Pontiac - Grandam :: 2001 - Random Starting / Fuel Pump Will Not Kick In
I have a 01 GrandAM 3.4. I have a reoccurring problem with this car. The car will randomly not start, and die while driving. Some days I can drive the car with no problems, and some days it will only have starting problems. These problems are very random. When the car doesn't start it will crank and turn over however the fuel pump will not kick in. You can turn the key on and off several times, and it will fire up. This DOES NOT seem to be a problem with the passlock theft system. The security light has never came on, and you do not have to wait any amount of time for the car to start, you only have to flip the key back and forth several times. The car after running will occasionally die, after the car dies it will usually start back up on the first try. I am very puzzled by this problem not sure if it is the ignition switch, fuel pump, or something in between.
View 19 RepliesNissan - Quest :: 2001 - Won't Start After Replacing Fuel Pump And Filter
Replaced fuel pump and filter on our 2001 Nissan Quest. It started up for a few minutes but once it got hot it sputtered out. We sprayed some starter fluid in it. Still nothing.
View 13 RepliesElantra XD (2001-06) :: Replaced Fuel Filter Now Engine Won't Run
Replaced fuel filter. Got all 4 washers plus cap from old filter. Engine won't start. Saw there is a fifth rubber washer that nobody mentions anywhere and transferred that to the new pump. still won't run.
When I turn the key to On, I can hear the pump turn on for 2 secs and stop. if I do this 5-6 times and then try to start, engine will start and then die immediately. seems the pump is not pumping when the engine tries to run. it pumps only for two secs when the key goes from Off to On position.
There are two lines going to the pump. which one feeds the engine. if I disconnect that line, should I see fuel coming out when I turn the key and try to start the engine?? or is there a better place to disconnect closer to the engine??
Ford Super Duty (1999-2016) :: 2002 - Gas Engine Won't Start After Replacing Fuel Filter / Pump Relay / Air Filter?
After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 RepliesCorolla :: 1991 Toyota Is Sputtering After Replacing Fuel Filter
After replacing the fuel filter, O2 sensor, and checking plugs and wires and the rotor, my 91 toyota corolla is still sputtering and its driving me nuts.
View 1 RepliesCavalier - Chevrolet :: 1998 Sputtering / Fuel Filter Changed
My sister has a 98 chevy cavalier and it is sputtering i changed the fuel filter but that did not work.
View 6 RepliesFord F-150 - 1997-2003 :: 2001 - Sputtering At Random Times
It started sputtering at random times a few days ago and the check engine light came on. The two codes are p0401 (blocked egr system) and p0402 (egr valve stuck open). It seems to do it most when it's cold but some days it'll do it non stop.
View 1 RepliesFord - Explorer :: 1993 - Started Slowing Down And Sputtering - Fuel Pump Dead?
93 explorer 215000 miles on it runs like a champ 99.9% of the time. I am on my way home today on the highway going 75mph when all of sudden it started slowing down and sputtering. I quickly pulled over and as I did the car shut off. When I was pumping the pedal nothing would happen. I initially thought fuel pump is dead as I dont know if its been replaced. 45 minutes later on the side of the highway after multiple times trying to start, it does and I cruise the next 20 miles home no problems at all????
Got home started it a few times, NO PROBLEMS!
Elantra XD (2001-06) :: 2003 - Sputtering After O2 Sensor Swap
My 03 Elantra GLS was throwing an error code that my reader said was the upstream O2 sensor (before the CC in the manifold) and the #3 plug. I swapped it out at the same time that I changed out the spark plug and spark plug wires and the thermostat housing.
The thermostat housing installation all looks good. There are no leaks/drips anywhere near it and all seems good.
The problem is that, after clearing the codes and taking the car for a test run, all seems good until I get it to the point where it is about to shift into 3rd or I've reached about 20-40 MPH. At this point, the engine sounds like it is gasping for air and ready to cut off. If I pull over for a moment, I am able to get going again until I reach those same conditions. I've even had the gas pedal floored and the car won't move during these times and the CEL is now back on saying that the brand new O2 sensor is the problem again (the codes for the #3 plug are no longer showing).
