Accent MC (2006-11) :: 2008 GLS Stalled At Stoplight And Will Not Start
I have an 08 accent gls hatch that stalled the other day and wont start. Replaced the crank and cam sensors as well as the map and purge valve. Now it sputters and stalls with the fuel pump jumped. Has spark ans well as fuel at rail. What am i missing- no engine codes...
View 8 RepliesAccent LC (2000-05) :: Stalled When Coasting Down A Hill And Now Won't Start
Was coasting down a hill(manual transmission) and the car stalled out on me. Tried for a couple minutes to restart it with no luck, the engine turns over but just wont start.
As I post this I still haven't got the car home so I haven't been able to do any trouble shooting yet. Once I get it home I'll ceck for fuel and spark, and from what I have read already people have said it could be the Crankshaft Sensor.
2001 Accent 1.5 - Manual
Up until this there has been no signs of any issues with running or starting...
Accent LC (2000-05) :: Stalled When Braking To Make A Turn
Driving along down the highway, was braking to make a turn and they car stalled on me. tried to crank it over in neutral. then pulled over put it in park and cranked it over, nothing... got a tow home and in the garage. The car will turn over till the cows come home and i can smell fuel. I pulled a spark plug out and got a spark. Check engine light stays on with the battery light.
2005 accent 1.8
148k miles on it
new spark plugs
Will I get a spark if the crankshaft position sensor is bad?
Elantra XD (2001-06) :: 2002 GT Died While At A Stoplight And Won't Start
I have a 2002 Hyundai Elantra 2.0 5spd manual GT with 90k miles. I just bought the car 2 weeks ago. The previous owner claims he did regular maintenance on it. He said the timing belt and water pump were done around 65k miles but didn't have paperwork on it. Has brand new tires. Battery is a year and a half old. I just replaced the spark plugs and plug wires a few days ago just because I don't know when the last time the previous owner changed them. 3/4 showed normal wear and were probably needing to be replaced. One of them (the one all the way to the drivers side) had a decent amount of corrosion built up in the wall leading down to the spark plug and then around the fitting for the 5/8 socket had quite a bit of corrosion around it to. The end of the plug looked like the rest of the plugs however. Before I installed the new plug I cleaned it up. As far as I know there isn't any other mechanical issues. He said he had the clutched replaced too. Which I find a little odd because it doesn't even have 100k miles on it yet and if it wasn't driven like a race car, that clutch should last a lot longer I would think.
My girlfriend was driving it home from work today and it died on her when she stopped at the off ramp of a freeway. I showed up and pushed the clutch pedal down as hard as I could and it fired right up. However, I walked away then she called me back because she couldn't get it to accelerate after that. Unfortunately I didn't actually try to drive it at that point which was stupid so it's possible she just didn't have it in gear all the way however it appeared that she did. It then shortly after died and hasn't started since. I'm getting power to everything else in the car including headlights and some lights and everything else I can think of. It won't even attempt to crank. It just does nothing when I try to turn it over.
I believe a few people recommended changing the crankshaft sensor. I have read that if the crankshaft sensor goes bad it will have the problem I am currently facing. At this point I'm assuming my girlfriend just didn't have it in gear and that's why it couldn't accelerate because if that wasn't the case, then that sounds to me like it's slipping and the clutch needs to be replaced. Anyways, other than the crankshaft sensor, I am thinking possibly the starter or alternator. I know it has a MAP instead of a MAF sensor and I know where it is but I'm not sure if that would cause this issue because I figured it would at least turn over. If it was the alternator if the batteries were dead I would charge them and if it died again that would be a strong indicator it was the alternator. But the batteries didn't really read low and I threw them on the charger anyways and it said it was fully charged shortly after I did that, and then I tried starting it again and still nothing. So right now I'm leaning towards the starter or this crankshaft sensor. My buddy said to take a screwdriver to the starter and try to jump it but how exactly to do that to test it. I have read multiple things online for other vehicles that the crankshaft sensor being bad will cause the car to not start.
