Accent LC (2000-05) :: 2001 - Intermittent Central Door Locking Failure
I have an accent 2001 saloon which I bought a few months back. Turned out to be a real bargain but the door locking feature is really irritating. It will work 2-3 times in a row then stop for the rest of the day. The next day it works first thing but may not work again for several hours. Then 2-3 times in a row .. yeah you guessed it - the dreaded intermittent fault.
Now, the door handle inside the door has broken (plastic piece has snapped) so I am fitting a new one. Thought it might be a good idea, while I am at it, to have a look inside the door. I took out the whole door lock mechanism - see photo 1. Having found I could get it out, I put it back pending a bit of advice.
I presume that there is some sort of electric-powered actuator or solenoid or whatever, that locks all the doors from the drivers side. Is the piece I am talking about, the close up in photo 2?
If so, (or not) what is the likely fault here, and what can I do about it? I have put some WD 40 spray into the locks and eased them a bit. Otherwise not sure what to change/replace.
Tiguan :: Central Locking From Key Fob
Every VW I've owned has incorporated a central locking feature (i.e. - You hold the key in the off position, and it closes the windows and sunroof). Does our car not have that option? I though I heard somewhere that if you hold the alarm set button in the key fob that it'll close everytihgn, but that doesn't work.
View 9 RepliesPassat (B5) :: How To Get The Windows To Go Up With Central Locking
I was wondering if it's possible to get my windows to all close when I press my central locking on my Passat? It's a 2001 B5.5 model with front and rear electric windows. Is it possible and if so how?
View 6 RepliesGolf/GTI VI :: Where To Change Central Locking Settings
I am trying to set my locking system so that one touch on the remote (lock or unlock) will control both doors and the hatch, instead of having selective unlocking; I can't find this in the MFD menus, and I can't seem to access Controller 46 through VCDS, or anywhere else I'd expect to find that function. but where to change this setting?
View 22 RepliesGolf IV R32 :: Boot / Tailgate Not Opening With Central Locking
I'm having some problems with my tailgate (boot) handle. At the moment the boot 'intermittently' works with the central locking. If it doesn't unlock then I have to use the keyfob to open/close a few times before the handle opens the boot. Fortunately it works every time with the key. I must stress that I've never used the key in the boot. The boot lock is set to work with the opening/closing of the central locking. So this problem is NOT user error.
I have posted some pictures of the problem I've now seen with the mechanism. Ok so in the above picture, you can see that I've put a black arrow pointing at the 'latch' in it's correct position.
When you operate the central locking via the keyfob (or inside the car), it pushes the electrical popper (to the left) which rotates the mechanism CLOCKWISE, and in doing so, it pushes the LATCH across so that it can connect with the boot handle
In the following picture, you can see how the 'LATCH' isn't moving across to the position in the first pic. This is why my boot can't open with the central locking.
I must make clear that the electric popper is doing the job as it should. There is nothing wrong with it's function. The problem is the latch is not rotating (clockwise) into it's correct position. It can be moved by hand easily.
The problem could be solved by attaching a spring to the latch, so it pulls downwards. But I cannot understand why or what has stopped it from working as it should. The latch moves fine if you use the key in the lock, so at the moment, the only way to make it open is either open/close the central locking 10times, or use the car key.......
Prius (2004-09) :: 2005 - Remote Central Locking Not Working?
My 2005 Prius has today developed a fault, the central locking won't open or close with either of the remote key fobs. I allowed for a strange coincidence that the batteries in both fobs could die at the very same time and replaced one, still not working. The mini-key in the fob will open/close the central locking (all doors plus rear hatch). But of course the alarm would sound as soon as I opened the door, inserting the fob into the "ignition" socket and starting the car silenced the alarm after about 30 seconds, but the remote fobs still won't operate the central locking or activate the alarm.
View 5 RepliesBmw - 325 :: 2004 - Central Locking System Not Working Properly Occasionally
Had this car for two years and I love it, but the central locking has been a bit glitchy since I bought it. Sometimes it works perfectly for weeks.
Sometimes it unlocks the driver door just fine, but a second click of the button won't open the other doors.
On a couple of occasions (today was the second time) it won't unlock any door. If I use the keyhole in the driver door to unlock that door, I have to hold the key to force the lock to stay up while I pull open the door with the other hand. If I let go of the key, it relocks itself.
