Corolla / Matrix 2009-13 :: Throw-out Bearing - Noise Comes And Goes As Clutch Pedal Is Released
Title should say Throw-out bearing aka Release bearing.
I have a 2010 5 speed Corolla CE. Having problems with their Throw-out bearings. At around 8000 miles the sqeaking/chirping noise of the bearing was too much so I brought in it to the dealer to fix. They agreed and made the repair.
Now it is only at 10000 miles (22000km) and I can hear it starting again. Just wondering if it is a common problem?
Noise comes and goes as the clutch pedal is released. If you push it in it will go away. It also will happen in all gears but easiest to hear in neutral.
Golf/GTI VI :: Transmission Emits Chirping Noise - Bad Throw Out Bearing?
I have a '10 manual trans gti. Only 16k miles on it. When starting cold and on an incline/decline at a certain level of clutch play, the transmission emits an odd chirping/whirring noise. Aside from the noise, the transmission is butter.
I brought in into the shop to get inspected and was able to replicate the noise for the technician. His thought was a bad throwout bearing.
Here's where it gets interesting. They quoted me about $600 labor just to confirm the issue. Should it be the throwout bearing, the replacement would be covered under warranty. labor would also be included. However, if they found it to be a wear product it would obviously be on me and stupid expensive.
Some people also thought maybe the clutch plate fingers are slipping? (I don't know that much about cars..)
Corolla / Matrix 2009-13 :: Quick Chirping Noise - Water Pump Failing?
So recently every time I start up the Rolla I get a chirping noise real quick and everything seems to run alright. I had my neighbor, a GM mechanic just look quick; and on the belt connected to the water pump looked like it was unusually worn on spots of it.
The car has about 27XXX miles on it ('10 Rolla S).
Going for an oil change next week, going to try and find out what's going on with this thing. I've seen other threads talking about the water pump causing the symptoms I've described at around the same amount of miles. Seems like a common part to fail on the car.
Corolla / Matrix 2009-13 :: Faint Noise From Engine Compartment When Driving / Idling
I have a 2009 Corolla 1.8 with 18,000 miles on it. My wife mainly drives it, today after getting it washed, I was driving and noticed a very faint noise from the engine compartment. Seems to be coming from the passenger front. The sound is something like grr grr grr.... I made sure it's not the wheels by putting the car in neutral and giving it gas which made the sound audible (I can also hear it while idling).
I had my wife sit in the car with me, and she couldn't hear anything, but I can, so I'm afraid when I go to the dealer he will say the same "I can't replicate the noise". What it can be?
Corolla / Matrix 2009-13 :: 2010 S - High Pitched Squeak / Chirping Noise On Cold Start Up
I have a 2010 Corolla S Got it brand new in november of 2009. Its been 5 years since I had it and never had this problem.
So this has been happening for a month now, and I can't figure out what it is? It only sounds at first startup of the day when the engine is cold and only sounds off for 1 second right when you start the car.
Corolla / Matrix 2009-13 :: Rear Brake Making Noise
I have a 2009 matrix 1.8 automatic with 103,000km on it. The brakes were making a noise so I pulled off the front wheels and inspected and cleaned the front brakes which were in great shape. I pulled the rear wheels and found that the outer disc pads were wearing on about a 30 degree angle. The inners were just fine! I've been doing brakes for over 40 years and have never seen this! Also, the rears don't work hard and should outlast the fronts by at least 2! I called Toyota Canada and they blew me off until I asked to talk to someone higher up! They are doing a technical review, but I believe they will tell me it's just my car! I think it's a design flaw!
View 13 RepliesCorolla / Matrix 2009-13 :: 2010 LE Making Click Noise While Steering
Our 2010 LE has been making a noise while steering. When you steer it left and right, it clicks. Regardless of whether the vehicle is moving or not, it still clicks. It sounds like its coming from under the upper steering column cover behind the steering wheel.
View 1 RepliesCorolla / Matrix 2009-13 :: Brakes Making Noise After Cold Start
Is it possible for the brakes to make some kind of noise when it's cold outside?
I've been noticing some kind of noise after a cold start, I'd drive the car a little bit then apply the brakes and it would just make this random noise coming from the front-right side of the car. It sounds like a grinding noise, but I can't really tell. It doesn't create an issue either, I'll let go of the steering wheel and the car doesn't drift in any direction at all, the noise appears but the car is slowing down properly.
The noise disappears though after the 1st time it happens, and would only reappear after you've turned the car off, parked it where it's cold and it would only appear after not using it for at least 2 hours. My dad already took it to the dealership and they said the brakes are perfectly fine.
Corolla / Matrix 2009-13 :: XLE Started Making High Pitched Noise
[URL] .... I couldn't figure out how to embed the video...
My mother's 09 Corolla XLE just started making this high pitched noise.. It makes this noise every other day, then it makes a loud pop sound and goes back to normal..
Corolla / Matrix 2009-13 :: Toyota Making A Loud Grinding Metallic Noise On Front Left Side
I have a 2009 Toyota Corolla and it's making a loud grinding metallic noise on the front left side. It does it while I drive the faster I go the louder it gets. When I turn to the left it makes it louder, when I turn right the noise decreases. PG&E have been breaking the roads by where I live and there's a lot of little rocks I drive thru. I'm wondering if that's the problem?? What do I do?
