Toyota - Camry :: 2001 - Check Engine Light On / P0440 Code
Check engine light was on for some time when I had filler neck and cap replaced. Computer sensors did not re-set until 501 mile mark, when light came on again. Checking the web, I find that some who appear to have knowledge of problem say it could be hoses, sensors, valves, or evap canister--the charcoal canister.
Mechanic who did original smoke test and recommended replacement of filler tube wants to replace evap canister without checking anything else. What should I do? At wits end, and car needed to pass inspection 2 days ago. Car has 157,000 miles or so...
Camry :: Got OBD Code Of P0031
Check engine like on my 03 Camry with 2.4L is own & got an OBD code of P0031. Just bought the car with 38k miles one owner & can't pass local emissions.
View 10 RepliesCamry :: VSC And TRAC OFF Light Won't Go Away - CEL Code
I recently had a CEL code for bank 2 cat converter.. I drove the car with the CEL for 8 months and one day the VSC and TRAC OFF light popped on and wouldn't go away. I took it to toyota and they told me that it is because the check engine light is on and once the CEL goes off the others should as well. Well i recently replaced the bank 2 cat and cleared the CEL and iv driven over 300 miles already the CEL has not come back on but the VSC and TRAC OFF light remain ON....
View 2 RepliesCamry :: 98 - Getting EGR Code PO401 Continually
I have a 98 camry 4 cyl and am continually getting egr code po401. I've cleaned out and tested egr, replaced modulator and the vac switching valve. Replaced several hoses also. Car runs fine, in fact this code came the day after traveling 700 miles. It comes back on fairly quickly after properly resetting computer and 1 or 2 drives.
View 3 RepliesCamry :: Decoding Of Code C0205
I recently purchase camry 09 and when I did the computer for the car it returns me P0012 and C0205 errors. I have searched for P0012 error and got an idea to check the oil control valve. but for C0205, what exactly I have to check for?
View 2 RepliesCamry :: Code P0430, P0157 Came On
My 2009 Camry came down with the p0157 code which I looked up & is oxygen sensor circuit, low voltage bank 2 sensor 2. I'm trying to figure out which side this is(driver or passenger)? Also have a p0430 code-catalyst system efficiency below threshold.
View 2 RepliesCamry :: Code P0441 - CEL Not Going Off After Gas Cap Has Been Tightened
The check engine lamp on my '04 4cyl came on Saturday. I checked the code. It's P0441, which is supposed to be 'Evaporative emission control system incorrect purge.' I found a page on the web that said this might have to do with the gas cap. When I checked the cap it had not been tightened.
I've been driving it for 3 days and the check engine lamp is still on. How long should I expect it to take for it to extinguish? It seems unlikely to the point of incredible the gas cap was left loose (which I've never seen before) and another failure in this very system could have happened simultaneously. Particularly since this is the first time the check engine lamp has come on in 9 years and over 100,000 miles
Camry :: 2002 LE - CEL Came On / Code P1349
I have a 4 cyl 02 camry LE. Recently the CEL came on and a few minutes later the oil light. after a day or so they went away. When it happened, I immediately went to the auto parts store and they checked the engine codes and got only one the P1349 repeated several times.
About 6 months ago my water pump leaked and that was replaced along with the timing belt. Shortly after that I had the oil changed and they over filled it i found out. I changed the oil and that was fine. i did develop a slight oil leak from the top passenger side of the engine though. so far i don't notice my oil level dropping. I just see some oil spray in that area. I mention this as they seem related to the code.
The code relates to Possible causes
- Dirty or low engine oil
- Valve timing
- Oil control valve
- Variable Valve Timing controller assembly
- Engine Control Module (ECM)
Camry :: 2007 - Code P0606 / ECM Is Bad On The Car?
My friend has a 07 Camry 4cyl and has code P0606, Engine control module/Powertrain control module processor. The car runs and drives good. My friend recently got the piston rings replaced about a month ago for the recall, and he told me the service light was not on when he dropped off the vehicle. After he got it back it wasn't on and just came on a few days ago. Hard to believe the ECM is bad on the car, I'm thinking it was something with the removal and install of the engine causing P0606. Does it need to be reflashed?
