Ford 6.0L Power Stroke Diesel :: Coolant Leaks And Head Gasket Failure
Early 04 but 06 motor, Coolant filter, BPD EGR cooler, Head studs. I did use the search tool, overloaded with EGR cooler leaks and head gasket failure in the results.
Noticed ECT Spiking 217 (EOT 187)as went to post office,10 min run time from a cold start. Checked Degas a bit low, did my business and went home. Got home ECT 223 EOT(221) zero coolant in Degas and notice this mess. as well as puddling up under radiator.
I left the truck running and added some water to the degas hoping I could spot the leak, no love.
On our trucks do we have a weep hole for the water pump? I didn't notice any water or stains around it or the pulley. Nothing around the hoses either... yet.
Once it cools I am going to pull the fan shroud and look for a possible hole in radiator. Are there any other suspect areas?
Ford 6.0L Power Stroke Diesel :: Loosing Coolant - Head Gasket Leaking?
I LOVE my Super Duty and with only 15k on it (have a company truck) plan on keeping it for a long time. I've had an EGR Delete and new Oil Cooler along with some misc things done to the engine and turbo, about 6g's worth. Now my mechanic at NCB is telling me that the reason I'm loosing coolant is that my head gaskets are leaking. I'm looking at another 5-7 grand which is a no go for me. I'm thinking of doing the work myself, especially since I've seen where i don't have to remove the body to do it.
Okay, here is the question, I've been having a hard time finding a comprehensive list of the parts I should be getting to do the job. Looking for a list or link on what I need to do it correctly and anything I might want to do while my engine is apart so I don't have to do this again?
Ford 6.0L Power Stroke Diesel :: 2005 - Sooty Coolant - Oil Cooler Or Head Gaskets?
Just bought a 2005 F250 PSD, got a smoking deal on it. It has 321k miles and has been very well taken care of however I do believe that it either needs a new oil cooler or has bad head gaskets. Pictured below you will see what the coolant looked like when I let the first batch lose. It does not seem foamy, which is interesting to me, however there is NO EGR to cause this soot.
About the truck:
- It was bulletproofed at 50k miles (EGR delete, ARP head studs, etc).
- There is no puking of coolant (drove it 100 miles from where I purchased it and nothing)
- When the truck is started you have to let it warm up for about 10 minutes,otherwise it seems to not have full power. (was going to reflash the ECU in hopes this repaired that problem).
Ford 6.0L Power Stroke Diesel :: Did Head Gaskets Now Lights Won't Working?
I just pulled the cab and did headgaskets, studs. I put everything back together and when I turn the key, nothing, no lights, zero.
I've checked all connections and batteries are good, checked all fuses, where to start with this?
Ford 6.0L Power Stroke Diesel :: Light Coolant Smell During Hard Acceleration?
My delta runs about 10 to 11 but it has gone up to 17-19 towing nothing for 2-3 seconds. No fogging of the windshield, and carpet is not wet. Puking is on the top of the degas and the bottom, and I have change the cap three times now. My coolant level is below the min level if the truck is warmed up the coolant line sets about 2 inches from the bottom of the degas bottle. The pictures are so big I could not figure out how to make them smaller.
View 8 RepliesFord 6.0L Power Stroke Diesel :: Engine Coolant Blowing Out Of Coolant Reservoir
I have coolant blowing out of my coolant reservoir when ever i hold it to the floor it does it with or without the banks programmer... 6.0L power stroke...
View 14 RepliesFord 6.0L Power Stroke Diesel :: Engine Does Not Crank - No Coolant In Reservoir
I did not run the truck for 5 months and the engine will not crank. I charged the batteries but when I turn the key nothing happen, I hear the glow plug system going but nothing else, starter does not click at all.
One thing that scares me is that there is no coolant left in the reservoir and I am scared that it went in the engine. I did have to add coolant last summer.
How can I first test the starter? Can I turn the engine by hand? If I push the truck, does the engine turn and can I tow it without damaging the engine if it is hydrolocked?
Ford 6.0L Power Stroke Diesel :: 2006 - Coolant Leak In Front Of Engine?
I have a 06 f250 that has a coolant leak in the front of the engine. It's was leaking about a month ago replaced the water pump it stopped. Then about 2 weeks later it started back up again. It only happens when the engine is cold. But once it warms up it starts leaking again. I am confused as all get out on this.
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2003 - Engine Heated Up Due To Loss Of Coolant
So I have a 2003 6.0 king ranch w/ 164k on it.. EGR delete, high pressure oil pump, coolant filter and SCT tuning. A couple months back I had a coolant flush done. After about a week the coolant tank was empty.. Engine heated up due to loss of coolant.. I flushed system again and put ford gold coolant back into the tank. (5 gallons). A couple days later and coolant was very low and engine heated up?? There are no signs of leaks anywhere...Added water and it cooled back down. I'm lost. EGR is deleted but no studs done.....
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Engine Coolant Temp Gauge Does Not Work
Bought this truck, and the engine coolant temp gauge does not work, so I replaced the sender, still don't work.
