Nissan - Altima :: 2000 GLE Idling Rough - Motor Gone Because Of Oily Spark Plugs?
Nissan altima gle (2000) and for the past 3 weeks it has not gone over 55. The car was running ok before but was idling rough. A mechanic replaced the intake manifold gasket, the MAF sensor and the fan sensor. I decided to change my spark plugs when I noticed the idling was getting worse. The spark plugs had oil on them and now a month after the new ones are burned (like ashy tip, black thread) and dripping oil again. I think is the oil not letting my car accelerate in the highway. I considered changing the valve gasket, cables and cap for the spark plug. A mechanic told me not to bother because the motor is a lost. Is he right?
View 16 RepliesTiming-belts :: 1979 Toyota Pickup - Engine Turns But Does Not Start
I have a 79 toyota pick up, that will not run. the engine turns but does not start. It has spark, though not the best should start. The carb is old but there is gas in the engine when i try to start. compression in all the cylinders is fine. A friend thinks maybe the timing chain jumped a tooth. I cant find the bright link on it so im having trouble knowing if that is the problem. What it could be?
View 5 RepliesToyota - Corolla :: 2002 - Tighten Spark Plugs To Same Torque Specifications As Regular Plugs
I am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
Passat (B5) :: 2003 - Oily Residue On Front And Side Windows
My wife's 03 wagon has developed this weird problem. I keep the car pretty clean, always clean the inside windows a couple of times a month. We always defrost with the A/C on, no recirc.
We had the car in the body shop for some front end damage. Ever since then the front and side windows seem to have this oily residue on them. The stuff will not come off. Tried Invisible Glass, my usual cleaner. Really awful to see at night.
If the heater core was leaking under the carpet, could this cause it? or if the sunroof drains were clogged? I also changed the cabin filter with an aftermarket one from a vortex vendor.
Prius (2004-09) :: Oily / Greasy Residue On Exterior Won't Wash Out?
Basically, I wash the car myself. I wash with a soft spongy brush and exterior car wash fluid.
Now at the bottom areas (near the skirts and just lower bumper) and also some lower part of the doors, I notice stains that look brown in color and they don't disappear by me just using the spongy cleaner. It got to a point where I used my nail on the greasy bugger (the spots are small but annoying looking, barely a millimeter in diameter), and it spreads and becomes a light brown in color. I have to use my nails to get these buggers out and at some times there's tons of them based on the weather and the driving conditions.
Ford 6.7L Power Stroke Diesel :: Oily Residue Under Hood
I got a little oily residue on my hood here. It looks like it might be a little wet near the coolant hose & throttle body area. I also have the H&S Intercooler pipe kit installed. Not sure how long this residue has been there, but it is still wet, so its not all hardened. Maybe it's just loose intercooler pipe bolts?
View 7 RepliesToyota - Celica :: How To Remove Spark Plugs To Turn Crankshaft
I'm trying to turn the crankshaft by hand to verify my timing belt alignment, but meeting some resistance. is this because I have the spark plugs in? do i have to take them out to turn the crank? also, that little groove in the belt guide doesn't seem to line up with anything or get held by the rib on the crankshaft. does that matter, or have i got it installed wrong?
View 1 RepliesCamry :: 2008 Toyota CE - P0101 Code After Replacing Spark Plugs
This past Sunday, I replaced the spark plugs on my 2008 Toyota Camry CE, following one of the sticky DIYs. My car has approximately 107,xxx miles.
Last night on my drive home from work my CEL came on. First time seeing a CEL light since my BMW days, . Luckily, I have a OBDII scanner at home and after running the scanner, it gave me the following trouble codes:
- P0101
- P0172
I went ahead cleaned the air filter (I have an Injen SRI installed).
After doing some research on the interwebs, I have concluded that this code has to do with the MAF. Time permitting, I am going to clean the MAF sensor later tonight. In the meantime I reset the CEL, to see if it will come on again.
My only question, which I am unable to find an answer to, is:
Can there be a possibility that the P0101 and P0172 trouble codes be related to me replacing the spark plugs, or is this just a mere coincidence?
Toyota - Camry :: 1996 Frequently Keeps Losing Power To The Spark Plugs
My old 1996 Camry with 2200 cc 4 cylinder engine, frequently keeps losing power to the spark plugs. I have changed the fuel filter and the ignition coil. That did not work. I also noticed that the car was starting when I unplug and replug the primary wire plug to the ignition coil. So I have replaced the primary power plug with a six inch pigtail and a used plug purchased from a salvage yard. This is not working either. The Toyota dealer near my house want to replace the igniter and the Engine Control Module just to be sure that these are not the sources of problem. The dealer did not test these parts. So I refused to replace the parts without a proper test. I would like to test these parts. Is there a test available for the igniter and ECM that could be performed. I have access to a lot of tools. I need a schematic and/or test to test these components.
