Camry 2012+ :: Install Factory Stereo System
What this plug is use for Im trying to install the factory stereo system back..2012 Toyota Camry XLE I4.
View 7 RepliesCamry 2012+ :: 2014 - JBL Stereo Takes Too Much Time To Connect
I have the jbl stereo and when I start the car it literally takes 2 solid minutes or so to connect sometimes i have to turn the radio off and then back on to get it to connect always has done it. Tried with other phones also i use a iphone 6.
View 7 RepliesCamry 2012+ :: Belt Line Molding Removal?
I just bought a '12 Camry SE. However, the belt line molding (shiny trim piece below window) is dented in. How can I safely remove the piece without damaging anything? I may be able to knock the dent back out of this piece after removing it. Any specific tools required for removal? If I purchase the new molding from the dealer it will cost about $100, which I would like to avoid.
View 7 RepliesCamry 2012+ :: Back Up Camera Don't Line Up With The Side Of Car
I just installed a back up camera - great picture clear day and night but the problem I am having is the guidelines on the camera don't line up with the side of the car, the driver side seems fine but the passenger is around a foot short, I have mounted the pavement twice so far.
View 1 RepliesCamry 2012+ :: 2.5L Engine - Capacity To The Fill Line?
We have a 2013 Camry with the 2.5l engine.
I just changed the oil and filter for the first time. The good book says the capacity is 4.6 qt. I did that, started the engine, let it circulate then shut it off for a half hour. The dip stick shows about half way between the full and add markers. So, seems like the capacity to the fill line is more like 5 qt.
Camry :: 2004 - Leaking Gas After Pump About Line Before Full Line
I have a 04 camry and this car leaks gas after i pump about line before the full line. What do i need to do?!
View 2 RepliesAccent RB (2012+) :: Stereo Powers Up But No Sound Comes
I've got a 2012 Accent GL with a stock stereo system. Worked fine for nearly two years until a few days ago.
Start car, everything powers up except the stereo. (Dash lights up, so the stereo buttons are back-lit, but no power to the stereo.)
Pull the in-dash fuse (20A, "ACC") below and left of the steering column, it is not blown, plug the same fuse back in and the stereo powers up. Clock, tuner, volume, audio controls, etc. all respond on the display but no sound from the speakers!
Have checked every fuse and relay, including the ones under the hood and the "in-line" fuses...none are blown. All fuses good.
Is there an amplifier in that model? Is there a fuse somewhere behind the stereo, in the dash? There's no reset button on the stereo that I could find. I also left the ACC fuse pulled for a few hours to attempt a reset, to no avail.
Malibu - Chevrolet :: 2012 - Stereo Locked On Screen?
i bought another stereo from Ebay, but its shows locked on the screen.
How to unlock stereo for 2012 chevy malibu?
Camry :: JBL Stereo Powers On But No Sound
I just acquired this 2005 phantom grey Camry SE with the 3.3 V6. Has 60k on it. Whole car is mint, except for a the JBL stereo with 6 disc changer. It powers up, takes disk but no sound.
View 5 RepliesCamry :: 2007 - Stereo Comes On But No Sound Coming Out
My stereo comes on but there is no sound coming out. I checked all fuses and that's obviously not it. What it could be?
View 14 RepliesCamry :: JBL Stereo - No Sound Coming From The Speakers
2007 3.5L xle... I have the JBL stereo ( no gps ), and the lcd screen works, I can change from am, fm, aux, cd.. BUT I have no sound coming from the speakers. Every function on the stereo itself works, BUT I have two knobs at the top of the stereo ( one on the left, volume/power ) & the right side ( bass, treble, balance and fade ) .
