Ford 6.7L Power Stroke Diesel :: 2015 - Upfitter Switches Powered When Truck Is Remote Started?
2015 KR. want to install a high idle kit controlled by an upfitter. If I remote start the truck with the upfitter left on, will that switch be powered while the truck is remote started, activating my high idle?
View 4 RepliesFord 6.0L Power Stroke Diesel :: Can Put 2005 To 2007 Outfitter Switches In 1999 To 2004 F250?
Is it possible, Can you put 2005 to 2007 outfitter switches in a 99 to 2004 F250?
View 2 RepliesFord Super Duty (1999-2016) :: 2015 F250 - Installation Of Upfitter Switches
I just got a 15 f250 with the console and nav system but it didn't come with the upfitter switches.
I picked these up and got a copy of the .pdf for the installation, but I'm finding it hard to follow for where the relay and box should install. I ran the wire up to the upfitter switch location and can even find a nice spot to connect the grounding wire.
I can't for the life of me figure out where the box installs and where the wiring harness taps into the main harness. Need a photo of where your box is installed and where it taps into the main harness?
Ford Super Duty (1999-2016) :: 2010 - Wiring For Power Dash Camera Using The Upfitter Switches?
I have a 2010 F250 and wanted to power a dash camera using the upfitter switches. I purchased a 12volt wire, but am unsure on where to wire it so that it will only power up when the ignition is on..
View 7 RepliesFord 6.7L Power Stroke Diesel :: Addition Of Aux Switches - Wiring Diagram?
My truck didn't come with factory option aux switches. Can it be added, and is wiring present?
View 14 RepliesFord Super Duty (1999-2016) :: Upfitter Switches Relay Install
I want to install a set of upfitter switches but my truck didn't come with them...so I bought the switches and the relay/wire harness as well...I cannot find any good information on where to mount the relay and where an extra plug on that harness goes too. I have found the wires that attach and go through the firewall but I am not sure where the rest of this mess goes...my truck did not come with the wire harness already installed...
View 4 RepliesFord Super Duty (1999-2016) :: 2011 - Upfitter Switches And Fog Lights Installation
How hard is it to install the upfitter switches and the fog lights? Is it all plug and play?
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2003 F250 - A/C Compressor Intermittent Working
I have a 2003 f250 6.0. Recently, I have noticed that my air conditioner will work at first but once the compressor cycles off it does not come back on. I end up having to turn the a/c controls to off and wait about 5 min then turn them back on and it will work for a about 5 min then blow warm air again.
This happens more when towing rather than just driving around. I have changed out the sensor on the canister but it was no dice. The system is charged to the correct level according to my gauge. This occurs more often on hotter days than any.
While the truck has been running and the system is malfunctioning, I have crawled under the truck and noticed the center wheel of the compressor is not turning but can be turned by hand. Do I need a new compressor or am I missing something else that would be simpler?
Ford 6.0L Power Stroke Diesel :: 2004 F250 - Keyless Code Not Working?
Ok just bought a '04 F250 Diesel. Loving everything but can't get the keyless code to work. The keypad lights when I touch it and I have retrieved the 5 digit code from the "Bosch" box behind the radio. No deal. Locks don't react at all to the factoy code. Know what? I read that there is a list of all the possible codes. Where can I get that list?
View 14 RepliesFord 6.7L Power Stroke Diesel :: F250 - Windshield Wiper Sprayer Not Working
6.7L ... Just traded in my F250 on a 2011 F350 Lariat. Love it. Period. Except that my windshield wiper sprayers will not work. I don't hear anything when I hit the button. No click or motor running. I can't figure out what fuse it is because I don't have an owners manual.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2006 F250 - Tachometer Not Working Properly
I have an 06 f250 6.0. When I bought it a few weeks ago I turn the key on and let the glow plugs warm up and start the truck it would start easily. Now it seems like it's taking longer to start . The temperature are between 50 and 80 degrees. I changed the fuel filters and it's still taking to long to start.
2nd I noticed today that when my truck is at idle the Tachometer is at 0 and when I'm driving 60-70 MPh it goes up to 900 or maybe 1200. It seems to be running fine no loss of power that I can tell. What could be causing the long crank time and my Tachometer problems.
the glow plugs and injectors are new I don't remember the brand and the fuel filters are brand new Motorcraft.
Ford 6.7L Power Stroke Diesel :: 2011 F250 - Diagnostic Mode Not Working
I've done it before but now when I try to enter into the diagnostic mode I'm not getting anything but the typical message center. I'm holding the down arrow button, inserting the key, and then starting the truck. No diagnostic mode. Am I doing something wrong? 2011 F250.
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Rough Idle And Dies / No Power
My truck died on the way home the other night. After pulling over it started right up but died three more times on the way home. Changed fuel filters, cps sensor which wasn't bad when tested, checked fuel pressure (60 psi), cleaned egr valve, fcim has 48 volts, batteries have 12 volts. Tried unplugging egr valve and icp sensor. Truck will start with icp unplugged . Ipr, stand pipes and dummy plugs were replaced last year when I purchased truck. Truck will run in park fine no issues idled normal, builds rpms and boost. Put it in drive when it gets warm rough idle and dies but starts right back up evertime. When truck doesn't die it has no power.
View 10 RepliesFord 6.0L Power Stroke Diesel :: 2004 F250 - Half Of Instrument Cluster Not Working
So, went to drive the truck (2004 F250 6.0, 145000 mi) yesterday and the right half of my instrument cluster was not working (tach, trans temp and water temp), CEL and check gauges lights on. My scan gauges gives me readouts of all 3, so I know the computer knows the right values. Pulled all three fuses related to the cluster, all looked good. All gauges, including those not working, did full sweeps with key on after putting fuses back, so I know they function. Also, the glow plug light stays on way longer than normal.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2004 F250 - Instrument Cluster Right Side Is Not Working?
My right side of my instrument cluster is not working. the Tachometer, Engine Temp and Trans Temp gauge are non responsive, and the CEL and Check gauge light is on. I have seen other posts with people that had the same problem but no solution to what fixed the problem. 2004 F250 Lariat.
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Overheating When It Is Cold Outside
I just bought a used 2007 f250 with the 6.0 power stroke. The truck has approx. 160,000 miles on it. He is having a issue with the truck overheating when it is cold out. When the air temp is above 30 degrees or so, he doesn't have a issue. So,my he overheating only occurs when driving down the highway in low temperatures. It can idle in the cold fine.
View 8 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Max Oil And Coolant Temps?
I have a 2007 F250 with the 6.0. Towing up a long hill my truck went into limp mode. I didn't have gauges at the time so I didn't know what my temps were. I now have gauges. I know that the coolant and Oil temps should not be more than 10-15* apart, but what is the max temp that oil should EVER get towing up a steep and long hill? Also, what is the max temp that coolant should EVER get towing up a steep and long hill?
View 14 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Hooking Up High Idle With Upfitter Switches
I would like to do the high idle mod with my 2006 F-350 using the upfitter switches. I've seen a couple of threads about this but they are not real clear to me and don't mention the 2006.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Intermittent Crank / No Start
I have a 2007 f250 6.0 powerstroke that had an intermittent crank no start problem so I replaced the sti valve on the hpop. Put it back together no start ran a few tests found the FICM had 22 volts replaced that still no start replaced IPR valve because I got a 0 ohm reading from it still no start. I am just about out of patience with it I am going to add some pics of the scanner I am using. I dont know the difference between ICP DSD and ICP PRESS.
View 9 Replies