Sonata NF (2006-10) :: 2008 2.4L Engine Cranks But Won't Start
I have an 08 2.4L Sonata with 95000mi. When turning the ignition it will crank and sound like its about to start but won't. I was able to get it to start by pushing the gas pedal a bit when it sounds like it wanted to start. Once started, it ran rough and would stall unless I revved it above 1500 RPM. Still sounded like it occasionally miss fired.
I kept it revved until it reached normal operating temp. When I took my foot slowly off the gas, rpm dropped to about 500-600 and it seemed to pulse . I think engine was raising throttle to keep from stalling. It stalls if I try to put in gear without pressing on gas to raise throttle.
The spark plugs were changed at about 70K mikes. I have not read any codes as the car is stuck in the driveway. Could it be a vacuum leak? I know the Entourages have air intake hose leaks that cause rough idle but with a 6 cyl it still runs. Fuel pump problem?
Ford F-150 (2004-2008) :: 2006 Truck Cranks But Does Not Start
I just went out to move my truck to take out garbage and it cranks but doesn't start. It is 4.6L 4WD. I sprayed ether in intake no change. Checked all fuses all good. It has been raining pretty hard the last 3 days and it has been sitting in rain all 3 days. I checked for codes with a simple code scanner no codes. But the code scanner I used is not able to do KOEO or KOER tests. I know it needs new plugs but it has never sputtered or died on me. Has slight misfire but not engine stopping. I havnt had any check engine lights or problems before.
View 3 RepliesFord F-150 (2004-2008) :: 2006 5.4L - Cranks Slowly But Won't Start - Codes P0201 - 208
Bought a truck from a guy the other day. Long story, but he was a con artist. Told me the battery was dead from cranking it, he couldn't hear the fuel pump so he thinks it needs a new one. Got it home, checked fpdm, it was unplugged. Plugged it in fp running now. Charged battery. Cranks slowly won't start. Appears the engine has been changed. Have codes P0201-208, all injector codes. Cranking it over reminds me of an older distributor type engine that if off its timing. But also of cranking with a low battery. There's a new starter on it already. I'm going to pull the converter bolts on the weekend to see if they may have bound the torque when they installed the engine. Injector codes?
View 4 RepliesAccent MC (2006-11) :: 2008 - Spinning Noise When Trying To Start The Car
Car died while driving home. Now it wont start. The tow truck driver that towed me home swears that the timing belt is out. Car makes spinning noise when I try to start it. I plugged in my code reader and got P0342 Camshaft Position Sensor Circuit Low Input. Not sure where to go from here. Do I replace the sensor or take it in to have the timing belt done? 109,000 miles.
View 7 RepliesAccent MC (2006-11) :: 2008 GS Difficult To Start Only After Fueling
I'm having an issue with my 08 Accent GS. It is very difficult to start, but only after fueling. Any other time, the car starts without any problems. I have tried to simulate the issue at home by taking off the gas cap and replacing it, but it didn't have the same result.
View 8 RepliesAccent MC (2006-11) :: 2008 GLS Stalled At Stoplight And Will Not Start
I have an 08 accent gls hatch that stalled the other day and wont start. Replaced the crank and cam sensors as well as the map and purge valve. Now it sputters and stalls with the fuel pump jumped. Has spark ans well as fuel at rail. What am i missing- no engine codes...
View 8 RepliesAccent MC (2006-11) :: 2008 - Series Of Clicks When Turn The Key And Car Won't Start
My accent won't start anymore. When I turn the key, I hear a series of clicks, but the car won't start. When I put the key in the ignition, lights/radio/wipers all work fine. It's a 2008 manual car.
View 3 RepliesAccent MC (2006-11) :: 2008 - Hiccuping When Idling And Start To Accelerate
When idling and when first start to accelerate it feels like my car is hiccuping. I don't know what the issue is. I do know When i first bought The car about 8 months ago the oils Got wet when The dealer power washed he engine.
View 4 RepliesAccent MC (2006-11) :: 2008 - Won't Start Up After Replacement Of Timing Belt
The timing belt broke in my gf's '08 accent recently and I decided to have a crack at replacing the belt after getting a quote for $900 from the nearest mechanic (with no guarantee it would fix the problem).
When re-aligning the cam and crank to TDC, I wasn't sure if it mattered which revolution the crank was on (ie. 1st or 2nd revolution) when putting everything back together. I tested rotating the engine with the new belt on slowly to make sure there was no contact and everything seemed ok.
So basically now everything is back together, tried starting it up and it won't start and now i'm wondering if it would make a difference or not if the crank was rotated 1 additional revolution. Otherwise there is more significant damage.
Accent LC (2000-05) :: 2004 - Cranks But Won't Start
My 04 accent will not start. I have an automatic. It cranks but will not start. First I replaced the fuel pump and relay. Still nothing. Wasn't getting fire until my friend tested to coil and i tried to crank while the tester was in the ground wire while I turned it over and it cranked. Only worked for about an hour and is still not starting but it sounds like something isn't telling it to crank?
