Camry :: Overflow For The Radiator Started Gurgling / Head Gasket Replacement
On my car which never overheated but one day the overflow for the radiator started gurgling and I turned off the car fast and brought to our mechanic and he advised that it was head gasket after changing hoses and water pump. when I first realized the gurgling and shut off the car and never ran it again did i save the engine and replacing the head gasket is a good thing. also did I save the head from warping by my actions?
View 13 RepliesEclipse - Mitsubishi :: 1998 - Head Gasket Blew Out?
I have a 98 Eclipse (non-turbo) with 221,000 miles. Head gasket blew out on me this morning. Lost water, but stopped before temp went too high. Bought water to put in to make it to work.
Question: What are your opinions on the "Quick Fix" head gasket repair liquids I see advertized? Two that come to mind are Blue Devil and Steel Seal. I am cash strapped and several hundred dollars are not in my future.
Ford Fuel System :: Gasket Blew Out On The Choke
The gasket blew out on the choke (tube) plate on my 460. The one that sits on the engine with the tubes running up to the choke.
Do I need to apply a gasket sealer when I replace it or does it just go on dry? I've read some conflicting opinions on it. A tad on the corners to hold it in place. Put it on dry or put sealer on it.
I know when I remove it I will be able to tell but since I don't have any hi temp sealant. I'd rather buy some when I get the gasket than go back.
Ford F-150 - 1997-2003 :: Radiator Or Head Gasket Causing Overheat?
The problem is my new-to-me 97 Ford F150 5.4L SOHC engine, auto transmission, is overheating after driving it for a short while. Seems to be fine at idle. I have read previous posts with the exact same issue, but the consistency seems to be all over the map from burping the system, head gasket, thermostat, and possibly a plugged radiator.
Backstory:200,000+ miles.
Truck sat for 6 months after previous owner broke the shift cable.
Truck was in a front end collision. Frame looks bent underneath the engine.
Previous owner had overheating problem. He said he changed the heater core. Looks like brand new coolant in the system so story probably checks out. Desperately needs an oil change. Very black oil.
Previous owner thought the system needed a burping. So I'm largely assuming the problem started after the heater core change, or he misdiagnosed an overheating problem and thought the heater core could cause it. I have found a radiator cap and thermostat in the truck which seems to indicate he tried many things to fix the overheating and was unsuccessful. Engine looks pretty clean for the miles.
Symptoms/Backyard Tests :
Blows cold air with heat on highest level and on defrost.
Blender door fuse intact.
Doesn't overheat at idle.
Ran the truck for 15 mins with the coolant bottle fill cap off on level ground to try to burp it after draining some coolant and checking the thermostat orientation. Coolant level increased in the bottle. Large air bubbles came out. (Another session before this one, I ran it for 30 minutes with no coolant cap, and eventually coolant overflowed the fill bottle. Normal or no?)
Seems to overheat after the thermostat opens. After doing the 15 minute warm up/burp, I took it for a test drive. I drove it about 20 blocks with the temperature gauge on the dash reading the same as the warmed-up idle temperature. Got to the 20th block and the gauge immediately spiked to overheat with the oil pressure dash light coming on. I could be mistaken as the oil pressure light almost looks exactly like the overheat dash light. But I'm pretty sure the temperature icon was on the right side of the oil can icon and not the left.
After the above drive: Upper rad hose too hot to touch.
After the above drive: Lower rad hose medium warm. Could hold on to it if I felt like it.
After the above drive: Upper part of rad pretty hot. Not Insta-burn but hot. Tempature decreases to warm to cool as you go lower down the rad.
After the above drive: Both heater core hoses going to the cab luke warm.
Coolant looks brand new.
Radiator looks slightly bowed. Probably from the accident? Otherwise looks clean and minimal bent fins.
Drained some coolant and pulled the upper rad hose to see if the thermostat was upside down. Looks installed correctly.
No signs of weep hole leaks from the water pump.
Fan seems solid. Has maybe 1-2mm of play in the bearings.
Something that looked like steam from the muffler at startup, that disappeared after getting closer to a normal range warm engine.
I have driven crap cars for many years and I've never seen a plugged radiator which makes me skeptical of it being that. All the radiators I have changed were because they were eventually leaking from cracks in the radiator.
I would also be interested in doing an informal poll if you have read this far and have had this era of F150 that overheated. Have you ever repaired the head gasket? And/or have you ever changed the radiator?
Camry :: 2003 Camry 2.4L - Cooling / Radiator Fans Stay On All The Time
My 2003 camry LE 4 cyl cooling/radiator fans stay on all the time. As soon as I turn the ignition key both radiator fan start to spin even though the car is cold and not on. I checked all the relays and fuses. Checked the voltage on the coolant sensor harness with ignition switch on, there is no 5v or the green pin is not grounded. I am clueless where to go next.
View 14 RepliesCamry :: 2003 - Kicking Noise From Head Gasket
Yesterday my 2003 camry has kicking noise from head. i am not sure it is broken valve or the VVTi broken. the oil look like silver. There is no cel code and car run ok.
View 7 RepliesCamry :: 2003 - Oil Leak From Driver Side Head Gasket
I own a 2003 Toyota Camry with 195,000 miles. We have owned the car for about 6 years. It is now leaking oil from the drivers side of the head gasket. The oil has been leaking down onto the exhaust and smoking, and it has been getting worse and worse. This is a second car and is not used much, only once a month for short trips. Is there any temporary fix for this that can maybe get me through a year? Also, I have heard mixed opinions on how hard replacing the head gasket is, does the engine really need to be removed?
