Ford F-150 (2004-2008) :: Manual Shift Hydraulic Clutch Adjustment?
Is there any mechanical adjustment on the manual shift hydraulic clutch? My clutch is not slipping but is just about all the way up on the pedal.
View 3 RepliesFord Transmission :: Manual 5 Speed Trans - Spinning Noise After Push The Clutch In
My cluch is almost 2 years old and gets treated with kid gloves , I shift low in the RPM's And accelerate slow for smooth shifting and fuel savings (17mpg avg.). But as of yesterday I can here the gears wind up after I push the clutch in. No problems with power or gear handling , Just the sound of the gear(s) (low dry rev/wind sound) No visible leaks , Clutch has oil at the step mark. Also - I can Make The Trans create the same sound if I keep the clutch petal in and rev the engine.
View 3 RepliesAccent LC (2000-05) :: 2002 - Manual Trans Has Small Leak At Slave Cylinder For Clutch
So my accent with a manual trans has a small leak at the slave cylinder for the clutch. I am driving home and it's shifting hard. I get home pull up to where I live and push In the clutch and the car feels like the clutch is not pushed in. RPMs drop and car stalled. Look under hood and see not fluid in clutch master cylinder. Fill with fluid and pump pedal. I get some pedal back but the car will not crank. Nothing. I have accidentally cranked car when in gear in the past and there did not seem to be a safety switch as the car would move if my foot was not on brakes.
View 4 RepliesPrius (2010-12) :: Seat Height Adjustment (Manual Lever)
Can't bring the seat down it locks up?
View 3 RepliesElantra XD (2001-06) :: 1st Gear Keep Slipping - Linkage Adjustment / Hydraulic Clutch
I am searching for any kind of adjustment that might enable me to force the clutch level to the positive stop. It stands off about an 1/8" to 3/16" and I think is the reason I am not getting engagement in first gear, it slips heavily but fine in all other gears. The key way on the the lever prevents me from moving it a notch or two if I thought I could and don't know if that's even the answer . I can't figure out what is preventing it from returning fully on its own I can push it by and and a little fluid will squirt from the reservoir. Ive replaced the slave cylinder and bled it.
Is there any adjustment under the dash? This is a 2001 elantra that I just put a 2000 trans 5 speed.
My original plan was to pull the parts from the 2000 and replace in the 2001. I had lost 1st and 5th totally and found a 2000 that went right in with some minor mtr mnt mods. It shifts just fine except for this 1st gear thing. I saw a video and am having second thought about that move. I dont really want to pull the trans out again.
1st gear just keep slipping. new clutch kit installed when I swapped them out. It feels like a linkage thing somewhat but I cant find adjust ment to tryout.
Elantra GD (2013+) :: Auto Trans Clutch Slip?
I have a 13' GT with an automatic trans and 15,000 miles.
While getting onto the highway yesterday I was in D (not + -) and I was probably in 4th gear and hit the gas pedal maybe 60-70% down and my rpms shot straight to 6-7k but I didn't get any acceleration. I let the rpms drop and it drove fine after. Pretty sure I was smelling burnt clutch too (kind of unfamiliar with that scent, I've never slipped a clutch before).
I should probably take it to the dealer for them to look at it, but am worried it will be a 1-2 week thing and I'm not sure if I'd get a loaner.
Elantra MD (2010-15) :: 2012 GLS - Windshield Washer Nozzle Adjustment
2012 Elantra GLS ... The windshield washer spray pattern is too low. The nozzles on the Elantra appear to be entirely plastic unlike the conventional ball which I can poke a needle in to adjust it. I ran the hand under the cowl cover and could not feel any kind of adjustment mechanism. How to adjust the nozzles to aim higher.
View 27 RepliesElantra MD (2010-15) :: Manual Transmission And Stalling
When first drove the new Elantra, I stalled it more than should. At first I figured I was just new to the feel of the clutch, and not in tune with the hints of RPM given by the motor's sound, etc.
A couple of times after stalling, I pulled the shifter to a middle neutral, and then back in 1st, and now it really felt like it was in 1st. Eventually, I developed a quirky habit of shifting out of 1st to neutral and back to 1st every time I stopped. My kids commented on it and they don't even drive.
A couple of times I've cautiously done this test, and it proved my suspicion. Suppose you are coasting at a speed of around 40 mph or 60 kph, and intend to come to a stop ahead. I typically push the clutch in and coast, then brake. Somewhere along the coast to stop, I will also put the gear into 1st. I've discovered that if the gear shift is put into 1st while the coast speed is sufficiently high, the actual gear selected is 3rd. Then, when you start to pull away from the stop, the engine stalls.
If anyone tries to reproduce this shift into 3rd when 1st was intended while still coasting, be careful and let out the clutch slowly at the early part of the release so you will get a hint from the engine RPMs what gear it is heading toward. I don't want to be responsible for wear and tear on your transmission/engine or accidents. I've only attempted this test on a road with no traffic, myself.
