Elantra XD (2001-06) :: Clicking / Popping Noise When Reversing, Turning The Wheel And Braking
Okay I have a 2006 Hyundai Elantra with 56,000 miles. Whenever I have been driving for a while in town and and the car is heated up, I get a clicking/popping noise coming from the front end whenever I reverse, turn the wheel, and then brake.
I've been testing it more but it won't always click or pop when i turn the wheel, but when I push the pedal down to stop it clicks and pops a lot. And then as I turn the wheel back without being on the brake pedal it'll click a little bit more.
Normally this would sound like a suspension problem but the fact that I have to push the pedal down to "activate" the sound has me baffled. And the weird thing is, is sometimes when I'm turning into a parking spot at low speeds it will click just a little bit..
It almost feels like the brake lines are getting tangled up and making sounds. I know that's not the case but I'm trying to describe the sound. It's not the normal pop you would get when a tie rod is going out. It doesn't really sound like its metal on metal. And it doesn't constantly click while reversing or turning like it would if it were the CV axle.
The car stops just fine though.. I'd even say the brakes are pretty touchy. The other issue I have with brake sounds is coming from the back. When I'm slowing down ... at around 15 mph it will click in the back every rotation. It has to be coming from the drum brakes. That doesn't concern me so much as it probably is time for new pads or something in the hardware needs tweaking.
Camry 2012+ :: 2014 SE I4 Metal Clunk Sound When Reversing Back And Turning Steering Wheel
When I was reversing back and turning the steering wheel. I heard a metal clunk sound and it had happened twice in the past two days. Today happened after I released the parking brake and set it to reverse. What is the problem? Miles on the car is ~30700 miles.
View 2 RepliesCamry 2012+ :: Toyota LE - Popping Noise When Go Over Any Bumps Or Turning
I am a owner of a 2012 Toyota Camry LE with 18,000 miles on it. I am having a issue when I go over any bumps, or turning, I hear a popping noise coming from the right rear.
View 4 RepliesCamry :: 2010 - Steering Wheel Makes Clunking / Clicking Noise When Turning Car
I've recently replaced the power steering pulleys and belts. Now when i turn car, it makes a clunking /clicking noise and sometimes the power steering tugs back a bit. 2010 camry.
View 3 RepliesCorolla / Matrix 2009-13 :: Clunking / Popping Noise When Turning And Accelerating Left
Have a 2010 Corolla, 42k miles, from a dead stop, turn left under power with wheel about 90% of one full turn, get a clunking popping clicking noise from the front end -- I cannot tell if from the left or right side -- I've been in the back seat too, and cannot determine if the noise is coming from the left or right side up front. I've had the car since 34k miles, has been making this sound ever since, not sure if its gotten worse, if it has, maybe just a little.
No noise if turning while NOT under power (coasting). No noise if turning to the right. No noise while driving in a straight line or veering left at a higher speed. Also, I tried to recreate this noise from a dead stop, turning going in reverse, both left and right, and no noise ever.
If in a parking lot, from a dead start, turn wheel left almost one full turn, accelerating slowly I can get the car to make this sound continuously (until I start going too fast beyond my comfort zone).
Have looked under car jacked up several times, nothing obvious. CV axles have minimal play and the boots are in great shape. Suspension parts appear ok.
My gut tells me could be a CV axle, but not certain, and I don't know which side..... something else that could cause this ?
Camry 2012+ :: 2016 - Clicking Noise While Turning Steering Wheel Left Or Right
I have 2016 camry 4 cyl have roughly 2300 miles and I'm noticing a click click while turning the steering wheel left or right while stationary and vehicle running sounds like it's coming from under the dash.
I've seen there is a tsb for other year camry intermediate shaft issue, my vehicle is lowered on eibach Springs and would hate to take back to dealer and have them blame it on the springs in a vehicle that has only 2,500 miles.
Camry 2012+ :: Noise Coming From Front When In Reverse Turning Wheel And Braking
Heard an noise coming from the front of the car when in reverse turning wheel and braking only happens when im braking and make some turns not all turns.
View 9 RepliesCamry 2012+ :: Clicking Noise While Reversing And Braking Randomly
The other day I reversed into a parking spot, and noticed as I was braking and reversing a loud clicking sound is coming from what seems the front driver side engine area. Every time I would brake it would click. I read of this problem on the Gen 6 and apparently there is a TSB for the front Rotors needing to me re-machined? The funny thing is this only happens when I reverse and brake, but it only happens randomly.
View 14 RepliesCamry :: Power Steering Leaking - Popping Sound While Turning Wheel
I returned from my 2nd Deployment on the 5th of July and noticed I had no (what I thought to be) brake fluid. SO i bought some DOT 3 and filled it. A month later(2 days ago ish) I re-filled again with DOT 3. As I put the cap back on I noticed it said power steering... So I found the guide here and flushed the power steering completely. I thought that maybe the brake fluid had just been squeezed out of the lines somehow but I was wrong. Sitting, the car drips power steering fluid. A resevoir every 12 or so hours. I looked at it and found that it is not coming from the resevoir or lines or from the pump area. Instead it is coming from what I assume is called the boot? It is on the driver side. Where the half shaft comes out from the tranny there is another smaller piston arm looking thing that is hooked up to the power steering system and from there it is just dripping out. And the fluid on the actual arm or w/e it is called.
Issue # 2: Anytime I turn the wheel all the way left or right I hear a pop from that side of the car to which I turn. Any others have this as well? Or could these two issues be related?
