Ford 6.7L Power Stroke Diesel :: 2012 Vehicle Died / Does Not Crank - Blank Instrument Panel
I was driving my vehicle and turned a corner and the vehicle completely died. No illuminated instrument panel, power windows, radio, turn indicators, HVAC not working. Turned ignition key off and back on and blank instrument panel no information. The vehicle does not crank.
All components which do not require the ignition key turned on work fine; IE headlights (low and high beams; they are bright), emergency flashers, power mirror, power seats, brake pedal adjust, door locks (remote and from the door panel), horn, and interior lights to name a few.
Is there a relay which the ignition switch activates to provide power for all components tied to the ignition switch? If so where is it located.
Ford 6.0L Power Stroke Diesel :: No Crank / Start - 30 Amp Fuse PCM Power Relay Is Blown
Ihave a 2008 E 350 6.0 , while driving i hit a small pothole no big deal the van stops running and coasts to the side of the road. get her towed. The dash lights show the PATS is engaged so it is no start no crank.
The 30 amp fuse PCM power relay is blown. when i replace it it blows as soon as i turn the key. im checking for wire chafing but so far have found none.
Ford 6.0L Power Stroke Diesel :: 2003 6.0 Just Losing Power And Shut Itself Off / Crank But No Start
2003 crank no start, 196k bone stock truck egr still in truck and stock head bolts. Replaced the icp sensor and ipr sensor, both from ford. What happened is I got fuel then about 15 minutes afterwards my truck acted like it was going up a hill and was just losing power and shut itself off. ficm tested 48.5 volts all 8 injectors tested good and there is oil pressure. Had an egr fault code but I'm at a loss.....
View 7 RepliesFord 6.0L Power Stroke Diesel :: 2003 - Cough / Sputter For A Few Minutes With No Power After Long Crank
So, a year ago or so I had the truck die on me, it would start after cranking it a long time and cough/sputter for a few minutes with no power. I thought it seemed like a weak hpop or leaking oring, so I tore it down and put it all back together with a something or other hpop. Now I have a no crank no fuel pump condition, the injectors don't cycle when I turn the key on, I do get relays clicking, but no start, the yellow/blue wire gets the starter to turn over, but no fuel, so couldn't start if it wanted to... I am getting 120 ohms (like 122) on the dlc 6,14 and millivolts, basically nothing between 4 and 14...
I sent the ficm off to get rebuilt and they told me that it was already good (charged me anyway though, ah well...) I wiggled wires around and pulled my ficm plugs apart and pushed the wires in some, didn't seem to move any... What is next? There can't be that many things that cause all three, No Fuel Pump, No Crank and No Injector Buzz, can there?
Ford 6.7L Power Stroke Diesel :: 2011 F250 Crank But No Start / Reducing Engine Power
My 2011 6.7L F250 Superduty died on interstate the other night. Picking up throttle pulling onto interstate when a message came on the dash "reducing engine power" and the truck died. It will crank but will not start. It will start on ether but dies when that runs out. Has the following codes... p1249 Wastegate control valve, p0087 fuel rail/system pressure too low, p1291 & p1292 injector high side short to ground or battery (bank 1 & 2), p2291 injector control pressure too low-engine cranking. The codes are telling me I don't have enough fuel pressure but scan tool says I have 4000 w/ key on and 6370 while cranking and I thought 5000 was the pressure needed.
View 9 RepliesFord 6.0L Power Stroke Diesel :: 2003 - No Power To Dash Switch?
Ive changed all relays underhood cause i could not find info on which relay is which, checked all fuses under dash. Checked to make sure up stream on 4x4 fuse position has power. And i checked for power at 2 wire on transcase no power at 2 wire, i am also finding no power at back of dashswitch.. Looking for a wiring diagram that shows complete esof schematic
View 14 RepliesFord 6.7L Power Stroke Diesel :: Source For Switched Power Under The Dash
I am looking for a source for switched power under the dash. I am going to wire up power to my TST507 TPMS but I would like to have switched power. I have a bundle of wires all capped off under there but no idea if any are switched power. I thought I would ask before trying to probe each and every one.
