Elantra HD (2006-10) :: Brake Noise Before And After Rotor / Pad Change
I recently changed the rear pads/rotors on a 07. the dealer said it needed new pads because I guess the heard a light grinding noise but I did not think they looked at it. I believe the pads/rotors still had 10K miles left on them. The car has 40K miles on it.
Anyhow, I noticed the old pads had some life to them, but uneven wear in some cases. Looked like the classic issue with brake pad/caliper design tolerance error.
I did grind down the pad holder a bit so they can slide on the caliper easily without getting stuck and resulting in uneven wear.
After the new pads/rotor, the rear right appears to be making the same light muffled grinding sound when you apply the brake.
Elantra HD (2006-10) :: Right Rotor Is Stuck On Parking Brake
Doing a rear brake job on my 2008 elantra. Left went fine. However, the right rotor is stuck on the parking brake. It is loose, but held on to the springs of the parking brake.
How do you back off the parking brake? Also, how do you remove the parking brake cable?
Ford 7.3L Power Stroke (1999-2003) :: How To Remove Driver Side Rear Rotor
I noticed my rear brake smoking on the truck really just the rear driver side. I had replaced the pads and caliper and rotor a very long time ago. What I think happened is the parking brake got hung up somehow. The wheel was extremely warm and the reason I noticed it was not only the smoke but I felt some sort of wobble or almost out of alignment issue.
When I got home I noticed the smoke and extreme heat. I removed the caliper and the pads look still "new" and evenly worn. I did bleed the caliper just to make sure no air, I even put a spacer in the caliper and my wife applied the brake and they closed appropriately. Then I was trying to get the rotor off and no success. I did adjust the parking brake but I am not sure if you move it up or down to loosen it up?
I have used PB Blaster to try and loosen it up, rubber mallet while I turn it (although it does not turn easily at all), I sprayed it inside where the adjuster is hoping it would seep down between the shoes and the hub. I heated the hub up with a little torch - no success. I was thinking of using a wood piece as a butter and hammer from the inside out on the rotor but fear that will warm the rotor itself.
Golf/GTI VI :: 2010 - Unable To Remove Rear Side Headrest In Order To Install Child Seat
I have a 2010 4 door GTI. I'd like to install my daughter's front facing Britax child seat either in the rear right or rear central position. However, in either case, I'm finding that most of the rear weight ends up on the headrest and I would like to simply remove the headrest from that seating position.
I read in the user manual that to remove the headrest,I pull it to it's highest position and then push the button on the right side of the plastic entrance of the head rest into the seat, and 'simply' pull the headrest vertical out of the seat.
This is similar to how this was done in other cars I've owned. However it is not working for me with the GTI. Once I pull the headrest to the highest possible position I can get to, I press the button but the headrest simply refuses to come out. I've tried this on the other rear seat and same problem. With the middle rear seat I can't seem to pull the headrest out beyond its lowest position.
Lexus RX 2004-09 :: Rear Brake Rotor Won't Come Off
I'm in the process of changing pads and rotors on all 4 wheels. I've done all brakes and rotors, except that I'm stuck on the driver rear. The driver rear rotor won't come off!
Here's what I've done so far: I've used the metric jack bolts (I didn't buy the long ones) and that freed up some rust, with pb blaster. Now, the rotor comes out a bit, and I'm able to move it around, and the rotor comes forward a little bit towards me. It's so wobblily that it seems like it is about to come out. The rotor isn't solid stuck on, like most threads I've read.
While hammering, I think a piece of hardware of the parking brake fell down on the ground. Do u think that the parking brake is not allowing the rotor to come off? If so, I was reading online that there is some way to release the parking brake via a hole though the rotor, but I'm really not familiar with this. I'm not even sure if it's the parking brake that's not allowing the rotor to come off.
Camry :: 2007 - Rear Rotor Stuck On Parking Brake
I am trying to remove the rear rotor of a 2007 Camry, but it appears to be stuck on the parking brake. The parking brake is not engaged, but the pads are firmly pressed against the rotor (rotor was loosen from hub assembly using bolts through the two threaded holes).
I have removed the rubber plug and attempted to turn the star adjuster, but it doesn't seem to move in either direction. Also, the adjuster should rotate away from you to tighten the brake and toward you to loosen, correct?
Camry :: Unable To Find A Diagram For The Rear Brake Drum Of 2005?
Worthless Chilton's manual went in trash. I don't have a working PC and Im unable to find a diagram for the rear brake drum of my 2005 camry.
