Ford 6.0L Power Stroke Diesel :: 2004 - Runs Bad After Diesel 911 Injector Cleaner

I filled up at the same fuel station I've filled up at for 6 months, never had a problem. I just bought a 6 liter and put some injector cleaner in on the last fill up. Ever since then, it's been running really rough and missing when cold, and even when it's warm if I really lay into it, it'll pop and sputter. The fuel in water lights been on since I bought it. I think I have a bad sensor, because it was running fine until I put that cleaner in. Since its been running rough I put in new fuel filters and drained the fuel water separator, which only had fuel in it. I don't really know what it could be, but I'm 99% sure it's an injector issue since it started only after I put fuel treatment in.

View 8 Replies

Ford 6.0L Power Stroke Diesel :: Lack Of Power / Replaced Injector Now Won't Start

I was driving and my truck started have lack of power, could barely get going on hills, tons of blue smoke (smelled like diesel) real rough idle. I unplugged injectors and found #5 made no difference. I replaced it today and I can't get it to start. It'll get to 2000+ psi 48v ficm, low pressure oil registers, ficm says its in sync. It will crank and blow a lot of black like its half firing or something. It has even crank to, until it tries to fire. From what I've been reading could it be the ficm? That one circuit is fried?

View 14 Replies

Ford 6.0L Power Stroke Diesel :: Brief Loss Of Power When Accelerate While Driving - Bad Injector?

Occasionally when I'm driving, I'll accelerate and get a brief loss of power, then it'll pick back up, followed by a puff of white/blue smoke. This usually happens when the oil is over 120*, but not quite to full operating temps. It doesn't happen every time either. Only 3 times in the past week. Otherwise, there is a very faint haze of white smoke that seems to be constant. It is very difficult to see unless against a dark background. Oil level is good, I check it once a week, no rising or lowering levels.

I pulled the EGR yesterday, all good, although a tad dirty. Cleaned up no problem. Haven't had a chance to do a bubble test yet. There are some DTCs, but I can't remember off the top of my head what they were. I'm about to go clean the inside of the truck, so I will pull those and update in a few minutes.

Truck has about 148,500 miles.

Torque Pro lists these codes: C1145, P0299, P0677

View 7 Replies

Ford 6.0L Power Stroke Diesel :: Difference Between Injector Harness?

Is there a difference between the two harness #'s here besides the first number:

3C3z9d930aa

4C3z9d930aa

Are they the same part? Is one for a different model truck than the other?

View 7 Replies

Ford 6.0L Power Stroke Diesel :: Fuel Injector Replacement

My 2005 F-250 does not have power when the engine is cold. When the engine warms up then it seems fine. I believe that the fuel injectors need replacement. I was told that one cannot get new injectors. They are all re-manufactured. Is this correct?

View 14 Replies

Ford 6.0L Power Stroke Diesel :: Fuel Injector 8 Replacement

I may have to replace fuel injector #8 on my 2004 6.0. Aside from doing brakes and rotors, I don't have any experience working on my truck.

Side note- this is the second injector to go bad in the past few months. Ford also wanted to replace the HFCM, so I'll be doing that as well.

View 7 Replies

Ford 6.0L Power Stroke Diesel :: Injector ORings Size?

What the size of the internal oring is? So far I have had no luck finding the size. I'm looking for the lower housing to body oring.

View 14 Replies

Ford 6.0L Power Stroke Diesel :: Injector Keeps Frying Starter?

My 6.0 keeps trying starts on a regular bases. I was told it was a week injector by mechanic so we replaced that one and bought a new starter. Within 2 days it had fried that one also. We did check batteries and they tested good even put them in another dismal and drive them for a week. Mechanic told us we need to put another injector in it. But I don't see how a injector can fry the starter.

View 12 Replies

Ford 6.0L Power Stroke Diesel :: 2004 - Jerks Around 50 To 60 Mph - Injector?

I have a 2004 F250 early build over 260K miles on it. After taking a trip out west Texas and back I noticed my truck starts to jerk a lot around the 50 to 60 mph range under moderate throttle. Getting a contribution code on #6. FICM voltage stays over 47v during KOEO and startup. Took an inferred thermometer and even after truck is at operating temp #6 is reading about 3 degrees cooler then the others.

When cranking the engine everything sounds smooth but startups are getting harder. Usually let it idle for a few minutes before taking off on cold start but I am having to let it warm up longer before I can get any power. Did a bubble test and passed and oil level hasnt changed. Fuel mileage has been sucking bad also. Safe to assume the injector is shot and needs replaced? Use Delo 5W-40 Syn every change with motorcraft filters.

View 4 Replies

Ford 6.0L Power Stroke Diesel :: 2004 F350 - Missing Like Lost Injector And Losing Power

I have a 04 F30 4x4 with a sick 6.0 power stroke. It has 230k on the mileage and ran good. I was driving at speed when she started missing like it had lost an injector and loosing power. The RPM's dropped under 1000 so I had to pull over off the highway. When i pulled over and put it in park it shutoff. Tried several times to get to start but after 10 minutes it started up. I drove about 2 miles and it started the same process. This went on 2 more times before I was able to finally limp home the 40 miles.

It never shut off again but ran very poorly. I put a new valve in and when I tried to start it just mad a pound clunking/clacking noise. The repair shop put a starter in it because it had stopped engaging and was going to ruin the fly wheel. I looked at it and it was eaten up pretty bad from trying to get the engine to turn over. So now all it will do is a single clunk and will not turn over. He says it could be a bad injector that flooded a cylinder or blown up in the bottom end. He did take serpentine off and still no go.

