Accent LC (2000-05) :: Power Steering Pulley Stops Spinning
I have a 2002 Accent 1.6L and when I turn the wheels all the way too the right or all the way to the left the pulley stops spinning. Could this be that the pump is going bad or something else?
View 2 RepliesAccent MC (2006-11) :: 2009 - Noise Coming From Power Steering Pulley
So I purchased a 2009 Accent hatchback about 11 months ago and so far its been great. However, recently (as in the past 2 weeks or so) I have begun noticing a strange cyclic noise developing from the engine compartment accompanied with some minor vibrations. Over time it has grown more prominent. I would rather deal with this before it becomes worse (and more costly) if its a serious issue.
Some info: I recently took a trip to North Carolina (from Florida). I also recently replaced the spark plugs before I left, so they are relatively new. The car has about 37k miles. After popping the hood and taking a look, it seems as though the noise is coming from the power steering pump/pulley area. The noise seems to match the rotations. Either way, here's a video of the noise (pardon the moving in the video, I was mainly recording for sound): [URL] ....
It may sound like normal engine operation, but it did not make that cyclic sound for the first 10 months, so it worries me. Perhaps I'm just paranoid.
Accent MC (2006-11) :: Power Steering Pulley Locking Up And Start To Slip
I have a 2007 Accent GLS with 70,000 km on it. At times, my power steering pulley will lock up and start to slip. All belts have recently been replaced. After about 2000 km after replacement, is when the problem started. The problem is intermittent and the pump itself turns freely after the belt is removed. When it locks up a loud squealing sound can be heard. This happens only when tight turns are made (usually it's to the left). Could it be related to the pressure switch relief or relief valve?
View 11 RepliesAccent LC (2000-05) :: Power Steering Pump Making Lots Of Noise
My car is a 2002 Accent. So last weekend I replaced my timing belt and my 3 other belts. Before I did this the belts were not squeaking and I was not having any issues with my power steering. I started my car up and the power steering pump was making lots of noise, the power steering reservoir was still full. I was told it's probably the power steering pump and that I would need a new one. So I got a new one, put it on and still the same thing. I looked online and saw that it may be an air bubble in the line so I removed the cap on the reservoir and, with the car turned off and the front wheels off the ground, cranked the wheels lock to lock about 20 times. I started the car and it still makes noise. This morning the power steering felt like it was lagging as I was backing out of my driveway and the squeaking happens when I am idling and gets louder and worse up to about 2000 rpm then stops, which it has been doing since I replaced the belts. I am not sure what else to do, did I mess up the new pump by driving and not bleeding the air out?
View 2 RepliesAccent LC (2000-05) :: Power Steering Belt Is Making Squeaking Noise
The steering on our 02 Accent has been becoming more and more difficult. The belt on the AC compressor snapped off recently. Could this missing belt be causing a problem with the power steering belt? The power steering belt is now making a squeaking noise.
View 3 RepliesFord Ranger / B-Series :: 2000 - Power Steering Pulley Wobbles Slightly / Belt Squeaking
I purchased a new 2000 mazda b4000 2 weeks ago and the belt was squeaking and I knew I had to change the water pump so I replaced it and the squeaking didn't went away... I thought maybe my idler pulley bearing was worn out cause I could see it wobble back and fourth when the engine was running... Replaced it, still squeaking! Change my belt still squeaking! look further turns out my power steering pulley wobbles slightly. I'm thinking about trying a gator back belt and see if the squeaking goes away. Could it be dangerous to run the truck as it with a slight misalignment in the power steering pulley? or it'll be a must replacement asap?
View 3 RepliesAccent LC (2000-05) :: Leak In Power Steering System
2002 Accent GS, automatic 1.6L engine ... Have a leak in the Power Steering system and I was wondering if it was safe to take the Power steering pump belt off just to get to my mechanic (who is about 18 miles (27 Km) away). I would rather not get towed, but I don't want to do any damage either. I am not all that mechanically capable but think I can get the belt off myself.
View 4 RepliesAccent LC (2000-05) :: 2003 - Tightening Power Steering Belt
Where to find a nice, simple step by step instructional for tightening power steering belts for a 2003 hyundai accent?
View 4 RepliesAccent LC (2000-05) :: No Power Steering - Belt Screech During Cold Start
Awful belt noise that erupts during cold starts. I realize that this usually means a replaced belt. I want to know how to go along diagnosing which belt and then how to replace it. Here's the symptoms:
1. Awful belt screech when turned on, goes away within 20 seconds
2. Belt noise comes back when turning the wheel to back out of a right driveway
3. The STEERING WHEEL feels like it has no power steering WHILE the screeching is happening.
4. The headlights (when on) dim for about 3 seconds
5. All these symptoms happen when the temperature is below freezing and it's a cold start.
How is the belt screeching connected to the steering wheel being tough I turn?
Accent LC (2000-05) :: 2002 Slow Acceleration / Seems Like Losing Power
I have a 2002 accent 1.6.(272,000 miles) It has been having this issue for awhile now. It is very slow to accelerate, seems like it is losing power. Also if I press the gas pedal hard it does not want to shift correctly unless i back off the gas pedal some and then it will shift fine. I have had the transmission checked and it has no issues (transmission has be replaced with only about 80,000 miles on it). Also if i try to run the AC it really looses power. It currently does not have any diag codes when I have it scanned. So far I have replaced spark plugs, ignition coil, fuel filter, and a diode that I was getting a code for. I am just curious if there is something that could be causing the issue that will not report a code.
