Volvo :: Motor Seems To Burn Out Spark Plugs - Car Running Rough With No Power
Motor seems to burn out spark plugs every month. I was using non volvo sparks. I took car to Volvo dealers and repairers who gave car a diagnostic check but nothing showed up. They told me to use Original Volvo Spark Plugs which I did. The Car went great with no problems for about 3 months thinking problem was fixed. Low and behold the same problem came back.
I changed spark plugs again (original Volvo) and car only ran for 10 ks and then ran very very rough with no power. Motor felt like it was running on a few cylinders. It seem this problem happens mostly in hot weather. Motor also heats up but when cooled down runs well again. I intend to buy new rotor Bosch and Distributer cap and if needed coil.
Silverado :: 2000 Drl Headlights Always Burn
drl headlights always burn instead of running lights when the truck is started. How can I correct it?
View 14 RepliesSilverado :: 1997 Chevrolet Z71 4x4 Truck Will Not Turn Over
I have a 1997 Chevrolet Z71 4x4 truck. 350 engine.
This morning I went to start the vehicle and it cranks fine but doesn't turn over. It cranks at a normal speed and then every second or so struggles, and then cranks normally again. About 2 weeks ago I went to start it and the starter didnt engage, it just spun. I released, tried again and it started right up. It did that twice over about two weeks. I figured the starter had gotten too weak, so I replaced.... No change.
The truck has been running quite rough for a little while, and I was doing research to replace the valves and sensors that were recommended (EGR and Idle Air Valves), but the truck seems to have decided that I will do this maintenance now, whatever it is. By running rough, I mean, when it idles, it shakes some. Going down the highway, it runs fine and doesn't miss or anything like that. It is sluggish, but it is a 16 yr old truck with 230000 miles, so it just seemed somewhat normal.
I have checked for spark, and verified that. I can smell fuel when I crank, so I don't think its a fuel problem, although tomorrow I will see if it will fire off starter fluid to verify. I have had the rotor go out before, but it seems when it did that it didn't stagger when I crank.
Ford 6.0L Power Stroke Diesel :: Glow Plugs Failing On Right Bank
About a year or so ago, cyl 5 glow plug failed. 6 months later number 1 failed. Now number 3. I seem to remember someone mentioning that the module can sometimes cause produce similar problems. Are there two circuits in the module, one for the left and one for the right, or just one circuit for both? 167K on it so it doesn't surprise me that they fail but just odd that they are all on the same side.
View 5 RepliesFord 6.0L Power Stroke Diesel :: Disable Glow Plugs While Testing Trailer Wiring?
I drained my batteries enough that I needed a jump after the last time I was troubleshooting trailer wiring, since I keyed on a bunch of times. What fuse or relay do I need to pull out next time? I'm thinking of pulling fuse 302, HFCM relay (or fuse 7 in the disto box under hood) to disable the fuel pump, but what fuse or relay is for the glow plugs?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: F250 Won't Start After Glow Plugs And Gpr Replaced
I replaced the glow plugs and gpr and the truck won't start. I'm also having to replace the water fuel separator. What is going on? 1999 F250 7.3l ....
View 10 RepliesFord 6.0L Power Stroke Diesel :: How Long Glow Plugs Stay On During A Cold Start
How long do the glow plugs stay on during a cold start? Do the glow plugs stay on during the first few minutes of running?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Code P1393 - Glow Plugs On Driver Side Are Not Working
I am having a difficult time trying to track down the root cause of a P1393 code in a 99.5 7.3. The code means all the glow plugs on the driver's side are not working. I don't have any other codes related to the glow plug system present in my computer.
I've replaced:
1)The Glow Plug Relay (I have the CA version with the shunt)
2)Valve cover gaskets and wire harnesses
3)Glow plugs
I've used all OEM product replacements.
