Ford Transmission :: Shift Collar Replacement - Won't Engage Completely In Gears?
Been working on tightening up the 3 on the tree assembly because shifting has become troublesome; not wanting to engage gears completely, tough to go from 1st to second and so on. I have already adjusted the linkage per the shop manual with no improvement and found that it was not misadjusted. One of the first tasks is to replace the bushings from the shift rod to shift level under the hood though the bushings have some play but don't look that bad.
I have noticed the amount of play in the column when in neutral seems excessive, between 2nd and 3rd I can move the shifter about 2-3 inches up or down from center without feeling any tension toward a gear. This I think is the shift collar. Before I go tearing into the column, after replacing the shift collar was the amount of play significantly reduced?
Park Avenue :: 1992 - Hard To Shift Into Park From Other Gears
1992 Buick Park Avenue, Base. For awhile now I've had trouble shifting into park from other gears. Sometimes, it'll flow right into park without trouble. Other times, I have to work it, to kind of baby it in. However, it simply will not shift into park from reverse. Period. If I'm in reverse and want to park, I have to go into drive, neutral, etc, and then try to move it into park.
A mechanic I know looked at the neutral safety switch and thought it could be causing the problem. We figured it wasn't in the steering column or the cable to the switch because if we disconnect the cable, you can slide that lever all day long. So I purchased a new neutral safety switch and had him install it, but the same problem is there. Actually, let me clarify: while it was in his garage, with the old switch, it would no longer go into park at all, regardless (kind of decided to just stop altogether). At least with the new switch we can baby it into park, but it is basically back to where it was last week. He mentioned it might be deeper in the transmission, but that's out of his league.
Town Car :: 98 Lincoln Gears Won't Shift From Park
Gears won't shift from park. What's wrong? Is it the neutral safety switch?
View 5 RepliesAccent LC (2000-05) :: Transmission Won't Engage Gears
own a 2005 Hyundai accent 1.6L engine. I replace the engine today. The previous engine had internal damage. The transmission I left alone. I didn't disconnect the wiring. I only removed the engine. The transmission worked flawless. When I turned on the car the engine sounds great and the transmission sshifted gears and the wheels were moving. The speedometer worked so then I turned the engine off and lowered the car down from the Jack stands and tired it shine but this time the transmission did not shift gears. I lifted the car back up and did still did not shift gears. The transmission does nothing. The checked the guild level and it's full. What can cause a transmission to suddenly stopped engaging gear?
View 2 RepliesGTI 337/20th Anniversary :: Clutch Sticking When Released And Gears Only Engage When Push Hard Shift Knob
Been having trouble shifting into any gears on these chilly mornings in VA now... The clutch has been sticking on its way out when I release it and the gears don't want to engage unless I really push hard on the shift knob.
View 11 RepliesPassat (B5) :: 1999 - Transmission Does Not Engage / All Gears Selected
99 Passat1.8t auto, transmission doesn't engage into any gear ... Cluster shows that all gears selected ....
ATF level OK and VAGCOM doesn't show a ny codes/errors for trann When I put D or R - car revs up to 1200RPMs and thats it Checked ECU and TCU (tranny computer) no signs of water in them I don't really know history behind this vehicle but it had been sitting from 2009, had run before without problems (at least thats what previous owner told me) ...
Subaru - Outback :: 2000 - Transmission Will Refuse To Engage Into Any Of The Forward Gears?
My 2000 Subaru Outback (75,000 miles) runs well almost all of the time. Every so often, especially when the weather is cold and I have been making many short trips, the transmission will refuse to engage into any of the forward gears (Auto-Trans). It will do reverse, no trouble, but not the forward ones. It does not do this with any sort of regularity or consistency. I have had it checked by my mechanic and he said that although it did this it sounded fine and was not shifting roughly. Thinking it might be a fluid pressure problem, he put in fluid additive to soften the seals and this worked for about a week, then back to square one. I saw enough notes posted on other forums by other Subaru owners to know that this might be an issue with this year's model--maybe some sort of quirk that I hope can be fixed without a new trans.
View 5 RepliesHonda - Accord :: Dashboard Gauges Don't Work And Cannot Shift From Park
I own a 1994 Honda Accord with 200,000+ miles on it. Suddenly the Dashboard controls stopped working, and the shift lever wont shift out of Park unless I manually force it to shift by inserting key in to the slot beside the shift lever. I suspect it has something to do with the brake fuse. Where the break fuse is located.
