Elantra MD (2010-15) :: TPMS Light On Dashboard Is Illuminated / Valve Stem Caps Broken
2012 Elantra GLS. Wife comes home and says the TPMS (tire pressure monitoring system) light on the dash is lit. I check the tire pressure. None abnormally low but I decide to top them off. Notice that two of the valve stem caps are broken. The tips are broken off so I can see the little red gasket. On opposite sides of the car. No damage to the wheel covers. The valve stems don't stick out past the wheel covers so I wonder how the caps could have gotten broken. Could that be why the TPS system is giving me a warning? If by chance there was a pressure issue does the light reset itself or does the dealer have to do it?
View 19 RepliesElantra XD (2001-06) :: 2004 - Rear Brake Sticks / Parking Brake Is Broken
I have a 2004 Elantra GLS. My left rear brake was hanging (wheel was very hot to the touch after driving, while other wheels were not), so I had a friend check the brake pads. We decided to replace the pads and rotors. While doing so, the parking brake seemed stuck in the on position, so I opted to have him disconnect it completely until I could afford to replace it. I had used it for the first time about 2 weeks before I noticed the hot brake problem, so we figured that must have been why the brake was hanging.
My friend replaced the rotors and pads, put some penetrant/lubricant on the piston of the caliper and reassembled the brakes. He did use the special tool to spin the caliper in when putting the pads on, however he didn't know that was necessary and tried to force them in with a C-clamp first.
Now, I seem to have two problems:
1. The left rear brake still hangs sometimes. I will drive the car and when I park it I can feel the heat coming off of the left rear wheel. It is extremely hot, so I know the brake is hanging (even with the parking brake disconnected). What is the problem here? Is the caliper bad? Would replacing the caliper solve the problem? Does the parking brake have to be connected to stop the caliper from hanging up?
2. My second problem is the pulsating of the brakes. I am afraid the rotor is warped because of the heat, or maybe he didn't clean everything well enough before he put the new rotor on. How can I figure out what the problem is? Is there a way to check a rotor to see if it is warped? Could there be another reason I feel the pulsating brakes? By the way, the brake fluid is full.
If the caliper needs to be replaced and I can leave the parking brake disconnected, are there any special instructions my friend should know about before working on this? He does work on a lot of cars and rebuilds cars to sell, so he is pretty knowledgeable. I think the only thing he didn't know about was rotating the piston. I would like to provide him with detailed instructions if necessary.
Elantra MD (2010-15) :: Driver Side Brake Light Does Not Come On When Pedal Pressed?
I have 2013 Elantra ( 20,000 miles) and when I put the brake lights on without the headlights on everything works ok but when the headlights are on the driver's side brake light does not come on when the brake pedal is pressed. I thought it was a bulb problem so I replaced it but I am still having the same issue. What is going on? I know it is still under warranty but I figured I could handle a burnt bulb issue but that was not it. I noticed that the drivers side bulb is not as bright either when brake is pressed without headlights
View 11 RepliesElantra MD (2010-15) :: Broken Radiator Shield Under 2012 GLS
Pulled into a parking space as usual the other night and when backing out, I badly ripped up the "radiator shield" (if its called that) plastic cover underneath my car. I ended up removing it all together after removing a few remaining clips holding it in place and drove home without problem. It looks like it protects the radiator.... What this part is called?
View 10 RepliesMaintenance / Repairs :: Broken Wire In Door Jam?
I've got broken wires in the driver door. Do I have to solder them?
View 11 RepliesCamry :: Broken Wire Harness Spark Plugs
Two of my plugs locking clips broke today on the wire harness side where the coil over plugs into the harness today while changing spark plugs. They will plug back up, but they won't lock together like they are suppose to. How critical is this? It is my wife's car will she break down? I drove the car maybe twelve miles, and everything seemed fine.
View 8 RepliesFord Excursion :: Middle Wire Of Taillight Broken?
My tail light. The middle wire broke I was thinking of soldering it together?
Is this part specific to the Excursions or can I go to the junk yard and get it from other Fords?
Ford F-150 (2004-2008) :: Broken Coil-on-plug Wire Clip?
2007 F-150 Screw 5.4... Successful spark plug change. Well, sort of. I disconnected some of the coil clips/wires from the coils during the operation. Upon installation of the wires/clips, one of the clips did not 'click' into place.
Thinking the clip needed to be pushed/pulled, I bent the clip a bit and it snapped off! Being the slow learner that I am, a second clip also did not 'click' in place, and you know where this is going: I have two broken clips out of 8. After those two, I was much more gentle.
So, can these clips be replaced and/or spliced in? I'm thinking about just using nylon ties to hold them in place. So far, they are staying put just by being pushed in place, but these two do not seem very secure.
In the future, what is the correct way to make sure these things 'snap' back into place if they seem to not want to cooperate?
Here's a picture of the two 'press clips' that broke off....
Ford F-150 (2004-2008) :: P0453 Code After Broken Ground Wire
My 2007 F150 5.4L would not crank at all the other morning. After checking the battery, I discovered that the ground wire to the starter was completely frayed and broken off right at the eyelet connector to the starter. I spliced it back together and the truck fired right up.
