Ford 6.0L Power Stroke Diesel :: 2006 F350 - Clunking When Go From Drive To Reverse And Now With Drive Too
So I have a 06 350 and I'm getting clunking from drive to reverse and now with drive too, I know my rear diff is on it's last days but I am wondering if that could cause the clunking and now my truck around 90km shakes likes crazy and same thing wana know if that's the diff. And if I was to fix diff myself would it not just be easier for me to just swap axles if I wanted to be cheap??
View 12 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Hard Shift From Park To Drive Or Reverse
2011, 69,000 miles. My truck is experiencing very hard shifts from park to drive or park to reverse after a cold soak. It goes away once warmed up. I can't find any excessive driveline play and my transmission fluid level appears fine and in good condition.
The last repair done on my truck was around 7,000 miles ago and it was for a transmission fluid leak around the bell housing. They just replaced the seal between the torque converter and transmission.
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Transmission Work Slowly - Hesitates To Engage Drive After Reverse?
I have a 2002 7.3 e350 quigley 4x4 Sportsmobile with 312k miles. 2nd owner. Bought it with 295k miles 2 years ago. From what I gathered the tranny is original.
After reversing at a downhill angle, stopping, and shifting the lever to Drive, the tranny doesn't seem to put Drive in gear and depending on the angle of the slope, the van will roll back or barely creeps forward even with throttle. Put it in 1st gear, and the tranny engages that in gear and drives forward no issues, then I can shift to 2nd, then Drive and the tranny shifts fine after that.
No weird tranny noises or clunking. Noticed this issue about a month ago or about a couple thousand miles ago. Did tranny service (drain, filter, fill) at the ford dealership at 305k months ago.
I can only replicate this issue when Reversing on a down slope. On a flat surface van Reverses and engages Drive like normal.
Ford 6.7L Power Stroke Diesel :: 2016 - Clunk Sound Happens When Go From Drive To Reverse Or Using Exhaust Brake When Towing?
What is the source of the sound? Listen for the clunk b/w 3 and 4 seconds. I just dropped off my 2016 Super Duty 6.7 CC LB 4x2 at the dealership. I'm afraid that they will say the sound is a characteristic but I never had the sound on my 2011 Super Duty 6.7 CC LB 4x4. This sound happens when I go from drive to reverse or when using the exhaust brake when towing. The sound does not exist when the transmission is cold only when it is fully hot. It will also make this noise when climbing a really steep hill in first gear with fiver and the torque converter needs to slip a little.
As far as I can tell all of the u joints are tight and the axial support is tight I only have 2000 miles on my truck.
[URL] ....
Volvo - V70 :: Transmission - Little Slip / Jerk When Accelerating
I have a 2000 V70 with 103K miles. I bought this car used (that's another story!) only about 6 months ago. I started to notice a little slip when I would hit the gas after being stopped at a stop light or something. Now the "jerking" happens even when I am sitting still. It really only occurs when I am just accelerating. I took it to one mechanic who told me it needed a new transmission and to another who ran the diagnostic and could not find anything wrong with it. Not sure what to think. I guess you could say I don't want to believe mechanic #1!
View 30 RepliesFord 6.7L Power Stroke Diesel :: When Put In Reverse Transmission Would Not Shift And Truck Not Moving
I am using my son's truck this week, 2012 F250, 120,000 miles or so. I left it running in the drive while I got something from inside the house. Guess it was idling approximately 10 minutes. When I put it in reverse the transmission would not shift and the truck didn't move. I killed it, re-cranked it and it went in reverse.
As I was driving down the road the transmission would change gears up and down for no reason. I stopped the truck, and put it in park. I would put it in drive and the transmission sounded like it wanted to slip. I put it back in park and the transmission would not engage. I then killed the truck, re-cranked it, and it drove fine for awhile and started doing it again,
I kill the truck, re-crank it, and we go down the road.
Ford 6.7L Power Stroke Diesel :: 6r140 - Transmission Slams Hard Into Reverse / Shifting From 1 To 3 Is Awful
I'm having problems with my 6r140 in my 2011, the truck is an early build around 8/2010 I believe.
After cold soak when shifting into reverse after allowing engine to warm a bit the transmission almost always slams hard into reverse.
After that shifting from 1-3 is awful, the transmission will try to go into 3rd but downshift to 1st then fail to go back into 3rd multiple times. This situation is extremely dangerous when trying to pull into traffic.
Oh and once the transmission gets into 3rd it will skip 4th and go right into 5th. There is only 94k miles on this transmission/truck.
I just bought this truck about a month ago, does this sound like an issue with the solenoids in the valve body?
I'm very mechanically inclined and can swap them if need be but now we're talking few hundred in solenoids and then getting the trucks pcm flashed right?
Also fluid has been changed and I used mercon lv.
Ford 6.0L Power Stroke Diesel :: Transmission Engages Hard On Reverse / Vibration And Some Knocking Sounds On Takeoff
05 F-350 6L .. Automatic Transmission
When I got the truck I noticed it would slam hard into reverse. Ever since it is taking longer to engage reverse gear and now I have to rev it to 1000 rpms for it to engage with a hard SLAM.
I also noticed that if I do a fast take off, there is a knocking sound coming from drive shaft/differential area (like knock knock knock knock knock then goes away). Then a slight vibration ending at around 30 kph (~20 MPH). There is also some oil leaking from the transmission. I added some mercon sp yesterday - it was a bit low.
My guess for the knocking and vibration is the center support bearings and U-joints. Transmission??? One thing I know I am going to be banging away at that shaft but the transmission problem really scares me.
