Santa FE SM (2001-06) :: 2002 2.7L FWD - Gas Pedal Sticky
I have a 2002 Hyundai Santa Fe 2.7L FWD. The gas pedal feels sticking. I cleaned the air intake butterfly once, but it only works for 3 to 4 days. The gas pedal becomes sticking again. What's the problem it might be?
View 2 RepliesCamry :: Creaking Noise When Press And Depress / Gas Pedal Is Sticky
Ok so I had this creaking noise at first when I press n depress the gas pedal (how normal driving should be) and I sprayed some WD40 and now the noise is gone, but it becomes kind of sticky when pressing and depressing.
It's like when u rub ur finger on a glass window back and forth, there is time when it catches ur finger (sticks) before u can move it the opposite way, it's not smooth as it used to be (my other camrys are smooth).
When pressing a little, then a little more, it has that sticky feel, same thing when depressing the pedal. That's the best I can explain it and it is really noticeable when I'm stuck in traffic.
Do u think I have a bad pedal or some white lithium grease will take care of this?
Toyota - Camry :: Sticky Shift Lever On Hot Days
My 2000 Camry --4 cyc has a problem with the shift lever on hot days. It is hard to move from P to R to N to D and the other way back to P. There has never been any liquid spill on it. In cold days, the lever shifts fine.
View 2 RepliesToyota - Camry :: 1999 - Brake Light Comes On Sporadically / Pedal Needs To Be Pressed Down Farther
I have a 99 Toyota Camry and recently the breaklight has been coming on and off sporadically. I assumed I had done some damage to my E-break, as the other week I tried to back out with it on (cut me some slack, I just moved to PA after having only really driven in FL lol). I wasn't worried about it since I didn't notice any issues with my breaks, however the last few days I randomly have to press the pedal down almost to the floor to come to a full stop. There doesn't seem to be any consistency to this, sometimes it happens when the light is on but usually not. It does it both when I am stopped (causing me to move forward slightly till I depress it farther), sometimes when I am stopping normally, both when I'm going straight and right after turning, ect.
I checked my break fluid level and it is at the minimum line so I doubt that is the issue. I did some research and saw many saying that it was likely just air in the lines and that the system needed to be bled. But some also mentioned replacing the master cylinder so I wanted to see what response I might get on here (I don't know very much about cars myself).
Toyota - Camry :: Car Will Crank But Not Starting After Pulling Some Relays
I was trying to get my power windows on my 99 camry to work, so I tried switching some relays to see if this was the problem. I left the horn one out due to breaking it. The relays are not labeled other than the starter one. Anyway, my car will crank but not start. Acts like the timing is out. That belt was replaced 19000 miles ago...
View 1 RepliesSubaru - Forester :: Sticky Clutch Pedal
I recently had the clutch replaced on my 2001 Subaru, now the clutch pedal is sticking, could this be related to the clutch replacement or is this something else? I didn't have such a great experience with the mechanic that did the work so I don't trust him to tell me truthfully whether it's possibly a warranty issue or not. The problem happens intermittently. I'll push down on the pedal and when I release it it will only come back up half way. If you tap it with you toe it pops right up. Doesn't seem to impact the functioning on the vehicle.
View 3 RepliesBMW - 328i :: 2011 - Pedal Get Sticky When Brakes Applied
My car is a 2011 BMW 328i Coupe, currently at 24K mi. Recently i found my cars brake pedal get sticky after Ive applied the brakes from time to time. But nothing server. My routine schedule maintenance will be coming up soon, so i am just wondering what could be the probable cause. Could it be the brake fluid?
View 6 RepliesPassat (B7) :: 2013 - Sticky Brake Pedal When Let Foot Up Off
I just bought a 2013 Passat SE 2.5 about a month ago. Since driving it home I have noticed that the brake pedal sort of sticks when I let my foot up off it. It doesn't happen during hard braking, just normal to light, especially when I'm riding the brake in heavy traffic. When I lightly press the pedal in, it feels like something is sticking and again when I let off it has the same feeling and it will sometimes not come up with my foot, but it rather slaps/taps the bottom of my foot while returning to position.
I took the car back to the dealer to check out and of course the service tech didn't feel what I felt. So the let me drive a loaner Passat, same model, and I felt the SAME sensation in its brake pedal. At the time I just chalked it up to "that just must be how these are", but it's kind of annoying and I don't totally feel it's right. What is causing this?
Toyota - Camry :: 2001 - Check Engine Light On / P0440 Code
Check engine light was on for some time when I had filler neck and cap replaced. Computer sensors did not re-set until 501 mile mark, when light came on again. Checking the web, I find that some who appear to have knowledge of problem say it could be hoses, sensors, valves, or evap canister--the charcoal canister.
Mechanic who did original smoke test and recommended replacement of filler tube wants to replace evap canister without checking anything else. What should I do? At wits end, and car needed to pass inspection 2 days ago. Car has 157,000 miles or so...
Passat (B7) :: Sticky Gas Pedal / Tires Chirping When Turn From A Stoplight
2014 SEL V6. My mother bought a Passat last year at my urging and has just told me about an issue she's had since she brought it home. Her throttle is sticky in the very beginning of its travel. Meaning that whenever she starts off, she has to give it a decent shove to get into the 98% of pedal travel that people usually use. Usually this means that she's chirping he tires every time she makes a turn from a stoplight, and gets her head thrown back taking off in a straight line.
