Chevrolet - Tracker :: 2003 - Headlights Come On Automatically While Parking Brake Released?
I'm having trouble with the headlights on my 2003 Chevy Tracker. When it's light out, my headlights come on automatically when I release the parking brake, but turn off if I turn the switch that would normally turn them on. When it is dark out, or I drive under a bridge etc, they turn off and I can't manually turn them on. I can "flash" my headlights, but if I turn them on as if to leave them on, they don't turn on. This problem started about the same time that my AC blower stopped working, so I replaced the blower motor resistor and all fuses (I've heard that the blower motor resistor is also involved with the headlights). This fixed the AC, but had no effect on the headlights.
I can trick the lights into turning on at night only by shining a bright light directly on the sensor - they turn back off as soon as I remove the light. I took it to Pep Boys for a basic electrical diagnostic to see if I might be missing something silly, but once I described the problem they wouldn't even bother - told me to take it to the dealer and have the body regulator module reprogrammed.
Avalon 2005-12 :: Driver Side Wiper Blade Lifts At Speed On Down Stroke - Tension Spring Soft?
We took my 08 Touring down to Florida for our vacation, and while she performed great- {average 28-32mpg @ 70ish mph} -she fell shy of expectations when we hit a few light rains. At speeds above 70 the drivers wiper blade would clear on the up stroke but not on the down stroke....yes, 1st thoughts are go slower, but that isn't a real answer for me.
Before leaving I installed new brakes {rotors/pads/hardware} all around, new Michelin tires {all 5} and "new wiper blades" {rain-X}. The new brakes were very useful going thru the stop and go traffic in Atlanta, the new tires were very useful in the twisties of Tennesee's hills...but the wipers had me getting lapped often on the way back home due to the lifting issue above 70, so I kept to 65-70mph.
The way I see it, it's either the wiper blades not having enough "ramp" on the blade for the wind to push it down at speed, or the wiper arm tension spring is going soft.
My car is an '08 with 154k...{no leaks/motor still has great power/went 3400 miles and she didn't burn a drop of oil!}.
Accent MC (2006-11) :: Noise When Brake Is Released
My Hyundai Accent 2006 with 98000km has a noise when the brake is released. Braking is ok and seems to work well. This noise comes from the back when the brake is released.
View 4 RepliesChevrolet - Suburban :: 2001 - Parking Brake Adjustment
How do I adjust the parking brake on my 2001 Suburban? It is a 2wd 1500 model.
View 3 RepliesFord - F150 :: Clunking Noise While Brake Is Released?
My ford F-150 makes a clunking noise when I release the brake at a stop light or stop sign. It sounds like it is in the transmission. It only happens when I come to a complete stop and start moving again.
View 4 RepliesHyundai :: 2006 - Wheel Noise When Brake Pedal Released
Using mobile phone, Wife has an '06 Tucson. Noise like brakes squealing, but it occurs when you're NOT pressing the pedal.
The noise gets louder as the car goes faster, but the pitch of the squeal doesn't go up.
Prius (Gen 3) :: Loud Creaking Noise When Brake Pedal Is Pushed And Released
I traded my 2007 Prius for the 2010 III Prius on 5/30. I had 5 wonderful days with it and on the 6th day, it started.
There is a loud creaking noise when the brake pedal is pushed and released.
The dealership contacted Toyota and did everything that was suggested to correct the problem and no luck.
Civic - Honda :: Brake Making Squeaking Noise When Pedal Released
A mechanic recently replaced the pads of the front brakes. After the service, the break makes squeaking noise when I release the break pedal. According to the mechanic, it is normal, and I better ignore the noise. Is it true?
View 1 RepliesLexus GX 2010+ :: 2015 - Brake Too Loose / Noise That Sounds Like Air When Pedal Released
My father purchased the 2015 GX460 this past January and the car currently has 4,500 miles. The first complementary oil change was completed in July. I feel that the brake of his GX460 is not sensitive enough, and I have to step on the brake very hard to feel the truck stopping. Does every GX460 owner feel the same way? I told my father about this, and he said I'm just not used to it. I'm thinking about taking his truck back to Lexus to check it out.
The dashboard so far doesn't indicate any ABS problem. By the way, I'm an owner of a 2014 IS350 F-Sports, and my 350's brakes are much better in my opinion. I'm not sure whether my experience of my 350, which has larger brake calipers for its size, has influenced me to draw such conclusion about the GX460 brakes.
Also, I notice that when I step on/release the GX460 pedals, I hear some noise that sounds like air. Did some research about this on the forum, and some of you have that too. I still don't understand this issue.