View 5 RepliesAccent LC (2000-05) :: 2002 - Loosing Power / Light Dimmed
Today I had to boost my car three times, once boosted, I was loosing power, my lights dimmed, and my rev-ometer had stopped working.
My father said it would be a connector cable, the battery was very corroded. I just had my cat-converter replaced wednesday. today is the first time i've had this issue, i've had the car for just over a month now.
I'm really hoping its not my alternator. Because that would suck.
Accent LC (2000-05) :: 2002 - No Power To Fuel Pump Or Injectors
2002 accent with 70k on it the 1.6L
Here is the problem, the car sat for two years and when getting her back to life it would start so i started testing everything i could find. here what I get
Gets spark
Power to the cam and crank sensor.
All fuses and relays are good.
Found out the ecm was not grounding the engine control relay to turn on the pump and injectors so i added my own ground to the grey/orange wire and the pump turned and and it fired right up.?
so my question is what does the ecu look for to turn on this relay?
It was fine for a few days but now even with the relay grounded (activated) the car doesn't start . but let it sit and try again in ten mins and it will start every other time I come home from work and try....but i do still get power to the pump and injectors.? There might be a electrical monster in this car but I don't know what else to check.
I have another accent same year so I switch the ecu and every relay i could find over from the run ing car and i still have this problem, also changed the cam and crank sensor, so I am at a dead stop.
Accent LC (2000-05) :: Power Steering Lost After Cold Start / Came Back After Car Gets Warm
This problem has plagued me for a while(since last year). When I start the car in the morning, there's a brief period when the power steering is totally gone. When the car is thoroughly warmed up(after 2 minutes of driving), the power steering is back and there will be no problem. Wondering what could that be. The power steering fluid level is normal.
View 5 RepliesCelica :: 2001 - How To Remove Power Steering Pulley
I need to remove the power steering pulley on a 2001 Toyota Celica GTS to replace the pulley shaft's seal. I've got several pullers, so I figure one of them will work. But, I'm concerned that when I pull it out it could damage whatever it messes with inside. Also, I'm going to try doing this with pump on the vehicle.
View 1 RepliesAccent LC (2000-05) :: 2003 - All Metal High Pressure Power Steering Line Has A Leak
I have an 03 Accent. The all metal high pressure power steering line had a leak. So I bought a new one for around 70 dollars from Hyundai. This part has a curved shape and fits around the radiator. The old one was difficult to get off, but the new one is proving impossible to get on. I cant get it into place.
View 2 RepliesSanta FE SM (2001-06) :: Power Steering Pump Pulley Broken
My Santa Fe has a broken power steering pump pulley. Darn thing broke right around the spindle! I can not find a replacement anywhere. I've tried to find a one new, used and at the upull lots (only one Santa Fe in at Pick n Pull dang thing was stripped clean!). The pump is easy to find but this pulley is a ghost!
View 3 RepliesAlignment - Belts :: 1994 Ford E150 - Power Steering Pulley Out Of Line
I have a '94 Ford E150 (6 cyl). A few weeks ago the pwr steering fluid began to leak. I couldn't readily see where it was coming from and thought no big deal I'll wait until it's more pronounced. After a week or so of topping off the fluid, I heard a pop under the hood as the serp. belt broke (sheared off actually). Not sure if it matters but at the time I was all manual power with the steering as all the fluid had leaked out.
That's when I noticed that the power steering pulley was slightly out of alignment with the others. I replaced the belt, limped home and the next day the new belt sheared off like the 1st (in ribbons wrapped around the fan). Never had this happen before but is there any way to adjust positioning of the power steering pump and pulley?Looking on the bright side, I'll definitely have a chance to get to that leak now.
Ford F-150 (2009-2014) :: Oil Slowly Leaking Near The Power Steering Pump Pulley
2010, 5.4L... Noticed a small oil spot under the truck this morning. Took it into the shop after work, we lifted it up, and ran it for 15 min to see where the leak was coming from, and the truck did not leak a drop... until we turned it off. The oil would slowly leak near the power steering pump pulley. But only when the engine was not running ...
View 1 RepliesCelica :: 2002 - Power Steering Loud Whining Noise After Motor Swap
I am a Honda/Acura nerd. Decided to buy my friends 02 Celica that had piston slap from the famous oil consumption issue i learned about. Did a bunch of research and swapped in a Corolla motor. Everything seemed to go as normal, its in and running just fine. Only problem is now the power steering pump is making a very loud whining noise like its low on fluid.
Now first i must say the car ran, drove and turned just fine before the swap. No noises or issues aside from the piston slap. On the 1zzfe engine there is 2 bolts to remove the power steering pump and move it out of the way, easy enough.
My question is how did the power steering pump manage to get damaged? I've inspected under the car a bunch of times, inspected the top of the power steering pump, inspected everything i could looking for a problem. I just don't see any...no smashed hardlines, no leaks, has plenty of fluid, sensor is firmly plugged in. I notice when it is making the whining sound, the hardline that connects to the top of the pump is vibrating, which is what is making the sound i guess...if i crank the wheel all the way to the right or left it doesn't make the noise at all...