Additional testing:
1)Voltage on the glow plug relay posts going to the left and right bank is the same (I think this means the shunt is okay)
2)Disconnecting the wire harness to the valve covers yields 12 volts at all 8 glow plug connections during the glow plug cycle
3)In one of the steps of a troubleshooting document I found, it requires a KOEO On-Demand Self Test. It does not complete and ends with a P0605 code, "Internal CTRL Module ROM Error" using a Snap On Scan tool.
4)Using the Snap On scan tool to run a glow plug test results in "Test has aborted 64 - Abnormal Exit without result".
5)I checked part of the wiring loom and it seemed to be good.
Is there a way to test the wire that goes from the Glow Plug Relay on the driver-side bank to the PCM? I think that either this wire is bad, or a bad PCM.
Ford 6.0L Power Stroke Diesel :: 2006 - Failed Glow Plugs And Engine Flutter In Upper Gears
I've recently gone through and replaced all 8 of my '06 6.0's glow plugs as the check engine light has successively come on (I first did #3 about a year ago, then #5 seven months ago, #1 and #7 two months ago, and #2, #4, #6, #8 about two weeks, did all 4 on the drive side even the code was only for #6). A light came up for #1 again today, so I'm wondering would this be symptoms of failed glow plug control module? Also, can a failed module cause the glow plugs to fail prematurely? Haven't had a chance to ohm the plug yet.
The truck has also has been hard to start when cold and had a pretty bad engine flutter the past 8 months when cold at medium range rpms in the upper gears (1500-2000 rpms in 3rd, 4th, and 5th gear and accelerating like a grandma). I don't know if it could be glow plug related, or a bigger issue (I did the EGR/Oil cooler myself about a year ago as well and things ran good until the winter hit). If I plugged the truck in over night over the winter, the flutter was not nearly as bad, but now it's summer and it's still not liking the cold take offs.
Malibu - Chevrolet :: Turn Signals Work Periodically
I have a 2003 Chevy Malibu - periodically, they turns signals decide not to work. I don't know that one thing in particular causes them not to work. What could be the issue and is this something I can fix easily (I'm a novice), cheaply and quickly myself?
View 2 RepliesChevrolet - Malibu :: 2010 - Dashboard Lights Will Periodically Click Off
I have a 2010 Chevy Malibu with @23,000 miles. The dashboard lights will periodically click off. At this point the numbers on the speedometer, gas gauge, etc., are not visible.
View 2 RepliesMalibu - Chevrolet :: 2004 - Power Steering Periodically Going Out While Driving
My wife drives a 2004 Chevy Malibu and for the past year has had issues with the power steering periodically going out while driving. It has primarily happened when making turns at lower speeds <45 MPH and a dashboard warning will flash power steering when it happens. The temporary fix has been to pull over, turn the car off and back on and it corrects itself, but when taken to mechanic nothing registers as wrong. Was not as serious of an issue when it happened at low speeds, but the other day it happened at freeway speed. Nobody seems to have a solution, including Chevrolet.
View 3 RepliesChevrolet :: 1948 - Water Periodically Quit When Coasting Downhill?
The following issue has been stumping every mechanic that I have talked too. We have a 1948 Chevy with a 350 ram Jet and 700 R-4 transmission. The water temp while on the road runs about 180, and up to 195 in town. The following is the problem. When coasting down a hill it will periodically quit, like the key was turned off. I have to through it in neutral, start it, and then put in drive while rolling. It never has done it at idle, on straight a ways, or up hill. No, I can’t avoid going down a long hill sometimes.
View 18 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Won't Fire After Glow Plug Replacement Unless Plugged In
I just replaced the glow plugs, gpr, valve cover gasket and harness. When cooled down, cranks but won't fire. Smoke DOES come out the tailpipe. If I plug it in for awhile it fires right up. What else can I do or check?
View 5 RepliesFord Ranger / B-Series :: New Plugs Now Truck Running Rough
Although my lil' truck (2006 Ranger XLT, 2WD,with 4-cyl / 5spd, and 115K miles) has been running just fine since I bought it about a year & 5K miles ago, I suspected it still had its original spark plugs and I figured I should change them before problems arrived.