View 1 RepliesHyundai - Tucson :: 2005 - Transmission Won't Engage In Reverse Or Park Immediately
I have a Hyundai Tuscon 2005 with 140K automatic transmission. Original Owner and has treated me well. Current issue is the transmission will not engage in reverse or park immediately when shifted most notably first thing in the morning or in the late evening after sitting for a while. It acts as if it is in neutral until it engages after revving the engine for a while. Once it engages, it is a little sporadic for a few minutes and then all is fine for the rest of the day no matter how many times I start, stop or turn the car on or off.
Runs like a champ until the next morning and it starts all over again. A couple of times the check engine light has come on and I can tell that the transmission is stuck in 3rd gear. I can't manually get it to go up to 4th or down to 1 or 2. I can clear the code and then all is back to normal again with normal shifting again available. Short of a transmission rebuild (whihe probably won't happen) could it be electronic in nature since it comes and goes?
Ford Excursion :: Transmission Will Occasionally Hesitate To Engage Drive From Park
Just a little background, my Ex is a 2000 V10 4x4 with 217,000 miles. I've owned it for a little under a year. Very clean truck, and well maintained by previous owner. Now the issue. Starting about a month after I bought it, it would occasionally hesitate to engage drive from park. I checked fluid and it was full and clean. I had a buddy recommended that I check for chafed wires in the steering column which I did and found nothing. It seemed to get better for a while but now it's back. It's doing it more than half the time I put it in drive and sometimes takes 10-15 seconds to engage. So am I probably looking at a new trans? Or, is there anything that can be done to save the old trans?
View 1 RepliesFord Transmission :: 1994 - Barely Engage - Grinding Noise In Park And Neutral?
I have a 1994 F-150 extended cab electronically activated 4x4, with the 302 V8 and an e4od transmission.
When the truck is running and it is in park or neutral it makes a grinding/whining noise and when it is in gear it doesn't engage, or occasionally will barely engage, but only enough to move it a little ways.
I've read a couple of post that suggested bad connections to the transmission could cause the transfer case to be in neutral which could cause a similar problem to this. I checked all the connection the best I could and the only thing I found that gave me any concern was one of the wires connected to the transfer case shift motor had some of the insulation melted or rubbed of and the wire was a bit corroded.
Is there any chance that this could be causing my overall problem with the truck not driving? Or what might be going on with it? Or any way I might be able to fix it without having to hand over a significant chunk of change for the full rebuild.
Kia - Sorento :: Hard Shift Between 3rd And 4th Gears In Transmission
2009 Kia Sorento. The Transmission was replaced twice last week and the week before. For the same problem. 50K miles. Auto Transmission...
I have a hard shift between 3rd & 4th gears, I have had the transmission replaced twice. Could it be something else?
Ford Transmission :: Shift Into Some Gears Sometimes But Not Without A Lot Of Resistance
I gotta 93 f150 XL it has a 4.9L and a T18 borg Werner trans. I replaced the clutch,throw out bearing, pressure plate and pilot bearing and after reinstalling trans I am unable to go through my gears.
If truck is off I can shift into some gears sometimes but not without a lot of resistance. Also some gears will let me in easy, then fight me as I try to back into neutral.
Truck starts right up but if I start in neutral I can't shift into any gears and get a lot of grinding when I try to put it in gear.
If I start in gear it drives in the gear but I have to force back into neutral. And then I'm stuck in neutral again.
It is a hydraulic clutch and fluid is full and there are no visible leaks. I am 100% sure clutch disc is facing correct way as I triple checked it while installing.
BMW :: Automatic Transmission - Gears Shifting From 1st To 2nd And 2nd To 3rd But Won't Shift Any Higher
I have a BMW 523i SE AUTO (1997) 2494 Petrol. In auto transmission the gears will shift from 1st to 2nd and 2nd to 3rd but won't shift any higher. In steptronic/manual transmission the gears will shift from 1st to 5th without any problems therefore suggesting that the problem isn't the gearbox itself. Only very occasionally does the shift electronics telltale light appear on the dash, yet the problem with the auto transmission is continuous. A local garage specializing in automatics suggested that it was the gearbox inhibitor. I've today had this changed but the problem still exists.
