Toyota - Camry :: Brakes Are Binding On Drive
I drive a 1997 Toyota Camry with 210,000 miles on it. Recently, my brakes were grinding. My ex-mechanic father said he would replace them. When he took the wheel off, he found that the calipers were bound and had been for awhile, as the rotors and pads were metal on metal (whoops). Both sides were completely replaced- pads, rotors, and calipers (he figured if one caliper was binding, the other was or could be soon, though the wear wasn't as bad). He bled the brakes and things were ok for about a month and a half.
My new issue is that the brakes are binding on my drive home from work (after it sits outside for 7-10 hours). The car lugs along. I pull over, try pumping the pedal (which is very stiff) and then make my way home, where my boyfriend takes the car around the block and does something magic and the brakes are no longer stuck. They aren't stuck the next morning, but are when I get in the car at the end of the work day. The wheel wells smell strongly of burning rubber as well.
Things we have checked : We've jacked up both front wheels and the tires spin. They spin less easily when the brake binding problem is present, but they still spin. We've checked the suction, the hoses that connect the booster to the engine, and the brake booster- all appear ok. The brake fluid levels are fine. The pedal remains stiff when you put the car in neutral and even when you turn it off. So what do I do next? We're semi-handy and I'd like to drive this car a bit longer, though I've started the replacement car search.
Aurora :: When Put Into Drive RPMs Won't Get Above 2500 Then Begins To Choke
Engine runs fine while in park but if put into drive rpm's won't get above 2500 then begins to choke.
-Fuel filter changed
-no vacuum leaks
-disconnected cat
-good spark
Corolla / Matrix 2009-13 :: Low Idle Between 600 And 800 RPMs And Vibration In Drive Or Reverse
I think I resolved the idle issue on my 2009 Corolla S with 82,500 miles and Automatic Transmission.
Symptoms:
Idled at between 600 and 800 rpms
Annoying vibration in drive and reverse, no vibration in park or neutral
On hard stops, the engine felt like it was going to die
Turning on the a/c would cause the idle to increase to 1000 rpms and the vibration would go away.
At 82,500 miles, I cleaned the throttle body which was extremely dirty.
Process:
Disconnect the positive battery cable
Remove the top of the air box and flex duct going to the throttle body
Disconnect the two coolant lines going to the throttle body, make sure and have a few old bolts to plug the lines so you do not lose too much coolant
Remove the electrical connector to the throttle body
Remove the vacumn line to the valve cover
Remove 2 bolts and 2 nuts (10mm) securing the throttle body to the intake.
The throttle body does not have a gasket, it is an o-ring which should be fine.
Once you have the throttle body off of the engine, clean it thoroughly with Chemtool throttle body cleaner.
The inside of the throttle body and throttle plate should look like shiny milled aluminum. when done.
Spray chemtool into the two ports where the antifreeze lines were connected. If possible use compressed air to blow out these ports.
Clean the inside of the intake and the mesh screen where the throttle body bolts to the intake.
Reassemble, connect the battery, crank the engine and just let it idle for a good 10 minutes
The 2009 Corolla S DOES NOT have a serviceable IAC. It is riveted on to the throttle body. This is why it is important to spray the cleaner in the antifreeze ports in order to clean it. These ports are the antifreeze bypass ports.
Ford Transmission :: RPMs Drop And Truck Dies As Soon As Put It In Drive Or Reverse
Just finished putting a fresh 460 backed by a (1977) c6 in my '68 ranger and now I'm having (what I believe is) transmission problems. The truck will idle and rev properly in gear but as soon as I put it in drive or reverse the RPM's drop and it dies. I jacked the back end up and put it in both drive and reverse and the tire's spin, but if I try and apply the brake to stop them the truck will die. My suspicion is that the torque converter is locked up all the time. I have managed to get it in gear and give it gas and it'll drive and shift fine, until I come to a stop. My question, what would cause the converter to do this? It's the same transmission and converter that I pulled out a month ago and I never had any issues before...
View 4 RepliesFord F-150 - 1997-2003 :: 1998 - RPMs Speed Up After Shifts Into Drive?
I have a 98 F150 4x4. I had some trans trouble so I pulled it out and had it rebuilt. Now when it shifts into drive the rpms speed up right before it shifts. What is causing the trans to do this? It doesn't do it all the time, only if I take off faster the usual which is most of the time.
