine. It's a pretty much steady tick and goes away for a few seconds here and there. when you increase RPM's it's still there and I think goes away at higher RPM's, it doesn't get louder as you increase RPM's just stays the same level. Will get it to shop Monday hopefully and get this checked out and NoX sensor changed out too.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Clicking Noise Coming From Front End When Applying Brakes At Slow Speeds
A while back I posted a thread trying to fix a clicking noise coming from the front end on my F-350 dually when applying the brakes at slow speeds (under 15 mph).
While returning from our camping trip last week the noise is back again. It does not occur after the truck sits overnight or for a few hours. But after driving for 30 minutes or longer the clicking will return when I apply the brakes at slow speeds. I tested the rotor temps with a heat gun and it seems to start when the rotor temps get above 120 degrees F. So I removed the brake pads & calipers, regreased the slide pins, cleaned up the pads and applied some lubricant on the back of the pads. I also bent the pad clips so they would fit snugger/tighter in the slots.
Whatever I did seemed to cure the clicking while driving around this weekend. I made sure I got the front brakes nice and warm - up to 180 degrees or so.
When I did this same procedure a few months ago the clicking went away - but eventually returned.
Should I get some better clips? Replace the sliding pins? Pads? The rotors & pads were replaced this winter & the shop said they and the labor are still under warranty. But if they use the same clips - I'm concerned I'll be back to square one in a month or so.
Ford 6.7L Power Stroke Diesel :: F250 - Loud Buzzing Window Noise Coming From Front Passenger Side
Fixing issues with my truck. I just ordered some latex surgical tubing and am getting ready to fix the rattling noise in my rear door by using the Epic's Door Seal Mod. Hopefully this will take care of that issue.
One more annoying noise though. Has there been any fixes to the buzzing window noise that is coming from the front passenger side. If the wind is blowing right and I'm running over 50mph, at times get a loud buzzing noise and really bugs me. Something is vibrating and at first i thought i had a speaker going out but found out that wasn't it.
I've called my dealer and informed them of this and asked if they've heard of this but of course they haven't and this usually means the won't do anything besides look for recalls or something. I have the noise recorded and scheduled an appointment with my Ford Dealer but again, they won't do anything most likely.
Ford 6.0L Power Stroke Diesel :: Popping Sound When Turning
I bought my 6.0L Diesel about a month ago. Recently when I turn to the left it makes a weird popping sound and gets the "death wobble" If I turn it sharply to the left it will then stop. Last night it got terribly worse and it wobbled at any speed no matter what. I put it up on jack stands and turned the wheel with both tires off the ground, and the sound still happens. I am only by myself and I tried to figure out what is wrong with recording on my phone to see if a ball joint was freezing up but couldn't see. Is there anywhere I should focus on more or less with the camera to see what the issue could be?
View 6 RepliesFord 6.7L Power Stroke Diesel :: Edge CTS Turning Off Itself - Hot Interior?
I've had my Edge CTS for two years and never noticed it turning itself off last summer.
This year, if the windows on the truck are rolled up and the interior is hot, The Edge displays a Red Error code and shuts down. 5-6 miles down the road as the truck has cooled off, The monitor will turn back on. I just don't remember that ever happening last summer, And I'm sure it got as hot as this year.
CTS turning itself off because of interior temps?
Ford 6.0L Power Stroke Diesel :: Crank No Start After One Hour Of Turning Off
I have a 2004 Excursion with strange symptoms. It will start cold and when you drive it for a while, then turn it off, it will start again right away. If you leave it for an hour you will get a "crank no start". Leave it till the engine cools down completely and it will start again.
The other day it wouldn't start cold, but after I had it towed in to a mechanic, he turned the key and it started right away. I left it with him for 3 days and he could not get it to "not start". So I picked it up and drove it for an hour, parked it and left it for an hour came back and had a "crank no start" till it was cold again. I love my truck but it doesn't seem to like me.
Ford 6.0L Power Stroke Diesel :: Transmission Bucking When Shift From OD Down - A/C Turning Off And On
We are on vacation pulling the 5th wheel. On the last of the three days driving the transmission starting doing something I have never seen. When running about 60mph and starting up a grade, when I push the pedal and it should shift from OD down, it bucks really bad. It only does it under those conditions and only when towing. It does it when the tow/haul is on and tow haul is off. Also, in the afternoons on the last two da,ys the A/C has started to turn off. The fan still runs but the cooling cycles off. After a while it comes back and is ice cold but then cycles off again. It only seems to do this when the engine fan is running to cool off the engine under load. I have it scheduled at the local dealer for a transmission service and A/C check....
View 12 RepliesFord 6.0L Power Stroke Diesel :: Motor Turning Over 5 Seconds Before Starting
First off I'm new to the 6.0 powerstroke that being said, I bought a 07 f350 with 102k miles in VERY good condition and I'm planning on doing the bullet proof on it. But my question is that when I start the truck it will turn over about 5 seconds before it starts up. I've even cycled the glow plugs twice with no difference. If I shut it off after it's warm and start it right back up it'll still turn over for about 3 seconds.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2003 F250 Keeps Cranking And Not Turning Over
I have a 03 f250 6.0 . I rebuilt the whole top end. When i finished it 15 months later due to personal issues I started it. It ran for about 4 hours i turned it off the next day i went to start it again and didn't kick over so i figured it was batteries they might of died (it was about 3 degrees out) so i went to get new batteries put them in and it started using diesel 911 and starter fluided i let it run for awhile. I went back the next day to start it and it did t turn over it just kept cranking and started to die out so i stopped trying. Now a week later I am at it again. Could it be not starting because of bad fuel trying to get through the system or could it be something else?
View 3 RepliesFord 6.7L Power Stroke Diesel :: Turn Signal Won't Stop Automatically After Turning?
All of a sudden, my turn signal won't stop automatically after making a turn. I read that the multi function lever needed to be replaced. I did, and nothing changed... what is wrong since its not the lever assembly itself?
View 6 RepliesFord 6.0L Power Stroke Diesel :: Cooling Fan Turning Too Slow / Doesn't Speed Up When AC Is Turned On
6L w/automatic trans,no tunes,no mods. Fan doesn't speed up when ac is turned on. I checked connector at fan shroud and #25 10a fuse and wanted to see if there's anything else I can do or check before taking it to dealer. I haven't towed heavy since I noticed ac not cooling at idle but last time I did tow the fan ramped up on hills and stop and go. I'm in Texas so I must get this right asap. I heard of some with manual override so I would like to do that as well but also heard rumors the override can damage pcm. Any manual override?
View 8 Replies