View 3 RepliesElantra HD (2006-10) :: Power Windows / Rear Defrost And Brake Lights Not Working
After not starting my car following several days of extreme cold, my battery died a couple of weeks ago, and after boosting the battery, I noticed a couple of electrical accessories (power windows, rear defrost, rear brake lights) are no longer working. I was told by a mechanic at the local Wal-Mart that it was possibly the main relay, which I replaced at the dealer, but that did not fix the issue. I've checked the individual fuses for these accessories, and all of them are OK. How to troubleshoot this?
View 7 RepliesFord Excursion :: Changing Rotor - Can't Remove Broken Bolt?
I was in the process of changing out rotor and pads and my caliper bracket bolts while loosening them. The weird part is the bolt was turning in the process. The passenger side was easy as pie. The drivers side has me stuck. I have tried to drill out the broken bolt but noting is working. I don't know where to go from here. I have already purchased a new caliper and the bracket that goes with it. I just need to get this old one off so I can move on.
View 14 RepliesElantra MD (2010-15) :: How To Remove Rear Deck
So I tried removing my rear deck but was unsuccessful. I removed 4 "screws" when folding the seats then the ones inside the trunk but it didn't come off. Did I miss anything that is holding it down?
View 4 RepliesElantra MD (2010-15) :: How To Remove Rear Seat Bottom
Is there any trick to removing the rear seat bottom, or do I just need to pull each side up with enough force until it pops out? If I get my hand under the edge of the seat there seems to be a decent amount of give to it, but I don't want to break anything...
View 8 RepliesElantra MD (2010-15) :: 2012 - How To Remove Rear Bumper Reflectors
I have a '12 Elantra Limited and I'm planning to smoke the rear bumper reflectors. How to remove them?
View 20 RepliesElantra HD (2006-10) :: How To Remove The Central Console Off
What are the steps to remove the central console off? I am going to replace my airbag control module.
Remove the silver one first or remove the black trim first? I already removed the four screws , front 2 and back 2.
Prius (2001-03) :: Unable To Remove Key From Ignition
I thought I would try and resolve this issue while I wait for the battery module to arrive.
I read through all of the past articles relating to my issue with no luck of resolution.
When the car is turned off, the steering wheel never locks. Even when I rock the steering wheel left and right it never locks.
Passat (B5) :: 1998 - How To Remove The Rear Disc Brake
What tool I need to replace the rear disc/pads in my 1998 VW Passat 1.8T. I believe is called a wind back tool and I have seen it in the web.
View 1 RepliesElantra HD (2006-10) :: How To Remove Door Lock Actuator
I have a 2010 Hyundai Elantra (GLS, I think). I was having problems with the factory alarm, and while troubleshooting that, I found that the lock on the rear door (drivers side) works well manually, but fails (won't lock or unlock) most of the time when using the key fob or the master lock switch on the drivers door. I'm pretty sure the actuator for the door lock/latch is going bad, and I'd like to take it off the vehicle for inspection and if bad, replace it.
So, I took the door panel off, and found there is a huge aluminum cover over most of the door, with about 9 bolts holding it on. I can't seem to get it off, to gain access to the interior of the door where the actuator is mounted. I've tried the local Hyundai dealership, local auto parts stores, but how to remove it. Removing the bolts lets me pry it away enough to peek inside, but I can't find what's holding that aluminum cover on.
Elantra HD (2006-10) :: 2007 - How To Remove The Crank Pulley
Preparing for a timing belt replacement on a 2007 elantra. well aware of how to remove the crank pulley and do the job. My question is this : once you have the nut off, does the crank pulley come off by hand or is a puller required? came off nicely wiggling it by hand on any accent i've done, but never done this particular job with the elantra.
View 4 RepliesSonata I45 (YF - 2011+) :: 2013 - Unable To Remove Car From Park
I've had this issue 2 times already but I usually just turn off the car and power it back up.
When I first turn on the car the P doesn't show up in the indicator to show what gear im in and I'm unable to come out of Park with the break pedal depressed all the way down, (break pedal became stiff) turner off and turned the car back on and same thing....
2013 Hyundai Sonata 2.0t ....
Ford F-150 (2004-2008) :: Remove Rear Brake Rotors?
I'm having a hard time trying to remove one of my rear brake rotors.
I thought these simply pull straight out and off, but mine might be rusted in place. I soaked the front facing area around the axle with Kroil and then tried jolting it out by tapping it with a rubber mallet. No success
What's the trick?