View 1 RepliesAccent LC (2000-05) :: 2001 - Cranks But Does Not Start
I have a great little '01 Accent and it has been a blast. That was until it decided not to start. I was on my way home from work when I realized the car was acting sluggish. It was not accelerating like it should have and it was it did not seem like I was going as fast as it said. When I went to go use it again, it started, then died and has not started since. I checked oil, and it was low. It wasn't out, but it was low. I have checked batt, fuel filter, fuel pump, and loose wiring.
View 3 RepliesAccent MC (2006-11) :: 2007 Engine Cranks But Does Not Turn Over
My Accent recently died in traffic. All of the electronic components seem to be working. The engine cranks but does not turn over. I removed the spark plugs and they were soaked in gasoline and the plugs on the 1st and 2nd cylinder had a black residue. I dried them off and tried to start the car again, no luck. The spark plugs were soaked in gas.
Over the summer (5 months ago) 2 ignition coils fouled out and I replaced them along with all of the spark plugs.
Accent LC (2000-05) :: 2003 - Cranks, Has Spark But Won't Start
My wife's 03 accent cranks over good, but won't start. It does fire some but won't start. I tried squirting starter fluid in the intake and that only made it fire less. Spark is strong on all four cylinders. At first I thought I found the problem because it had weak spark on the middle two cylinders and i replaced that coil pack and now all four are strong, but still same problem.
She drove it home and parked overnight, and in the morning it wouldn't start. I don't think it is the timing belt. I replaced it not too long ago, and I took a peak behind the top of the cover and all still appears to be as it should.
I am now at a bit of a loss. I mean it has good spark, won't start with starting fluid, so what could it be?
Accent LC (2000-05) :: At Start Up Cranks - Starter Won't Working?
Went to Advanced Auto to get the battery tested since it takes a few cranks for the engine to start. I thought it was the battery but after testing the battery they think maybe its the starter because the battery and alternator shows that its perfect.
I will also be taking the car to get the timing belt and drive belt replaced and the spark plugs and wires. I just want to know if you all think its the starter or should i check anything else.
Accent LC (2000-05) :: Cranks But Will Not Start / Fuel Pump Was Not Spinning
Accent that will crank but won't start. I found out that the fuel pump was not spinning, so I purchased a replacement. Before installing it, I connected all of the wires and the new pump wouldn't spin either. I then hooked the pump directly to the battery and it spins with no problems. After that I realized that the power wire for the pump must be shorting somewhere. So I hooked up the old pump and ran a new power wire from the relay box to the pump. The pump now runs, but the car still won't start. I definitely have fuel to the rail now. I unhooked the fuel line at the fuel rail and it sprays as soon as I turn the key to "On". Now all I need to know is if I'm forgetting something (bleeding the fuel rail?, etc.). Are there any other parts I'm forgetting?
View 24 RepliesAccent LC (2000-05) :: Car Cranks But Won't Start For Hours / Days Intermittently
I have a 2002 Hyundai Accent with about 222,000 mikes on it. It runs extremely smoothly, but I've had problem after problem with startup. My clutch sensor was loose for a while, replaced my starter, replaced the ignition coil, everything that could stop the thing from starting up has happened. Finally for the last couple weeks, the car has had these spells where it will crank forever and not start, like it did when I replaced the coil (I did that again just in case, not the problem). These spells last varying mounts of time.
A few times it's started up in minutes, and two times now it's been out for at least a day. I've checked everything and it seems to not be getting spark when it's not starting. I'd really like any insight to this. I'm considering changing my crankshaft position sensor and camshaft position sensor, but I can't even find those on my engine. What could be causing this? I really need a car that will start up and is reliable. It should be noted that the car USUALLY starts fine. This only happens about once every 5 or 6 days.
Accent LC (2000-05) :: Hyundai Died At Idle On Park Now Cranks But Won't Start
Car died at idle on park. Tried to start it back up and was only getting crank. I took it to a local mech and he said my timing belt failed. I paid for the repair and the car still wouldn't start. The shop said the ecu went out. I replaced the cam position sensor and main relay under the dash. Still not getting it to start. I also have a ecu from an 05 accent, would this be plug and play? What else can I do?
View 3 RepliesAccent LC (2000-05) :: 2001 GS Won't Start / Engine Cranks Fine But Doesn't Fire
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
Accent LC (2000-05) :: 2001 1.6 Cranks But Won't Start / Car Wouldn't Shift Into High Gear
I have just recently acquired an 01 Accent with the 1.6L and have had a few problems with it. It has about 112,000 miles on it and at about 109,000 it had the following services performed by the previous owner (reputable shop did the work)
-New battery
-New timing belt kit
-New water pump
-New valve cover gasket
-New plugs
-New belts
-New front pads
-New front rotors
-New rear wheel cylinders
-New front CV axles
-New tires all around
-Alignment
Now since I got it with about 111,000 miles on it, it ran and drove great until I had to put a new alternator on it as well as having to take the center console and automatic shift lever out to repair the wires for the O/D button. Car wouldn't shift into high gear. The problem I am having now is the car will crank but it will not start. Not even a sputter. I drove the car to and from work the day previous and then went out and started it to go to work in the morning and it started fine and ran fine for a minute or two then it just died like I turned the key off. No spitting or sputtering like it was running out of gas just died completely. Checked a few fuses and such and really not sure where to go from here because I don't have a code reader and don't wanna just throw parts at it, I would rather troubleshoot the problem.