Gasoline - Chevrolet - Suburban - Flex :: 2008 - Slight Stumble When Idling With The Brake On Or In Park
I have the 5.3L FLEX Fuel with 98K miles. I have purchased this 2nd hand and having a slight idle stumble when in park as well as in drive @ a stop light...etc. If i am under way, the vehicle runs flawlessly. When i am idling with the brake on or in park, there is a slight stumble that is driving me crazy. I have replaced the high dollar IRIDIUM plugs but did not replace the wires...they looked fine. I did clean the throttle body. I get fuel from different places and it does not make a difference. I have not cleaned the fuel system professionally but I have used OTC additives such as SeaFoam. No codes are exhibited on a diagnostic computer or any updates available for that matter.
View 11 RepliesChevrolet - Nova :: 1970 - Stiff Clutch Pedal / Tension Adjustment?
My 1970 Nova has a very stiff clutch pedal. Is it possible to adjust the tension on it? It's getting to the point where it makes my foot sore to drive the thing- very annoying. It has a 3 speed on the floor gear-shift.
View 11 RepliesChevrolet - Suburban :: 2002 - Scraping Noise While Driving
OK so - I had the rear axle bearings replaced, but I'm still hearing a rotational scraping noise while moving (whether gas is applied or not, or whether braking is applied). Gets slightly louder the faster I go. But when I turn, the noise goes away. It's hard to pinpoint where the noise is coming from. My wife swears it's in the front; to me it sounds like it's in the middle (so it would be being transmitted from the source).
I took it back to our mechanic, but he can't hear it very well - he admits that his hearing is not what it used to be (he's in his 70s). Only thing he hears is "gear noise in the rear"... meaning he'd have to replace the differential in the back which would be prohibitively expensive and not worth it. He said I should come back in a couple weeks when his younger employee will be back so he can listen for it.
Chevrolet - Suburban :: 2000 - Noise And Vibration During Driving At Speeds Of 70 Mpg
I have noticed a louder noise and increase in vibration during driving at speeds of 70mpg + ... What is the cause??
View 1 RepliesGolf/GTI VII :: Spring Binding Popping Noise After Neuspeed Race Spring Install
This noise I have is driving me crazy, installed neuspeed race springs and now I have this weird spring noise, sounds like the springs are binding and then releasing when you turn the wheel, like a clicking dinging noise, it's on both sides and happens when moving slow and turning the wheel and when stationary and turning wheel, it sounds like tug and release not really spring bind I checked install and everything is correct even disassembled bearing assembly and everything is fine, lubed spring seats with silicone paste nothing is working.
When looking at the spring and turning wheel it's almost like the spring is getting stuck on the middle part of the seat then releasing, I know this was a common problem on the mk6 but I haven't heard anything about the mk7 the spring is seated in the lower perch perfectly the upper is were the noise is coming from you can see as you turn the upper bearing by hand it actually somewhat twists the spring and then releases and that's what makes the noise, and it dose not move in a nice circular motion kind of like an egg shaped rotation and it makes the spring flex and pop I think there's a problem with the springs,
Chevrolet - Suburban :: 2002 - Faint Humming Noise Coming From The Rear
I have a 2002 suburban . I have a humming noise coming from the rear . It starts at 45mph and then goes away at 47mph. I hear it again between 60-65 mph then goes away . This is a faint sound . When pulling a trailer the sound is much more noticeable and more constant from 55-64 mph . When I let off the gas the sound is still there and fades as the truck slows. Am I dealing with a bad tire ( I plan to rotate them to see if that is the cause ) or a wheel or axle bearing ? To note I replaced the front wheel hub/bearings just about a year ago .
View 2 RepliesChevrolet - Suburban :: 1999 - Ticking Noise Like A Turn Signal Continues Until Apply The Brakes
My Sub makes a wonderful ticking noise that resembles a turn signal--it continues to tick until i apply the brakes. i have just replaced the brake switch and the noise is still there. All the lights on the vehicle are not illuminated while it is making the noise, it makes the noise while either driving or idling.
View 4 RepliesChevrolet - Suburban :: Squeal / Groan / Clicking Noise Coming From Right Front Of Engine When Accelerating
2003 Chevy suburban, 115K miles, accelerating I hear a squeal/groan/clicking noise coming from right front of engine. Did not happen this winter, started again in spring. Loses power if stay on accelerator. If let off and then reapply, it will momentarily go away. Appears to be only when air conditioning on. Bad AC or just the pulley?
View 1 RepliesHyundai - Accent :: 2004 - Ebrake Doesn't Have Any Tension / Brake Light Not Coming On?
I have a 2004 Hyundai Accent, stick shift. I replaced the rear brake shoes and the wheel cylinder on the driver's side and bled it after, and now my e-brake doesn't have any tension in the handle and the brake light doesn't come on when you pull it up. The brake does set enough, when you pull the handle up, to stop the car from moving, but I think on a steep incline it would probably roll. How to fix it?
View 5 RepliesTouareg :: When Parking Brake Released In MFI Got Warning Parking Brake Fail To Release
Had my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 Replies