Ford 6.7L Power Stroke Diesel :: Any Way To Turn Rear Heated Seats On With Remote Start?
It would be nice if you could have the rear seat heaters come on with the remote start, but only when you knew you would want them on. Like tonight 5 of us are going out and it will be hours and in the 20's when we get back to the truck. Where I park in the lot is at the limit of the remote start so it is farther than I want to walk to manually turn them on (plus doesn't that defeat the purpose of remote start.)
I was hoping that if they were powered on when I shut the truck down, they may come on at restart but nope. I tried a few combos of truck running on remote, and with the key. Is there a secret way by chance?
Ford 6.0L Power Stroke Diesel :: Alternator Warning Light And Lose Power Steering Soon After Brakes Got Stiff
I just wanted to share with you all a cautionary tale about belt tensioners and idler pulleys. I am now a firm believer in installing the aforementioned items when you replace your drive belt. 15000 miles ago I replaced the drive belt and didn't heed the warning of some here on the forum.
For the last month or two I have noticed what sounded like road noise which I dismissed because I had just had new tires installed that had a more aggressive tread pattern than my previous tires, I also noted that the ECT had been a bit higher than normal, like running in the high 190's to low 200's on average.
Well while driving today I get the alternator warning light and lose power steering and soon after the brakes got stiff, this was followed by ever increasing ECT which got to 242* before I could get it off the road and shut down. It is too early to tell if the noises and the ECT temp rise were the result of this tensioner going out...
For what its worth the only tools required were a 10MM end wrench and a bit of skin to get the job done.
Ford 6.0L Power Stroke Diesel :: 2003 - Lose Power / Coughing And Blowing Bluish White Smoke Then Shut Off
I picked up a 2003 6.0 awhile back went ahead and did studs,gaskets, delete. Was driving it and seemed to lose power, started coughing and carrying on blowing bluish white smoke then shut off. Ended up hydrlocking #5, Oring on injector was tore when took out. Put all back together, ran horrible, did a balance test with AE, showed #3 injector, replaced, ran horrible, did AE dropped #1 injector. So in process of replacing the rest of the injectors. Just wondering why it is or was dropping them 1 at a time. Ficm was showing 47.6 to 48.6 volts, could that be it?????
View 14 RepliesFord 6.7L Power Stroke Diesel :: Heated Seats Quit Working?
The only problem it's had is the heated seats quit working.
View 14 RepliesFord 6.0L Power Stroke Diesel :: No Heat Only A/C
I'm getting ready for the change in weather and noticed that I don't have any heat. A/C blows cold as a blizzard but its cold even when I have it all the way in the heat.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Heat Up During Idle
I have a 2004 Excursion Limited with a 6.0 PSD. Recently I have noticed my temp, I have a Scan Gauge II, slowly climbing when I am idling. On the highway it runs anywhere from 175-205 depending on time of year and load I'm pulling. Lately I have noticed it starting to climb while sitting in a parking lot at idle after coming off a steady speed run. Temp goes from about 175 up to about 205 just at idle. It is a slow creep up not a dramatic change. I have checked my coolant levels and it is full. I have made sure the front of the radiator is clear.
View 8 RepliesFord 6.0L Power Stroke Diesel :: No Heat Blow Cold Air Only?
today me and the wife where riding around doing some things before the snow storm. we went to the store and the heat was great but when we came out cranked the truck and all of a sudden no heat at all would just blow cold air. im not trying to go to a dealer and get charged an arm and a leg so where do i start.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Compressor Spin Even If AC Or Heat Isn't On?
Ok so I have another issue. This is one of three right now. Had the truck flat bedded home due to a seized rear caliper. Carrier bearing is causing vibration, will replace that this weekend. My question is does the ac compressor spin even if the ac or heat isn't on? Mine wasn't spinning today when the truck was idling. Should it always spin and just not be "engaged " my ect was quite high too but I thought that was due to the locked up brake.
View 14 RepliesFord 6.7L Power Stroke Diesel :: Heat Only Works On 90 Degrees
Having issue with heat only working when the temp is at 90? I turn it down one click 85 and it goes cold?
View 3 RepliesFord 6.0L Power Stroke Diesel :: 2006 F350 - No Heat From Thermostat?
Went today to check out a buddy's truck, 06 F350 164k egr and cooler delete. He finally did his thermostat yesterday, after not having warm heat for months. Today on the way to work, had great heat for about 10 miles, then it went cold. Pulled over to check coolant, cracked cap loose, let pressure out, now had heat again. Same thing on the way home. Had the white streaks down from the cap, lost a small amount of coolant, just at min line now. He's owned this truck since 48k and no heads have never been off.
View 8 RepliesFord 6.7L Power Stroke Diesel :: Takes Long Time To Blow Heat?
I'm thinking this is probably just the way they are, but I don't understand why........... I have a '12 F250 supercab 6.7 FX4.... truck is an XL, no supplemental heat or anything. If it sits outside over night, and I go out in the morning after say a 35-40 degree night, start it up and let it run 10-15 min then drive 5 miles down the road to town, both temp gauges are still pegged on the cold side, and there's virtually no heat blowing on the defrost. Even if it sits in the heated garage over night, same temp, same drive to town in the morning, same lack of any heat.