View 8 RepliesFord 6.7L Power Stroke Diesel :: Coolant Leak Somewhere On Top Of Engine Running Down To Oil Pan And Bell Housing
I have a coolant leak somewhere on the top of the engine running down to the oil pan and bell housing. I have done some research and discovered it could be the coolant inlet tube to the turbo.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2004 F250 - Coolant Leaking On Rear Right Of Engine
I spotted a leak last nite on my 6.0. It is coolant, running down the right rear on 2 metal lines that go to the trans I think. It was dark and 24 degrees so I did not spend too much time looking. Shut the mother down til I could research. 2004 250, 6.0 FX4x4, stock. Coolant was changed to green by previous owner. Bought it 4 months ago. 187,000 miles.....
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Engine Gets Warm / Hard To Restart
I have s 2007 f250 superduty with a 6.0. Recently after the engine gets warm I have a problem restarting it. I have to turn the key to the run position until all sounds have stopped then I have to pump the accelerator to get it to start. Sometimes I have to repeat this three or four times before it starts. I have had the fuel pump rebuild and installed two new batteries. What I should be looking at.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Turbo Would Not Spool Until Revved The Engine Hard
It started after a blue spring upgrade. my turbo would not spool until we revved the engine hard then it kicked in and it's kinda worked since then.. it feels like the truck is struggling on acceleration and the boost builds fast up to 30lbs, the EBP seems to be stuck at 21.48psi until your in 3rd then it jumps and I have power again, also the turbo dumps (farts) if I let off even a little until the EBP jumps then no issues. I replaced the sensor and it's stuck at 21.48 all the time.
Now, I unplug it and it jumps between 26 and 28psi, plug in the old sensor while it's out laying on the motor (not installed) and right back to 21.48. I don't know where to go with this and it's my only truck so I need it running. also it was blowing the intercooler boot off at the turbo during a normal acceleration and the turbo spool has a howl to it when EBP is stuck...
Ford 6.0L Power Stroke Diesel :: 2004 - Coolant Reservoir Empty / Leak Coming From Rear Of Engine?
While servicing the bosses 121k 6.0, I noticed the coolant resevoir empty. It took 1 1/2 gallons to bring to proper level. Returning under truck to install drain plug, I noticed coolant coming from rear of the engine(right side). And of course Ford has changed the cooling system cap, so I wasn't able to pressure test it to pinpoint the leak. Started the engine and seen coolant coming from the left rear as well. I've been reading here to see what others have been seeing, (EGR cooler, head gaskets). With all the heat shields,not much room to look.
After work I did go and buy the adapter to test the cooling system. With any luck I will be able to see leak better.
Ford 6.0L Power Stroke Diesel :: Small Coolant Leak Coming From The Passenger Side Near The Back Of Engine
I have a small coolant leak coming from the passenger side near the back of the engine that forms a spot about the size of a dinner plate if it sits for a few days.
One thing I noticed is if I turn off the AC selector switch when I park I will get the drip but if I leave the switch on MAX AC when I shut the truck off I do not get any leaking.
It is definitely coolant and not just the condensation from use of the AC. If I haven't used the truck for a few days or if I have run it with the AC off I will get the drips.
If I run with the AC on and leave the switch in the on position when I shut the truck off it won't leak. I have tried to locate it from looking above and below but can't determine where it is coming from.
Ford 6.0L Power Stroke Diesel :: Lost Some Power / Leaking Head Gasket
My 2004 6.0 has lost some power and the head gasket is leaking into the coolant. How long can i continue to drive the truck before too much damage is done to the engine?
View 10 RepliesFord 6.0L Power Stroke Diesel :: Front Of Truck Covered In Coolant - No Coolant Pressure - Fix?
Well got home and the front of the truck was covered in coolant. I must have driven 2 hrs after I noticed no coolant pressure, but temperature was great so figured it was another crappy cap. Looking to get a quick turnaround. Need to go out of town for work Saturday so I have this week to get it done.
Just put a stock unit back in? I don't think I need to do anything else in that area. Belt/pulleys/radiator all done last spring.
Ford 6.0L Power Stroke Diesel :: Coolant Flush With Thermostat And Coolant Filter Install
This weekend my friend and I plan on doing a coolant flush, new Mishimoto thermostat housing with high temp thermostat and install a Mishimoto coolant filter.
Truck currently has some unknown green coolant in it and Im going to replace it with Rotella ELC. I plan on doing a couple hose water flushes then follow with about 5 distilled water flushes. I've been reading about putting some Cascade in on first flush to dissolve any silicate goo that might be in there hanging out. I might give that a try. Im sure I can manage this part from all the stuff I read about doing flushes.
This is the part that looks like a little more work involved than the flush. Doing the thermostat kind of worries me because of the tight area in there to work with the fuel line and the EBP sensor being right there. The current thermostat holds temps around 175-185 under normal driving. I bought the new Mishimoto thermostat housing with the high temp thermostat installed in it when they had their pre sale going on for the housing.
I decided to just go with the whole thing because of all the stuff I read about people having issues with the thermostat not fitting the older housing correctly since Im certain I have the original housing from 2004, like everything else that's still original on my truck. I plan on removing the thermostat before doing the flushes and then installing the new housing and thermostat and coolant filter before I add the ELC.
The coolant filter install looks fairly simple to do so I should be ok with that.