Toyota - Camry :: 1996 - All Four Brakes Keep Locking Up
I have a 1996 Toyota Camry, I was having a noise from right rear and every now and then the car would start slowing down like I was braking. I replaced all four calipers, rotors and the pads, then bled the whole system. The noise went away, but the car still seems to engage the brakes, but only after a few minutes of driving, but then it goes away.
I thought it was a single brake line, but after not driving it for a week, yesterday I was driving it and after about 20 minutes it started again, when I pulled over all for wheels were smoking, after allowing it to sit for a few minutes, I was able to drive home 30 miles without it happening again. Would this happen with just one line bad, as someone suggested, or is this an issue with the master cylinder, bad brake fuild or something else?
Toyota - Camry :: 2005 - Power Steering Rack Leaking And Front Struts Cracked
We have a 2005 Camry XLE, with 102,00 miles on it. It has been very well cared for, and only serviced by our Dealer. We would like to keep the vehicle for another 50,000 miles. We have had an assessment of the vehicle done by the Dealer, because our brakes were very soft.
He found a great deal of air in the lines and flushed them out. He also found:
1.) Leaks in the power steering rack, which he graded as a level 8 severity on a 10 point scale. Repair estimate is $1100 to replace and align.
2.) Both front struts are cracked and graded for severity as an 8 on a scale of 10.
What do you think:
A.) Are these safety issues ?
B.) What are the consequences of delay ?
C.) Are these problems indicative of other likely problems ?
D.) Is it better to have a Dealer perform the repairs ?
Camry :: Front Right Brakes Gradually Start Locking Up When Driving
Replaced all components of front right braking system. Calipers rotor pads and hoses. Still, every other day or so the front right brakes gradually start locking up within minutes of driving.
I just bought car. I am stuck with this problem now. Only thing left i'm told is replacement of abs module.
Can you just bypass a faulty abs module instead of replacement?
Ford Brakes/Suspension :: 2005 F250 Front Brakes Calipers Are Locking Up
I have a 2005 F250 & both front calipers are locking up. I have replaced the front pads, no change, my mechanic installed a new master cylinder. No lockup for about two weeks until today. Front calibers are locking up again.
View 1 RepliesCamry :: Replaced Both Front Struts And Creaking Sound Coming From Front End
Last night, I replaced both front struts with Monroe complete sets (new springs, mounts, boots, struts, etc) and I had my front rotors smoothed out. That cleared up about 75% of the noises coming from the front of my car Except for one.
Whenever I'm braking, there is a noise coming from my front left wheel. It's not a brake squeal, but more like a creaking sounds that comes around with each rotation of the wheel. It slows down with the car, and I can make it last longer by doing a slow roll with the brakes one. So when I'm fast it sounds like "Crk! Crk! Crk!" When I'm going slow it's "Creeeeeak... Creeeeeeak... Creeeeeak..."
Last night, I also replaced the sway bar link on that side. The brakes are smooth and the tires were balanced a couple months ago (no steering wobbles at any speed)
Camry :: 2005 Toyota - Front Brakes Frozen And Would Not Release
My wife has a 2005 toyota camry with about 84000 miles. She had been complaining of intermittent issues but no one could find the cause till yesterday. Her front brakes were froze and would not release. I took it to the shop and they said the left front was hung and the pad came off and chewed the rotor up. They suggested a brake job. Well in the process of replacing rotors and pads on the front they could not get the caliper to release. Make a long story short, the rotor and pads are changed but the front brakes will not release. They checked the lines and they look good.
View 7 RepliesToyota - Camry :: Time Period For Changing Struts?
How often do I need to get new shocks and struts - I've been told mine are weak Car is 10 yrs old with 165,000 mi.
View 7 RepliesCamry :: 2009 Toyota - Front Brakes Clunking / Knocking After Replacement
I changed the front brake rotors & pads on my wife's 2009 Toyota Camry & everything seems fine except when doing sudden or slightly hard stops it seems to do a clunk/knock type sound from the front brakes. It also only does it sometimes not every hard/sudden stop.