I did remove the battery cable to reset the codes in case my reader wasn't fully clearing them and verified that the fuses related to the ECM/ECU were all good.
Elantra XD (2001-06) :: Rough Idle Under 1000 RPM - Sputtering Backfire
2003 Elantra gt 90,0000 miles manual transmission. Rough idle under 1000 rpm it smooths out completely above 1000 rpm.
Also the engine makes a ticking noise from a cold start up. It stops making the ticking noise after 1500rpm or when the engine warms up.
Occasionally the car has a sputtering backfire. This happens when I park the car after being on the highway.
Replaced the plugs, wires, and the pcv valve. Dropped the oil pan and it and the oil pump pick up screen were clean.
The only check engine light to come on was for the speed sensor. It has since gone out on it's own.
Ford 6.7L Power Stroke Diesel :: Fuel Filter / Pump Started Squealing And Making Vibrating Noise
Well, I last summer my fuel filter/ pump started squealing, and making vibrating noise, replaced the fuel filter changed the noise slightly, some times it would go away, sometimes the line going to the filter under the hood would vibrate, couple weeks ago truck warning light came on- "low fuel pressure warning" came on, hum... went out, came on a couple days later, then finally put me into limp mode, luckly only 1/2 mile from home... checked filter on frame/ tightness, it was tight, the pump on the filter housing was very noisey still, well, I figured 200 dollars cheaper than taking to ford....
I waited and pump arrived 3 days later, replaced it and low pressure warning still on, but pump was very quiet, and when I restarted low pressure warning and reduced power came on in driveway, hum.... I thought code was still in computer, I disconnected battery and turned headlights on to try and kill the code, started it and now the engine light came on, nothing else, and truck ran fine....hum.... went to autozone, and they pulled the code, low fuel rail pressure, p0087, guy said to drive and code should go off, truck runs fine. Drove truck a couple days and engine light went off, Truck runs great.......All is good.
Ford - Explorer :: 1995 - Replaced Fuel Pump / Filter / Pressure Regulator / Crank Position Sensor But Won't Start?
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 8 RepliesElantra XD (2001-06) :: Random Misfire Code That Would Come And Go
We have been fighting a misfire code for about a year now and I'm pretty sure I finally found the cause. Last Spring the car died on the road and we had it towed to a local service center where they said the fuel pump was bad...this was the 2nd in about 2 years (previous owners doc). We had it replaced and the car was fine but as mentioned had a random misfire code that would come and go. In the last month the car has left us stranded several times and then started after a few hours or a day. While checking the connection to the fuel pump with a meter and test light I verified the pump was getting power correctly to the 5-pin connector but would not start. I unplugged the connector and the 1st 2 pins in the harness connector were damaged and probably burnt.
I cleaned it and applied dialectic grease and plugged it back in turned on the key...fuel pump primed and then the car started and ran fine. It then started to randomly turn on and off but not enough to stall the car. I wiggled the connector and the it I could make it run or shut off. Obviously the connector is bad and the contacts are intermittent. While driving the vibrations would move it just enough to make it cut on and off and more than likely cause a misfire code and sometimes stall the car. My problem now is I can't find a replacement connector/pigtail for the harness connector anywhere including the dealer. Where can I get a new connector for the 5-pin fuel pump harness connector? I have found a MAF replacement connector that looks very similar but not 100% sure if it's the same.
Elantra XD (2001-06) :: Random Misfire On Cylinder 2 / 3 And EVAP Codes
Trying to troubleshoot my 2001 Elantra (173k). I'm having intermittent trouble codes being set and I'm wondering if they may be related:
P0302
P0303
P0446
The cylinder 2 and 3 misfires are relatively recent. Plugs and wires are visually ok (and not that old). I swapped plugs 1 and 4 with 2 and 3 to see if the plugs are bad. It took 3-4 days, but the P0303 set again (and it's very intermittent - car will noticeably lose power for a few seconds, code set, then run fine for several days). I also sprayed carb cleaner on the intake manifold gasket with no change in engine idle, so the gasket appears to be intact.