View 4 RepliesCorolla / Matrix 2009-13 :: 2010 LE Faint Gear Whine Coming From Transmission At Around 60 Mph
I recently purchased a new 2010 Toyota Corolla LE auto and I really like it. I have about 2000 miles on it now and just recently noticed a faint gear whine coming from the transmission at around 60 mph. You can only hear it when the radio is off and you really listen for it during the acceleration. It only does it when transmission fluid is fully warmed up after driving for about 15 miles. 2010 corolla uses U341E transmission that specifies Toyota WS transmission fluid. I noticed that 2001 - 2005 Supra uses the same transmission but it requires T-IV fluid which has more viscosity than WS. Noticed this faint gear whine on this car or do I need to take it to the dealer? My other car 2003 Toyota Echo uses U340E transmission and it has gear whine as well, except it is more pronounced than in Corolla, so I an trying to figure out if this is normal for this transmission or not.
View 10 RepliesCorolla / Matrix 2009-13 :: What Keeps The Cam Bearing Shells From Spinning
On a 2ZR-FE 1.8L what keeps the cam bearing shells from spinning? This would be the shells closest to the cam chain, sprockets etc.
Are there the little tabs that are bent out at the end of the shell like a rod bearing, or are they locked into position as the cam cap is tightened?
Corolla / Matrix 2009-13 :: Tranny Output Shaft Bearing Gone At 67000 Miles
So my girlfriend got this car (2013 corolla s) a few months ago and we started hearing a funny noise, I thought it was a wheel bearing going but nope its the ouput bearing on the tranny, passenger side. is this common on corrollas? how hard is it to change? I have a tranny from an 06 corolla, are they the same? and could i just swap trannies if changing the bearing is too difficult?
View 2 RepliesCorolla / Matrix 2009-13 :: 2012 - Steering Column Making Clicking Sounds?
I just bought a new corolla a few weeks ago, (Build Date April 2012), so far the car is great except for one issue.
I've noticed when pulling out parking spaces the steering column makes a clicking noise. It sounds more like a plastic noise. My last car had to have intermediate steering shaft lubed every 40k (Pontiac) but it was more of a "clunk" sound. This is more plastic on plastic noise however this appears to be only when the wheel is about 1/2 turn from the "end" or all the way left, or all the way right.
I am trying to figure out if this is a "normal" sound or if something was not put together right. Here is a video .....
Corolla / Matrix 2009-13 :: Brake Pedal Spongy And Making Hissing Sound
2009 XRS ABS brakes .... I changed all four brake pads and flushed out most of the old brake fluid. Bled all four sides. But now while I am in idle (like waiting for a light to turn) my brake pedal is spongy and is making a hissing sound. All was good before I did this job.
View 3 RepliesGTI 337/20th Anniversary :: Dead Ringer For A Throw Out Bearing Noise
20thae with a UR 7lb flywheel and spec stage 3 clutch. Got rid of the dual mass flywheel and installed a lightweight flywheel and spec clutch now i have a god awful noise that is dead ringer for a throw out bearing noise. talked to the spec guy at waterfest today and he told me that the dual mass acts as a dampener and this just doesn't make any sense in my head. touch the clutch pedal in any gear at any speed and the noise disappears.. uy at spec said it was in the trans and the only option was to change for a thicker gear oil. p.s. i took out the clutch and everything back apart and measured everything is oem thickness and the throw out bearing is in good shape.
View 7 RepliesGolf IV / Jetta IV :: Knocking Noise While In Neutral - Bad Throw Out Bearing?
so lately I've been noticing a slight rattling/knocking noise coming from my car while it is in neutral and the clutch is not pushed it. When I push the clutch in, the noise goes away. I've read that this could be a sign of a bad throw out bearing? Is this right? If it is the throw out bearing, how long can I expect until it completely craps out on me? It seems to only do it on cold starts and sometimes on the uneven ground. I figured I should start saving some money to have this done because I'm not comfortable doing it myself.
Some other questions I had is my car is a 24v VR6 and it has 144k original miles. The timing chains and guides have not been replaced (to my knowledge at least). I know that replacing the throwout bearing requires removal of the transmission and so does doing the lower timing chain. If I get my throw out bearing replaced, should I have them do the chains also since they are already in there? I have no noise coming from my chains at all so there are no signs that they are going bad. Also, should I have my clutch replaced while they are in there? Again, no signs of a bad clutch either.
Ford F-150 (2009-2014) :: 2012 - Engine Started Making A Chirping Noise When Accelerate
I have a 2012 3.5 eco boost. It has 82,000 miles. I just purchased a large travel trailer. That is the first thing I have ever towed. When I was accelerating onto the interstate the engine started making a chirping noise.( not the normal turbo whistle). It went away when the rpms came down, and now every time I accelerate, it makes the same noise around 2000-2500 under load.
View 6 RepliesCorolla / Matrix 2009-13 :: Drive Shafts Are Stressing The Final Drive Bearing On Transmission
My mechanic just informed me that because of my extreme drop, the drive shafts are at an angle that is stressing the final drive bearing on the transmission. I am leaking very small amount of fluid, he said it might not be a big deal.
View 3 Replies