View 9 RepliesCamry :: Sunroof Glass Blew Off
Driving on the highway Christmas eve, oddly heard the wind noise and made sure the windows were up, checked the sunroof and no glass.
Didn't notice the glass had blew off, no noise of any kind except the wind noise.
The sunroof was installed by Toyota / came with the car, bought it brand new.
Honda - Accord :: Engine Continues To Gunk Up The Radiator / Blown Head Gasket Or Block
My car blew a head gasket in the fall. A friend replaced it and rebuilt the head. The head was taken to a machine shop, was not warped but was planed just a little. The engine was put back together but it continues to gunk up the radiator with yellow gunk. We put block sealer in and it today there is gunk in the over flow bottle again. This is a 1998 Honda Accord with only 103,000 miles on it when the gasket blew.
View 2 RepliesFord Ranger / B-Series :: 2000 V6 - Blown Head Gasket / Radiator Fluid Goes Straight To The Oil Pan
I have a 2000 Ranger, V6 4L, and I believe my head gasket is blown, my radiator fluid goes straight to the oil pan. It has probably been leaking for a while, I did not realize it was leaking internally, I had been adding coolant for a few months but thought it was my radiator leaking because it had a crack in the housing, so I had that changed, but then a few weeks after that It gave out. I drained, and flushed the engine twice, and just parked it. My question is, should I just have the head gasket changed, or does it need a new engine because it had been leaking for a while and not sure what kind of damage it has done internally.
View 3 RepliesCamry :: 2009 - Rear Brake Light Blew Out - No Warning On Dashboard
I have a 2009 Camry LE. My right rear brake light blew out, but no warning light seems to pop up on the dashboard. I only realized the brake light went out when someone pointed it out to me. How can you tell that the brake light blew out? (I checked the manual but didn't find anything)...
View 4 RepliesCamry :: 2003 4cyl - Passenger Side Radiator Fan Not Working But Temp Gauge Stays In The Middle
I started my car and noticed that something under the hood was very loud. It sounded as if there was a large fan left on high and I was right. The passenger side radiator fan doesn't come on. The drivers side does though and yet there is no overheating! Ive taken short 15 mile trips here and there but the temperature gauge stays right in the middle. If i give this radiator fan motor a good whack with a screw driver, it comes right on. What it could be? Does it need a motor replacement? Could it actually be the relay if when I give it a whack, it comes on?
View 5 RepliesFord F-150 - 1997-2003 :: 2000 - Blew Out Plug?
I've seen some discussion about the 4.6 motor not blowing plugs, so I just wanted to add to the confirmation that they do. 106k miles on the motor, #5 came out today on the freeway.
I was looking to repair myself, but the Timesert kit is expensive.. I'm thinking I now want all 8 done so I don't have to deal with this again.
Saturn - Vue :: 2003 - Engine Suddenly Blew All The Transmission Fluid Out The Back
i have a 2003 saturn vue 2.2 liter engine that suddenly blew all the transmission fluid out the back. it looks like it is on the top of the transmission around some bolts up top on the drivers side, not on the bottom. could this be a seal or has the transmission blown?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F250 - No Start After Non-serviceable Plug Blew Out
Here are the details. Just replaced my HPOP, IPR and ICP and while driving at 75mph I hear a loud pop under the hood. Several seconds later CEL comes on and I have no power and the engine is shutting down as normal. I pull over, get out and there is a massive amount of engine oil everywhere, I get it and the first thing I look for is the HPOP area and the "non-serviceable" plug is GONE.
I was able to find the metal piece that goes in between the plug and the ball, but no ball. I find the dimensions of the tiny ball (.25") and replace it. I order the long thread fix from RIFFRAFF install it and now I have a no start issue. While waiting for parts I change the oil and filter, clean the oil soaked engine and pray that nothing else was messed up. I do not have an AE or OBD-II, the truck has 300k on it....
Camry :: Transmission Filter Pan Gasket
Question? I am getting ready to change my transmission filter on a 2002 camry 4 cyl, do I reinstall gasket dry, coat with fluid, or use gasket eliminator on both sides of gasket or what?
View 1 RepliesCamry :: 2004 - Oil Pan Gasket Leak / Replacement?
2004 camry, oil pan gasket replacement required? Mine is leaking.
Was there anything difficult about it? Any special notes or tricks about replacing it? Seems like it would be a simple job.
Camry :: 2002 - Oil Pan Gasket Leaking At 140 K Miles?
2002 Camry 4 Cylinder. 140 K miles
I am pretty sure the oil leak I spotted is from the oil pan gasket. (Interestingly I searched and didn't find many posts about this, that makes me wonder if this is not a typical issue.)
Is there anything that blocks removal? Does it just drop out after undoing the bolts?
Also can I get the felpro gasket? Do I need any sealant?
Camry :: Oil Leak Coming From Valve Cover Gasket
so I have a 2azfe engine
So there's an oil leak coming from the valve cover gasket (just purchased vehicle dirt cheap with 220k)
found this
Notice all the oil sitting on top of the exhaust mani gasket
In the left(lower) part of the picture it appears to be scraped.
the gasket appears to be newer, I did NOT use a screw driver to remove the valve cover, which is what this appears to have been done..
Can this be sanded down then filled with jb weld, and then regasketed?