View 1 RepliesTiguan :: 2011 - While Applying The Brakes The RPMs Will Go Up While Slowing Down
Just got the Tiguan SE- love it! We have had it for about 3 weeks. I noticed sometimes while applying the brakes, the RPM's will go up as I am slowing down. I know the car has to move between gears when slowing down or speeding up, but it almost as if it gets "stuck" in a gear when the car is slowing down. Any thoughts, input? We don't drive fast, we apply the brakes and gas slowly to ease the car in. This just seems odd as my past car (2005 Maza 3) did not do this. I am new the VW family so maybe I am just not used this.
View 6 RepliesFord F-150 - 1997-2003 :: When Trans Is In Drive It Will Not Upshift Until RPMs Reach 2500
-My pickup was parked and hit in the rear axle in January. I had to have the whole axle replaced as well as the leaf spring to frame mounts.
-I finally received the pickup back and now when the trans is in Drive it will not up-shift until the rpms reach 2500 and it is a hard shift.
-Also the speedo does not work now.
-Check engine light also came on with code P0500- vehicle speed sensor.
-I replaced the VSS at the transfercase and the ABS sensor in the rear differential with no change.
Ford 6.0L Power Stroke Diesel :: Jerking Symptom Around 50 MPH If Drive Normally About 1500 RPMs
Me and the wife just now noticed this issue after about a week of owning this 6.0 f350 auto 4x4. Leaf spring front and rear. Long bed. Listing all this stuff because not sure if it matters.
Around 50mph if we drive normally about 1500rpm the truck seems to jerk a little as we climb in speed. If we get the truck into the 2000rpm range it goes away.
Not sure if it's suspension, transmission or engine. Any clue what it could be. ???
Ford F-150 (2004-2008) :: Transmission In Drive - Truck Almost Stops Accelerating At About 2000 RPMs
Well I am not sure if i have trans problem or not. If I put the trans in drive and go through the gears when the RPM's get to about 2000 the truck almost stops accelerating, until you give it much more gas, this happens in every gear. but If you push the button to take it out of overdrive and drive like that it doesn't do it.
View 1 RepliesFord - Explorer :: 2002 V6 2 Wheel Drive Will Just Shut Off / Engine Shudders And RPMs Drop
I think it's possessed! My sisters vehicle, a 2002 Explorer with a 4.0 V-6, automatic, 2 wheel drive will just shut off. At first it acted like it would vapor lock. But it would start right away. then the a while later, (several months), it got where it would drop rpms and the engine shudders, sometimes not dying.
When this first started, the throttle body was cleaned, a new air filter installed, fuel pressure checked. Everything checked out and for a few days it ran fine. Then it started all over again. There has never been a code thrown. All of this goes on only when the ambient temp is above 70 deg.'s. below 70 deg.'s it runs perfect.
Last week it went to the mechanic again and a new crank speed sensor, fuel pump, and diagnostic done. He could not find anything wrong any where. Took it for a test drive and it dyed on the mechanic. Still no codes. What the problem might be? Every Mechanic that has looked at it has gave up, one even saying, " it's possessed."
Integra :: At Stop Light If Hit Brakes A Few Times RPMs Drop And Start Going Up And Down
Basically i have an integra here used to be a gsr with a type R engine. Basic bolt on's and 8lbs flywheel, 6 puck racing clutch. Here are the problems, i hate fixing other shops messes but here we go. When sitting at a stop light if we hit the brakes a few times every time we do it the rpm's drop and start going up and down, some times when the car is just sitting there idleing it does it. Had the same problem on a del sol with a gsr engine and b16a2 head on it done from the same shop. Also when its cold the owner complains that it will take him like 1/2 hour to start it. I was thinking that the grounding wasn't good enough. The check engine light is on as well, but how to get the ecu codes out of this ecu.
View 14 RepliesSubaru - Outback :: 2011 - RPMs Are Much Higher Than When The Engine Idles If Use Brakes
When I use my automatic transmission to slow my vehicle on steep downhills, the RPMs are much higher than when the engine idles because I use my brakes. The pistons are firing many more times per minute - so am i using more gas? Is the answer different for a standard transmission?
My "mystery vehicle" is a 2011..... outback...