View 7 RepliesFord 6.7L Power Stroke Diesel :: Decreased Power Message Across The Dash Info Center
Got a Decreased Power message across the dash info center today and was limited to only around 5lbs boost. I stopped and pulled the codes and here is what I found:
P054E - Fuel Quantity lower than expected
P1249
P1247
P0471 - Exhaust pressure sensor range/performance
P02D7 - Injector learning @ max
P0402 - EGR flow excessive detected
I dumped the trailer and limped home to change the fuel filters. I could only go 35mph on the flats and 10mph on any kind of up hill slope. I switched out the filters, purged the air, fired her up and cleared the codes, all seemed well. I backed out and went for a test lap around the neighborhood, as soon as I turned the corner and rolled on the throttle and reached 35 the message came back and the codes returned. I will be towing it in to the dealer tomorrow for diagnostics.
Ford 6.7L Power Stroke Diesel :: Reduced Engine Power Message Came Up On Dash And Truck Died
2015 F350 6.7L, 43,000miles
My family and I were driving into West Virginia this morning when the reduced engine power message came up on the dash and the truck died. I coasted off to the side of the road as best I could and got out. Immediately I smell diesel fuel. I look under the truck and there is fuel all over the passengers side frame and when I keyed it back up fuel started spraying down by the right front wheel.
Pulled the fender liner back and saw a small rubber hose that looks like it came off of a tee fitting down by the egr components. I tried to get it back on but wasn't able to get it seated 100% and when I tried to restart it blew off again. Truck is completely stock and ran perfect right up until it died.
Ford 6.7L Power Stroke Diesel :: 2012 F350 - Reduced Engine Power
The truck (2012 f350 6.7 lb cc 131,600 miles) started fine. Then while i was setting up the defrost i accidentally hit the ac button. Well I then hit it again to turn off. At that point the engine stalled. Which has never happened to me before. I started it back up which took a bit longer to get it to fire. It now says "Reduced engine power" and runs kinda rough. I thought well im at the end of my fuel filters life so why not change it since i had one. Well the. The FF housing broke. After replacement FF housing and filter it will no longer start. I took the filter back off and checked to see if it was cross threaded or sucking air. I checked that twice. Still no start cranks fast and strong. Codes are
P2138 something to do with the gas pedal
P0193 fuel rail sensor A high
P06A6 voltage on circuit A is whacky (paraphrasing here)
P0532 ac pressure sensor low
Ford 6.7L Power Stroke Diesel :: 2012 - CEL Comes On / Bucking And Power Surge?
I Have A 2013 F250 I Have A H&S On It. I Have It Delete. And The Cel Comes On In The Morning, Ill Get The Code In The Morning. But It Has Something To Do With Coolant Temp Sensor. It Also Does Like A Bucking/Power Surge. Boost Goes From 0-10-15 ,When you Hold Pedal Steady. Do I Need To Update My H&S Or What?
View 14 RepliesFord 6.0L Power Stroke Diesel :: 6.0 Would Not Crank With Key
While priming the high pressure oil system were using the starter jumper wire but after a while I wanted to watch the insight so I pulled the ficm relay but then it wouldn't crank with the key but before I pulled the ficm relay it would. Now it will start if you turn the key on and use the starter jumper wire but it still won't crank with the key. The truck has a viper alarm system I am thinking that might be causing the issue. How to trouble shoot that? Also I don't know if it is related but it has to crank for too long before it starts.
View 3 RepliesFord 6.7L Power Stroke Diesel :: 2012 F250 - Engine Feels Like Missing At Low RPMs / Power Loss
I have a 2012 F-250 6.7L w/8K miles. I have been struggling with this issue for 6 mo. The engine feels like its missing at low RPM. I would equate it to the feeling of a bad coil pack in a gas engine. The boost indicator drops to 0 for a split second then recovers. The dealer says they can't find the issue but went ahead and replaced the turbo. After the turbo replacement It got worse. This is an intermittent problem with no codes.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Hot Crank No Start Sometimes
The truck was running fine then I shut it off one day and it wouldn't start back up long powerful cranks but wouldn't start pulled the valve covers checked branch tubes and dummy plugs all looked good (not for sure though) replaced the icp and even tried unplugging it after the hot crank no start to see if that worked because that was the only a code I threw but alas it did not work.
I did a air test and closed the IPR valve via fancy tool and was getting some minor gurgling out of the oil filter resivuar and was guided to change the hpop being that was the beloved issue I couldn't get the j-tube out to inspect but everything else was clean as a whistle ... I was getting some air flow threw the oil filler cap and the air intake box on the driver's side valve cover but was told that is normal but not sure how normal when I replaced hpop it appears it stopped gurgling as much.
