Ford 7.3L Power Stroke (1999-2003) :: F250 Won't Start After Glow Plugs And Gpr Replaced
I replaced the glow plugs and gpr and the truck won't start. I'm also having to replace the water fuel separator. What is going on? 1999 F250 7.3l ....
View 10 RepliesFord 6.7L Power Stroke Diesel :: CEL Code P263C For Glow Plug Driver Performance
CEL came on in my 2013 6.7L with 74K miles a couple days ago. Pulled the code today and it was a P263C - Glow Plug Driver Performance code. Any remedy for this.
View 8 RepliesFord 6.0L Power Stroke Diesel :: Glow Plugs Failing On Right Bank
About a year or so ago, cyl 5 glow plug failed. 6 months later number 1 failed. Now number 3. I seem to remember someone mentioning that the module can sometimes cause produce similar problems. Are there two circuits in the module, one for the left and one for the right, or just one circuit for both? 167K on it so it doesn't surprise me that they fail but just odd that they are all on the same side.
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Code P0670 - GPCM Glow Plug Control Module Control Line Failure
How to fix SES P0670?? I understand there's a whole procedure on checking fault.
P0670:GPCM Glow plug control module control line failure. Open/grounded circuit, open/shorted GPCM, failed PCM
But how did you resolve problem? replaced GPCM, found open circuit, short --if so where?-- or replaced with updated harness.
(4C3Z-12B568-AA connector upgrade kit as in picture)???
Ford 6.0L Power Stroke Diesel :: Disable Glow Plugs While Testing Trailer Wiring?
I drained my batteries enough that I needed a jump after the last time I was troubleshooting trailer wiring, since I keyed on a bunch of times. What fuse or relay do I need to pull out next time? I'm thinking of pulling fuse 302, HFCM relay (or fuse 7 in the disto box under hood) to disable the fuel pump, but what fuse or relay is for the glow plugs?
View 2 RepliesFord 6.0L Power Stroke Diesel :: How Long Glow Plugs Stay On During A Cold Start
How long do the glow plugs stay on during a cold start? Do the glow plugs stay on during the first few minutes of running?
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2006 - Failed Glow Plugs And Engine Flutter In Upper Gears
I've recently gone through and replaced all 8 of my '06 6.0's glow plugs as the check engine light has successively come on (I first did #3 about a year ago, then #5 seven months ago, #1 and #7 two months ago, and #2, #4, #6, #8 about two weeks, did all 4 on the drive side even the code was only for #6). A light came up for #1 again today, so I'm wondering would this be symptoms of failed glow plug control module? Also, can a failed module cause the glow plugs to fail prematurely? Haven't had a chance to ohm the plug yet.
The truck has also has been hard to start when cold and had a pretty bad engine flutter the past 8 months when cold at medium range rpms in the upper gears (1500-2000 rpms in 3rd, 4th, and 5th gear and accelerating like a grandma). I don't know if it could be glow plug related, or a bigger issue (I did the EGR/Oil cooler myself about a year ago as well and things ran good until the winter hit). If I plugged the truck in over night over the winter, the flutter was not nearly as bad, but now it's summer and it's still not liking the cold take offs.
Ford F-150 - 1997-2003 :: 1999 - Driver Side Power Window Not Working
The drivers side power window in my truck is up and will not lower. I took off the interior/trim panels. Accessed the power connector for the window motor.
I can hear the relay cycling. when I put a meter on the power connector, I get voltage applied for the "up" condition, no voltage for the "down" function.
Sounds like a bad relay to me. What say the wizards? Where is the relay located?
Ford 7.3L Power Stroke (1999-2003) :: Glow Plug Change / Oil In Turbo
I'm getting ready to change the glow plugs in my dad's e99, 196k on the clock. When I pulled the air intake tubes I found some oil in the turbo:
The inlet tube also had a bunch of gunk in it too:
Does this look like it is caused by the PCVor is it a bigger issue?
Ford 7.3L Power Stroke (1999-2003) :: Re-torque During Glow Plug Replacement?
I will be changing all the glow plugs in a few days. Should I re-torque the head bolts or anything while I am in there? Don't want to button it back up and then wish I had done something while in there.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Glow Plug Bypass With GPCM?
I've read what little information I can find about making a glow plug bypass, but everything so far applies to trucks with glow plug relays. Since mine is an Excursion I have a GPCM instead of a relay. How I might accomplish this?
