Bonneville :: 1996 SSEI - Can't Open Trunk With Key Or Button
I have a 96 SSEI, it has been sitting for one year....I put it back on the road yesterday and done some shopping, and found out the key won't open the trunk so i tried the button on the door and it didn't work either. So how can i get the trunk open, I couldn't find the fuse the the release button.
View 11 RepliesBonneville :: 1996 Pontiac Keyless Entry Reprogramming
I have a 1996 Pontiac Bonneville, when i bought it it came with a remote that was broken, so i have an old remote from a 2000 Chevy Venture that i want to program to work with my Bonneville, my owners manual has no information on reprogramming and I don't want to pay a dealer or mechanic money to do it, looking for the process of re-programming this for my car?
View 3 RepliesPontiac :: 1996 Bonneville Deploying Airbags While Driving
On Sept 10, 2011 I was driving towards a major highway when my airbag light came on. I just figured it was a sensor malfunction and kept driving. I proceeded to the highway and when I was up to 57MPH I put my cruise control on. About 3 minutes later both of my airbags deployed while I was driving. Do you think I need a lawyer?
View 19 RepliesPontiac - Bonneville :: 1996 - Oil In Antifreeze With PO300 Code?
How serious or expensive is cost of repair for problem causing oil in antifreeze for 1996 Bonneville with PO300 code?
View 5 RepliesBonneville :: 1991 SSE - Check Engine Codes 13 And 14 Shown
My 91 sse showing codes 13 and 14. I have changed the thermostat and the temp sensor. I tested the O2 sensor, it appears to be sending the proper signal. The check engine light comes on after the car warms up. I don't know what else to check,the wiring looks OK.
View 11 RepliesPontiac - Bonneville :: 2002 - No Reverse In Drive
I have a beautiful 2002 Pontiac Bonneville SSEI with just over 100k miles on it. I've been saving for a new set of tires and a new regulator for the rear window. The window suffers from the "pop and drop" syndrome but I have instructions on how to fix it myself when I can get the parts.
Yesterday, I started her up to go to my second job when I discovered I had no reverse. In drive, I could just creep forward at 3000 rpm. Fixing a transmission is probably the worst case scenario I could imagine happening.
I'm left with two options: Either find something simple I can do myself to get it moving again or get what I can for it and use the proceeds to buy a piece of metal to get back and forth to work.
Honda - Element - Belts :: 2004 - High Pitched Noise Similar To Drive Belt Slipping When AC Compressor Cycles On
I have a 2004 Honda Element and when the AC compressor cycles on it makes a high pitched noise similar to a drive belt slipping. The AC is still cold and the noise is not overwhelming (yet). I know this vehicle has a serpentine belt and that doesn't appear to be making any noise. The only noise is when the compressor is running.
Is there a belt that drives the compressor (other than the serpentine)? And, is this something that I should get fixed ASAP or can it wait until my next oil change? Meaning, if I wait until the oil change (under 1,800 miles) will hurt anything?
Bonneville :: 1996 Vehicle Making Whine Noise When Put Transmission In Reverse Gear
When you put trans in reverse makes whine noise no reverse. The forward gears are fine. Could this be a solenoid problem?
View 1 RepliesPontiac - Bonneville :: 2005 - Check Engine Light Codes
Every year at this time I get check engine code about either the temp. sensor or the thermostat. I replace the temp. sensor every year, and last year I replaced both the temp. sensor and the thermostat and flushed the cooling system and replaced the coolant. but not this year, no I'm not doing it! For there has to be some other reason other than the temp sensor failing each year! 2005 Pontiac Bonneville 3.8 V6....
View 6 RepliesBonneville :: Fuel Tank Replaced - SES Light Comes On After 10 Minutes Drive
I replaced the fuel tank on my 91 SSE and now the SES light comes on after you drive for 10 minutes. When you park for a time and restart the car the light is off .It comes back on again after 10 minutes. When replacing the tank I did find part of the EVAP line from the tank to the canaster rusted thru and replaced it.The gas cap appears to be OK. The engine runs fine no problems starting or accelerating . Where should I look?
View 5 RepliesPontiac - Bonneville :: 1987 - Socket Size To Remove The Drive Axle Hub Bolts?