Intrepid :: Drive Train Vibrating / Resonating Strongly When Engine RPMs Reach About 1800 - 2000
I have a 97 3.5. A few years ago something in the drive train started vibrating/resonating strongly when the engine RPM's reach about 1800-2000. I can feel it most in the gas pedal but it also resonates through the dashboard and sometimes makes the dash cover buzz. It didn't start out faint and get progressively worse, just started one day and has been there ever since and hasn't really gotten worse. Actually started after replacing my plugs, wires, intake gaskets, and valve cover gaskets. I originally thought engine, then I thought maybe it's in tranny, but it's worse when a/c is on although compressor is quiet and works great.
More info: has 198k, runs like a champ, no hesitation; tranny replaced @ 104K
Gmc - Sierra1500 :: Sticky Brakes - Car Does Not Move When Put It Into Drive
This one should be easy but I feel the need to check. Lately the brakes on my GMC sierra pick up truck has been sticking. Not badly but ever so little. Seems to happen most when it has been parked and when i put it into drive it doesn't move. If I let it sit there for a moment the brakes release and it does just fine after that. If I hit the gas and go I get the same result. what do you think? Calipers??
View 12 RepliesLexus RX 2010-15 :: Rear Brakes Locked Up When Put The Car In Drive
I have a 2013 RX 350. Over the past few weeks I have taken the car to the car wash at night to get the salt off, the next morning when I get in and start the car put the car in drive the rear wheels are locked up, It appears the froze over night due to the extreme cold we have been having. I rock the car back and forth and eventually they release with a loud pop. I actually have a 10ft tire mark in my driveway. I have been told this is common on Toyotas. The car only has 10,000 miles on it and it only happens after being washed and sitting over night in very cold temps.
View 6 RepliesFord Super Duty (1999-2016) :: 2012 F250 6.2L - Drone / Vibration When In Drive Between 1600 - 1800 RPMs
My 2012 F250 6.2L (Gas) engine developed a noticeable drone/vibration when in drive between 1600 - 1800rpm. RPMs above and below that range is fine. But when accelerating, as soon as the RPMs reach 1600, you can feel a slight vibration through the gas pedal and a noticeable sharp draon/moan up till about 1800 or 1900 rpm, then its normal.
I took it to my ford dealer and took the service manager out for a test drive. He said that there is a drone and slight vibration withing that RPM range. He thought that the engine mounts may be loose. But aside all that, he felt something was off and wrote up the service order.
When to pick up the truck and now the service manager changes his tune and said that the drone is normal and happens on all 6.2L super duties.
To be honest, I have the feeling he is pulling my chain.
Golf IV / Jetta IV :: 2000 / 2.0 - Dies Mid-drive / No Power Steering Or Brakes
This is the second time the car has died mid-drive. was getting off an exit on the interstate, popped it into neutral from 5th. suddenly had no power steering/brakes. engine just shut off. pulled over to start it, and engine just turned over. no starting-just the cheerful noise of a cranking engine. nice motorist pulled over and gave me a jump, which worked. The first time was the same story. going into neutral to coast down a hill, and it died. was about to get a jump and it started after sitting for about 10 mins. What is going on here?! fuel filter? pump? I'm at a loss.
View 12 RepliesVolvo - Abs - Brakes - Noises - V50 :: 2009 - Shhhh Noise After Start The Car And Drive Off
I have had to return my V50 twice for ABS associated problems. The first time to change a speed sensor then to replace the passenger side front hub. Now the car is making a soft shhhhhh sound for a split second whenever I drive off. According to the car manual on page 8, the car tests the ABS system "when the car first reaches the speed of 12 mph... The brake pedal will pulsate several times and a sound may be audible from the ABS control module. This is normal."or so the manual says.
My pedal has never pulsated except when I was having problems with the ABS system. In Honolulu, there is only 1 Volvo dealer and according to them the shhhh sound is normal. The repair tech went so far as to take me for a drive in a new 2011 V50, which did make the same sound. I am concerned only because I feel the braking system is important to me and the history of ABS issues. Volvo Customer service deferred to the dealers' service center. Should I take it in because the brake is not pulsating.
Santa FE SM (2001-06) :: Brakes Make A Grinding Noise - ABS / ESC And 4 Wheel Drive Lights On
2004 Santa Fe, after starting car the brakes make a grinding noise, the nthe ABS, ESC and 4 wheel drive light come on. After the initial grinding the noise stops and the brakes work fine. Just the lights stay on.
View 4 Replies