Ford 6.7L Power Stroke Diesel :: Brake Vacuum Pump Oil Leak?
Haven't found any other useful info on this, but local dealer says that's where my truck is leaking oil from, and since it's considered brakes not powertrain the repair won't be covered under warranty ...
Backstory goes : dropped my truck off at local dealer Thursday to repair an oil leak from near front main seal area of the engine discovered while inspecting to initiate a bumper-to-bumper warranty through Ford ESP- their platinum warranty. I figured with all the electronic widgets and non-powertrain stuffs on this beast I wouldn't mind paying for 3yrs/36k miles of trouble-free motoring, y'know?
Apparently it's the O-ring on the brake vacuum pump that's allowing engine oil to leak. I can't even find this thing, just looking for some further explanation. I'm keeping an open mind so far, I don't suspect the dealer's just trying to get one over on me, just trying to be good and educated before I go plunk down for the repair.
Ford 6.0L Power Stroke Diesel :: 2004 E350 - Bad Vacuum Pump - Replacement?
I have a 2004 E350 6.0 with a bad vacuum pump. I tried looking on Youtube for a video on replacing the pump but no luck. Looking for a video or instructions on replacing the pump? It looks fairly easy but you need to be a snake to gain access to the pump bolts.
View 9 RepliesFord 6.7L Power Stroke Diesel :: 2013 - Four Wheel Drive Vacuum Pump And Solenoid Location
I have a 2013 6.7 and i cant seem to get my 4wd to work in auto position on hubs i think i have it narrowed down to the solonoid for it but cant seem to find location on it.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Vacuum Pump Running Constantly?
My vacuum pump I noticed is running constantly and also my vents are stuck on defrost.
I narrowed it down by taking off the lines going from the tank to the 4x4 solenoid and the tank to the HVAC line. If I plug both lines I get pressure to both but it still won't shut the pump off. Why won't the pump shut off? Leaky tank?
If I plug the red line back into the solenoid I cannot get pressure to come out of the HVAC line. (Switch in cab set in 2wd)
I can make the pump shut off by plugging the main inlet to the pump.
I took the tank out and can't find any cracks or leaks. Could something inside the tank be broke?
Also why can't I get pressure when the red line is plugged into the selinoid?
I can't figure it out. Almost seems like the 4x4 solenoid and the tank are both the problem.
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Vacuum Routing From Pump To Hubs?
I am in the process of replacing the complete front end on my 02 CC 4x4. Im replacing the hubs the lockers all seals and spindle axles. complete brakes with power stop and stainless brake lines ......I am going to switch back to the original automatic lockers. I am curious if has a simplified one line for the vacuum routing from the pump to the hubs?
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: PCM Gone Bad / Vacuum Pump Is Also Making A Loud Noise
I think my pcm has gone bad. My wait to start light won't come on an when I turn my key on I can't hear my fuel pump cut on anymore. My vacuum pump is also making a loud noise.
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: Backup Lights And Vacuum Pump Not Working
My 16 year old F250 4X4 diesel has developed a problem with no backup lights working, and the vacuum pump is not getting power. The fuse (#28) checks out OK, and I'm told to check for a broken wire on or near the backup switch. I don't know where to locate the backup switch. I have the huge Ford Service manuals, but they are written with the perspective that you should already know where the switches are. Where to find the switch?
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2006 - Power Steering Pump Replacement
When replacing the power steering pump on my 2006 should I go OEM on the pump or save some money and get a Napa or aftermarket remaned unit with the pulley installed? Also, whar is the fluid capacity of the power steering system?
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2004 - No Power To Fuel Pump
So I'm stumped I have an 04 6 liter and I have no power to my fuel pump. My fuse under my Dash is good which is a 20 amp fuse which is number 40. My inertia switch is not tripped and I have power to it however my fuel pump does not have power what else could it be? Is there a relay somewhere else?
View 5 RepliesFord 6.0L Power Stroke Diesel :: Coolant Leak / Drips Off The Power Steering Pump
I am having a heck of a time finding this coolant leak. It drips off the power steering pump. I replaced the upper radiator hose and the heater "y" hose that goes to the bottom of the Degas bottle. I recently replaced the lower radiator hose as well. So the truck runs normal. When the system is under pressure I do not see any leaks. But after the engine is completely cold it starts leaking a small puddle of coolant. Its appears to be coming from the power steering pump. But I am sure its something above or near it. This is on my 2005 Excursion with a 6.0. Can the water pump be going bad and leaking this direction. I would expect a water pump to leak straight down the middle of the engine. What to look for? The thermostat seal stays dry. but it has to be in that area. What is really messing with me is. When it is hot and pressured up It does not seem to leak. Only after it has been sitting for hours and cools off..........What the heck!
View 14 RepliesFord 6.0L Power Stroke Diesel :: Vacuum Leak Under Dash?
I found out by accident that my vacuum pump is now running all the time. It's not the gray line to the heater valve and it's not the vacuum canister as I already checked the easy stuff. I need some direction where to start looking under the dash as I have never been under that part of my truck. Any common issues or where to look?
More information: The pump only runs all the time when the HVAC control is set to OFF or MAX AC.