Left knob push to power on and off = works
Left knob volume control = no and does not display volume level on lcd screen either
Right knob = nothing works
Camry :: 2003 - How To Change Stereo Audio Deck
I bought this audio deck: [URL] ..... Now I want to install into a camry 03 and I managed to install but I can't get the rear audio to work. Here is the audio deck back of it :
and here is the wire for the radio and the harness
Now my front 4 speakers work but not my rear. I bought the amplifier one because the plug fits my camry as the other non JBL one doesn't and I have no clue if I have JBL or not. Now according to the instruction for the harness [URL] .... the green and purple rca cable is for the rear 2 speakers so what do I do?
Camry :: 07 - JBL Stereo System Will Intermittently Only Play Sound From Tweeters
Basically, my JBL will intermittently only play sound from the tweeters. Sometimes it does this, sometimes it plays like normal (i.e. from all the speakers; therefore, I don't think the other speakers are blown). It's only happened to me twice, so I have yet to notice a pattern, but I suspect it may have something to do with the Bluetooth capability. It's just a guess, and I'm sure an unlikely one, but that's about it. I figure it could also be wiring, which I will find out when I take the area apart to get a closer look. But since it's playing from the tweeters that makes wiring or connection an unlikely culprit, right? It's not a major problem, just annoying, that's all.
View 4 RepliesCamry :: 2011 LE Stereo Volume Keeps Dropping For No Reason While Driving
I brought my car back to the dealer last week because my stereo volume keeps dropping for no reason while driving and I have the ASL turned OFF. the dealer said unless they can duplicate the problem there is nothing they can do. I just got the car in july...
View 1 RepliesCamry :: 02 - How To Replace Cat Converter
I have an 4cyl 02 Camry LE and I'm getting an P0420 trouble code. I've changed Air/Fuel Ratio Sensor that comes off the front Cat Converter and the rear 02 Sensor that is off of the rear Cat and I'm still getting that code, so as a result I'm changing the front converter that comes off the exhaust manifold. Now my questions is:
#1. Do I have to put any type of compound or anti-sieze on the new gasket that goes over the cylinder head studs?
#2. Do I have to put any compound or anti-sieze on the O-Ring at the bottom of the front Cat. as well before I re-assemble everything?
Tiguan :: Fitting 2014 R Line Fender Flares Onto 2012 SE?
Not sure if this has been asked/done before but would the 2014 R Like fender flares fit onto my 2012 SE? I have the opportunity to buy the flares off of the 2014 but I wanted to make sure they fit without modification.
View 4 RepliesCamry :: 2005 - Evaporator And Catalytic Converter Failed
I just took my 2005 Camry to get smogged and it failed. The reading said that my evaporator and my catalytic converter failed. I reset and drove her for almost 200 miles to get the reading settled, but that did not work. I checked all my fuses and the smog-guy and I have no clue what the issue could be. I don't think that the catalytic converter needs replacing since she only has 60,000 miles on her, but what could be the problem that it keeps saying 'fail'.
View 6 RepliesGolf/GTI VI :: 2012 - Suspension Clunk At All Speeds In A Straight Line After Lowering
Alright cliff notes are lowered my 2012 GTI on Eibach Pro Kit springs and Koni Yellows (adjustable) as a DIY driveway job and at first were OK, but 2 weeks later are clunking to the point where it sounds like its going to fall on the ground. Any road imperfection makes it clunk (from the front only).
-Clunks all the time, slow, fast, turns, straight, large or small bumps. Doesn't clunk with dips...
-Gets better when its hot outside (>70 degrees),
Camry :: 2006 SE Lost Electrical Power After Replacing Catalytic Converter
06 Camry SE I4
I had to replace my catalytic converter because of the code I was getting. It wasn't difficult to do, but took me a while because I had to transfer the thread rods to the new CAT. Once the new CAT was installed, I went to test her out, but noticed that the car all of a sudden, has no electrical power. Nothing at all. I checked all fuses and nothing is blown. The only electrical I messed with on the car was the O2 sensor.
Car has a brand new battery from yesterday. The only thing I didn't do is install a support bracket on one side, because it was missing a bolt and one thread rod was stuck in the old CAT, i couldn't remove it.
A friend suggested that the missing bracket may be causing a ground issue. Is this true?