What size socket I need to remove the driveaxle hub bolts from this car? I can see the bolts are considerably larger than the socket I have for my Ford Tauruses, and I would like to eliminate the guess work before I go to carquest to get the proper socket. Unfortunately bringing the car to the store and trying sockets until I get one that fits is not an option, since the car is not running right now.
View 3 RepliesGolf IV / Jetta IV :: 2.0 Throwing Multiple Codes
So my car has been dropping multiple codes after I scanned her and found all five: p0303, p1128, p0172, p1300, p0301. She is just a simple five speed AEG and has no mods other than a SRI. I already replaced the MAF but that ended up causing more codes and I have checked the vacuum lines to no avail.
View 2 Replies1996 Blazer - Flashing Cel Light P300 Multiple Cylinder Misfire?
So my 96 blazers cel started flashing and the truck started running extremely rough. I changed the catalytic converter and the o2 sensor that is in the pipe. Made no difference. So I knew my intake manifold gasket has a leak so I changed the gaskets and put knew bolts in. I wasn't thinking and took my distributor out and forgot to mark the timing. So played like heck getting it in timing again. Took a bit cause I didn't realize there was two timing marks. So got it started again was running really rough so thought 180 off turned it nothing. So put it back started it up still running very rough and flashing cel so put a new crank sensor and cam sensor in and a ignition coil in. No dif still. Could it be the egr or ECM?
View 12 RepliesInfiniti :: 1996 - Brake Light Switch Replacement On Multiple Occasions
I have 1996 Infiniti I30. I have had to replace the brake light switch on multiple occasions. And even now it appears that I may have to again after replacing it about a two months ago. What would cause this, faulty switches or internal electrical problem?
View 1 RepliesTrailBlazer :: Multiple Codes - ABS Kicks In If Braking Lightly
My 2003 TrailBlazer LT (regular wheelbase) has the following codes:
- C0265
-C0281
-C0267
-C0237
The ABS light is NOT on! Every once in a while, if braking lightly, the ABS kicks in. That is the only symptom of any problems at all.
My first thought is could this be a bad ground at the EBCM or does it look like my BCM is on it's way out? I am wrong all together it the problem is something else?
Golf/GTI VI :: CEL Flashing Then Stayed On - Multiple Fault Codes
Car was taking 3-4 seconds to turn over when I started it one night. After that, flashing CEL and then CEL stayed. Car idles ridiculously rough, thought it was just a coil pack but seems to be a lot more. What is going on with my car?
Performance mods:
APR intake (stage 1&2)
SPM track edition turboback
Stage 2 revo software
R8 coilpacks and NGK plugs put in 9-10k miles ago
Have 52k miles on the car if that matters
Golf IV / Jetta IV :: Getting Multiple Codes After New Trans Installed
I finished installing an auto out of a 1999 beetle into my 2000 golf. I used the beetle TCM now it wont shift out of 3rd. If I manually start in first it will shift up to 3rd but nothing past 3rd. I had it scanned with a generic scanner and these are the codes. P1780, P1783, P0725. I researched the heck out of this and I'm not sure what to do. Do I need to take it and have a vag com hooked up to make sure the ecm and the new tcm are talking? It seems others have had these issues and I thought it might be solenoids but that's not what's coming up.
View 2 RepliesPrius (2004-09) :: Red Triangle And Multiple OBD Error Codes
The red triangle warning on my dash recently came on so I am taking it to the nearest dealer on Monday. I think all of this is covered under recalls/warranty. Am I right?
View 4 RepliesAccent LC (2000-05) :: Getting Codes For Multiple Misfires On Cylinder 1 / 2 And 4
I have a 2000 lc 1.5l ... I just rebuilt the motor machine shop work and all it Will start and run for 3 seconds and then die. If I hold the gas pedal it will run but sound rough and as soon as you let go it dies I have been able to get codes multiple misfires, misfire cylinder 1, misfire cylinder 2, and misfire cylinder 4 I have put brand new plugs (copper core ngk), wires coils, crank sensor, cam sensor, iac, tps, maf and the injectors all have new orings it also has ntk o2 sensors that might have 1000 miles on them...
View 1 Replies