After I manually unlocked and opened the driver door, I reached in and pressed the button on the console. It would not unlock the doors. This car has only one door keyhole, the one on the driver door. Locking always works on all doors, and it locks the doors itself as it should as I take off down the street.
When it is misbehaving, it misbehaves with either key and the console button does not work either, so I am pretty sure the problem not the transmitter.
If it always behaved as it did today, I would suspect that the microswitch in the driver door was shorting, and telling the system that the key was in the door and turned full right all the time. However, that would not explain why the usual failure is to open the driver door but not the others. Where is the receiver for the remote lock control?
Camry :: 2005 - Central Locking Will Refuse To Lock The Doors Occasionally
I have been having problems on and off with my central locking for a while now with my 05' Toyota Camry Altise. 95% of the time it works perfectly, however occasionally the central locking will refuse to lock the doors, chirping at me twice as if a door is open. I know that all of the door switches are working fine so this isn't the cause of the problem.
I believe it may have something to do with the fact that I had to replace my driver side door a while ago, and that now the actuator may not be working properly or misaligned and jamming. What should I be looking for to make sure this doesn't occur? I thought it all went back in perfectly. Interestingly I can get around the problem by turning the ignition on and off and trying again.
Santa FE SM (2001-06) :: Driver Door Controls For Central Locking Does Not Unlock The Doors
I have a sante fe which has problems (suspect multiple) with central locking , intermittently locking itself - very annoying - even driving down the road.
Drivers door controls for central locking unlock button does not unlock the doors - button just doesn't do anything. Lock button works fine. In addition window controls on drivers door dont work - only control that works is the one for the drivers door.
Final piece of the puzzle - the red light in the drivers door does not work either nor does the drivers door button panels light up. Starting to wonder is there a fuse or quirky power supply problem somewhere.
Santa Fe (CM - 2007-12) :: Loud Buzz Comes From Nearside Front Door / Noisy Central Locking
Every time car is locked, a very loud buzz comes from the nearside front door. I have had the problem for over a year - the locking still works, but clearly something is wrong.
View 5 RepliesFord Excursion :: 2000 - Hubs Locking Warning
The 2000 X I have has Warn locking hubs on them. Just to be clear, I'd need to switch them to 'lock' then choose either 4-Hi or 4-Low on the dash in order to engage the transfer case, correct?
View 8 RepliesWindstar :: 2000 - ABS Warning Light On And Off Intermittently
I decided to tackle my ABS warning light issue because it's been on and off intermittently since I bought it.
I first suspected bad wheel sensor(s) per many previous threads. I borrowed a scantool with the ABS diagnosis and found that all 4 wheel sensors are reading same speed value, but they indicate wheel speed of about half of the speedometer reading. Another thing I noticed was that the ABS main power relay output is "1bit" when the ABS warning light is OFF and is "0bit" when it is ON.
So it seems like the ABS power relay is bad. My alldata manual for this model says that the part number for the relay is FOAZ14N089A but it also says that "the ABS is not equipped with an external ABS Relay. According to wiring diagrams provided by Ford, the function of the ABS relay is incorporated into the ABS module". Does this mean that I have to replace the whole ABS module or HCU just because the relay is bad?
Why wheel speed is different than speedometer?
Accent LC (2000-05) :: Odd Vibration And Belt Squeal Intermittently At Idle
I am posting about a cam sensor code and alternator belt squeal.
Yesterday after getting in from a 600 mile drive from salt lake to eastern Oregon i took a look at the car to put some fogs in and clean it up a bit. It had always had some odd vibration at idle and belt squeal intermittently at idle. I pressed down on the alternator at idle and the vibration noise went away. So bam. Found that.
The nut on the square head mounting bolt holding the alternator was missing. So it was kind of just flapping around. Replaced the bolt and put a lock nut on. Problem solved so I thought.
I'm still getting belt squeal. And i think that its out of alignment. It looks like the pulley side of the alternator is closer to the engine block than the other side. Is this adjustable? Is the bushing on the mounting side worn out to the point of movement? Is this fixable?
