Camry :: 2010 Manual Transmission - Hard Shifting Into 2nd Gear
Just curious if there are any other 2010 owners with any difficulty shifting gears in their manual transmission camrys? I noticed during my test drive that I grinded my way into 2nd once... I thought it might have just been my nervousness with a new clutch at the time. However, I've since put 300 miles on the car and I still have trouble putting it into second gear on a daily basis. Sometimes it grinds a bit, and sometimes it catches or a half second before it pops in. All the gears OTHER than 2nd gear go in like butter as you would expect with a new transmission. I'm not new to a clutch... this is at least my 4th car with a stick, so I don't think I'm doing anything out of the ordinary when shifting.
It reminds me of some older (100,000+ mile Nissan) cars I've had in the past... the syncromesh was wearing out and it would grind going into second or third, so I put in some RedLine MTL and got a little more life out of the transmission... but there shouldn't be a need for that kind of thing on a car with less than 1000 miles on it?!
Toyota - Camry :: 1991 - Transmission Leak / Bumps Into Gear On Hard Acceleration
I have a '91 Camry that's my daily 50 mile round trip commute car. It runs well and still has lots of pep at 156,000. There are oil and tranny leaks (tranny leaks around the pan seal) but I check the levels and keep everything topped off. Tranny fluid and filter were changed about 20K miles ago. I am the original owner. Shifting is OK unless I accelerate hard, then it "bumps" into gear. On hard acceleration it is a pretty good bump but if I back off the gas it shifts much better. There are no other symptoms, at lower speeds it shifts fine unless the A/C is on, then I get bumps above the 1-2 shift. What the problem is?
View 3 RepliesFord - Focus :: 2001 - Brake Pedal Feels Hard / Transmission Hard To Shift From 1st To 2nd Gear
Could my brake issue be related to my transmission problem? Neither are constant. Brake problem= sometimes the brake pedal feels hard, like there's no power brakes (I drove a car once. ..looong time ago. .. that had no power brakes or steering) but it will kick in after a short distance. Transmission prob= seemingly unrelated, is a problem shifting from 1st to 2nd gear. This has happened maybe a 1/2 dozen times, the first time and mostly when in heavy commute traffic and when going between 1st and 2nd gear because of the slow commute speed, but also at other times when not in lengthy slow commutes. When it doesn't shift, the odometer doesn't work (shows only dashes) and an engine light comes on (the sprocket/gear looking one). Usually the transmission will eventually shift and the light goes off.
I read that the brake problem might be a vacuum hose problem? Something about a booster? Is this dangerous? or is it like having a car w/ no power brakes? Going to have my transmission looked at this week. Read on another site about dropping valve seats on this year car. If there's a major transmission problem, I'm wondering if it's worth fixing? I changed, timing belt, water pump, front and rears brakes, tires. 143,000 miles.
S-10 :: Transmission Hard Shift Into 2nd Gear?
I get a hard shift into second gear, it jerks into 2nd but not all the time. I only notice it after driving on the freeway for several miles. It has 60,000 original miles. Service Engine Soon light come on after the hard shifts with a transmission fault code. I reset the Engine light and let it set 20 or so minutes and it shifts like new.
1997 CHEVROLET TRUCK S10 2WD
6 Cylinders 262 X 4.3L SFI
Automatic
Ford Transmission :: Hard Shifting From 1st To 2nd Gear
Have a 2000 expedition with 84,000 miles. Tranny seems to shift hard from first to second gear. Its been 24,000 miles since my last dealer tranny service. Thinking of getting a new service now before the recommended 30,000 manual recommendation. Whats happening?
View 6 RepliesChevrolet - Avalanche :: Transmission Shifts A Little Hard Going From 1st To 2nd Gear
Have a 2002 avalanche Z71. Transmission was rebuilt 33k ago. It currently shifts a little hard going from 1 to 2nd. Real problem shows up between 40 mph and 50 mph. It suddenly shifts into overdrive which drops the engine rpm waaay down and starts lugging the engine.
Took it back to the guys who did the rebuild. They drove it around and noticed that the computer reported no codes. They claimed it was the TPS and said to replace it. I did. Problem is still there.