Although what I am claiming sounds wacky, I think it is possible, given that transmissions over the years have been moving towards electronic rather than physical linkage.
Elantra MD (2010-15) :: How To Remove Manual Shift Knob
I have a 2011 elantra a 6 speed manual and im trying to take off the shift knob and can't seem to do it....
View 33 RepliesElantra MD (2010-15) :: Manual Transmission - Cruise Inoperative In 6th Gear
I've been working on a cruise control issue on & off for about a year now. Vehicle is a 2011 UD Elantra with a 6 speed manual trans. Problem is cruise won't set in 6th gear. Works perfectly in 2nd through 5th gears.
Cruise power light stays on but won't set. Upshift indicator working correctly. I've had Hyundai field service engineers look at it 3 times with no luck. Vehicle has no fault codes at all. All switch & sensor inputs are correct. The only vehicle I had with a man. trans. to compare to was a 2013 MD. Cruise worked fine in 6th on that vehicle. The last word we got from Hyundai (supposedly from Korea), was that this is normal and cruise on that model is not supported in 6th gear. I find this hard to believe but I wouldn't doubt this is a programming issue. 6th gear should be the most used gear for cruise operation.
Elantra MD (2010-15) :: 2013 - Turn Off Manual Tranny Shift Indicator
Is there a way to shut this feature off. I don't need to be told when I have to shift or down shift. I thought the manual tranny E's had the ECO button which would turn this feature off, but there's no button.
View 5 RepliesLexus IS 2014+ :: Manual Adjustment Of Headlights?
How hard is it to manually adjust the headlights? is it possible?
View 2 RepliesGolf V R32 :: Headlights Seems High - No Manual Adjustment
R32 MKV owner of 6 weeks. My headlights seem high, seem to be blinding other drivers. No manual adjustment, its meant to do automatically depending on vehicle weight etc?? How I sort this?
View 11 RepliesPhaeton :: Driver Side Headrest Stuck After Manual Adjustment
I have a 2011 Phaeton with manually adjustable headrests on the front seats, haven't checked the rears, the drivers headrest stuck in the up position after moving it to clean underneath, pushed the button to lower the headrest with no luck and noticed the button was loose and not seated properly so I pulled it all the way out long piece of plastic with a small plastic pin on the end, put it back in a it bends the pin to the side, so decided to check out the passenger side it has a shorter piece of plastic with the same piece of plastic on the end and you guessed it that won't go back in either.
View 1 RepliesElantra MD (2010-15) :: Manual Transmission Loose - Gears Make Noise As Shift From Coast To Drive
Ok so my transmission feels loose, too much play between the coast and drive side of the gears. Makes enough noise now that my wife complained about it so I'm looking into taking it to the dealer. I pretty much expect them to pass this off and do nothing, but its getting worse especially in the last couple of months.
Noticed a lot of play in there gearbox? Can you hear the gears make noise as they shift from coast to drive side?
Passat - Volkswagen :: Manual Seat Adjustment Started Working Sluggishly
I have a 2001 VW Passat with only 75K miles. The manual seat adjustment started working sluggishly, so I took to my mechanic. I was told that the mounting is very thin sheet metal and cracked. They welded it up and it is somewhat better, but not nearly as good as new. Can't imagine that my problem is unique. Still a safety issue here - should VW have a recall?
View 1 RepliesElantra MD (2010-15) :: Code P0880 - Trans Stuck In 4th Gear
I have a 2011 Elantra 1.8 automatic Gls with 133k miles. While driving approximately 70 miles per hour the car downshifted to fourth gear, and would not shift up or down. I drove the car home and found that this is called "lump mode". I checked the codes, and found P0880 tcm voltage input. I replaced the fluid temperature sensor and harness, and checked continuity through the harness. I found no problems in the harness from the tcm to the solenoid connector. I then purchased a matching tcm, but the problem persisted. If the battery cable is left off for several days the problem will disappear until the car warms up.
View 4 RepliesElantra MD (2010-15) :: 2012 - Tap Clunk Type Noise When Shift The Auto Trans Into Drive And Reverse
For a few months now I have been hearing a tap clunk type noise coming from under the car when I shift the auto trans into drive and reverse. Also sometimes when the car is slowing when driving I hear the tap sound as it shifts into first. I drove in by my local dealer and they listened to it and said Elantra transmissions can get noisy there is nothing wrong. They told me I have plenty of Warranty left so if something happens I will be covered.
View 2 RepliesElantra MD (2010-15) :: Clicking Noise When Disengaged The Clutch And Go
On my 13 Elantra since the day I got it almost 2 year's now has always made this click noise when I disengaged the clutch and go, (not the clutch solenoid noise similar) I'll hear the clutch solenoid then almost like my left front brake was slightly sticking it makes a click like the caliper's popping loose!? I've mentioned it the stealership & nothing they tried to tell me the dust shield was touching however the noise came back within minutes I noticed it! It's just one of those annoying sound's that you need to figure out or go crazy, stick model, could it be the clutch fork or bearing releasing just can't figure it out.
View 4 Replies