Ford 6.7L Power Stroke Diesel :: 2015 F350 - Mounting Location For Air Compressor
I have just installed air bags on my 2015 F350 DRW and looking for a location for the air compressor and control unit for the wireless manifold.
View 14 RepliesFord 6.7L Power Stroke Diesel :: Lost Power For Running Board Lights
I added LED lights to illuminate the running boards on my Lariat. Did this about 15 months ago and all was fine until this week and I noticed they weren't coming on any longer. Both sides are out of commission. The running board lights on each side are wired to the respective plug for the running board lights on each side. The interior lights that are on the same circuit work fine (fuse #12 in the passenger side fuse box).
So I'm scratching my head trying to figure out why both sides have gone out at the same time but the fuse is ok. It's winter here and my truck doesn't completely in the garage so I'm hoping to limit my time lying under the truck out in the cold, on a wet floor! I thought there might be another fuse in the engine compartment fuse box but there isn't, at least according to the manual.
Ford 6.7L Power Stroke Diesel :: Mounting And Placement Of 50 Inch Straight Light Bar?
I just purchased a 50 inch straight light bar it is 5D so just mainly projection focused spot beam, mounting one towards the back end of the roof? what to be used to mount it and how ? Also driving in the snow should not be an issue because it is a projection Focus being but if you have mounted one and driven in the snow.
View 1 RepliesFord 6.7L Power Stroke Diesel :: Running Board Fit From 2008 To 2015 Model Vehicle?
if 08 factory running boards will fit on my 15? After ten weeks of waiting she finally in town but the dealer told me I never mentioned running boards so it's either swap my old ones or pay 600 for some after markets similar to the factory running boards.
View 6 RepliesFord 6.0L Power Stroke Diesel :: Idling In Gear And Driving / Vibration Through Go Pedal And Floor Board
Trying to track down a vibration issue. Not steering. But, idling in gear and driving. I feel the vibration through the go pedal and floor board and seat on driver side.
Checked obvious points. Down pipe, complete exhaust system. Motor mounts, tranny mounts and steering.
Got to be some other spot I'm missing. Checked driveshafts. Everything seems OK.
Ford 6.7L Power Stroke Diesel :: Plastic Pull Handle Hanging On Bottom Of Diesel Fuel Tank
What it is or why there is a three inch pull handle hanging down on the bottom of the Diesel Tank on my niece new 2012 F350??? It is sitting hanging there begging to be snagged and ripped off the bottom of the tank!!!!! I'm at least going to Gorilla Tape it up to the bottom of the Tank.
View 10 RepliesFord 6.7L Power Stroke Diesel :: How To Drop DEF Tank
Looking for instructions, How to drop the DEF tank? I've loosened a few bolts, but still can't get my hand in to thread in the nut. I've already lost one nut, gotta pick up a replacement at the store tomorrow.
View 4 RepliesFord 6.0L Power Stroke Diesel :: A/C Compressor Clutch Won't Releasing
The clutch in my ac compressor is not releasing causing it stay on all the time and not cycle and get hot and freeze up the system. Also pulley seems to be angled like it's not sitting straight. Can I just replace the clutch on the front? if so what's all involved. I need to do the entire compressor?
View 12 RepliesFord 6.0L Power Stroke Diesel :: 2005 - A/C Compressor Removal?
2005 F350 6 liter.
AC compressor clutch was toast. Thought it was just the clutch. Started to notice the truck struggling to start, with some smoke on acceleration that was not present before.
Today, paid a guy to replace my AC compressor clutch. He called me out a bit ago to show me what he found.
Looks like it was not the actual clutch. Looks like the bearing on the pulley took a crap. Bearings got wedged between the face of the pulley and the clutch. Mangled up the compressor clutch coil as well. The actual pulley, snapped off the bearing part. Pulley was only held on by the center bolt on the clutch hub. So, long story short, the compressor is locked up. Have to replace it.
This guy tells me he cannot do it, because to remove the compressor ,the motor has to be unbolted from the motor mounts and raised. Is this true? I have a service manual, that does not say anything about that at all. It does indicate that the compressor has to be removed with the third bolt loosened but still in place.
Can I get some info on the removal of the AC compressor in this truck? The idler/tensioner pulley has already been removed. The fan shroud has been removed.
Ford 6.0L Power Stroke Diesel :: Compressor Spin Even If AC Or Heat Isn't On?
