Nissan - Quest :: 2002 - Starts And Idles Fine But When Give It Gas Has No Power And Misfires
I have a 2002 Nissan Quest. It starts fine, idles great. But, when I try to accelerate, the car bogs, hesitates, misfires and I get p0300 random misfire, p0325 knock sensor. I get no dtc when it is just idling. The fuel pressure is fine, regulator works good, the cam sensor is clean, the coil tests good, the compression is good, as are the wires, cap and rotor.
View 2 RepliesFord F-150 - 1997-2003 :: 2002 - Stumble And Try To Die When Give It Any Gas
I have a 2002 f150 with a 5.4. It runs bad but all the data looks good. When you rev it in gear it revs sluggishly but when you put it in drive and give it any gas it will stumble and try to die. Un plug the tranny and it revs great and when in gear it runs great, but it obviously is stuck in second gear. I have codes for tcc short, solenoids a and b short, tcc short, and pressure control solenoid. I have replaced all of these parts inside the tranny including the wiring harness and main connector (transmission side). The OD light is also flashing. I Have run out of stuff to replace, obviously its something transmission related if the truck runs fine with it unplugged.
View 1 RepliesTiguan :: 2009 SE 2.0T Stutter Or Stumble Periodically
My Tiguan runs really well for the most part. I do have a slight issue that happens above 2200 RPM or so that seems to be getting worse as time passes. With little effort on flat road, the car runs flawlessly. Up a slight incline or light grade on the freeway it gets an intermittent misfire or stumbles periodically (getting more frequent). It smooths out and has a ton of power with heavier acceleration.
It doesn't always happen (though more often than not lately), doesn't throw a code, ambient temp doesn't effect it, happens rain or shine and engine temp doesn't change it. The only code I get from time to time is P2181 (coolant performance), but I can't see that being the issue and it stays happy right around 190ish. Gas mileage is not effected, getting around 27-28 MPG average. Using 91 octane Shell gas. I did a Seafoam induction cleaning since it started happening and Seafoam in the tank with no change. Seems to happen in all gears. if I stay below 2200 RPM it never occurs. The car has about 68,000 miles on it.
F Series :: 1982 F150 Truck Starts And Idles Just Fine But Stalls At Stops
Today I acquired a 1982 F150 with a 302 engine, 4 brl. Edelbrock carb. The truck starts and idles just fine, but when I come to a stop, try to give it gas to go it dies. It starts right back up, and I have to rev it high a couple of times then put it in gear and it will finally go. When I got it home I let it idle a few minutes and tried playing with the air and fuel mix but don't know what I'm doing, really. It seems I can hear a hiss, and when I was reaching for the air/fuel screws I got a little shock on the hand from the distributor. We want to use this truck as a farm truck, and plan to get a manual for it, but what might I might check for the cause of it stalling.
View 1 RepliesFord Excursion :: 7.3 Idles Fine Then Rises To 1k RPM - Smooths Out When Give Throttle
As the title says, I just replaced my JVC harness and glow plugs, now it start and run fine, but it will suddenly raise the idle to 1000rpm, and sit steadily untill I press the gas pedal, then it will fall into its normal idle range. I replaced the stuff today, and I did not get the time to get the engine hot, or test drive it, before I had to leave. But the engine did start fine, and idle fine. Except from the sudden raise after a few minutes idling, it will then hold around 1k rpm.
Strange, can't remember if it did that before. I get no fault codes on my SCT device. The car has been sitting for 3 months before I finally got the glowplug relay, mine was non functional.
Ford Ranger / B-Series :: 2003 - No Power / Cannot Give Throttle Or Bogs Real Bad
I have an 03 Ranger 4.0 4x4 5 speed. It has no power, can't give throttle or it bogs real bad. Baro shows 18in vac with KOEO. When running it has 15in vac. Replaced MAF, fuel pump, and fuel filter.
View 4 RepliesFord Ranger / B-Series :: Transmission Start Jerking When Give It Gas / Engine Stalls
I have a 2000 ranger 4.0l 4x4 automatic transmission 5r55e. When I put it in drive I don't have any problems except in do it starts jerking when I give gas. When I put it in reverse I can move but as soon as I give gas it stalls the engine tranny was sitting in another truck swapped it with mine I changed the filter and 5 1/2 quart of oil.
I when to a transmission shop plugged it inn no codes and he said he would changes all solenoid and valve body gasket but he's not sure what is the problem. So I started to take out valve body and notice the oil is darkish red and was wondering if it was normal or not and if I'm taking that valve body out for nothing or should still go ahead ...
Ford Ranger / B-Series :: Dies / Won't Restart - Motor Stumble Every So Often
My MILaw Truck 1992 ranger isnt running good and I need to get it going
Only a P0111 at this time IIRC
We started the truck tonight and idel ok Could see the motor Stumble every so often. She went to drive it and it Cuts out under Load Or you must rev it up to keep it from Stalling.
And if it does Cut out you have to let it sit for 5 minutes to restart what is Weird is it dont Smell Flooded either I smelled the VAC Line to the FPR and it was DRY and Did NOT Smell like Fuel.
It was dark didnt do much trouble shoot as the Flashlight died. I wonder about Fuel Filters. And Also about the Idel Control. The Mis or Stumble seams Random
Any testing I can do I have a DVM and that Code Reader. Might have to find something to check fuel press with where would I check it at the fuel rail I assume. Going to try and go over the Basics tomorrow If there is Anything Specific I should check?
Ford Ranger / B-Series :: 3.0 Engine Stumble When Cruising On Highway
OK,it's a Taurus but it's the 3.0 Vulcan.On the highway crusing easy,now and then I'll get a stumble.It's like the key is turned off and back on.The tach stays steady but the car stumbles like the key was cycled quickly.I had to put a fuel pump in it a few weeks ago and now it is starting every time but this stumble has me stumped.
