Toyota - Camry :: 1992 - Idle Speed Is Around 2000 RPM At Cold Start
Since having my engine replaced with a newer used engine block my idle speed when I first start it up or when it is cold is around 2000rpm which lasts for about 2-3 minutes until it begins to fall to the normal range of 1200-1400 and finally to 850 or 900rpm when warm. how can I fix this or is it okay to idle at 2000rpm for a couple of minutes? is it hurting anything?
View 3 RepliesToyota - Camry :: 1992 - Cold Start Idle Is Up To 2000 RPMs Until It Drops To Normal Within 3 Minutes
I replaced my engine that had 155,000 miles with a newer used one with about 30,000 miles. since the swap my gas mileage is down by one third or more. Everything else seems fine except that my cold start idle is up to 2000rpm's until it drops to normal within 3 minutes.
View 2 RepliesCamry :: CE 2000 5S-FE With Code P0770 And High Idle Speed
Camry 2000 CE 102,xxx miles. My car died in Jan 14, after have P0770 for while, only Reverse gear work. The mechanics said the tranny need to re-build. I had him bring the tranny to tranny shop to re-build ($1650), then the code still pop up. Brought it back, they said the ECU needs to be reset. I had the car next day then that code pop up again!
They replaced the Solenoid E. The code is still there. Brought the car back, they took the tranny to rebuild it again. Drive the car for a day, the darn code pop up again, now they blamed on the ECU. Ok my mechanic guy replaced it at my own cost for part ($150) but the code is still there. This time they blamed on the high idle rpm approx. 1600-1800. My mechanic tried to fix the high idle speed so the tranny stop blaming other causes. He cleaned IAC valve, replace O-rings (I don't remember the location of them) then he said whenever he inserted the new ones, they start to crack!
Toyota Camry :: 2000 V6 Runs Rough When Cold
2000 Toyota Camry le v6 .... When I first start my car it runs rough after about 5 to 10 minutes it runs fine. I have no check engine light on. I used sea foam and the problem went away for a couple weeks then it came back. I have about 30k on my spark plugs.
View 10 RepliesToyota - Camry :: Will Not Idle / Alternator Does Not Kick In Until 1500 To 2000 RPMs
My toyota will not idle. The last time this happened, it needed a new battery. The idle is controlled by the battery. The alternator doesn't kick in untill 1500 to 2000 rpms. The battery checks out OK this time. It's an 03 4cyl.
View 5 RepliesToyota - Echo :: 2005 - Squeaking Noise At Startup And At Low Speed
Need to diagnostic the noise coming from my Echo 2005? 70K miles. I took to the dealer twice and spend a total of 500$ but the noise still there. The dealer changed the drive belt , new brake pad and clean the rear drum and adjustment. The noise occurred at start up and sometime at low speed below 10mph. The noise increase then stops after 6 second. [URL] .....
View 10 RepliesGolf V R32 :: Rough Idle After Cold Startup
If my car's been sitting - say monday morning after sitting all weekend in the garage- it runs rough for a little while. Sometimes only for a few seconds, sometimes for a little while after the idle drops. The colder the car is, the longer and worse the condition. It feels like a cylinder isn't firing.
After a particularly cold and wet spell (I had the car outside) it ran so badly it threw a code for one of the cam position sensors and #4 misfire. I replaced both of the sensors. That worked a little.
Since I was due for 80k service and saw a misfire when damp, I replaced the ignition coils along with the spark plugs. That worked a little more. But, it still does it. What else could it be if not ignition? Sticky valve? something else?
Acura - Rsx :: 2002 - Sudden High Idle Speed On Startup And Slight Rumble
I'm the loving owner of an amazing '02 RSX. She is just about to hit 100K, and has been completely trouble free. This past sunday, I started it up in the morning and immediately noticed a semi-harsh vibration, with high idle speed (1500ish, normal is 500). If I give it gas, the vibration and rumble noise goes away, but if it put it in reverse, it seems to get worse. After a few miles of driving, the idle speed returns to normal and seems to feel/sound fine. Also of note, if i hit a dip in the road, i get a vibration and engine sound that resembles that of a flat tire. I know this sounds random, but it's the best I can do at describing it. There are no check engine lights, temp is fine, and otherwise seems to be driving great. I initially thought bad spark plug or air filter, but have since thought of vacuum pressure or O2 sensor, maybe even an engine bolt break (from the sound it makes driving into a dip). Could this be as simple as getting a bad batch of gas?
View 3 RepliesToyota - Tacoma :: 1999 - Lower Idle When First Startup
I have a 1999 Toyota Tacoma pickup, 5 speed stick 4 cylinder. When I first start it up it runs at a lower idle than it should. But as soon as it warms up just a bit the idle goes to about 12-15K rpm. Also, when it sits during the day and it's warm outside it will start up with the fast idle.