Ok so I have another issue. This is one of three right now. Had the truck flat bedded home due to a seized rear caliper. Carrier bearing is causing vibration, will replace that this weekend. My question is does the ac compressor spin even if the ac or heat isn't on? Mine wasn't spinning today when the truck was idling. Should it always spin and just not be "engaged " my ect was quite high too but I thought that was due to the locked up brake.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Compressor Continually Clicks Off And On
Compressor continually clicks off and on..... No cold air.... Checked freon seems to be full.... Big line never gets cold?
View 10 RepliesFord 6.0L Power Stroke Diesel :: A/C Compressor Died On Truck
So the A/C compressor died on my truck. I am looking at replacing it myself and it looks rather tight in there. My labor manual says I have to pull the fan/fan clutch, fan shroud and right inner fender to gain access.
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Tank Won't Getting Fuel?
2011 F4 56.7 L diesel will not allow fuel in the tank.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2005 F350 - Compressor Damaged?
I recently picked up a 2005 F350 6.0. I got it cheap with a plugged oil cooler, and went in planning to do studs, gaskets, and all the Ford updates just to have it out of the way. When taking it apart, I quickly noticed that the compressor was damaged. Looks to me like some foreign object(s) entered the turbo, would bounce off the wheel, impact the cover, and repeat.
Engine seemed to run great. Turbo spooled quickly and while I wasn't paying close attention, I'd glance when accelerating and it'd be in the neighborhood of 27 PSI. Engine cranks evenly and starts well, so there's no obvious engine damage. I'll inspect the bores closely with the heads off.
So my main question: Assuming no damage elsewhere, Do I need just a wheel? There is some pitting and high spots on the cover, but could it be carefully worked down with the cover removed? Do I just need to get a wheel and a cover? Or just a whole new turbo? Looking for a budget-friendly option to remedy this properly.
Ford 6.0L Power Stroke Diesel :: Oil Leak Under Turbo Compressor Housing
I have a small oil leak that is showing up under my turbo compressor housing. It's starting to show a little in the valley. Not a big leak, just not sure were the source is and would like you opinions and recommendations. I have been cleaning it up every few days, drive it then use a mirror and rag to try and locate the source.
Here are some pics, I hope I took some that are good enough. Unfortunately I cleaned up the oil before the pics, but I circled and marked the location.
Concerned about the turbo, but I don't understand this leak since it's not coming from the center section. The turbo drain pipe is new and it does not seem to be coming from there. The leak is not enough to show a change on the dipstick the last 3-4,000 miles as far as I can tell.
Ford 6.7L Power Stroke Diesel :: Compressor Kept Running For A Few Seconds After Truck Was Off
Strange thing happened yesterday and again today. I have my compressor hooked up to up fitter #3 ,turned it on yesterday to fill the tank back up to 120psi. Before it filled up i shut the truck off to fuel up..but the compressor kept running for a few seconds after the truck was off. and today doing some running around the compressor turned on out of the blue when i was driving..but the switch was off.
The shut off switch (on the compressor itself) turns it on at around 90psi and shuts off at 120, but the thing filled my tank to 180 before i noticed it was on, pulled over to shut the truck off and again it ran for 10-15 seconds after the truck was off. I'm pretty confused. maybe it has something to do with the build up of snow under the truck, we just got 16" two days ago. but still when the up fitter is off shouldn't that cut the power from the accessory hooked up to it?
Ford 6.7L Power Stroke Diesel :: Loud Electrical Pop With Air Compressor Relay
Every time my air compressor would shut off I got a loud annoying pop through the radio. Even if the radio was off I would still get the pop. I knew it couldn't be good for all the electronics in the truck so I tried a mod.
Diodes across the relay signal terminals need to be installed in performance carts to protect the electronics. I put one of these diodes on my truck this week. 100% of the pop is gone.
I used this one : ACC-KIT-CSD-1
Ford 6.0L Power Stroke Diesel :: Compressor Cycling But AC Not Blowing Cold At All
So my Ac is not blowing cold at all. I can hear the compressor cycling. I filled the sys with freon. Still not cold I am pretty sure I have a leak but wouldn't it still blow cold? What do I need to check to fix this? The temps are getting in the upper 90's and 100 s I need Ac bad...
View 14 RepliesFord 6.7L Power Stroke Diesel :: Coolant Level In The Primary Tank Low
2012 6.7 .... Noticed my coolant level in the primary tank was low. Thought it was totally empty but it had about a half inch left in it. Topped it off and also needed about a quarter inch in the secondary. I would say about a half gallon between the two. Truck was at about 36k. Has 37.5 on it now and haven't noticed any loss. Never smelled anything, no signs of any leakage. Oil looks fine. Is this 'normal'? Owners manual says to check and add. Never had this with a gasser or any of my tractors over the past 30 years. This is my first light diesel.
View 14 Replies