When I did the following air test but it started when cold but then it struggled but it did start then my batteries died out turns out I do have a bad negative connection I getting the batteries re charged gonna pick them up today and tighten that connection along with a new air filter via reading in the hanes manual that can sometimes cause a hot crank no start .
Ford 6.7L Power Stroke Diesel :: 2011 - Won't Crank Intermittently?
I have a 2011 F250 w/6.7 Powerstroke. Love it. In September I came out of work, turn the key to on position...no glow plug indicator light, no high pitch whine of the fuel pump and most importantly, it won't crank. Gauges all light up, but no glow indicator, no fuel pump sound and no crank. Get towed to dealer. Next morning they try it, and it starts right up. They can't get it to fail. Sent me home with no trouble found.
A few weeks later, same condition in my garage. I had thought that maybe there was some sort of safety switch that perhaps thought it wasn't in park. I put in neutral, roll back about 6 inches, glow plugs light, fires right up. Now I think I'm on to something. In the last 2 weeks, it happened 2 more times, and both times I'm able to get it to light up by rolling a couple inches. Then, last night, same problem, but parked against a curb. Try to push up hill, but no luck.
Have to get towed to dealer again. Tow truck drops at dealer, and because I knew it would, I tried to start, and it worked. Dealer called me, says they can't get it to fail (again), but found one battery was "bad". I'm not really buying the battery story, but also understand the dealer having trouble figuring out what is wrong when nothing goes wrong for them.
Ford 6.0L Power Stroke Diesel :: 2004 - Crank But Won't Start?
I have a 2004 6liter. I parked one day two weeks ago and a went out last week to move it and I will only crank over. No fire No start!!!! Have new batteries. New fuel filter and have fuel coming in to the fuel bowl. I have gone over the harness, checked my fuses. I do not have a reader or scanner. Any recommendations. I want more than just a code scanner.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2003 - Crank But Won't Start
I was driving down the road and suddenly lost tons of acceleration power had to almost flour it to move at all so I pulled off the road to stop and check it out. After I stopped I couldn't get it to start again it would crank like it wanted to start but nothing. So I had I towed home and it sat for a little while and then I tried to crank again, and it started and idled like crap and when I pushed down on the gas pedal there was no reaction, rpms didn't go up or nothing but still would idle like crap.
Symptoms stayed the same for about a day and no I have a crank no start. So then I did what little I could do just to see if it was an easy fix I changed the ICP sensor, IPR sensor, and EGR valve needed to be replaced so I replaced that too. Headstuds and gaskets have been done as well by previous owner but not I think it might be an HPOP problem? I am unable to read codes at the moment as well just FYI. Could this be a fuel filter issue even tho the secondary housing fills with diesel?
Ford 6.7L Power Stroke Diesel :: No Crank / Lost Communication To PCM
So my 6.7 left me hanging the other day, went to start nothing. Towed it into town started. Went to start it couple days later nothing. Jump the plug by right battery starter turns. When key is turned to run no glow plug light, no fuel pump prime. Tested ignition switch good. Tried 2 new Batteries nothing. got power on fuse 52, continuity from fuse 52 to pcm connector. Fuse 49 and 50 also have power. Took all 3 connectors at pcm out and blowed air through and sprayed W.D nothing. Even tried with connector on transmission. Scan tool will not communicate with pcm.
Codes after cleared:
instrument cluster:
uo100 lost communication to pcm
u300a-64 ignition switch...
transmission:
u0294 lost communication with pcm
Body control module:
u0100-87 lost communication with pcm
B10f1-14 key in switch short to ground or open
Ford 6.0L Power Stroke Diesel :: Long Crank After Night Sit?
I'm having a long crank cold start issue. It takes about 2 five second cranks before the truck will start up. It just started acting this way yesterday before I fired it up to go to school. After its warm it fires up no problem the rest of the day, just takes a bump of the key.
I don't think it's the GP system as this truck has started at -20 to -25C all winter long unplugged with no issues. From my reading some sources say that it could be a HPOP leak, maybe dummy plugs?
Is there any way for me to do some more diagnosing - places to look or test for? There are no stored codes other than an EGR code due to the delete. Truck is completely stock with atlas 40.