View 3 Replies

Ford 6.0L Power Stroke Diesel :: Glow Plug Light Came On - Lost Power - No Injector Cycle

Ok yesterday while driving my truck the glow plug light came on couple times and lost power but the light would turn off and power came back. It has done this before and it was the injector harness grounding out on the engine. I replaced that last time. I checked over the knew one and did not see any chaffing on the harness.

Now this morning I go outside to start it and I can hear my fuel pump and vacuum pump but injectors wouldn't cycle. It has also done this before but I could never figure out why. Last time I tore into it checking through my wiring harness and couldn't find anything. When I put it back together it started fine.

View 10 Replies

Ford 6.7L Power Stroke Diesel :: Engine Seems Louder / More Injector Noise

I bought my truck just after xmas with 46,000 kms on it. Quite new. AS I've put on almost 18,000 kms on since I bought it I recently noticed my motor is quite a bit loader than it used to be. There is more of a diesel sound to it. More injector noise one would think. Its one of the things that I've always like about the 6.7's. they are super quiet. What would cause my engine to get louder ??????

View 14 Replies

Ford 6.0L Power Stroke Diesel :: 2005 - Injector Intermittent Code

Been working on a 2005 6.0 with 218kish miles on it. When I got the truck it had a contribution 2 code stored, no check engine light, just could see the code on the code reader.

Truck idled like crap, lacked power, so I replaced the injector. Truck improved but still had a miss, this time it had a stored code of injector 6.

Ordered another injector, got it installed today. Fired the truck up, ran perfectly, drove it around, absolutely 0 issues ran like a dream. Parked it for a few minutes before starting it again to wash it. Rough idle, not horrible, not noticeable. Cylinder 6 contribution code stored again, no check engine light.

So I drove it, I drove the hell out of it for about 15 minutes with the AC at full blast, WOT, etc etc. By the time I was done, truck was back to running smoothly.

Just walked outside after dinner to see if it would still perform well, or if it would idle poorly again, sure enough, 6 contribution, rough idle.

I just changed fuel filters with OEM, air filter is new. I just cleaned the EGR valve- although maybe it's not clean enough?? Oil change is tomorrow (had to wait for the filter to get shipped in).

I'm at a little bit of a loss on how to cure this miss, unless it's possibly an oil pressure issue from bad/old oil causing it?

View 12 Replies

Ford 6.0L Power Stroke Diesel :: Cleaning Injector Bore Cups?

Have the Alliant 6.0 specific bore brush kit on the way, however was curious how others use the brushes? My concern in whilst cleaning the bores, debris might somehow work it's way up into the fuel passages with the up and down action, risking said debris lodging in those tiny screens of any adjacent injectors which is the last line of defense against debris. Am I missing something? Correct me if I am wrong but with the injectors out those passages are just open to the world, correct?

View 10 Replies

Ford 6.0L Power Stroke Diesel :: Injector Stiction Not Working Properly?

Cold start the injectors definitely are not "clicking" the way they should be. Bought a scan gauge II and checked the FICM voltage and it never drops below 48V. EOT/ECT never really get past 8/9* ....

Issue is when I first start driving you can feel a definite miss, but as soon as the truck warms up it runs excellent, no issues starting hot. I did put 15w40 in it but upon some research I drained it and put in 5w40 syn and it definitely solved some of the issue but it's still there.

One other note the battery's are a little weak in the truck so tomorrow I will have new ones-putting this in as a side note in case it may cause an issue

View 10 Replies

Ford 6.0L Power Stroke Diesel :: Installed SCT Tuner 3 Injector Not Working?

I installed a sct tuner on my truck and used the default street flash and my #3 injector promptly took a dump. Will a tuner kill injectors?

I just finished up oil cooler rebuild studs, blue spring and egr delete.

Now it looks like i have more injectors going bad.

I have 147,000 miles on the truck.

View 14 Replies

Ford 6.0L Power Stroke Diesel :: 2004 - Crank But No Start - Injector

I have working on this one for a while ( sick wife keeping out of garage for some time) Truck fires up in the morning when cold then refuses to start when warm. Of course HPOP leak. HPOP was replaced 5k miles ago. Now today when I drove with AE connected truck all of sudden started to run rough on the highway. I pulled DTC P0279 low circuit for injector 7. My question is can the leak be at injector 7 on the oil rail? Maybe cracked injector? Waiting for the motor to cool so I can do pop off valve cover . BTW early 04 .

View 13 Replies

Ford 6.0L Power Stroke Diesel :: 2005 Injector Harness Fit On 2004?

Will a 05 injector harness work on a early 04?

View 1 Replies

Ford 6.0L Power Stroke Diesel :: Rough Idle - Code P0270 - Bad Injector?

my excursion just started hard and had rough idle one morning then code P0270 - injector, FICM or wires between are the logical choices I think.

started with wires - all connections good at FICM and injectors (applied dielectric silicone) - checked all 4 wires from injector connector pins for resistance with omh meter from X-1 connector. no change

so next is FICM. couple years back sent to ed for repair. if I remember right it was power supply side only so the "brain" side might have gone? good news is could I get a loaner FICM off fellow 6.0 and installed (can't confirm condition of loaner - trucks been parked a while) same code same cylinder - no change.

I read somewhere possibly swapping two injectors (say 2 and 4?) and see if the code follows the injector or stays with the cylinder, further test for a bad FICM

Is that necessary? I would hate buy and replace the #4 injector just to put it back together to find no change then forking over 6 7 hundred more on a new FICM.

View 14 Replies