Camry :: 2009 - Clunking Sound When Turning Steering Wheel
So my 09' Camry now has 130K KMs on it and for the last few months I've had an issue where when I turn the steering wheel (at rest and while moving) there is a clunking sound and feel in the steering wheel at various spots in the steering wheel rotation.
I'm worried the u-joints (if it uses them) in the steering column are worn out and might need replacing/lubricating but I'm not sure how to address the issue without an expensive Out of warranty visit to the dealer.
Camry :: 2007 - Clunking Noises When Turning Steering Wheel To Left
My 2007 Camry makes clunking noises when I turn the steering wheel to the left mostly. This happens most often when the weather is warm and hot but not during the winter time.
The noise seems to come only from around the steering wheel area inside my vehicle. Hence, I don't think it has to do with the CV Joints or anything like that but the steering wheel unit.
Ford F-150 (2004-2008) :: Popping Type Noise When Turning The Steering Wheel To Right
I have an 08 F-150 5.4. When sitting still or moving, and turning the steering wheel to the right and only the right past center, there is a popping type noise somewhat like a screw driver down a washboard (for those who'll know what that is). I replaced the ball joints because I saw a slight amount of play, but the noise is still there.
View 12 RepliesSonata NF (2006-10) :: Popping Noise When Reversing Into Parking Spot
I've been hearing a popping noise occasional when reversing into a parking spot for about a year no, its like 3-8 pops each time. I looked at the CV joints and the rubber hosing is intact. I am pretty sure this particular noise now is not ball joints squeaking.
How long can I let this slide without replacing. Is the CV joint sold as one whole piece?
BTW I'm checking out the 2013 Sante-Fe....
Ford Ranger / B-Series :: Steering Wheel Lock Damaged - Popping Noise When Turning
While in the locked position, the steering wheel was purposely jerked hard to disable the mechanism on a 1996 Ranger. Now the truck will not steer easily or smoothly and a popping noise is evident when turning. I'm not concerned about having the wheel lock, but would like to be able to return driveability to normal.
The same guy who caused this damage also damaged the ignition. No key is needed to turn the switch now.
I'm lost as to how the steering locking mechanism works and wondering if I need to tear apart the column or if maybe there is a locking pin accessible that needs to be removed to regain driveability.
Golf V R32 :: Popping Noise Coming From Front Passenger Side When Reversing?
Almost every single time I put my .:R in reverse and the car starts moving I hear a popping noise with pauses in between each pop. I think it might be a ball joint and the noise is coming from the front passenger side.
View 18 RepliesFord Super Duty (1999-2016) :: 2011 - Slight Popping Noise When Turning Steering Wheel
I have a 2011 F250 4x4 with 8000 miles. I put a 3.5" ReadyLift on it at 3500miles and Rancho dual stabilizers at 5000miles. This past week I've started to noticed my truck's steering making slight popping noises when turning the steering wheel. I crawled under the truck today and I can't pin point the orgin of the noise. It seems it is coming from higher up in the steering system possibly. It doesn't seem to be from the wheels or tie rod.
View 14 RepliesAccent RB (2012+) :: Popping Noise When Turn The Wheel About Halfway In Either Direction
So, I now have just under 20,000 km on my Accent, and lately there have been some noises popping up. I'm wondering if they're normal or not.
1. At low speed or completely stopped, when I turn the wheel about halfway in either direction I hear a popping noise. It sounds like it's coming from the steering column, but I'm not completely sure. I just began noticing it a couple days ago. So far it only seems to happen after the engine has warmed up; doesn't happen right after a cold start.
2. After the engine has warmed up, I also hear a knocking noise coming from underneath the car. It happens only at low speeds or when stopped. It seems to be directly related to the engine RPM.
When it idles around ~700 it will knock once. If I keep it in neutral and press the gas, it'll knock again. Let it idle, knock. Apply gas, knock. It also happens when in gear. I think it's either the fuel or exhaust system. Maybe it's the sound of the in-tank fuel pump turning on and off? It sounds the same regardless of how much fuel is in the tank.
This has been going on for a couple months now, and there don't seem to be any ill effects related to it... yet.
3. This isn't a noise, but a smell. Since it's summer here now I've been using the A/C quite often. While it's running it's ok, but when I turn it off it smells like a wet basement for a while.
I'm thinking that maybe the evaporator isn't draining properly and mold is growing in there. If I turn the blower on high right after turning off the A/C sometimes little water droplets will come out. I should also mention that it's very humid here at this time of year.
Suspension - Nissan - Sentra :: 2012 - Making Clunking Noise While Turning Wheels Or Parking?
I have 2012 sentra with CVT transmission & 60,000 miles. I just got 60,000 miles service done. Service adviser called me to let me know that I need to have replaced upper strut bearing on the front (left & right) replaced because they are making clunking noise when turn wheels or parking. When I asked for the reason why they should go bed he told me that it's normal, some sand other debris could clog there or water could have damaged it.
View 4 RepliesPrius (2010-12) :: Clunking Noise When Turning The Steering Wheel - Replaced Intermediate Shaft 3 Times?
Our 2012 Prius with now 17,000 miles in 8 months has developed a clunking noise when turning the steering wheel, especially far to the right at low speeds.
The first time the dealer identified it as a failed intermediate shaft and replaced it under warranty. Shortly after we told them it was starting to make the noise again, but they claimed they couldn't replicate the sound and anything they heard was normal 'linkage' (whatever that is). Shortly thereafter the clunking progressed so we took it in for now the third time, and they confirmed the problem, spoke with Toyota who said we must have had a bad part, and replaced it again.