Chrysler - Towncountry :: Oil Light Comes On When Engine Starts Cold
The oil light on my 2005 Chryler Town & Country comes on when started when it is cold outside. It stays on until I turn the key off and restart, then it goes out and does not come back on. My mechanic cannot find anything wrong. This only happens in cold weather, not in the summer.
View 10 RepliesChrysler - Towncountry :: Squeal Coming From The Engine Compartment / Hard To Start
I am the 2nd owner of a 2001 Chrysler Town and Country Minivan Limited. The vehicle is in very good shape and I service it every three months and have the tires rotated every six months.
Just recently I have been having a problem with it not wanting to start. I have had a bit of a squeal coming from the engine compartment and know it is the serpentine belt that needs to be changed out before it gets bad (I have only heard the squeal probably three times since December 2012.)
I would rather buy my parts and have the mechanic put them on instead of him buying them and charging me double.
My question is...do you think it is only my belt or should I think in the direction of the Starter or something else. After about threee or four tries it will finally start.
2000 GMC Jimmy - Loss Of Power / Hard Acceleration
I have a 2000 gmc jimmy 300.000 km 4.3 vortec .starts ok, even when cold idle smooth but when I accelerate past 2000 rpm it has a complete loss of power. I bought a fuel pressure tester key on 2 seconds 60 psi when I start the vehicle and running 55 psi. I took it on a road test it stays at 55 psi and has a hard acceleration and will go to 60 psi ,and then starts to break up my first question is how can I block off the return line to the tank, there's no rubber hose in any of the connections just steel lines and hard plastic with push connectors, is there a plug that you can buy or how I can block off the return to see if the pump will build pressure to 75 psi to 80 psi will this will tell me whether the pressure regulator is faulty or the fuel pump needs to be replaced.
I have a manual its a Haynes for chevy blazer gmc from 95 to 2004 it says with central sequential fuel injections (csefi) key on engine not running it should be approx 55-61 psi the engines running at idle it should decrease through 3 to 10 psi according to this manual i am within range but i have read on other posts that it should be 60-65 would you say that my 55 psi reading is okay? or should it be 60-65? also when i blocked the return line should i get a reading of 75 or higher? if the reading goes up does that mean that the fuel regulator is faulty? and if it doesn't go up does that confirm that the fuel pump is the issue?
Golf IV R32 :: Hard Acceleration In 3rd Gear / Momentary Loss In Power
Having problems where sometimes the car won't go into gear, other times it's fine? The problem started after some hard acceleration in 3rd, there was what felt like a momentary loss in power. I dipped the clutch as I thought a boost pipe had popped off, all was fine (still seeing boost when revved). After this it got progressively harder to get gears, finally resulting in not being able to get into gear at all.
I found I could get it into 1st with the engine off and could go up gears normally, but couldn't change down without stopping and turning the engine off. The clutch is working fine, the biting point is normal. The problem seams to come and go randomly, it will work fine for a while and then start playing up again. When working the gearbox feels normal, there is no grinding or wining noises. I can move between gears normally and do clutch less gear changes.
There is now a vibration which can be felt at 1000rpm when stationary. It feels like it coming from the engine/gearbox and seems like something is out of balance as it shakes the whole car. The car is on 91k, supercharged running 470hp & 370lb/ft (at flywheel) and is fitted with a Spec stage 3+ clutch and solid flywheel.
Chrysler - Towncountry :: 2006 - Check Engine Light Comes On When Wet Outside
We have had an engine light that comes on when it is wet out. (Usually from rain) Until recently, the codes were not stored in memory. The last time we tried this, there was a 420 code set. Our mechanic said it was the catalytic converter. This vehicle is a 2006 and only has a 100,000 miles on it. Neither of the oxygen sensors have been replaced. The car doesn't seem to run any differently when the engine light comes on.
