Ford F-150 (2009-2014) :: Gas And Brake Pedal Adjustment
I just purchased a 2011 F-150 XTR and i noticed the pedals very close to me and i know it does not have electric positioning and it appears that looking at it, it can be adjusted manually..
View 10 RepliesLexus LS 2007+ :: Brake Pedal Height Adjustment - Any Way To Reduce An Inch Or So
Perhaps a strange question, but is there any way the pedal height can be decreased. On my 2010 LS 460 it seems to be higher than on my previous 2005 LS 430 to the extent that I lift my foot off the accelerator pedal and miss the top of the brake pedal. It's happened often enough that I've been wondering if it could be reduced an inch or so.
View 1 RepliesCamry :: 1992 - Changing Rear Brake / Adjustment?
Changing brakes on the 92 camryHow do i adjust them ??They have the auto adjuster but can i get them close before i put the hub back on or is it go in reverse and keep hitting the brakes.I used to know but i forget
View 19 RepliesFord Super Duty (1999-2016) :: 3rd Brake Light And Pedal Adjustment Switch Does Not Work - ABS Light On
Was checking fuses for why my 3rd brake light and pedal adjustment switch does not work. Was also looking for a fuse to tie into so that a light in the cab floorboard will stay on when the headlights or marker lights are on... After trying several spots to no avail (finally putting it into the bright headlight fuse). I got the light to work.... But now my ABS light stays on!!! Also 3rd brake still not working...
View 1 RepliesToyota - Camry :: Parking Brake Barely Holds While In Drive - Adjustment?
05 Camry, 2.4L, 47K. Vehicle parking brake barely holds while in Drive. How is this adjusted? On my 91 Corolla, the brake adjusts itself by pulling up on the handle. The Camry does not have this feature so does this have an adjustable cable? If so, where did they hide this adjuster?
View 15 RepliesCamry :: Adjusting Parking Brake (E-Brake) Pedal On 6th Gen Toyota
I have a 2010 toyota camry that needs a parking brake adjustment. the car still stops with the transmission even if the parking brake pedal is pressed down. I changes the pads in the back and it seems to be a little better, but it's not as good as other Camry's I've been in. Where to look as far as the adjustments go? and possibly how if it's not the usual method.
View 4 RepliesCamry :: 2004 - Brake Pedal Goes Almost To The Floor
My 04 Camry is having brake issues. It has 205k miles. The front pads are great and the back shoes are great. (Drums in back) I've had them adjusted multiple times but my pedal still goes almost to the floor. It's not the master cylinder cause I've already replaced that. The pedal doesn't bleed off either. But I have bled the brake lines and there is no air left in the lines.
View 14 RepliesCamry :: XLS Have Pulsation When Brake Pedal Applied
My Camry XLS have pulsation when brake pedal is applied. The pulsation get increased with the speed and very noticeable at 60 -70 mph.
Is it front or rear break issue ? If you think rotors has to be re-surfacesd should I also change pads ?
Camry :: Brake Pulsation / Vibration On Pedal
My car is a 2004 Toyota Camry LE 2.4L. I've been having a brake pulsation problem with my car for few months. I feel the vibration on the pedal and also on the steering wheel when I brake at high speeds. And also I feel like the pedal goes too low and not responsive enough.
So I took the car to a local shop 3 days ago and they told me that the front rotors are bad and have to be replaced. They installed new Wagner front brake rotors and pads. But still I get the same problems described above. Today I drove on the highway and got the same vibration both on pedal and steering when I apply brakes.
Camry :: Brake Pedal Went To The Floor When Stepped On It
My mother went out 2 days ago to go run errands, she stepped on the brake pedal and it went to the floor (car still in garage and in park, low mileage car 81,xxx garage kept). I have not been able to duplicate the issue. The fluid has been changed twice since new, no signs of fluid loss, undercarriage inspection revealed nothing. I am thinking maybe a vacuum hose issue.
View 2 RepliesCamry 2012+ :: Shake At Brake Pedal
My car is fairly new with 21700 miles approximately. It started to give me a little shake at the brake pedal. I drove to Victorville,CA last night and the shake was strong enough for my passenger to feel! Toyota said its a bad rotor and I have to take care of that because warranty will NOT cover that!
View 5 RepliesCamry :: 1998 - Brake Lights Will Not Come On When Step On Pedal
I recently installed an aftermarket rear spoiler with third light. While searching and testing for a hot brake wire to hook up to, I somehow accidentally shorted out the brake lights. They will not come on when i step on the brake pedal.
I checked the corresponding fuse and it is still intact. The brake light symbol on the dash is "on" so I know the "brake light out" sensor is still working....is there something im missing in getting the brake lights to work again ?
Camry :: Brake Pedal Sinks To The Floor When Braking
A friend brought me a car with the issue that the brake pedal sinks to the floor when braking. She said it was never low on fluid so I replaced the master cylinder and bled all of the lines with a friend pumping the pedal. The pedal would still sink to the floor. I tried vacuum bleeding the brakes and found that the front left consistently had large bubbles.
I Teflon taped the fitting on the calliper and the bleed screw which improved the problem but didn't fix it. I then replaced the calliper. The front left calliper still won't bleed and the brake pedal still goes to the floor. When I bleed it the regular way, the fluid comes out of the bleeder like it bled nicely. Neither of the rubber hoses that connect to the calliper have any visible damage. I had a friend pump the brakes while looking at the hoses and their is no bulge or swelling in them. Could the ABS need to be bled?
Camry :: 2007 V6 SE - Soft Brake Pedal After Maintenance
I have an 07 v6 SE with 220k on the clock. Recently switched out my rear pads with no problem, but still had a small shake under braking - so tonight we pulled the front wheels off and switched the front pads and rotors out - did an oil change while it was there.
