Camry :: ABS Light Is Coming On And Off - Reluctor Ring?
My abs light is coming on and off. It turns out the ABS ring on the right hand side has some damage on some of the teeth. Is it possible to just replace the ring? and how hard of a job is it? I tried searching and could not find anything on this part.
View 4 RepliesLexus GX 2010+ :: Outer Ring Is In KM And The Inner Ring Is In MPH
I bought my wife a 2011 GX460 from Lexus. On my way home i realized the car was in KM not MPH. The outer ring is in KM and the inner ring is in MPH. The dealer thought they were going to be able to change but turns out they can't. I'm at a crossroads, what do i do. They offered to try and find a new car or i keep the car and we work out a deal of some sort. If i keep the car will i run into other issues with it being from Canada. So, what makes a 2011 GX460 from Canada different then one from the US ?
View 14 RepliesCamry 2012+ :: 2013 SE Not Blowing Any Air From HVAC System
I have a 2013 Camry SE that is, out of the blue, not blowing any air from the HVAC system. I checked the 2 A/C fuses any they are ok. The lights light up on the control panel like normal and the rear window defogger works correctly, so I don't think it's the control panel. I can't find any fuses or relays relayed to the blower motor in either fuse box.
What else should I check? The car is still under warranty (for a month!) but if it's a cheap and easy fix, I'd rather save the hassle of giving it to the dealer for a day and fix it myself.
Camry :: Burning Smell Through HVAC System After Braking (02 SE V6)
Our 2002 Camry SE V6 incurs a burning odor through the HVAC system after braking from moderate or higher speeds (at low speeds, this does not happen). It can last for a few seconds or a few minutes and then goes away (it does not happen while in motion). I cannot smell anything outside the car.
The car was inspected & serviced two months ago with no issues found. The front valve cover was replaced about a year ago but the back valve cover was OK to leave as is.
I would want to say it is the brakes or the snow tires causing the odor but it is strange it only smells inside the car.
Camry :: How To Open HVAC Knob Controllers / Changing LED Lights
In the sticky post on the LED lights and how to change them. I was able to open the radio and removed the 8 green caps that was covering the radio's blue LEDs. I love the result.But the front of the HVAC knobs still shows the retro cyan color. I think it's the same blue LED with the green rubber cap over it. I tried opening it but failed. I didn't want to break anything. I want to go back and take a look at it again.URL...(Yes, the neo wedge bulb on the HVAC position indicator (left-most; Off, Low, ..., High) is out, I need to order some more. Originally, they were orange I think. I prefer blue. The green indicators in front are working fine.)
I had the bulbs replaced more than a year ago, but now I'm tired of looking at the retro cyan color. How to open it without breaking the parts inside?After unscrewing and taking the center console out of the car, I am able to isolate the radio unit from the HVAC controller unit and open it to reveal the circuit board, but I could not separate the HVAC knobs from the board. I don't know if the HVAC are soldered to the board or not, so that's where I stopped.
Camry :: 2002 LE - All HVAC Function Stopped Working From Standpoint Of Air Blowing
My buddy has a 2002 Camry LE(?), without Automatic Climate Control. He had experienced the flashing A/C light like many others, but his solution to the problem was to direct-wire the compressor to the battery. Seemed to work fine, and the compressor still works. Fast-forward to two weeks ago. All HVAC function stopped working from the standpoint of air blowing. No outside air. No A/C. No heat. AND no rear defroster. He replaced the Magnetic Clutch relay tonight thinking it might have something to do with the problem, but that did not solve it. We checked the blower motor, and it only has 0.01V going to it when the air is on. We're getting no sound of anything going on in the cabin.
View 14 RepliesFord Excursion :: Overhead Console Light Sockets Broken Copper Ring
Looking for a replacement part for the Copper Ring that bulb screws into? Attached is a picture I copied from a previous post. Notice the copper ring. On mine 2000 Excursion one of these rings is broken.
View 14 RepliesGolf V R32 :: Placement Of Oil Filter O-Ring
I have been reading the forums and am quite curious at to the placement of the small O-Ring on the shaft of the filter. It has been said to remove it even though the filter has a dedicated groove for it. That goes against logic as I would think the shaft should seal to allow proper flow through the filter. I would think without the O-Ring flow could not be controlled. Also I have never seen such a dedicated way to ship a loose part. All pictures of the filter show the O-Ring in place on the shaft. It seems to me when I changed my oil I removed the original filter small O-Ring and used it to replace the drain plug O-Ring.
View 17 RepliesCelica :: O-ring Oil Leak When Engine Turn On And Accelerate It
I have a 3SFE 1997 engine. I've installed a Toga HV oil pump. My engine also has an oil cooler. But when I turn on the engine and accelerate it oil starts shooting out of the oil filter. When I remove the filter it has blown out the filters O-ring. I use 5W-30 since I've rolled it of the show room. What can it be?
View 4 RepliesPassat (B7) :: Seems Like Small Ring Creeping From The Outer Edge
[URL].............