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: 1271 Injector Code - High Side To Low Side Open Cylinder 1
I've got a 1271 code and I can't seem to make it go away. Code definition is "High side to Low side open Cyl 1". The truck runs fine, no rough idle, no excessive smoke of any color, just the damn CEL light stays on. I check the UVCH and all the injectors ohm in at 2.7 ohms. I've already done the updated clips under the covers. I run all the buzz tests and KOEO/ KOER tests and all appears OK. My AE won't do a Cyl contribution test. All the injector data shows all 0.00. I know its not that perfect. "high to low open", does that mean I've lost a ground? If so where?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Broken Glow Plug Outer Wall
Well I just "did" the glow plugs on my recently acquired 99 7.3 and while 7 came out with no problem, one of them gave me more resistance when turning than expected and then "snap". Now here is the interesting part. What actually came out is the threaded top portion of the outer wall, while the rest of the outer wall and the electrode are still in the block. I have done a lot of searching and it seems that usually the electrode detaches from the outer casing and the entire outer casing comes out with only the electrode or part of the electrode stuck in the shaft (usually due to carbon buildup or swollen tip). In this case though, the outer wall of the plug sheared in two, which seems to imply that the outer wall itself is what is stuck in the shaft and not the electrode. The attached picture hopefully explains what I am trying to say.
I can easily latch on to the end of the electrode with some vice grips, but even if I managed to get that out, I would still have the outer wall of the plug in the hole. At the moment I just screwed the threaded part back in to keep the everything from blowing out so I could crank the truck. It cranked right up and seems to run fine. My inclination is to just leave it as is and hope that 7 good glow plugs will do the job, as I have some nightmares about making things worse in trying to make them better. Any chance of the electrode falling into the cylinder if this much of the outer case is still there? How to remove stuck electrodes, etc. but none on a stuck outer casing?
Ford 7.3L Power Stroke (1999-2003) :: Glow Plug Control Module Function?
OK, what does a glow plug control module do? The short bus I got has one on it. It looks like it fits right into the circuit without much, if any, modification. I got one with my short bus and am curious if it would be something worth adding to my pickup. So...what does it do and could I/should I install it?
View 4 RepliesFord 6.0L Power Stroke Diesel :: Glow Plug Code And CEL Code P0675
Truck has been running very well while in the warmer North Carolina climate pulling trailers with no limp mode or wrench light. However, when daughter started the truck this morning, SGII showed one DTC and when she pulled it up it was P0675. OK, glow plug num 5 maybe or the module. No issues starting or rough cold idle. I told her to clear the code and we'll see if comes back.
She did ask if it is something she should have it repaired before the trip back to Vermont. So I thought I'd ping the group here since reading posts, they seem to be fairly easy to replace (and assuming it isn't a chafed wire) and I could probably save her some $. Just want to make sure there isn't any chance of real engine damage.
Ford 7.3L Power Stroke (1999-2003) :: Driver Window Switch Not Working?
New to these trucks so a quick question on the window switch controls. I put power to the truck for the first time in about 8 years. First thing i wanted to do is see if the power windows worked. Everything went down very nicely but getting them back up was a no go from the driver seat. They all worked well seperatly but not from the pilots seat? Is it a typical issue with these trucks? When rocking the switch I can hear a relay under the dash panel close to where the access panel for the fuses. Mirrors work as well as do the locks. I pryed up the switch panel and un plugged it and reinstalled it with no luck. As it is I cant get the driver side window up or the passanger window up from the driver side?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Different Battery Box For Driver Side?
Is there a different battery box or better battery holder for the driver side without all the air filter housing stuff. I had an AFE Big boost filter and when I modified the stock battery box it still had the bottom section of the air filter compartment well after about 4-5 years I was cleaning the filter today and there was a hole rubbed in the filter from moving around and the pre filter is getting holes wore through it. So I cut the air box part off so now the filter will sit on the fiberglass stuff on the fender well. I ordered a couple of the new Blue Donaldsons from RiffRaff to replace the Big Boost filter. The modified filter box looks kinda like a hack job because all I had was a cut off wheel and the plastic got hot and now I have melted buggers all over it. I thought I saw somethin a long time ago about a battery holder out of a van that was just the bottom plate but can't find it anywhere now.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Won't Fire After Glow Plug Replacement Unless Plugged In
I just replaced the glow plugs, gpr, valve cover gasket and harness. When cooled down, cranks but won't fire. Smoke DOES come out the tailpipe. If I plug it in for awhile it fires right up. What else can I do or check?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 E450 - No Ground To Glow Plug Solenoid?
I have no ground to glow plug solenoid, wiring is ok right up to the computer. Where I should go from there?
Its a 2001 E450 PSD. glow plugs not coming on at all.
should I be checking an engine temp sensor?
I don't have a wiring diagram so I am going in somewhat blind. ]