Ford 6.7L Power Stroke Diesel :: 2016 F250 - Click Sound From Transmission Area When Sifting From Park To Reverse
I picked up a 2016 F250 Powerstroke in the first of March. I owned a 2011 before and loved it.
The 2016 has been great so far, but I've noticed a sound that wasn't present in my 2011.
When the transmission is warmed up, I get a "cla-click" sound from the transmission area when sifting from park to reverse. It doesn't do it all the time and I can only hear it, not "feel" it.
This AM I heard a similar click sound when I came to a complete stop. I only heard it while stopping, not while taking off. I could repeat it almost every time I stopped. I was in drive the whole time I heard the click sound while stopping.
What it may be? I know sounds are one of the hardest things to communicate/diagnose.
Ford 6.0L Power Stroke Diesel :: Jerk When Going Down The Road / FICM Going Bad?
If my ficm is going bad will it cause it to jerk going down the road and spit and spudder going down the road..sounds like injector but it aint smoking at all.. I think there;s a recall for the ficm for my truck too.. f250 2004 6.0....
View 3 RepliesFord 6.0L Power Stroke Diesel :: Truck Will Sometimes Jerk / Speedometer Starts Wavering
I need the transmission speed sensor for my truck and I am getting a confusing array of Motorcraft and Ford part numbers. I have Motorcraft numbers DY1251 (Turbine Shaft Speed Sensor Assembly) and DY1229 (Transmission Speed Sensor). Not sure what the difference is between the two.
I've been having a recurring problem where, when my speedometer starts wavering, the truck will sometimes jerk, like maybe it's trying to down shift or a stumble of some sort. I've replaced the VSS in the rear diff (with Motorcraft) which cleared up the worst of it, but this problem still persists.
Ford 6.7L Power Stroke Diesel :: Tranny Slip And Lunge Between Gears
I'm at 5,500 miles and the last couple of mornings I've had my tranny slip and lunge between gears, sometimes 2nd and 3rd and once out of 1st. I know there's an update/flash that needs to be done but my build date says not required. My truck was finished April of 2012. I'm going to call the stealer but I'm sure they will "check it out" and say nothing's wrong so it would pin point this issue.
View 7 RepliesNissan :: 1994 V6 Will Slip Into Neutral When Put It In Reverse Or Drive
i have a 1994 nissan quest 3.0 v6 and when i put it in reverse or drive it will slip into neutral if i am stopped. Also the front motor mount needs to be replaced, which I will do soon. Are these problems related, if not how do i fix the shifter/linkage problem? When driving the vehicle upshifts and downshifts perfectly.
View 1 RepliesFord Super Duty (1999-2016) :: Transmission Slip In 1st Gear And Reverse?
Drove the wife to work this morning. The turn off into town there was a lady stuck so I pulled over in the drifts. After putting in back in gear I had to get on it to get out of the drifts. Snow was blowing over the windshield, and I imagine throughout the engine bay.
After that it felt like it stayed in 2/3rd gear. I'd hit the pedal and it would redline and sort of accelerate jumping in and out of gears. So i slowed down to a stop. Accelerated slow and it was ok but when I got more on the pedal it would feel like it was slipping. Once I got in the driveway, she idled for about 15 mins while I shoveled out my spot. Once putting in gear again I had to rev it up for it to move.
Also reverse, had to rev it up to move it.
Scion - Xb :: 2006 - Auto Transmission Slip In Drive
220,000 miles, auto transmission slip in drive, reverse ok. What needs to be fixed and what will it cost?
View 2 RepliesSonata I45 (YF - 2011+) :: Transmission Will Jerk / Buck Fairly Hard When Put Into Drive
I have a 2011 Hyundai Sonata limited with 68,000 miles on it. Once the car has been warmed up for awhile and I shift into drive after a stop, the transmission will jerk/buck fairly hard. It only does it while being put into drive and I haven't had any other issues while driving.
View 7 RepliesLexus SC430 :: On Start And Put In Drive Transmission Slip For About 5 To 10 Seconds
I have an interesting automatic transmission problem. Hot or cold makes NO difference. When the car is started, put in reverse it will work perfectly 100% of the time. When the car is started, put in Drive the transmission will slip for about 5-10 seconds before working perfectly. When the car is started, if you wait 3-5 minutes, then put it in Drive it will work perfectly.
View 13 RepliesHonda - Odyssey :: Transmission Started To Slip When Putting Car Into Drive
I have a Honda Odyssey with 154000 miles on it. In February it started to slip when putting it into drive. I thought this was due to the cold snap. The slip/delay grew until it would disengage from gear when driving. Eventually it was not safe to drive and I had it towed to a transmission shop. They have replaced the TCU, the torque converter arm & the transmission & the ring kit. He has told me that he won't charge more than he originally quoted me, but when I went out there yesterday nothing had changed (it was still on the lift with the exhaust & undercarriage on the floor) since two days prior when he told me it would be done on Friday. Do I have any recourse, and how do I make him finish this job?
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Transmission Slipping When Put It In Drive
My tranny is acting odd. I put in drive and seems to slip a lot in 1st, barely even move at some times. If I put it in 1st with the shifter it goes in and grabs then I can shift up to 2nd or drive and there aren't problems. It drives normally when not from dead stop.
Transmission has 50k miles on it since replacement. Fluid level is normal. I don't tow and drive it particularly hard. I will have to go back and look at miles since last fluid change. I should be right around 30k miles since last change.