View 10 RepliesChrysler - Ptcruiser :: 2006 - Gauges Drop - Stop Working - Power Loss
2006 Chrysler PT Cruiser. While driving, it seems at random, all gauges drop and stop working, no gas getting to the car, power loss. Sometimes lasts a split second, sometimes lasts up to 30 seconds. The car will even stall here and there, but usually not. Usually, power gets restored. But sometimes the car won't even start for an extended period of time. Of course, when the mechanic takes it for a ride it does nothing wrong.
View 2 RepliesChrysler - Towncountry :: 2006 - Engine Spits And Sputters After Running For 2 - 3 Minutes When Gas Tank Filled
I have a 2006 Town and Country with the 3.3L V6. The last four times I filled the gas tank the engine spits and sputters after running for 2 - 3 minutes. Sometimes it will even stall out. It will re-start after cranking for 4 - 5 seconds and then runs fine. It only does this right after I fill the tank and doesn't do it again until the next fill up. Thought that I might have water in the tank so I added a bottle of HEET to see if it would cure the problem, no effect at all..
View 4 RepliesChrysler - Towncountry :: Poured Power Steering Fluid Into Transmission
I poured 2 ounces of power steering fluid into an automatic transmission. What a wake up when I saw gold instead of red dumping into the funnel. I then poured 14 ounces of ATF+4 into the transmission to top it off. It's been only 8,000 miles since the transmission was flushed. Should I flush now or is the power steering fluid compatible?
View 4 RepliesChrysler - Towncountry :: Brake And Power Steering Fluid Replacement
I was advised to replace my brake and power steering fluild at 40,000 by the Chrysler Dealer. Ever heard of this?
View 8 RepliesSonata NF (2006-10) :: Power Loss While Acceleration
I was cruising on the highway and tried to accelerate and no more power. Could feel engine losing power. After I shutdown the car and start again, car was fine.
View 3 RepliesFord 6.0L Power Stroke Diesel :: Runs And Starts Perfect But Under Medium To Hard Acceleration It Bucks / Sputters
Starts good cold and hot. Taking off like a grandpa on an evening drive don't notice a thing. Only codes that keep coming up are 2614 and 2617 which are cmp and ckp open curcuit codes and a software incompatibility code for FICM which is due to the updated software in the fresh FICM I installed. HPO pressures are good, has boost, idles smooth, revs nice when in park. New injectors (cause it was running rough especially cold before) and CMP and CKP (because of the above codes and didn't change)and ICP and IPR (last 2 installed because of HPO codes that are gone now with the IPR and ICP). Fuel pressure is 65psi (updated spring). When you step on it while driving it sputters and bucks like it's out of fuel, let off the throttle a bit and it purrs like a kitten. I'm a little stumped. I think it puffs a little white/blue smoke while it bucks.. not much tho. and it comes in little puffs. Took off filler cap and there is almost no blow by.
View 6 RepliesChrysler - Towncountry :: Wipers / Radio / Power Windows And Blower Drops Out After Startup
I have a Chrysler 2002 T & C. When the ignition is "on", everything works, but if the car starts, these accessories drop out and don't come back on for minutes at a time. The ignition switch has been replaced, but it still happens?????
View 3 RepliesChryler - Towncountry :: Loss Of Power When Give It More Gas And Transmission Downshifts
I have a 2006 Chryler Town & Country with the 3.8L engine. The car has 170K miles on it and I change the fluids/filters as recommended. I have never changed the plugs and wires though, or the fuel filter. The car starts and idles normally, and no issues driving in-town or on the highway.
Recently I have noticed a loss of power when I give it more gas and the transmission downshifts. The engine revs up but the power doesn't really increase and it makes a low growling kind of sound. The engine also starts to hesitate at around 3000 RPM if I rev it in neutral. I am thinking it could be the plugs/wires, fuel filter or air filter (even though the air filter is less was installed at 163K miles.
Lexus GS 2006-11 :: 2008 GS460 - Acceleration Power Loss / RPM Meter Jerks A Little
2008 GS460. 100K miles
I have noticed when I accelerate on a entrance ramp to the highway I notice the RPM meter jerks a little like it's trying to suck for gas or something else. I can feel it in the car too. This is the only time I have noticed this. I have replaced the spark plugs about 5K miles ago.