Accent LC (2000-05) :: Car Cranks But Won't Start For Hours / Days Intermittently
I have a 2002 Hyundai Accent with about 222,000 mikes on it. It runs extremely smoothly, but I've had problem after problem with startup. My clutch sensor was loose for a while, replaced my starter, replaced the ignition coil, everything that could stop the thing from starting up has happened. Finally for the last couple weeks, the car has had these spells where it will crank forever and not start, like it did when I replaced the coil (I did that again just in case, not the problem). These spells last varying mounts of time.
A few times it's started up in minutes, and two times now it's been out for at least a day. I've checked everything and it seems to not be getting spark when it's not starting. I'd really like any insight to this. I'm considering changing my crankshaft position sensor and camshaft position sensor, but I can't even find those on my engine. What could be causing this? I really need a car that will start up and is reliable. It should be noted that the car USUALLY starts fine. This only happens about once every 5 or 6 days.
Accent LC (2000-05) :: 2003 - Idle Varies Between 800 To 1500 Intermittently Within Seconds
My car is standard 5 speed transmission, when my car is running my idle varys between 800ish to 1500 intermittently within seconds and if I don't drive it after starting the car it will stall on me (in neutral) after the rpms go up and down about 9 times.
The thing I found is if I disconnect my idle air control valve attached to my throttle body it stops the jumps in rpm. I have tried replacing the valve with one of my friends control valve Hyundai accent 2004 that works and fits perfectly on his doesn't work on mine. Right now I have my idle air control valve disconnected at the moment but i want to fix this issue because my rpms are at 1300 at idle.
Accent LC (2000-05) :: 2001 Engine Cuts Out Intermittently - Idle Roughly
Been having a fair bit of trouble with my accent, at first my car sometimes would hesitate on acceleration in 1st gear. Now it has a rough idle and the engine just completely cuts out at random. It does however start straight back up. It makes an odd noise whilst idling almost like a misfire from the exhaust. On start up it blows a lot of white smoke. And when you do get driving it is really jerky. It's been serviced every 5000ks. I've changed spark plugs, map sensor and throttle body sensor, put a fuel injector cleaner through and still no improvements. It's been booked into the mechanics for next Tuesday.
View 1 RepliesAccent LC (2000-05) :: 2004 - Check Engine Light Coming On Intermittently
I have a 2004 Accent GS. It is an automatic. I have had it for almost a year.
In early November, the check engine light came on when the temperature dropped drastically and it went off when it warmed up a bit about 3 days later. Since then it seems to come on randomly and stay on for a few days then go off (usually around once-twice a month). Then in late December I noticed that the car had trouble starting after I refueled it, the first two times I though it was because I had let the fuel get down too much. Now every time I fuel up it does this. But just the first time turning on the car and no other time after that.
The check engine light had not come on again for almost a month, and then about a week ago it came on again. I double checked all the fluids and the gas cap but that's about as far as my knowledge of cars goes. When the light has come on I have not really noticed any handling differences. However since I need to put the car through an inspection very soon it is now concerning me a bit more. What could be causing the check engine light to go on and off?
Accent LC (2000-05) :: Motor Stalls At Idle Intermittently - New Fuel Pump Installed
Motor has been stalling intermittently since May. Finally had the fuel pump replaced last Friday (8/17/12). have been driving the car back and forth to work since then with no problems until yesterday. Made a run to the local convenience store and the car was shut down for about ten minutes. Came back out and car would not start! Gave it about 10 minutes and then it started again. Got it into the garage and let it run for awhile and it stalled out. Got the check engine light (a first for that) so swapped the fuel pump relay with one of the same part number. Fired right up and did not stall out.
Also, check engine light went out on its own. Swapped relays back to original positions, motor started right up, stayed running and check engine light went out on its own. What could be causing my problem? Since check engine light came on then went out on its own, would there be any trouble codes to read? One other thing, original relay has pinkish residue on the pins. What could that be about? First time poster so I hope what I have typed out makes sense. 2003 Accent 4 door with 1.6L DOHC motor. Approx 79000 miles.
Accent LC (2000-05) :: No Low Warning Fuel Indicator
I have a hyundai accent 2005 vehicle and there is no Low warning fuel indicator in the vehicle. My entire fuel tank ran dry still there was no low fuel warning light. According to my mechanic there is no low fuel indicator installed in the fuel pump
My VIN number is KMHCG41GR5U633054