Accent LC (2000-05) :: Stalled While Driving - Check Engine Light Popped On
2 days ago my 2000 Hyundai accent Gl 1.5 stalled while driving i lost no power to my electrical system all my lights and stereo stayed on but i lost all engine power the check engine light popped on and i had to have a friend tow me home this has never happened to me before. I had sat in my yard for about a year before i started driving it again due to money problems. I did a tune up on it before I took it out anywhere and ran some lucas injector cleaner and changed oil added some oil additive and changed my air filter spark plugs seemed fine so I didn't replace them and it ran for almost a month just fine i have about 150k in miles on it then suddenly just died while driving home from work I am thinking its in my fuel lines filter or pump are clogged up but I am not sure. I am going to start diagnosing it tomorrow. I can't get the check engine light looked at cuz I can't get it started.
View 2 RepliesAccent LC (2000-05) :: 2001 Won't Start But Has Power
I've got an 01 Accent and recently the thing won't start. It's acting as if the battery is dead when I turn the key despite having power to the rest of the car.
It doesn't even turn over but you can hear the gas pump kick in. I'm thinking it's the ignition switch that's faulty but I'd like to see what everybody here has to say before I start taking the column apart.
Accent LC (2000-05) :: 2001 - Cranks But Does Not Start
I have a great little '01 Accent and it has been a blast. That was until it decided not to start. I was on my way home from work when I realized the car was acting sluggish. It was not accelerating like it should have and it was it did not seem like I was going as fast as it said. When I went to go use it again, it started, then died and has not started since. I checked oil, and it was low. It wasn't out, but it was low. I have checked batt, fuel filter, fuel pump, and loose wiring.
View 3 RepliesAccent LC (2000-05) :: 2001 - Crank But No Start
2001 1.6 Accent ... The check engine light is not coming on when i put the key in and turn it...i checked ecu fuses they are all fine ...
View 2 RepliesAccent LC (2000-05) :: 2001 / 1.5 - Stalling When Let Off The Gas And Start Slowing Down
This just started over the weekend. It's stalling. It does it mostly when I let off the gas and start slowing down. If I give it gas, it seems to straighten out for a minute. It has done this a couple of times while driving also. It sounds as if the engine speeds up and then slows down and stalls. The check engine light is on also. It went out yesterday and then popped back on today.
View 2 RepliesSanta FE SM (2001-06) :: 2002 2.7L Won't Start After Engine Seized / Replaced
2002 2.7L. Engine seized. Bought a replacement also from a 2002. Tried to start today and no spark. I just replaced the physically broken crank position sensor. That seemed like it would be an obvious and easy fix, but still no spark. The broken sensor had frayed/shorted wires. Could that have damaged the PCM /ECU? There is a 2003 Santa Fe at U-Pull-It that was running when it came in. Will the PCM from that work? I am running out of time. I have to have this running before I leave on a flight tomorrow night. I do have a code reader (if I can find it) but I can't imaging it would have any codes if it hasn't started since I had the battery out. Not sure how that works.
View 4 RepliesAccent LC (2000-05) :: 2001 Suddenly Died / Single Click When Try To Start It
My fiance was driving my 2001 Accent, 1.6 manual trans, when it suddenly died. Now when I try to start it, I only get a single click. I also tried popping the clutch and nothing.
View 7 RepliesAccent LC (2000-05) :: 2001 Car Will Start And After 1 - 2 Minutes Violently Shakes Then Stall
My 2001 Accent doesn't give me any power when its cold in fact when I try starting it when its cold, the car will start and then after 1-2 min would violently (may be that's a little too strong a word to describe it) shake and then stall. This happens about 1-2 times and then the car finally starts.
If I drive my car uphill (not a very big), after heating it up, car would just start moving along slowly (or stall) even on the first gear and full gas. And sometimes while driving the car loses all power. It just trudges along no matter how much gas I press,
I no nothing about cars, so I am not sure if I conveyed my problem correctly. I just hope that the problem is fixable and wont cost me my entire salary to fix.
P.S: I always thought that the problem was me and that I couldn't drive a manual. Today a friend of the mine, who has been driving manual for 20 years also had the same trouble.