View 18 RepliesFord F-150 - 1997-2003 :: Oily Behind The Freeze Plugs
So I am working on my 5.4 I pulled and discovered that is is very oily behind the freeze plugs. The motor is on a stand and has been upside down a few times. There was still a little oil in it as I can see a decent puddle under it where I didn't tighten the drain plug entirely. Why would there be oil built up there? I have the two from the back of the heads out and the two on either side closest to the rear of the block. What kind of issue am I looking at? Here is the build thread that I am doing about the truck and this motor.
DH-Rear of Driver Head
PH-Rear of Passenger Head
PRBS-Passenger Rear Block Side
PMBS-Passenger Middle Block Side
DRBS-Driver Rear Block Side
DMBS-Driver Middle Block Side
Chevrolet - C-10 :: 1979 Not Starting / Engine With No Spark
1979 chevy c10.. No start.... 4.1 engine with no spark.... I have replaced everything in distributor including plugs and wire still no spark rotor is turning when engine cranks so I assume timing chain is good
I have replaced Ignition Coil, Distributor Capacitor & Terminal Block, pickup coil, Ignition Control Module, Distributor Rotor, cap, Wires
Seems like I am just wasting money on parts and still no start. Truck only has 50k for miles on it and not driven very much. Just died going down hwy with out any warning.
Pickup - Gmc :: Jump Start - Engine Cranks But There Is No Spark
What may have my son fried by reversing the polarity while jumping the battery in his 95 GMC pickup? The smaller wire coming off the + terminal was burned through,so I spliced that. The engine cranks but there is no spark.
View 3 RepliesWindstar :: Spark Plugs Keep Going Out
I am having a problem where my spark plugs keep going out. I changed all the plugs, wires and coil pack on my 2001 Windstar and within a few months my van was running on 4 or 5 cylinders instead of 6 and this isn't the first time it has happened.
View 14 RepliesSC/SL/SW :: 2001 Saturn 2 / Oil Around All The Spark Plugs?
I have a 2001 saturn sl 2 and I noticed some oil around all the spark plugs. The engine seems to be loosing oil a little bit as well, about a quart a week. Its not buring it or leaking that I noticed.
View 2 RepliesCamry :: 2003 - No Spark In Plugs
'03 Solara 4 cyl, 135K repl. Fuel pump, 45# press ok, NO scan tool code(s), turns over fine, no spark 2 plug. Started/ran fine before fuel pump change.
View 10 RepliesGolf V R32 :: Spark Plugs Not Firing
I was having some problems and one of my friends told me to post up here before I went and saw my mechanic. So my car isn't starting (its a 06 r32). Now I've gone through a whole list of things and what I have worked out is that it is the spark plugs not firing (none of them are) although they are all brand new and were working not too long ago.
Battery is fine and fuses look good no warning symbols on the dash so I'm at a bit of a loss as to what it could be. Relays? Coils?
Passat (B5) :: Oil Into The Spark Plugs Compartment
I was thinking about change my spark plugs on friday so today I went to check the ones the car have open the hood took the engine cover out and the ones on the sides, I see 6 wires 4 going to the left side(air intake side) and 2 going to the right side (where the oil fil cap is) so I say think this should be the spark plugs wires. I take one of the left side wires out and is cover in oil so I keep taking the other out one by one and all of them have a lot of oil I can't even see the sparks plugs. All the wires have numbers on top 1 to 6. I say this have to be the wires cause I don't see any other place where the plugs can be located at. The car is a 99 v6 fwd...
View 7 RepliesPhaeton :: How To Change Spark Plugs
I would like to have a look at the condition of the ignition plugs in my V8 Phaeton.
According to the service plan, it's already time to change them and it also seems that the car has lost some power when accelerating.
Is it even possible to change them with the 'usual' knowledge (knows how to change a tire and so on) or should I better go to a professional.
C/K :: 1995 - All New Plugs And Wires But No Spark
Had issues with TBI, rebuilt. Had some starting problems after truck sat for 1 day or more, but would start after a few tries. At one point when it was particularly stubborn, starter lead vibrated off. Once reconnected, truck started, ran fine, but had some electrical humming & radio interference. The starting issue continued with some low rpm stumbling, when driving check engine light would come on at cruising speeds and go off 7-8 seconds after letting off gas.
Had 1 day lest week when I drove a bit more then normal (150+) but ran fine other then engine light. Next day started, but ran horribly rough with violent back fires. At one point stalled and would not restart. It looked and acted like it was flooding itself out and poor spark. Less then a year I replaced cap, rotor and coil. Now I have done all new plugs and wires. Now it appears I have no spark. I had been in the dash messing with the blower motor relay 2 days prior to the stalling and not starting.
Does the ECM control spark? Cant it go bad slowly? And if I had to do alot of cranking of the engine to get it to start, would that have any thing to do with it going bad?