Ford 6.0L Power Stroke Diesel :: Power Steering Pump Making A Loud Whining Sound
My power steering pump was making a loud whining sound. No problem, changed the pump. Now after the truck is started I will have no power steering or brake assist, give the truck a little gas and you can hear the power steering pump "start". I have tried every way to get the air out, or is that not the problem. I even lifted the front of the truck off the ground with a forklift and with the truck off turned the wheel about six times stop to stop. Fluid level looks good and has since adding after the change.
View 4 RepliesFord 6.0L Power Stroke Diesel :: No Power To Fuel Pump
2004 F-250 4x4 6.0 diesel 120,000 miles, only modification is egr delete, i had a loss of power, pulled over truck died, replaced both fuel filters, found pump was not running, checked and had power to pump plug, replaced fuel pump, now no power to fuel pump, have power to fuse (40 i think) have power to inertia switch both sides, but no power to plug at pump. ran jumper wire to battery to get truck home. I need to know if there is any other component between inertia switch and pump, and or test points, as i think i must have a broken wire.
View 14 RepliesFord 6.7L Power Stroke Diesel :: Vacuum Valve Over The Alternator Buzz
What this part it is? It sits over the alternator on the driver side and looks like a couple vacuum hoses plug into it. Mine is making a very loud buzzing noise.
View 8 RepliesFord 6.0L Power Stroke Diesel :: Vacuum To Auto Hubs Leaking?
When I park over night while in 4x4, the next morning my hubs are disengaged and I have to manually lock them. There is an apparent slow/slight leak in the vacuum system. What would be the usual suspect, so I can start at that point?
View 3 RepliesFord 6.7L Power Stroke Diesel :: 2011 F250 - Vacuum Brake Booster Failures
Brake booster failures on 2011 and newer F-250's? I purchased a 2011 last august and the mechanic at the dealer I purchased the truck from stated that he had replaced the vacuum pump, vacuum brake booster and brake master cylinder on the truck just before I bought it as they were bad. Since then I have had two factory Ford vacuum Boosters fail on me. That makes at least three new factory Ford booster assemblies in this truck within the last year. What could be causing the problem? The truck is out of warranty and I am at a loss as to what could be causing them problem. Too much vacuum? Luckily the last two boosters have failed while sitting in a drive through and at a stop light, otherwise I may have had trouble stopping.
View 3 RepliesFord 6.7L Power Stroke Diesel :: Whining Sound / Low Fuel Pressure And Reduced Power Warning - Fuel Pump Just Died
So, I just had the fuel pump replaced on my '15 6.7 a month ago and it just died again. (next day edit: it didn't actually die, it showed all the same symptoms)
Same symptoms: whining sound, low fuel pressure warning, reduced power warning.
This time I'm 50 miles from home so I pulled off the road before it shut off. Interesting, I was in a hilly area and my low fuel warning came on too. We are waiting for a tow. I was considering trying to push on but don't want to get stuck in a dangerous spot on the highway. We're in a church parking lot.
So, last time this happened I was on flat road with about a half tank of fuel on a lunch break. I ran a mile after the warnings came on to feel out the issue and to see what would happen. I happened to be only about a mile away from my dealer so I drove that way. I got reduced power warning and then it cut power on me (limp mode). I made it to about 100 yards away before it cut off.
This time, I was in a hilly area at night on a windy two lane road with no shoulders in the woods. I was miles from civilization and was showing below a quarter tank of fuel. ~100 miles to EMPTY. I got the low fuel pressure warning first and then the reduced power mode before the whining noise started. I was climbing a hill on a curve at the time. I drove a quarter mile and then pulled off the road into a parking lot so I wouldn't be stuck on the shoulder. It didn't actually go into limp mode.
I let it sit a few minutes, talked it over with the wife and decided to call for a tow. After talking to the tow truck driver who said he would be an hour because he had to go find a bigger truck, I decided to see what I could do while I wait. I fired it back up and the fuel level dropped to below 1/8 and I was now showing 33 miles to EMPTY. I was parked on a hill with the back end up. I had backed the truck into a space to make it easier for the tow truck driver. I let it run a minute, checked for leaks and it seemed to run fine with no studdering or additional warning lights.
CEL was on but no new warnings. I put in my code reader and pulled the P0087. Just one code. I revved it a bit to see if there were any issues. It seemed fine so I decided to try my luck. I started driving towards home with the intention to stop at the first diesel station to fill up. Truck ran fine. After two minutes of driving gently, heart racing, my fuel level came back up and it now read 88 miles to EMPTY. I drove 11 miles to the nearest station and filled up. No issues. I shut it down. I fired it back up. Still no issues so with a full tank, I drove home the remaining 30 miles without issue.
Planning to take it in to the dealer Monday to get it checked. Could this be from an air pocked due to low fuel level and hilly terrain? Is my new pump dying already? Is there something else going on inside the tank or elsewhere?
Ford 6.0L Power Stroke Diesel :: How To Remove Water Pump
I'm replacing my water pump and was wondering how to remove this.
View 3 RepliesFord 6.7L Power Stroke Diesel :: Low Pressure Fuel Pump
So I just replaced the low pressure fuel pump on my 14 6.7 and it seems to be running as good as it was before. I need to get an aftermarket fuel filter setup for my truck. So what are you using, why did you pick that particular system and is it working, does it really work for taking out water and other contaminates? These fuel systems don't seem to be up to par in filtering modern day fuel, I need peace of mind.
View 14 Replies