Accent LC (2000-05) :: 2001 GS Won't Start / Engine Cranks Fine But Doesn't Fire
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
Accent LC (2000-05) :: 2001 1.6 Cranks But Won't Start / Car Wouldn't Shift Into High Gear
I have just recently acquired an 01 Accent with the 1.6L and have had a few problems with it. It has about 112,000 miles on it and at about 109,000 it had the following services performed by the previous owner (reputable shop did the work)
-New battery
-New timing belt kit
-New water pump
-New valve cover gasket
-New plugs
-New belts
-New front pads
-New front rotors
-New rear wheel cylinders
-New front CV axles
-New tires all around
-Alignment
Now since I got it with about 111,000 miles on it, it ran and drove great until I had to put a new alternator on it as well as having to take the center console and automatic shift lever out to repair the wires for the O/D button. Car wouldn't shift into high gear. The problem I am having now is the car will crank but it will not start. Not even a sputter. I drove the car to and from work the day previous and then went out and started it to go to work in the morning and it started fine and ran fine for a minute or two then it just died like I turned the key off. No spitting or sputtering like it was running out of gas just died completely. Checked a few fuses and such and really not sure where to go from here because I don't have a code reader and don't wanna just throw parts at it, I would rather troubleshoot the problem.
Prius (2010-12) :: Rough Idle At Stoplight - Dash Says Motor Off
I tried searching and only found rough idle at startup, so here is my issue. At the same point in my AM drive, quite often I'll come to a stoplight and the motor will idle fairly roughly. If I switch to the "car" on the dash, it indicates the motor should be off. It is not charging the battery. Today it did it when I was only one bar from full battery. Also did it at the next light I came to.
This happens at the end of the commute. I've already covered 40+ mostly highway miles.
Accent LC (2000-05) :: Blower Motor Not Coming On At All
My girlfriend has a 2005 accent and recently the blower motor started working intermittently.. After a couple of days of it coming on and off it now wont come on at all.. After checking the 30amp fuse under the hood, and the relay they all seemed to be in good shape, I even swapped them out with other fuses and relays to make sure that wasn't the problem. I checked for power at the Motor and it has 12 volts going to it when the fan switch is on.. so I pulled the blower motor itself and connected it directly to a 12 volt source and it worked, eliminating the possibility of the motor itself being seized. Now I read up on a few sites on how to check the resistor, so I did a few continuity tests on the resistor itself and didn't see anything out of the normal.. What I should check next or what the actual values on the resistor check I should be reading..
View 1 RepliesAccent LC (2000-05) :: Motor Struggling From Low RPM Acceleration
My problem is this: when I am driving and press the throttle hard from low rpm (anything under 2000-2500), the car will struggle to pick up rpm, and be incredibly sluggish to accelerate, until it reaches around 3500 rpm, at which points it returns to normal. Whilst it is struggling to accelerate, the exhaust sound is almost like a subaru, in that there is a series of small burp noises which stop once it returns to normal acceleration. It only whilst attempting to accelerate from low rpm that I have this problem, i.e. idle plus mod-high rpm is fine.
View 2 RepliesAccent LC (2000-05) :: Rattling Noise In Motor Area
I have 2000 accent 1.5 man trans have had it for 2 years it runs good have done alot of regular maintenance but since i have owned it there was a rattle coming from motor area assumed it was heat shield of some kind, but then i noticed it stops when clutch is engaged or when driving. it is also not there when first started on very cold mornings. wondering if it is a bearing in the clutch area?
View 2 RepliesFord F-150 - 1997-2003 :: New Starter Won't Turn / Motor Is Seized?
I have 98 f150 with 4.6 starter went so I put a new one on wich was a hassle and it tries to turn but just wont as if the motor is seized. I had been hear a loud howling sound from what I think is the ac unit and the ac line burst after trying to start. Would a bearing or something with the AC be enough to stop the engine from turning over? Or could it maybe be a wire connection problem? To me it sounds like a starter trying to start a seized motor but I cant see that my motor would be out it only has 190 000km and the oil looks good. but we couldn't turn the motor over with a ratchet? The truck had been getting gutless. I am stuck...
View 4 Replies