Santa Fe (CM - 2007-12) :: Engine Vibration After Timing Belt Replacement
2007 Santa Fe GLS 2.7 V6. T belt replaced by dealer at 62K. Noticed engine vibration when picked up vehicle. RPM is steady, engine runs smooth, no error codes, no strange noises. Mechanic who did the work confirmed vibration problem and recommended bringing it back - had no answer on the cause but mentioned lose motor mounts which I doubt - the car ran perfect until the dealer did the work.
View 3 RepliesLexus LS 2007+ :: Vibration At Highway Speed - Steering Wheel Out Of Balance After Rear Shock Replacement
Since I got my car back from the dealership after changing the rear shock this summer, I can feel a vibration in the car at highway speed. After the shock were replaced the car steering wheel was out of balance and pulling one side. After they attempt to align the car about 5 times it got a little bit better. Then I found out that they had an accident with my car and tried to hide it: [URL] ....
I suspect the tie rod may have been damaged so that could explain the steering issue. It also seems to have gotten worse over time. I'm trying to figure out the possible cause, if directly related to the tie rod damage or indirectly as if the tie rod damage could have caused uneven tire wear and then causing the vibration over time. I've attached some pictures, the 2 first are from the front passenger side, the 2 last from the front driver side. My tire are the Michelin pilot and this thread seems to suggest those tire might be hard to align properly: [URL] ....
I'm due for my winter tire change soon and see if thing gets better, I'll get them balanced too. I'll check at the same time for control arms/shock damage. But still, I would like some feedback and see if those tread wear are normal and hopefully get to the root of the problem (the outer edge on the tire in the back are much less damaged).
Acura - Tsx :: 2004 - Vibration Post Engine Mount Replacement
I recently had my rear engine mount replaced on my 2004 Acura TSX. It was originally identified by the original dealer as requiring replacement and when I took it to anther Mechanic he also verified this and during the replacement he showed me the original engine mount which had a definitive crack.
After installation the Mechanic indicated that the car would feel a little stiff for a while and would smooth out over time. What I found after the first couple of days is that the engine seems to have a significant vibration when I am in idle or after I brake. When the car is in motion there is still a vibration but it is not very noticeable. I just remember from prior feel of the vehicle. This vibration did not exist prior to replacing the rear engine mount.
Is this expected to be normal until I put miles on it. The Acura is a 2004 but only has 75,000 miles. I don't drive it very much but I am concerned that the vibration I feel when I brake may be creating additional damage.
Civic - Honda :: Vibration After Engine Replacement On 2008 Hybrid
Just had engine replaced by dealership due to oil plug coming out on highway and subsequent engine damage (their fault).As soon I picked it up, felt left to right vibration going from front to back during acceleration.Took it back to dealership. They balanced/rotated tires and checked alignment (they said within specs). Still feeling vibration and so did technician who rode with me.The service advisor pulls me over and said that per the "Honda Master Mechanic" they spoke to via phone, vibration is being caused by engine timing not being correct because, being it it had to be reset, the computer needs 500 miles to set it correctly. Does this sound like bull to you to? I'm thinking damaged strut when they dropped front end to install engine or motor mount.
View 3 RepliesGolf IV R32 :: Vibration And Gear Whine After Engine / Trans Mount Replacement
So I replaced the engine and trans engine mounts on my 2004 R32 today. After I got done and drove it there was some serious vibration and gear whine. It also seemed like I wasn't able to transfer all the power to the wheels, it was definitely slower to accelerate. Did something go out of alignment?
View 2 RepliesCamry :: 2007 / Headlight Assembly Replacement?
I'm trying to replace my dads 2007 Camry XLE japan built headlight assembly because his are insanely oxidized. Besides OEM's and CAPA's, what else are there? Any good aftermarket headlight assembly and achieve great results?
View 8 RepliesGolf IV / Jetta IV :: Vibration And Gear Whine After Engine / Trans Mount Replacement
So I replaced the engine and trans engine mounts on my 2004 R32 today. After I got done and drove it there was some serious vibration and gear whine. It also seemed like I wasn't able to transfer all the power to the wheels, it was definitely slower to accelerate. Did something go out of alignment?
View 10 RepliesCamry :: 2007 SE Cruise Control Switch Replacement
My girlfriend and I were riding in her 2007 Camry SE about a week ago on the highway. She pushed the button on the cruise control switch to turn it on, and the button popped out of the end of the stalk (it did not completely come out, but popped out about an inch). She pushed it back in, but it won't turn the cruise on now.
What all is involved in replacing this switch? I was assuming it was as simple as removing the bottom rear cover on the steering wheel and swapping it out, but I wanted to check beforehand.
Camry :: Front Wheel Bearing Hub Replacement On 2007 SE
Just had an oil change and during inspection they noticed that the drivers side wheel bearing is starting to go. They brought me back in the shop and I was able to feel the play in the bearing myself. Only a matter of time before it needs to be replaced.