Took it to a highly trusted mechanic. They said they think the valve body needs replacing but they don't do transmissions. The guy they recommend drove it around and he thinks it is the torque converter.
I am wondering what causes the computer to decide when it is time to shift into overdrive and I am wondering if there is some sensor that has gone whacko and needs to be replaced instead of starting to tear the transmission apart.
Passat (B5) :: 2002 - Transmission Hard To Shift To 5th Gear At 37 Mph
At 37 mph and transmission shifts to 5th gear a violent shift occurs. The fist time I thought that I had hit a cement block! It only happens in triptonic or if I leave the shift lever in 4th gear and exceed 55Mph. My local VW dealer said a new Transmission would cure it.
View 8 RepliesBuick - Rendezvous :: Transmission Shifts Hard Sometimes In Every Gear
130,000 miles transmission shifts hard in every gear sometimes other times it is completely fine. Thought about servicing it with new fluid, filter, flush but have heard that this could cause problems since so many miles...
View 19 RepliesLexus GS 2006-11 :: Transmission Hard - Jerking While Shifting To 2nd Gear
I have a 2006 GS RWD the transmission started acting weird 4 month ago went to many workshops and no codes were found in the computer and my problem is that when i am moving in the car for more than half an hour and stop the car seems hard and jerking while shifting to 2nd gear and if i put it in tiptronic it go to 5th gear immediately it seems ok when the transmission is cold so what do you think it has got 125000 miles on it and what is the normal temperature for the transmission so i can test it with mini vci...
View 7 RepliesAccent MC (2006-11) :: Manual Transmission - Hard To Shift From First Gear Sometimes
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
Santa FE SM (2001-06) :: Hard Jolt When Transmission Up-shifts From 2nd To 3rd Gear
I have a 2003 Santa Fe 3.5l FWD 155k miles. Car has been incredibly trouble free until now. When the transmission up-shifts from 2nd to 3rd there is a hard jolt. All other up-shift and down-shift points work smooth. Occasionally will shift smooth just after I start the car or if I am accelerating hard. The rough shift happens whether I am in D or use the "manual" shift control. This coincidentally(?) started just about the time I had a battery die hard and an O2 sensor fail. Both have been replaced. Changed the AT fluid and no difference. No engine codes, but I think the AT codes don't show there? What might be going on? Any chance the battery failure had anything to do with this? Seems odd that battery, O2 sensor and transmission all start acting up at the same time.
View 5 RepliesChevrolet - Blazer :: 1998 V6 Transmission Shifts Hard Out Of First Gear
I have a 1998 chevy blazer v6 about 127024 miles. My transmission shifts hard out of first gear when i get to 4 gear and it shifts hard. When car warms up really good car shifts find out of first gear but 4th gear still shifts hard. I did change transmission fluid and new filter in it and I check fluid level and it's full.
View 6 RepliesCorolla / Matrix 2009-13 :: 2011 Transmission Shift Hard From First To Second Gear?
My Toyota corolla 2011 started to shift a bit hard from first gear to second gear and sometimes it feels a bit like choking since November of last year after I started to commute about 38 miles to work. It happens when I am taking off and going straight and it doesn't happen when I am turning left or right. I have taken it to the dealer once, they reset the transmission computer, but it still felt the same and the way the other gears shift felt a bit differently.
I have seen a similar complaint about the same issue of gear shift from first to second in the NHTSA website and another forum with the same issue with a 2009 corolla with a seemingly loose motor mount.
Ford Transmission :: 1997 E350 - Hard To Move Gear Selector
I am just about committed to purchasing a 1997 Ford E350 extended cargo van with the 5.4. The transmission shifts through all the gears nice and firm (reverse also works). The only issue with the van is the column selector lever is very hard to move between the entire range of PRND21. It also does not "click" into the selected positions, you have to just line up the pointer to the desired gear selection.
Is this a complete deal breaker (internal transmission issue/replacement necessary) or, is it something relatively simple (such as a worn selector cable). The owner did admit the van has been sitting for sometime. It has 134,000 miles on it.