One thing that comes to mind is that when I went to tighten one of the guide pin bolts it was a real pain, the big bolt that the screw threads into kept spinning making it hard to tighten the bolt into & none of the others did this. I thought I tightened it down but possibly not?
Camry :: 2002 - Front Or Rear Struts - Which One To Do First
2002 Camry, 140K miles.
While I don't have any leaky struts etc, I have been planning to change struts proactively when I find time. (NOT Quick struts, have monroe OE Spectrum struts).
I understand I have to do them in pairs.
Which one takes more time? Fronts or rears?
And I am guessing alignment won't be way off if I first say do the front set then weeks later the rear?
Camry :: 2003 - Low Front After Installing Gabriel Ready Struts
I just finished replacing front and rear struts on my 2003 Camry SE. I decided to use Gabriel Ready Struts because I needed Boots, and Mounts. My Car has 150,000 miles, I noticed some mild nose diving during hard braking, and I wanted to improve this.
The Ready Struts did improve the nose diving, but I think the car had a better ride with original struts with 150,000.
The Car is lower in the front with the new struts, and higher in the back. Its obvious when you look at the car. I have a regular parking place at work, and the first day I parked I scraped the curb. I have parked there every day since the car was new without problems.
I am considering returning the struts, and buying KYB and using my original struts. I was concerned about using my springs with 150,000.
Golf IV R32 :: Front Brakes Locking Up
What would cause this? The brakes work fine until you get into that range of brake pressure in which the abs wants to kick in. The brakes then lock up(may be only front driver), the pedal sinks to the floor, and don't disengage until the car is at a complete stop. It does this with esp on or off.
The previous owner changed a front wheel sensor and bled the brakes. The abs module fuse under the battery cover was melted but not blown.
VCDS shows no codes. I did not do output test on pump, didn't have my laptop with me.
Abs pump bad?
Mc?
Servo?
Caliper?
Brake line?
I bought this car 2 weeks ago and the previous owner failed to let me know about the problem and it happened to me a mile down the road after purchasing the car. I started to notice a lot more because of the rain and snow recently. It's definitely an uneasy feeling. I really don't wanna drive the car till it's sorted.
Camry :: 2007 CE / 4cyl - Rubber Boots On Both Front And Rear Struts
I have 2007 Camry CE, 4 cyl, 102,500 miles. The rubber boots on both front and rear struts can be easily lifted with a screw driver to reveal the shiny shaft. Strut seems be pass the 'fast brake' test (no bounciness). There is oily residue on the strut body. Is that normal? If replacement is needed, should I go with Monroe or other brand. I want the original Camry ride.
Brake pads seem to have 3/16"-1/4" thickness left. All equipment is original.
Camry :: Horrible Sound When Go Over Bumps - Spring Snapped On Front Struts
The other day I heard a massive snap as I pulled out of the driveway. I drove to work and everything handled fine but if I drove over a bump I noticed a horrible sound under my car. Smaller bumbs just caused a ting. My gfs dad looked at it and said everything was fine. I surely didn't believe that so I just jacked up my car and right away I noticed my spring snapped!
View 14 RepliesSierra :: 1988 GMC C2500 - Front Brakes Keep Locking Up On Both Sides
I have a 1988 gmc c2500 with brake problems. the front brakes keep locking up both sides. Have replaced the calipers rotors pads and the brake lines. I can bleed them off and they release but has soon has you it the brakes they lock up again.
View 8 RepliesSanta FE SM (2001-06) :: Front And Back Brakes Locking On Intermittently
Front and back brakes heating up and locking on intermittently brake pedal feels normal this has happened 3 times over the last 500 km of driving pedal not sticking down break fluid ok no swelled lines today noticed front left and rear right rotors were hotter than front right and rear left once vehicle sits they release and all is good no abs lights or any other warning lights on.