View 5 RepliesNissan - Altima :: Transmission Won't Shift Into High Gears
My 2001 altima wont shift to high gear. driving around town seems to be ok, will driving on the highway be dangerous?
View 5 RepliesLexus ES 2007-12 :: No Lighted Panel When Shift Transmission Gears
The area where you shift transmission gears isn't lighted. Find that strange even though you can see what gear you're in on the lighted panel. Gear not the right term, but think you know what I mean.
View 4 RepliesSanta FE SM (2001-06) :: Hard To Shift Gears (Manual Transmission)
I have a 2004 manual transmission Santa Fe. I've maintained it very well since new.
About 6 months ago I noticed it was getting difficult to manually shift gears. It wasn't grinding or anything, just "hard" to get it to go into the various gears while driving. Before, I could shift into any gear with just 2 fingers on the gearshift and it was smooth as silk.
I went in and had the gear oil changed. This was something I didn't even know needed to be changed and the guy said most people never do. They showed me the oil they took out and it looked more like black water than oil and smelled kinda funky. They changed the gear oil out, but still no difference, and in fact it's getting worse.
The best way to describe it is the only way I can really shift gears now is to find that "sweet spot speed" where the gears will change on their own (so to speak). I find it particularly difficult going from 1st to 2nd, such as when starting from a stop light. People almost rear-end me now as it takes me longer to get it into 2nd gear.
Once in gear it runs perfectly, no problems. The clutch seems to be working normally, except perhaps while stopped in 1st gear, it sometime seems to jerk a bit, and I find this most noticeable if I'm stuck in very slow moving heavy traffic with the constant stopping and then moving forward slightly and such.
It is almost impossible to "gear down" into a lower gear unless I'm at the speed where it would normally go into that lower gear on it's own. The best way to describe it is how it is possible to drive a standard transmission car WITHOUT a clutch if you shift at just the right time/speed. But I DO use my clutch, but if I'm not close to "that speed" it's really, really difficult to force it into another gear, and the few times I do try and force it, I'll often get a bit of grinding.
Jetta - Volkswagen :: Manual Transmission - Hard To Shift Between Gears
I went on vacation for a week and left my car at my parents house. I came back and now it has become extremely difficult to shift between gears. It's nearly impossible to get the car into reverse, extremely difficult to get it into first, makes a thud when pulling it out of first, is semi difficult to get into 2nd, but only a mild nuisance to get into 3rd through 6th.
For more information, the car is a 2012 Volkswagen GLI with just shy of 40,000 miles. The car ran just fine before I went on vacation and the car was not moved while I was on vacation. I did notice that a little ticking kind of sound when I had the car in neutral with no clutch. So the throw out bearing was starting to wear, but it was a very slight. But I haven't had any other problems.
Ford Transmission :: 2001 7.3 - Half Shift Between 1st And 2nd - Stuck In Gears?
2 wheel drive. No problems shifting until a few weeks ago when I put a chip in the truck. Then became a funny sort of half shift in between 1st and 2nd. Kind of a half shift and then a final hard shift into the next gear.
I have only driven the truck with the chip setting in economy by Gearhead which is 40hp. Well, all day driving in an economy but I have played hard with all the settings, smoking my tires and what not but never actually driven it into anything other than the economy.
Tonight it's done. Starting in the normal drive from a red light it was in between that funny shift and then it just fell back all the way with a hard thunk followed by it wouldn't shift at all out of first gear. Took it out of tunes, same difference. Found out when I take off in drive it won't shift on its own out of first but when I put it in second from the tree it shifts into second as normal, coming from the drive. Then when I start getting up into the rpm range that she normally should shift past second I put her back in drive and she shifts into third (and fourth?) normally. If I remove the overdrive it still immediately downshifts. When I turn it back on it shifts back up normally.
But again, starting from drive I have to put it into second and then into drive for it to shift. I still have reverse and it still kicks directly into first from the park and takes off, just doesn't shift from first to second on it's own.
I checked the tranny fluid, it's seemingly fine. Great red color and full. Does not smell burnt at all. No flashing light or anything anywhere either. No blinking on the overdrive light on the stick or no warning lights anywhere else.