However, the check engine light suddenly appeared and I got a P0453 code which apparently indicates a high reading at the fuel pressure sensor. The CEL never appeared until the broken wire happened. I took a quick look at the fuel pressure sensor and wiring and nothing appears to be obviously broken.
One other thing I've noticed for a few weeks is a miss under load while driving. I have not seen any codes at all for the miss. I was leaning toward replacing the coil overs but now I'm wondering if the miss is related to the fuel pressure sensor.
Yaris/Scion & Vitz :: Wire Connection Broken To Camshaft Timing Oil Control Valve
Is it dangerous to the car to drive if the wire connection is broken to the camshaft timing oil control valve? It seems to run fine.
View 2 RepliesHonda - Accord :: 1992 - Broken Conductor In Brake Light System
I have a wiring issue. I have found a broken conductor in my brake light system, which causes my right and high-mount brake lights not to function. If I give the wire a good wiggling and fanangaling, I can get all the brake lights to come on, but eventually they go out again after driving for a few days. The problem I have is this: I don't know how to release the wire from its terminations. Unfortunately, I think the break is close to the connector (away from the bulb socket), so I can't just cut out the middle and splice in a new conductor. How to free the wires from this connector and bulb socket? I'm afraid to do too much tinkering for fear of pulling loose another, undamaged wire. The wire in question is the orange one.
View 5 RepliesGolf V R32 :: Broken Brake Light / Windshield Washer Stream The Shot Straight Up
I've got an '08 R32 I bought in May, before that I had an '07 GTI, so I know the cars pretty well. I have a couple of issues with the R that I never had to deal with on the GTI .
1. On my GTI, the rear windshield washer was a very strong stream the shot straight up. On the R, I've noticed it is weaker, and recently, it barely sprays half of the area, and it also moves with the wiper, from about straight up and over to the left. Any adjustment to tighten it back up, or if it is supposed to move.
2. I just had a brake light burn out Monday. I know I need to get behind the plastic and undo the nuts to remove the brake light assembly, but I have two questions: First, what are the make and model of bulbs used so I can pick some up to change at home.
Prius (2010-12) :: Replacing Broken Interior Light Cover
The plastic cover on the left front interior light came off; it is mostly intact but the small plastic tab in the inside (where the lightbulb is) is broken. It seems to be attached to the whole mechanism.
View 3 RepliesLexus ES 2007-12 :: 2010 - Replacing Broken Directional Light On Side Mirror
The clear cover on the directional signal on the right rear view mirror was smashed in a parking lot. I have purchased the replacement part but am looking for instructions as to how to replace it.
2010 es350
Elantra MD (2010-15) :: Brake Pedal Is Spongy
I have a question about the bleeding the brake? When I washed my E, I usually spray the wheel and the brake part. I don't know it is a good idea or not. Recently, I felt like I have to step further on the brake pedal to apply the brake.
The force is there and Brake assist is still in effect if I step fast enough. I just felt like the brake pedal is spongy. My E is on 36k right now. Do you think wash the wheel often will cause the problem to brake line?
I have confirmed that my Gf's Elantra is easy and ease to brake than mine. At the mean time, her brake fluid is darker than mine. My brake fluid is full and clear. Maybe I should not wash the wheel more often. Or maybe I get OCD too much?
Elantra MD (2010-15) :: ABS / ESC And Parking Brake Lights Are All On
Suddenly all these lights came on in a 2012 Elantra . Had at the dealer and they checked wheel speed sensors, wiring to sensors and said all those are ok and the abs module is bad. I replaced the module, bled the brakes and the exact same lights are still on with the same codes coming up. Tech is confused as I am.
View 5 RepliesElantra XD (2001-06) :: 2003 - Left Tail Light Works But Brake Light Is Out
My daughter has a 2003 Elantra. The left tail light works but the brake light is out. I opened the trunk and removed the two screws for the cover and found the wire going through a rubber plug. Upon removing the plug, more wires and no bulb.
How do I get to the bulb? There appear to be three screws and bolts, one on each corner, holing the tail light in place. On the fourth corner is just a rubber-looking plug. Do I have to take the assembly out to change bulbs or am I missing something?
Elantra MD (2010-15) :: Knock Under Car When Step On Brake Pedal
About 9/10 times when I step on my brake pedal (speed has not made a difference) I can hear and feel a hard knock under my car by my resting left foot. Started a few weeks ago. Haven't had work done to my brakes since May 2015 so I am thinking it is unrelated. What the issue might be?
View 2 RepliesElantra MD (2010-15) :: Brake Squealing After Replacing Pads?
Last week I replaced my stock 2016 Elantra's brake pad's with Wagner Thermoquiet another forum user recommended, came with new hardware (seats), however not new 'plates' (that are on the side of the pads), so I had to reuse the old ones which were quite dirty/ old looking. Anyway, I understand due to the old rotors being on there, I'm going to hear some unusual noise when letting off the brakes until broken in, however, squealing when I press the brakes? (Only happens at low speeds, like drive through window.) I greased all the metal components that make contact with the caliper. I NEVER experienced squealing with the old pads, & these are "supposed to be quiet & more efficient". I'm going to take the wheels off & look at them tomorrow. What I can do?
View 15 Replies