View 1 RepliesSubaru - Forester :: 2003 - Front Brakes Locking Up Especially On Hot Days
I have a 2003 Forester, recently noticed the front brakes locking up, especially on hot days. Completely immobilized car, to get going again I would have to wait for them to cool and/or cool them with water if pads smoking from trying to drive with brakes engaged, and tap on calipers and master cylinder to allow pads to release. Problem got worse as it got hotter out, due to job I rarely drive car and didn't get in for service yet. Last time pads burned a whole lot and braking felt odd (less pressure and uneven like rotors were messed up or pads burned up).
Took it into brake place, they had never seen before. When they inspected, discs were in bad shape with one cracked, but I don't think that was original problem, just caused by driving with them hot. Shop at first said fluid seemed clean but I left and later they said it was contaminated but I don't trust them. Shop solution is replace everything: calipers, pads, hoses, flush system, and replace ABS (the most expensive part I am hoping isn't actually necessary). I don't trust shop for several reasons including because they admitted having never seen this and seemed content to take maximum amount of money just to replace everything without knowing what actual problem was.
Ford Brakes/Suspension :: Hub Locking - Bang From Front End When Engage 4WD
I have been having hub locking trouble and finally located a bad vacuum hose. Hose has been replaced. Now when I engage the 4WD and apply a little power, I get a terrible bang out of the front end, then the truck moves on. Sometimes there is a second bang, sometimes not. The chain appears tight in the transfer case and the ujoints look ok. I have turned the wheels with hubs locked one at a time and the joints are free.
View 9 RepliesFord Brakes/Suspension :: 2008 F350 - Front Left Wheel Locking Up Intermittently
2008 F-350 wheel will lock for no reason. I think the Hydroboost has a hair line crack it and when the temp and pressure reach a certain number then it sends brake fluid threw the crack to the caliper? I also heard it could be in the ABS because its locking just one wheel?
View 1 RepliesToyota - Camry :: 2001 - Seat Belts Locking At Wrong Times Occasionally
Four or five years ago, our 2001 Toyota Camry (and my wife and I) had the misfortune of being in a T-bone accident when someone unexpectedly pulled a left turn in front of us and gave us no time to stop. We had the car front-end repaired at a collision repair center, and we were good to go, I thought. As I drove away, I noticed the newly replaced seat belts seemed to "lock" in place at times. They did lock at a sudden stop, as expected, but when entering the car and attempting to put on the seat belts, they would sometimes lock and release, causing me a repeated tug-of-war as I attempted to get enough slack to fasten the belt. This occurred on both the driver and passenger front belts.
Needless to say, I returned the car to the shop, and they cheerfully replaced the belts a second time. When I picked up the car, I first tested the belts, which seemed to perform flawlessly, so I drove home. My joy was short-lived, however, because on the way home, the locking problem returned. I returned to the collision repair shop yet again, and they replaced the belts a third time. The shop foreman personally tested the belts to make sure they worked, and he watched as I did the same. However, yet again, on the way home, the belts would lock unexpectedly.
Through much experimentation, I finally realized that if the car was facing any degree of a downward angle, I could pull the belts very easily and smoothly, yet they locked if I jerked the belts hard. This was as expected. If the car was level or facing an upward angle, however, pulling smoothly on the belt would result in them locking. This seemed very odd to me, and I mentioned it to the collision foreman. He immediately called Toyota to ask about it, and they had never heard of such a symptom.
So, for the past five years, I have been enduring the craziness of getting in my car and doing a repeated pull "negotiation" with the seat belt. I have also noticed that when I begin driving forward, if I will apply the brakes gently, both myself and any passenger can then easily pull the belts and fasten them while the gradual braking is occurring. It doesn't seem to be a safety issue because they do lock on a sudden hard stop, but it is counter-intuitive to me that a gradual braking allows the belts to move freely. Is it possible they could have installed the belts upside down or backwards, or something?