View 5 RepliesFord Ranger / B-Series :: 1996 - Motor Seems To Stumble When Going Through Gears
1996 Ranger 2.3. I bought it from a friend 2 months ago. 228,866 miles. The motor seems to stumble as I'm going through the gears. I've cleaned the mass air flow sensor and installed new air filter. Check engine light has always been on, O'Reillys hooked up their computer to it and said Emission Valve Malfunction. I see the charcoal canister, then I have 2 electrical sensors on same line. First one from canister looks like what Rockauto.com shows as a Vapor Canister Purge Valve. The photo has it with a yellow orangeish top. I don't know what this 2nd sensor is. It has a blue top.
View 2 RepliesFord Ranger / B-Series :: Intermittent Stumble With A Check Engine Light
Im getting an intermittent stumble with a check engine light. I have a 1990 Ranger XLT with a 2.3L 5spd. I pulled the codes 32 41 88. I looked them up but Im not sure what to check next. I have done much searching on several sites but havent found much. OBD-1 eludes me.
32(R)EVP - EGR not responding properly during test - EVP
41System Indicates Lean
88 Loss Of Dual Plug Input Control c ..
What does it all mean??? What would you check next?
Ford Ranger / B-Series :: 1998 - Dreaded Stutter Start - CEL On?
The facts: 98 rangers 4.0 4x4 177k
The issue: does the dreaded shudder start, check engine light is on saying lean bank 1 bank 2.
Fixes so far: have replaced every gasket intake base up, a lot of new sensors on the intake. All 3 of the 02 sensors new. Have not touched egr. Thoroughly inspected plenum and intake hose for cracks, no Pitts in the intake.
It's a NEBRASKA truck with zero rust. Thought maybe fuel pump might cause all these issues, however, the turn the key twice trick before starting makes no difference, and I can hear the pump turn on each time I turn the key.
Ford Ranger / B-Series :: 1998 - Occasional Stumble For A While / Blowing Black Smoke
1988 4.0 - noticed fuel mileage going down and an occasional stumble for a while but now I am getting some black smoke more when I let off the throttle than when I going down the road if I rev the truck get all kind of black soot all over the floor otherwise runs fine idles fine the iac has been replaced air filter replaced check the fuel pressure regulator for any gas leaking into the vacuum line and its clean.
View 14 RepliesFord Ranger / B-Series :: 1987 - Rough Idle And Stumble When Starting Out From A Stop
1987 Ranger and the computer will not communicate. I'm trying to check for codes because of a rough idle and stumble when starting out from a stop. Check engine works but won't flash when using a jumper across the data link. Used a OTC scanner but it only times out and comes up "no data". Where to go from here?
View 7 RepliesGolf/GTI VI :: Car Starts Fine But Won't Go Into Gear
.I have an 06 Rabbit and the clutch is not engaging. I woke up one morning to go to work and the car starts fine but won't go into gear. If i jam it in it just stalls out. I know the clutch itself is good since it was running perfect but just now wont engage.
View 1 RepliesCamry :: 2002 V6 SE Starts Up Fine But Does Not Move
Starts up fine but the car does not move. Car also has loud whine on cold starts coming out of driver side fender. It will also whine above 2000 rpm even after sitting out in the sun but goes away after driving. The car is at my parent's place and will be able to look at it later today..
View 4 RepliesPhaeton :: Car Starts Fine But Dies After 10 Seconds
I have an 04 w12 with 80k miles on it. It will start fine but will not run for more than 10 seconds. As it idles down from startup it settles to about 700 RPM's where it normally does then dies. If u drive it it will start and go into gear fine as u go to pull away it loses all power and dies. I have checked the minor things i know like air filters, oil, tranny juice all appears normal. New batteries less than 3 months ago also.
View 11 RepliesGolf IV R32 :: Car Starts Fine But Idle For Seconds And Then Just Bog Out
I've been having some issues with my mk4 R32. Right now i'm leaning toward changing the fuel pump and filter but i want to be sure before i do.....
Problem: I've been daily driving my r32 to work for the past couple weeks and about once a week it will start, idle for a couple seconds and then just bog out and die. no codes, just idle, then chugging and dying. it will fire with some starter fluid and will sometimes hold a very sickly idle but most the time will just run the starter fluid out. the weird thing is is that it's intermittent and will happen randomly and if i leave it overnight or sitting for a couple hours it will fire up like nothing was wrong. i just wanted some input on what it might be before i replace the pump. i have already done the relay so its not that.... the only code that it has ever thrown while i have owned it was for the intake changeover valve (N156) which i cleared and it hasnt yet to come up again.....
Volvo S40 :: 2000 Starts Up / Run Fine But Won't Idle
I have a 2000 volvo S40 19T, it starts up, and will run just fine if you give it any amount of gas, but it just wont idle. I unplugged the MAF sensor and it ran the same. I then took the IAC valve off and put a towel over the port (To let some gas in but not completely shut it off) It runs GREAT like that! I kept the IAC plugged in and the towel over the port, started her up and put a lot of pressure on the towel to cut of all air, the car idle went really really low and then it shut off. Now since the car knows it is stalling, and it needs more air I should be able to see the IAC opening and closing (Remember it is plugged in, but in my hand), it didn't move at all!
I have run the car with my towel over the IAC ports and chased all around the intake manifold and other intake duct work with carb cleaner to try and fine vacuum leaks to no avail. I even did the towel trick with a multimeter hooked up to the wires that plug into the IAC valve, it is getting a small amount of voltage, say 2 to 3 volts, but the new valve still won't open, and I have yet to confirm that the current changes with idle fluctuations when I press on the towel.