I had read in a forum somewhere that the misfires could be related to a vacuum leak, which could also be setting the P0446 code. I removed the charcoal canister and inspected the lines - visually ok.
I bench-tested the canister control valve and it did operate, though I noticed some charcoal blocking the valve so it would not close all the way when energized. I used compressed air to blow the debris out of the valve and it appears to close properly now.
I went to hmaservice.com and noticed there are no instructions for the P0446 DTC. I've been using a Haynes manual instead. For quite some time now when refueling, the fuel nozzle shuts off every few seconds (I have to slowly put the fuel in to avoid).
Some questions:
- Can these codes be related?
- Based on my symptoms, should I replace the canister control valve? What about the charcoal canister and the charcoal air filter - should those be replaced as well?
- What else should I check?
Elantra XD (2001-06) :: Oil Leaking Into Air Filter Coming Through Or Near Throttle Body
My 2005 elantra hvt 2.0 has oil leaking into the air filter coming through or near the throttle body, I've been told its an egr valve.
If it is...where is it and how much for a new one and is it an easy fix? If not what could be causing the leak?
Ford Excursion :: 2001 - Fuel Filter Housing Leaking
I could smell fuel so I popped the hood to look for a leak. On top of the filter housing cover fuel was puddled in the little nooks and crannies of the black cover and some had leaked over the side into the valley between the heads. Is this a common leak? How in the world did fuel get on top of the cover but not on the hood insulator cover?
Also, just bought this not too long ago and the po said he had just done the fuel filter service on it. The gasket seemed pretty flimsy and weak and didn't really fit the gasket surface. Although I'm used to my cummins powered trucks and they use a o-ring to seal the housing cover. 2001 excursion 7.3
Elantra XD (2001-06) :: 2004 - Code P0501 Caused By Shredded Cabin Air Filter?
My 04 Elantra GT hatch is my lifetime favorite car. Especially like the rear seats that fold flat. It has 104k miles, but I want to keep it going.
Day before yesterday the blower started making loud noises. I took car back to Pepboys who replaced the cabin air filter they put in a month ago. They had installed it incorrectly, and it shredded with a 6 inch hole in the middle, and paper everywhere. When I left, the fan was not making any unusual noises.
Yesterday I drove 20 minutes on freeway, stopped to shop, started driving, and turned on fan. Immediately the check light went on. Back to Pepboys, service manager said check was P0501 and was a transmission speed sensor that couldn't be related to the filter mess.
Last night I found the Hyundai forum and I read in a post that this is a wheel speed sensor that would be located in the right front wheel and well not far from the cabin filter. Is it possible that the debris from the fan/filter collision has affected this speed sensor? Or is this just a very untimely coincidence?
I know nothing about automobiles. What I should do next and thereafter? Is it safe to drive this car as usual until the problem is fixed?
Elantra XD (2001-06) :: Check Engine Light Will Pop On Occasionally And Code Reads Random Misfire
2004 Elantra AT ... 6 months ago top of the radiator cracked caused it to overheat and blow the head gasket and warp the head. Repaired that and compression is fine now. It ran great for 4 months but now it randomly stalls. at or near idle. Seems to do it more at operating temp rather then cold. Occasionally the check engine light will pop on and the code reads (random misfire). It acts just like it has been shut off. But immediately restarts.
View 3 RepliesPrius (2001-03) :: Warning Lights Goes Off - Engine Cabin Filter And Fuel Injection Cleaning?
Went to dealership today for oil change, they said they didn't see any leaks, didn't see anything wrong, etc. The warning lights haven't went back on since yesterday morning. I'll keep watching, I hope they don't activate again.
By the way, for everyone who had a 2003 Prius, how many miles did you get with your main battery? The dealership said they usually go after 100,000 miles and need to replace.
At 130,000 they also recommend an engine cabin filter and fuel injection cleaning. Seems like an automotive store would be cheaper for the cabin filter?