View 1 RepliesCamry :: CEL Came On And Throwing Code P0430
My CEL came on and is throwing code P0430. Is it just an o2 sensor? if so which one primary or secondary?
View 2 RepliesCamry :: P0606 Code - PCM / ECU Fault
So I had a P0606 code which points to a PCM/ECU fault. It would come and go and not really cause much of a problem with driving. It did stall once but it started right back up. The light would come on for half a day and go off. Rinse and repeat......
The dealer replaced it today under my extended warranty. Sure enough, the CEL returned today. I haven't had the code read but I can only assume it will be P0606 again.
Camry :: OBD II Flash Code List?
Looking for online list of OBD II flash codes?
View 7 RepliesCamry :: 2006 - Getting Code P0136?
My 2006 Camry V6 had the code P0420 before. I replaced 2 downstream O2. Now it throws code P0136. What should the next step I am looking for here? Is it a CAT issue?
If I need to replace CAT, do they have custom (modify) CAT to improve the performance?
Camry :: ABS And Brake Light On / No Code / Won't Reset On 04
ABS and Brake light coming on and staying on with an '04 Camry 4cyl XLE? I've found posts here of it flashing and wheel speed sensor codes etc, but nothing on it staying on and not re-seting.My code reader is not picking up any codes, I tried jumping pins 4 and 13 on the OBD port to read the code that way, and get no flashes from either ABS or Brake light, and tried the 8 pedal press method to reset the lights with no luck.
Before this, I was starting to get a little noise vibration at around 50mph which seemed to be from right front wheel, so on the wild guess that the bearing had gone bad and damaged the wheel speed sensor or tone ring, I pulled the sensor and it physically looked ok, and tested out at ~ 1kOhm.I checked all the fuses for the ABS system and they all tested ok.
Camry :: P0025 Code And VSC System MIL On At Same Time?
My 07 camry had the service engine light on for a few days, figured it was just the typical oil change interval and was going to get to it this weekend when I had a chance. On the way home tonight I got a double wammy, check engine light and the message center indicating I had an issue with the VSC system.
Got home and pulled the code P0025 telling me that the B camshaft position timing over retarded in bank 2.
I was just getting ready to pull the engine on my 97 landcruiser to do a HG and fix several oil leaks, including the upper oil pan. Nothing on the cruiser scares me, this does. Now this kind of shocks my system as I was not prepared for it.
This is a 07 XLE with the 3.5 liter 6. It has about 138k on the clock. I do get a bit of a shudder when accelerating hard but that has been there since I bought this last summer.
Camry :: LE - P0031 Check Engine Code
What to do to get rid of P0031 check engine code on my 4 cyl. Camry LE. He replaced O2 and A/F sensor (Denso with CA emission), computer module (got dealer calibrated it), verified wiring/voltages, inspected the catalytic converter. When the code is cleared it will not come up for some time, but when the car is started cold it comes right back again.
View 2 RepliesCamry :: 2.4L 2005 Vehicle - P0012 DTC Code
I have been looking for a reason for the P0012 DTC code and was looking for the VVTi Oil control valve & filter. I cannot see where it is on the engine.
View 3 RepliesCamry :: Gas Pedal Not Responding Code P2119?
This car had this problem about 4 years ago when my father in law owned it He had the dealer fix it and they replaced the gas pedal assembly i checked that and it is ok if i shut off the car and restart it the pedal works fine or about 15 seconds then back to idle
View 2 RepliesCamry :: When Drive Over 80 Mph Within 15 Minutes CEL Comes On With Code P0420
2006 Toyota Camry LE (4 cyl) with 149,500 miles. All maintenance up to date.
Over the past month, anytime I drive over 80 mph within 15 minutes, the CEL comes on with the code P0420. I read the code and erase it. The funny thing is typically I'm getting very good gas mileage during that tankful when the CEL comes on. I've read that it is likely the downstream oxygen sensor and I plan to replace it. (In February, I replaced the air/fuel sensor). My two questions are:
a) What is the part number for the oxygen sensor (non-California emissions)? I want to make sure I get the right part.
b) Why the CEL comes on after travel over 80 mph? Is this coincidence or is there a reason why this happens?