My old 2010 V10 that I traded for the 6.7, and my current 09 5.4 are the exact opposite of this. I can start the 5.4 cold, leave within a minute or two, and be making some heat within a few minutes. By the time I get to town, everything is well in the normal range, and I'm turning the heater down cuz it's too hot. Even once the 6.7 is fully warmed up the heater doesn't seem to make near the heat that the gas trucks do. I love the 6.7, I just find this a bit odd. Am I missing something, or is this just the way they all are?
Ford 6.0L Power Stroke Diesel :: 2006 F250 - Heat Up Very Quickly - CT And EOT Warnings Going Off?
My 2006 6.0 has recently started to heat up very quickly after i start it, after about 10 minutes of highway driving my ECT and EOT warnings are going off on my Edge CS programmer and reading 220F (both) and higher. My A/C also only blows out cold air if I am driving around, at an idle it just blows out warm air at me. Average summer temps at home of ~25C. What could be causing this?
2006 F250 6.0
165,000 km
Egr delete
Aftermarket Headgaskets and studs
Edge CS programmer
K&N Cold Air Intake
Ford 6.0L Power Stroke Diesel :: Bolts Holding Exhaust Heat Shroud Behind HPOP
There are two bosses on back of hpop cover that have bolts holding heat shroud for the exhaust. How difficult are these to remove? The drivers side looks fairly accessible, but passenger side I am not too sure of. I will be back to disassembling everything in a couple of days, and just getting a heads up on it.
View 5 RepliesFord 6.0L Power Stroke Diesel :: Clicking From Door Locks / CD Player Says Initializing / No Heat From Vents
This is the it's always something post. Alternator rebuilt to 185. Batteries tested by AAA. When I went into the truck tonight the door locks made a clicking sound like the battery was going dead. Truck fired right up at 0 degrees.
I just installed WARN locking hubs and now I only have a defroster blower that works. Is there anything else besides a vacuum leak that might cause that?
6 CD Player has had problems loading and unloading for a few years but now it just says initializing and goes right back to radio.
I am really regretting doing the right thing two weeks ago and not letting this truck burn when it caught on fire on the Turnpike.
Ford 6.0L Power Stroke Diesel :: Fill Rear Differential With Rear Axle Shaft Out?
I currently have the rear axle shafts off the truck. I took off, cleaned then put on the rear diff cover.
I live in an area that does nothing but form rust anywhere and everywhere in very little time.
I don't want rust forming in the rear diff gears - can I fill the rear diff up ? Or will it leak out of the rear shaft holes ? Can I fill it up halfway then ?
Ford 7.3L Power Stroke (1999-2003) :: Truck Would Stumble And Lose Power / Idles But Won't Rev Up
Problem started 2 days ago, driving around and my truck would stumble and lose power. Give it gas, won't rev up but it cleared and ran fine for a mile or so then it comes back (off and on all the way home). Check engine light didn't come on the first few times, came on a couple times on the way home (maybe 4 mile trip) but goes off when the truck runs fine. Thinking it was maybe the fuel pump (got 140K on the stocker). Talked to a few friends, some thought it was algae build up in the tank that was clogging the filter on the pump, underhood filter changed a couple hundred miles ago. Looked fine with slight brown build up at bottom of bowl when I replaced it.
Ran it around yesterday with a friend of mine and his scan tool hooked up, acted up once, check engine came on for a few seconds and shutoff. No code and for some reason we couldn't get it to live data while driving. I dumped in an algae eater yesterday and left the truck overnight since I had to work. Got home this morning to run her around the block to circulate the eater. Truck started and idled fine, went to pull out and she won't rev up, pumped the gas and NOTHING! Check engine light is on now but don't have a scan tool handy to read it. I heard the truck will store the code?
What this problem might be? What's a good scan tool for our trucks that can live data as well? CPS is good and already did the UVCH mod.
Ford 7.3L Power Stroke (1999-2003) :: Hard To Steer - Sometimes Lose All Power Brakes
I've got an E99 powerstroke. Recently it's been getting hard to steer, if not impossible. When I'm parked i can't turn the wheel and it gets better if i Rev the engine up, driving is usually ok and going around corners. It's just low speed, low rpm that it won't.
Also every once in a while when braking it feels like i lose all power brakes. The pedal goes to the floor and the brakes let go, then i can feel the pedal pump back up and i get a good feeling brake pedal again that actually stops well. All this happens within about a seconds time. But the steering is by far the worst.
I just did the power steering flush with atf and it didn't work. I'm thinking i need a new power steering pump, but want to ask here first to make sure. The truck has 290,000 on it, and it never has been replaced to my knowledge. I bought the truck with 147,000 however so it may have been done before that.
Ford 7.3L Power Stroke (1999-2003) :: While Driving F250 Start Chugging / Lose Power And Shut Off
I have a 99 F 250 7.3. It runs fine at idle even for a long time. When I drive around the block a couple of times it will start chugging and lose power and shut off. I have been mixing fryer oil with the diesel. I changed the fuel filter, oil change, crank sensor and fuel pump. I added 15 gallons of diesel and diesel treatment. Pulled fuel filter and bowel is full I'm not sure where to look next.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F350 - SES Light Came On / Truck Started Running Rough And Lose Power
I have a 2001 F350, 7.3. My service engine light came on and immediately the truck started to run rough and lose some power. I've checked the under the cover connections and they were both connected, I replaced the cam position sensor and I still have the same problem. The worse part of the hold thing is that there are no codes stored so I'm flying bind. Where to go next.
View 8 Replies