Happening to all 3 cars. All 2012
2- Passat Se 2.5L 60k/40k miles
1- Jetta TDI 65k miles
Shown driver rear rotor on Passat ( was cleaning Abs speed sensor ring)
Started about 35k miles on each car as a small ring creeping from the outer edge. Backside has maybe 1/4-1/2" clean braking surface.
Slide pins moove free and smooth
Pads were not seized
Caliper isnt seized
Notice the different ridges on the inner pad.
Obviously I want to replace the pads and rotors but before I do. I want to figure out the source for this disease so keep from prematurely replacing them in the future.
Dodge - Ram :: 1997 - White Ring Around Tire Sidewall
Well, I bought a 1997 Dodge Ram 1500 pickkup. It has 121,000 miles. The guy wanted $2800, but I talked him down to $2300. I think that will work out well. One question, though. One of the tires has a white ring going around the sidewall. I have heard of whitewall tires, but this is not an attractive white wall. The edges of the white are all jagged and peeling. What causes this? Was this tire originally black and the black peeled away exposing a psuedo-whitewall? Any time I've scraped a tire, there was just more black underneath. I don't really know what I'm looking at. Is this tire safe? You can see a pic here: [URL] ....
View 9 RepliesSierra :: Low Speed ABS Pulsing / Grease Between Lobes On Reluctor Ring In Hub
My wife has a Sierra 1500 2WD 6cyl that is doing the low speed ABS pulsing. I read this forum and performed the sensor cleaning as described in the TSB from GM. The problem did not go away, so I pulled the ABS fuse for now. When I was cleaning the sensors - which were covered with crap - I noticed a lot of grease between the lobes on the reluctor ring in the hub. I cleaned it as best I could, but I could not get all of it. My question is - should there be any grease visible on that ring at all? If not, then do I need to replace the hubs? If some grease is ok, then I guess I will do a voltage check on each sensor, but I don't want to change the sensors if they are just going to get dirty again. The problem is on both sides.
View 4 RepliesTiguan :: RCD-510, Bluetooth Incoming Call Ring Is Ridiculously Loud
I recently got a Wolfsburg Tiguan with the RCD-510. When there's an incoming call, the ring is ridiculously loud, yet I still need to raise the call volume to hear the person on the line.
View 4 RepliesFord F-150 (2009-2014) :: Ring Gear Diameter Size?
What size Ring Gear Diameter I have, 9.75" or 10.5"? Probably going to a 4:10 to get some power back after lifting my truck.
Current Axle Ratio: 3:55 LS
Bolt Count: 12
Ford - Mountaineer :: 2006 - Rear ABS Tone Ring Replacement?
replacement of a rear tone ring on 06 mercury mountaineer V/6 . I have a tooth knocked off of my left rear . Just wanted to know if there was any special procedure or tricks to it like heating up the old ring or something to remove it or just soak it with P.B Blaster or something similar and tapping it like a bearing race ?
Never did this or have never seen it being done before and rather ask the questions 1st Had the dealer to quote me 500.00 for a new axle and labor said they are impossible to get off or on they most times split ? Old gear head pre-computer car days
Ford F-150 - 1997-2003 :: 2001 XLT - Size Of Ring Gear
I'm replacing my rear diff cover and didn't realize there are multiple sizes. How do I figure out what the size is of my ring gear?
2001 F150 XLT 4x4 SuperCrew, 5.4L
S-10 :: 1992 Blazer 4WD - Remote Oil Filter Line Leak At Adapter O Ring
I noticed a drip on the remote oil filter adapter connecting block, it was appearing from the seam between the block with the supply and return lines to the oil filter and the engine adapter. I purchased a gasket set and replaced the two O rings, the old ones were hard and flat. The new ones are soft and round, I thought that would stop the seep, but there was no change. So after removing a few more times and cleaning, even substituting a slightly different size O ring with no change in the drip. The two aluminum blocks are held together by a 13 mm bolt. It is a 1992 S-10 Blazer 4WD 4.3L. None of the crimps are leaking.
View 3 RepliesGolf IV / Jetta IV :: Remove Immobilizer Induction Ring From Lock Cylinder
i have a car with a busted out steering column (drunk PO lost the key and tried to screw driver the ignition to get the steering to turn so he can move the car). i ordered a new key by vin and i managed to find the tumbler casing(damaged) but all the tumblers (still in good shape). i have installed another column in the car now and i pulled the lock cylinder assembly with the immo induction ring out. id like to take the tumbler casing out of the induction ring and put in my old tumblers.
how do you remove the immobilizer induction ring from lock cylinder?
Civic - Honda :: 1996 - Piston Ring And Head Gasket Replacement
Ive had both the piston rings and head gasket replaced on my 96 civic. This isn't for high end upgrades or anything just because i need to pass smog and both needed replaced. I am being told that once i get my car i should drive slow for 100 miles before i take it to smog. Ive read many different opinions on seating the rings but all are for people upgrading their car. I am sure I just got normal replacements.
View 19 Replies