I did bring it into the dealership a few months ago to get the fuel pump replaced as I noticed a hissing noise under the drivers side read door. They said fuel pumps rarely go bad on the Lexus. The mechanic did some fuel pressure tests and said everything looks good. He also said noise is the return line back to the pump.
Sonata I45 (LF 2015+) :: Engine Starts Hesitating Around 5k RPM Under Hard Acceleration
I'm on my second '15 Limited Turbo. Only have 2k miles, but I've noticed an issue with acceleration. When under hard acceleration, especially in 3rd or 4th gear, around 5k RPM the engine starts hesitating. It feels like it runs out of steam. This feeling lasts through beginning of next gear, then the car picks up again. It is actually faster when applying less throttle.
What it could be? It did it since new, I took it to the dealer once, but got some stupid response that it was just rev limiter kicking in (at 5k, right), unfortunately had no time to leave it with them again/show it to them. I also thought it might just go away on it's own, plus I don't usually drive it that hard anyway...
Chrysler - Towncountry :: 2007 - Shudders Between 40 - 42 MPH
My Town & Country 07 shudders (best word I can use to describe the sensation) between 40-42 MPH. First repair place convinced me I need tie rods, did not resolve problem. Next place said I need struts and new tires but the problem is not solved. Why the van would do this shudder, rumble, whatever - but only at 40? If I rapidly accelerate, like getting on the highway, it doesn't happen.
View 3 RepliesChrysler - Towncountry :: Car Stalled And Won't Immediately Restart
When I had 67 miles on my 2013 Chrysler T&C Van it stalled and would not immediately restart. The Electronic Vehicle Information Center revealed both the coolant and engine oil temp was in excess of 300 degrees. After 15 minutes the temps were between 280 and 285. The engine started and I drove slowly the3 miles to my house and had it towed to the dealership the next day. Mechanic found the quick connect coolant line to 3rd seat heater was improperly installed at factory allowing 1 gallon plus of coolant to escape.
A mechanical engineer and a Chrysler mech ( not one from the dealership) advises it is just a matter of time until I have internal engine damage. Chrysler Owner Assistance Dept assigned a case mgr. She reported the van was repaired and operating properly because the coolant line was repaired. Their first offer was 1 months loan payment, which I refused.
Chrysler - Towncountry :: 2001 - Calibrating The Speedometer?
I have a 2001 Chrysler Town and Country w/ 3.8L engine and 196,000 miles. Several years ago the transmission was rebuilt. Since then the speedometer was off 1-2 mph at 65 mph. I recently bought new tires and now the speedometer is off 2-3 mph at 65 mph. My question is: How do you calibrate the speedometer? I know all about the reset for a bouncing/stuck needle. That does not calibrate the scale. I've read about gear replacement and found the Hyper-Tech calibration programmer (which is not available for the 2001 T&C).
View 5 RepliesChrysler - Towncountry :: 2008 - Won't Start Sporadically
My 2008 Chrysler Town & Country has, since it was 2 mos. old, had a "no-start" problem. This is not a stalling problem. It happens when the car is off and I try to turn it on. The problem is very sporadic (sometimes several times a day - I do lots of short drives - sometimes several times over the course of a few weeks, then no problems for months). When I turn the key in the ignition, all electrical components come on (dashboard lights, air, radio, etc.) but nothing happens with the engine (it does not make a sound). The dealer has replaced a computer component, the battery, the starter, the electronic keys but the problem always happens again (within a few days of it the "repair"). I usually have to turn the key 3-12 times (sometimes I take it out of the ignition, sometimes I pray!) and eventually the engine starts. Because the problem is sporadic, the dealer has not been able to replicate the problem (though they have, at times, had it for a week or more and even driven it as if it were their own, home at night, to work, to run errands). Although the car eventually starts, it is very problematic when I have to be somewhere and it takes 10 minutes (not to mention a lot of worrying) to get it started.
View 3 Replies