Ford Super Duty (1999-2016) :: Transmission Shifting Hard Between 2 And 3 Gear
The tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 RepliesFord Transmission :: 1997 F250 - Shifts Very Hard And Sometimes Feel Like It Slips Out Of Gear
My 1997 F250 Heavy duty shifts very hard and sometimes feel like it slips out of gear (i press the gas pedal to the floor and speedometer rises very slow and truck doesn't move like it should.
View 14 RepliesFord Ranger / B-Series :: 2000 / 4R44e Transmission - Hard Shift From 2 - 3 Gear
2000 Ranger 4R44e transmission.Hard shift from 2-3 gear and when i run about 35-40 mph and brake then acelerate it downshifts hard . Whats wrong with it?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Transmission Slammed Hard Into First Gear And Sometimes Will Not Upshift
Everything was fine, running PHP 200X tune, switched to PHP 65 tow and took the 5er toy hauler on vacation last month. Pulled a lot of mountains,etc. While camping, took the truck unloaded to get fuel. Engaged tow/haul going down a mountain to utilize engine braking and the tunes "exhaust brake" and the trans slammed HARD into first gear. This happened twice. I refrained from using tow/haul. Heading home 450 miles with the 5er, I utilized tow/haul again (had it on the whole time, just like on the way down) and the truck and trans were flawless. Get home, switch back to 200X, and I'd say within a week or so, began having trans issues. Loaded stock tune, reset KAM with SCT, disconnected batteries with headlight switch on for a couple days, reloaded 200X and drove it for a couple days. No change.
It felt like the trans was slipping, not "going" like it should when on the throttle, and would sometimes not want to upshift. It would just act "weird". This would usually occur under 40 - 70% throttle (I rarely ever get on it more than that), but sometimes less. Never got any check engine light or tow/haul flashing.
So today I finally did what I should have weeks ago, took off work and ran the truck to a shop.
- First the tech hooked it up to the scanner. No codes.
- Test drove it. He said it drove fine for him. It was fine for me as well, driving it from my house to the shop (I didn't "get on" the throttle though).
- He monitored the voltage from the trans temp sensor. He said the voltage was fine, didn't spike or do anything crazy. He didn't seem 100% positive on this but, said it starts out at 5V cold and voltage should drop as the temp increases, which it did. However, the temp started out at 300 and then dropped to 200 as he was driving. #1 the temp isn't (shouldn't be) that high, and #2 it should increase while driving not drop. The temp shown on my Torque Pro app hit 149 on the way to the shop and 168 on the way home (90 degrees outside). So he seemed to think there was something screwy there.
- While driving it, his scanner showed a trans overheat (over temp/high temp, whatever) code, but no check engine light or tow/haul flash.
- Drove it home. Trans was fine until I got on it a bit and then it acted funny again. But just driving normal with light throttle it is fine.
* Thinking about trying a new temp sensor.
* Could it be in limp mode which is why it feels like it is slipping, i.e. doesn't have the normal power I'm used to?
* When the tow/haul light flashes, is it the tow/haul light on the instrument cluster? That's the only thing that lights up when I'm in T/H. Where you push the button never lights up. Assumed it was just white lettering and not a light.
Ford 6.7L Power Stroke Diesel :: Automatic Transmission Hard Shift Second Gear
Well I've been towing for almost 150,000 miles with a 2012 6.7 Lariat 4 wheel drive. Things have been going pretty well with the truck. I noticed some sluggish and indecisive type shifts early on but now I'm worried. I depend on this truck for pulling a horse trailer all over the country and Canada. Just recently I've been getting a hard shift or a thump or a clunk when shifting up or down in to second gear. I'm at about 152,000 miles and did a hot flush with LV ATF at about 148,000 miles. Should I worry or keep running?
I have a 97' PSD I'm thinking of giving a nice paint job and a flat bed but am reluctant to do so due to financial concerns and the fact that some folks may not want to see me pull up in an old truck no matter how nice it looks. My tranny temps have been stating under 200F and I really keep an eye on the temps when running up and down the hills while towing. The trailer is a 35' Gooseneck with a max GVRW or 14,000 pounds. Should I wait for the tranny to grenade and then drop in a built tranny and if so who's building these tranny's stronger than stock? Long time no see but this site has always been my go to for all my Ford truck questions, upgrades, etc.