As I suspected, the plugs that I took out looked to be original. I measured their gap and they all had excessive plug gaps - around 0.052" gap. I installed the four new AUTOLITE APP104 (double platinum) and checked their gap, and they were a bit tight at 0.042". My book says they should be at 0.044" gap. But I installed them at 0.042 anyway, figuring they'll burn wider in time.
One by one, I smeared a small bit of never-seize on the plug threads & at the plug-to-cyl head tapered edge. I smeared a dab of Dielectric Grease around at the top of the plug to ease the plug wire re-install and hopefully calm any possible arching. The plug wires came off the plugs easy enough and went back on just as easy.
I hit the key and the engine fired right up. It idled rough as expected. However, it continued to idle rough and if I raised the RPM level, it would respond, but still ran rough. It is throwing a 'Check Engine Light' on the dash cluster now - whereas it wasn't prior to the new plugs.
Ford F-150 - 1997-2003 :: Replaced Plugs / Coils Now Truck Won't Start
Yesterday I decided to tune up my 2003 5.4 for the 1st time at 82k miles. I replaced all 8 coils with MSD coils & motorcraft plugs. After doing so I went to turn over the ignition & got 1 single click, motor wouldn't even turn over. Battery is 3 months. Truck ran just fine prior to tune up other than the slight misfire I was starting to get.
When I was working on the passenger side I did disconnect the big bracket that had the multiple wire harness on the fire wall underneath the starter solenoid to gain access to the rear plug/coil. Where to start troubleshooting? I checked the fuses under the hood & dash but nothing looked blown.
On a side note I remember when I was putting everything away I tried to lock the truck with the Ford factory transmitter & it wouldn't lock?! I had to open the door & press the power lock button to lock the doors.
Impala - Chevrolet :: Changing Spark Plugs But Can't Get Grip On Rear Bolts?
I am trying to change spark plugs and wires on my 2001 Impala with a 3.8 liter. I was able to get the boots off of the front plugs OK but I am having trouble getting a good grip on the rear ones. It seems like they have glued themselves to the plugs. Removing the boots?
View 10 RepliesFord 6.0L Power Stroke Diesel :: Truck Lost Power And RPMs Dropped Only Glow Plug Light Came On
It's a 2004 6.0 excursion with about 190,000 miles. At 185,000 I pulled the motor and did new oem head gaskets, Arp head studs, bulletproof egr cooler and oil cooler system, bulletproof 48v ficm, strictly diesel regulated return, and I've been running gear heads srl tune before and after the truck was rebuilt.
Recently the truck has been acting up at random times. While running the gear head srl tune, the truck will lose power, the boost gauge on my edge insight will get stuck along with Icp psi, the water in fuel light and glow plug light will come on, and then after a few seconds it will clear itself and run fine. Last night I was on a two lane road and putting my foot into it and the truck did the same thing where it loses power, but this time the truck actually died on me while I was cruising at 60.
Same lights were on but this time the cruise control light fluttered while the truck was in the midst of dying. I tried restarting it and it took two sets of cranking before it fired and stayed running. On the way home I babied it and the truck lost power and the Rpms dropped and only the glow plug light came on. Got home and ran codes and I got camshaft and crankshaft position sensor codes and I tuned it back to stock, drove it around, and the truck ran fine, but while on a stock tune I am getting a egr valve code.
Ford F-150 (2004-2008) :: 5.4 Liter Truck - Spark Plugs Coming Loose
I have with my F150 5.4 liter truck. I had the spark plugs replaced about 1 year ago. since then I have had 2 plugs back out and come loose. I would smell a faint gas smell first that would tell me know that it was happening. the first plug was if memory is correct either number 8 0r 7 on bank 2. this time its number 2 on bank 1.
I hope that my mechanic just did not torque the plugs correctly and all I have to do is tighten them. If that's not it. Could the spark plug holes be stripped and have to be re-threaded? And if so how us that done?