I don't know if this is coincidence or not but, I found a rabbit sleeping under the hood during the winter (this has been going on for a while). The rabbit chewed through a vacuum hose and a spark plug wire. The vacuum hose was split right by the fitting so I just cut off the 1 1/2" of tubing and re-attached it. The spark plug wire I didn't know was damaged until I drove it for about 5 miles or so when I finally got out to see why it was still running bad. I then had to drive another 5 or so miles to the auto parts store to replace it. I have replaced all the spark plug wires just to be sure. What this would be?
Ford - Explorer :: 2003 - Poor Idle At Cold Startup
I have a 03 explorer 4.6 at cold start-up it wants to stall and it idles very bad just for maybe 5-6 seconds and then the idle picks up and it's fine. This only happens on cold start-ups, if I drive it and restart it's fine.
This started when I replaced the two front (up-stream) O2 sensors, I didn't need to change them just have 150,000+ mile and was trying to do something to get better mpg.
Do We should disconnect and reconnect the battery after replacing the O2 sensors on an 03? Reset the computer?
Toyota - Highlander :: 2002 - Cloud Of White Smoke Upon Cold Startup
I have a 2002 Toyota Highlander 6 cyl, 148,000 miles. I get a cloud of white smoke from the tailpipe upon starting a cold engine. Smokes for about 1-2 minutes, then smoke stops.
View 4 RepliesSonata NF (2006-10) :: Rough Idle At Startup When Car Is Cold / Missing On Several Cylinders
My 06 Sonata runs very rough at start up when the car is cold. It appears that it is missing on several cylinders. This last for about 15 seconds and then the car runs fine. What could be causing this problem? No check engine light.
View 10 RepliesGolf IV R32 :: When Startup Car Go Down To Its Normal Idle Point After Couple Of Minutes When Cold
Normally when cold the car would start and rest at about 1,200 maybe 1,300 for a couple minutes then go down to its normal idle point, recently when starting it when cold, it sounds and looks like it wants to do that but just goes straight to its normal idle point, its only started this a couple does ago and has me a little worried now. could there be anything wrong ?
View 12 RepliesCamry :: 2006 Cold Startup / Rpm Jumps To 2k
Cold starts only (warm starts completely fine), typically the rpm jumps to 2k or so then slowly climbs down as engine warms up. However recently one in ten start ups the rpm will jump to 2k then immediately drop to 1.5k (sounds like a drop in rev engine) or so. Engine does not shake or stall and still starts fine. Throttle body is cleaned and spark plugs were all replaced. However I cannot remember if this started happening before throttle body was cleaned or if its not related with it at all. Battery is fine too or according to battery charge test. I don't see any loose hose that were taken off while getting to throttle body. I recently tried fuel injector cleaner but didn't make much difference (only 1 application though).
View 5 RepliesCamry :: Engine Has A Slight Knock After Cold Startup
My 2011 Camry LE I4 with 21k miles has a slight knock after cold startup, at Idle for a few minutes that disappears after warming up. If you start and drive and don't let it warm up the knock, under load, is more pronounced.
View 3 RepliesCamry 2012+ :: 2014 SE Gas Smell From Exhaust During Cold Startup
2014 Camry SE i4 20,500 miles ... Is it normal to smell gas coming out from the exhaust during a cold startup? After the car is warmed up the smell disappear ...
View 1 RepliesToyota - Camry :: On Turning The Key Starter Clicks But No Startup
After 4.5 years of service my car battery seems to have died. On turning the key the starter clicks but it does not start. I jump started it yesterday. It worked fine. It won't start today again so I checked the battery hygrometer. It is green. I checked the water level. It is full.
View 9 RepliesToyota - Camry :: Automatic Transmission Whine At Startup
Bought a 2011 Toyota Camry about 2 weeks ago. Noticed a few days ago a severe whine I think is coming from the transmission, when it is started. The noise goes away after about 2 miles of driving and the car seems to shift OK. The dealership says this is "normal", but I've not heard other Camrys doing this.
View 2 RepliesToyota - Camry :: ABS Light Started Flashing On Startup
This is for our '05 Toyota Camry with 125K miles on the ODO, has ABS but no TPMS.
Around a few weeks ago the ABS light started flashing on start-up. Turned engine off and it went away. This has happened 3 times to far. The light stays off otherwise. Before this we had new tires installed and the car aligned and they said the rear was a bit off (had uneven tire wear), not sure if related or not.
I was able to read the code with shorting two pins and I get 33 & 34 which is both the rear wheel sensors. The part that I am suspicious about is both sensors going out together that not make sense. So I am thinking it is the wiring somewhere. Hopefully not the module ...
For now I have cleared the codes and want to see if they return. The sensors are expensive and seems like I have to take the rear bearing off to change them, so not keen on just throwing parts at it. How to approach the troubleshooting?