On it's first test drive - there's something wrong. The brake pedal travels all the way to the floor and is SUPER soft. It still stops. If I mash the pedal, the car will come to a sharp stop - testing on some sandy roads, the front brakes are definitely working - but the front pedal travel is WAY more than it was prior to the pad/rotor maintenance.
We ran out of light, so tomorrow we're going to get some new fluids and flush the system in case we got air in it.
Camry :: 1998 - Brake Pedal And The Dash Lights Goes Dim
My car sat for 3 months and then I tried to start it. When I turn the ignition on, everything looks fine until I hit the brake pedal and the dash lights dim. If I don't press the brake, the dash light dim when I turn the ignition to crank. Either way the starter either clicks or doesn't do anything and I hear a humming sound. My husband said, "The battery has been charged and measures 12.62 volts," but the cigarette lighter voltage measures 12.26, so they are not the same. I have tried jumping it and I still get clicks.
View 4 RepliesToyota - Camry :: 2005 - Brake Pedal Almost Sinks?
We have a 2005 Toyota Camry, had it since 30K miles/2008, now has 94K miles. Since we have owned it, the brake pedal feel has not been great, kind of mushy. It is the way this generation Camry's are. It gets driven mostly on fwy, so not much brake use. At 92K miles I changed the front pads and rotors, pads still had 30% left on them. The rotors were somewhat warped. Brake fluid has been gravity flushed every 2 years since 2008, last one in 2012.
Now, the problem is when wife drives it, twice at a lengthy red light, she has noted that the brake pedal "almost" sinks. It did not go to the floor, but the level went lower. The car did not move during this events. With the newer ABS brake systems, on all my three cars, after a full stop, I can push the pedal down further, almost close to the floor. The Camry is the same way, just with a baseline of mushy pedals. My wife only drives one of the other ones (Dodge Caravan,)and has not complained about that one.
The brake fluid level is solid/steady, no leaks at the wheels either.
Now looking at whats involved, seems I can change the master cylinder myself. The question is do I need to? I don't mind paying a mechanic to do a diagnostic too, just not sure what they are going to do. I believe, just as a defensive measure, they will go ahead and change the MC (which then I might as well do it myself). I could also continue to drive it, but don't want to be stupid here.
Ford Super Duty (1999-2016) :: 2012 F250 - Parking Brake And E-brake Adjustment?
The problem is I haven't seen one for a recent (2011+) SD. I don't see anything that resembles a rear drum. They look like 2 huge regular disc brakes.
I live on a hill. My old man taught me to put the trans in neutral, autos and manuals, put the ebrake on and make sure it holds the vehicle, then put the trans into park or 1st gear. This way the weight of the vehicle doesn't rest on the transmission.
How do I adjust the Ebrake? It's ALMOST holding the truck, just needs a minor tweak. I don't see the dust cover the write ups described at all. The one that reveals the Star Wheel. Are they different on these years then prior SD's?
Camry :: 2006 LE ABS No Stability Control / Brake Pedal Goes To Floor
2006 Camry LE 4cyl ABS no stability control, rear drum brakes. The brakes stop the car, but the pedal does go to the floor and it doesn't brake with confidence.
Prior to the repairs everything looked normal (aside from one wheel cylinder, see pic) and there was no leakage. The fluid was at the proper level though dirty.
I replaced the master cylinder and did a complete fluid flush and bleed. I also changed the front pads (it was time anyway) and the passenger side brake hose. I was going to to both hoses, but I wound up snapping the steel line on the PS and spent most of the day dealing with that. I decided not to press my luck with the DS.
I might change the DS hose, since I already bought it. At this point the only thing left is a weak caliper or wheel cylinder seal, or a bad hose (though I don't see any visible bulging when brakes are applied).
My wife was driving on the freeway last week and she applied brakes but they barely stopped the car and the brake light came on. She was able to limp it home without incident but the brake light stayed on and the car was braking poorly. The next day I inspected everything and found no leaks, and the fluid was not low but it was dirty. I drove the car and noticed braking performance was lacking (though it was never great to begin with) but I never saw a brake light. The brake light isn't on at this point.
Camry :: 2002 - Vibration Feel While Pumping The Brake Pedal
My 2002 camry has a vibration feel while pumping the brake pedal (no other vibration from car). It happens, when you drive slow or fast and stop. Happens when the engine is not even turned on and the brake pedal is just pumped. Its hard to describe the feeling other than zig zaggy on the way down, pulsating, etc. It starts to feel this way on the way down and halfway through the press ends smooth.
I took it to a auto mechanic two days ago and he stated the car had zero brake issues. Rotors and pads are in good condition (sometimes these are the cause for the vibration, but only when driving and stopping), fluid level are good etc. I asked him to test it out and pump it slowly or adruptly, at standstill or while driving, but he still couldn't understand what i was talking about. Researched on the net and found out the likely problem has to do with either Brake booster pump or Master brake cylinder. From a tsb (like a recall note from toyota, see below) , it seemed certain it had to do with the master brake cylinder. I took it to Toyota today and they stated it had to do with the brake booster pump instead , its not worth fixing bc it cost an arm and a leg. Just now i stopped by Active Green + Ross at 110 Gerrard and he stated that its most likely the Master Brake Cylinder, since if you were to pump on the brake while the car was off, turn on the ignition, and if the pedal goes down smoothly , the booster pump should be ok. (it does go down smoothly)
He also stated that for a refurb master cylinder (non toyota) + labour it would come out to 250 bucks. The dealership was going to charge me 1500 for the booster pump and labour. They also advised not to used non toyota parts.
This issue does not hamper safety issues with the car. Its more of an annoyance that i'd like to take care of. I also don't want to pay 1500 for a car with 150k on it.