How to replace the front wheel bearing/hub assembly? I don't have a press for the bearing itself so I'm assuming I can just replace the entire hub assembly. I have already replaced the drivers side rear hub assembly about 1.5 years back due to a bad bearing
Camry :: Strut And Spring Assembly Replacement On 2007 LE
Looking to replace my strut and spring assembly on my 2007 Camry LE with 130,000 miles. What is the best China units out there. The list is many Prime Choice, Detriot Axle, Unity, FCS, AST, Sensen, ect.... Maybe they all are made at the same factory. FYI Monroe and Gabriel could be made in China. KYB complete units are assembled in USA, I called them up.
View 13 RepliesCamry :: 2007 Toyota Glove Box Lock Replacement
How to replace the glove box lock in a 2007 Toyota Camry. I'm referring to part # 7 or 8 in the diagram below.
View 1 RepliesCamry :: 2007 - Rear Sway Bar Bushings Replacement?
As a lot of Camry in this world, my rear sway bar bushings went bad. Tried to replace them, I went slowly with the ratchet on the first bolt as I don't want to go with the impact tool, but that damn bolt decided to break anyway...
I called my local dealer and he said he don't have the replacement in stock and he cannot tell me the size of this bolt.
What is the size? My 07 SE have the bracket with only two bolts.
Camry :: 2007 Gen 6 LE - Climate Control Bulb Replacement
I own a 2007 Camry LE and one bulb behind the temperature dial is burned out. It is the bulb for the indicator on the outside edge of the dial. I am curious how to remove the panel and rotary dial to access and replace the bulb. I've searched the forums but cannot find a description with pictures (hope I didn't miss it somewhere).
View 6 RepliesCamry :: 2007 LE V6 - Vibration During Acceleration
I have an 07 LE V6 with 76,000 miles. I am lowered on coilovers and have 20 inch wheels. so i have a small vibration while normal acceleration between 10-20 mph once i go past 20 mph it goes away. If I am accelerating heavy I feel the front vibrating all the way up until i let go of the gas. i can feel the pedal and steering wheel a lot and the whole car vibrates kinda hard.
I got new tires and replaced the pass side axle already. at first i thought it was the axle since the boot was leaking and i heard the clicking noise. I've even tried putting my stock wheels back on n i still feel it. I am going to lift the car up and try to find whats going on and what to look for under the car.
Camry :: 2007 V6 Tensioner Replacement - Cricket Noise With One Of The Pulleys
2007 camry V6 ... I have a few questions regarding tensioner replacement. i wanted to know whats normal cost for that job? I am experiencing a "cricket" noise with one of the pulleys. I had the belt replaced but problem is still there. toyota is recommending to replace the tensioner assembly quoted for 1200. is that a bit high? low?
I have reviewed pervious post with related problems but my "cricket" is on when it has a load on or not... with a/c on or off.. Any online for 2007 manuals? the online link under the stickys does not work, it dispalys a message "site has been hacked".
Camry :: 2007 SE V6 - Vibration In Car When Trying To Maintain Speeds Of 65 To 70 Mph
I have a 2007 Camry SE V6 with approx 170K miles. A few months ago I took my car into the dealership and they performed a service on my car that is a bit confusing. According to the invoice it is labeled: ENGINE INDUCTION SERVICE COMPLETED FUEL INDUCTION SERVICE. The description for the part is TOP ENG/INDUCT SV.Since this service I have noticed a weird vibration in the car when trying to maintain speeds of 65 to 70 mph. Also, if I were to floor it, the car accelerates rough -it shakes and jerks.
View 2 RepliesCamry :: 2007 Toyota 2.4 Simply Not Starting After Head Gasket Replacement
A 2007 Toyota Camry 2.4 was brought into the shop I work at smoking badly and running terrible. The car had been run hot because the radiator was busted and it blew the head gasket. So I pulled the head and sent if off to the machine shop to have it checked. They said it was badly warped across three cylinder and they resurfaced it.
Now I have everything re assembled, but it simply will not start. All the timing marks on the timing chain line up where they should be. All four coils are firing. Injectors wires pulse noid lights. A few times it has hit and sputtered like it was trying to start but never successfully does.
Camry :: 2007 XLE With 19 Inch Highlander Rims Intense Vibration
I have a 07 Camry XLE, and recently got a great deal on some almost new 2010 highlander 19in rims, the rims are excellent... they have been balanced 2 times by hunter road-force machine and that seem to lower just a bit the vibration at speeds upward of 50mph, but not significant. 4 new tires are 225/40/19. my mechanic checked for bearings,Axel, etc. everything good, the rims are not warped/bended, no damage. air pressure checked..
I contacted a couple other Camry's with them on at car domain and I'm awaiting a reply. Is there something else that can be done about the rattling, intense vibration at high speed ? or just deal with it?
I have the minimum spacers in front because by the rim installers the rims would rub against the front calipers.on my original XLE rims i had no vibration what so ever.
Camry :: 2002 V6 - PVC Valve Replacement On 1MZ Engine
I have the 2002 V6 camry and I want to replace the PVC valve. I read through the FYI/stickies, and I can see exactly how to do it on the 4 cylinder engine, are there any instructions for the 6 cylinder engine, I just want to make sure I do the right thing?
View 14 Replies