View 3 RepliesPrius (2010-12) :: Boot That Is Attached With Brake Pedal Is Leaking Sticky Stuff
I have the regular Prius 2012, The brake pedal is attached to a rod that goes into a flex boot and then into the ABS module in the Engine compartment. The Boot is leaking sticky greasy/oily fluid. It not a constant leak. Its like it leaked on a Hot day and then stopped leaking.
Its not the one from my car, but its what I'm calling the ABS Mod Is this not just the lubricant for the Pedal or is this real brake fluid from the ABS module leaking into the Car? took it to Toyota and they said they had never seen this before and they are recommending to replace the entire ABS Module and Brake Fluid at a cost of $3346 + Tax. (roughly $2700 in parts)
Acura - Legend :: Sticky Clutch - Pushed Pedal And It Would Not Return Or Allow Gear To Engage
1988 Acura Legend, 2.7L 6 cyl., 181,000 miles only do 6,500 miles a year to train station, parked inside, runs great. Last week parked out in hot sun, '90s, for 8 hours. At first, no problem. When did errand and returned to car, pushed clutch pedal and it would not return or allow gear to engage. "Jammed" into 1st, then could not shift, shifted slightly by pulling up on clutch pedal with my foot. Parked overnight, cool, next morning seemed to be fine and crept to mechanic. Mechanic road tested and found no problem and now seems to be working okay. Would parking in sun, high heat cause "clutch cylinder" to "seize" or "freeze"? Is there a "fix"? Also, increasingly hard to get parts for this car.
View 6 RepliesSanta FE SM (2001-06) :: Engine Oil Light Flicker When Pulling Up At Roundabouts Or Junctions
100k 2.0D .... Recently when pulling up at roundabouts or junctions either at low speed or quite rapidly, the engine oil light flickers. This doesn't happen at all on idle no matter how high it is revved and never while speeding up or at high speeds. I have tried to narrow the time it happens and just ended up being confusing because it can happen slowing down while in gear with engine under strain or to a lesser extent while coasting with g/box in neutral at idle speed.
The engine oil and filter has been changed but to no avail (as expected). I could check the oil pressure sender and wiring but it doesn't make sense as why the fault is not sporadic and quite consistent when it happens. (Also I did look at trying to remove the sender unit and possible fitment of a pressure gauge but how the *BEEP* do you get any tools to that!). I did mention it to a friend who knows a pair of mechanics at a local garage who both straight away went *ooooh sounds like big end bearings!!*
Toyota - Camry :: 2005 - Brake Pedal Almost Sinks?
We have a 2005 Toyota Camry, had it since 30K miles/2008, now has 94K miles. Since we have owned it, the brake pedal feel has not been great, kind of mushy. It is the way this generation Camry's are. It gets driven mostly on fwy, so not much brake use. At 92K miles I changed the front pads and rotors, pads still had 30% left on them. The rotors were somewhat warped. Brake fluid has been gravity flushed every 2 years since 2008, last one in 2012.
Now, the problem is when wife drives it, twice at a lengthy red light, she has noted that the brake pedal "almost" sinks. It did not go to the floor, but the level went lower. The car did not move during this events. With the newer ABS brake systems, on all my three cars, after a full stop, I can push the pedal down further, almost close to the floor. The Camry is the same way, just with a baseline of mushy pedals. My wife only drives one of the other ones (Dodge Caravan,)and has not complained about that one.
The brake fluid level is solid/steady, no leaks at the wheels either.
Now looking at whats involved, seems I can change the master cylinder myself. The question is do I need to? I don't mind paying a mechanic to do a diagnostic too, just not sure what they are going to do. I believe, just as a defensive measure, they will go ahead and change the MC (which then I might as well do it myself). I could also continue to drive it, but don't want to be stupid here.
Toyota - Camry :: New Brakes Squeak After Remove Foot From Pedal
Two days ago I had the front brake pads on my 2003 Toyota Camry LE replaced because they were squeaking when I stopped. That squeak stopped, but after driving about 15 miles, I heard a squeaking noise AFTER I took my foot OFF the brake pedal. Pressing the pedal makes the squeak go away. I took the car back the next day and they changed the front rotors. While driving home, the squeak returned. I took the car to my regular mechanic this time. He says the guys who installed the brakes didn't clean anything when they put the new ones on, so he disassembled everything, cleaned the rotors, etc. and put everything back together. He also said they put the wrong pads on the car - I need ceramic pads and they used the metallic kind. Well, the brakes are still squealing when I'm not pressing on the brake pedal and stop squealing when I do press it.
Characteristics of the squeak....It only seems to happen when I drive the car more than 5-10 miles. When I drive a short distance, it doesn't happen. The sound is rhythmic, not constant. If I step on the brake and let if off slowly, like at a stop light, I can hear it "squeak, squeak, squeak" as the tire rotates. The faster the wheel spins, the more constant the sound. It only seems to come from the driver's side.
I hate to take the car back to the original shop because I don't think they know what they're doing. I'm scared of getting ripped off at one of the big chains (I'm a female and of course whenever I take a car in for service at one of those places "everything needs to be replaced.")
Will Toyota ceramic pads fix the problem? Can the wrong pads cause the brakes to squeak when you're not stepping on the brake pedal? Someone else suggested it might be the caliper binding and that would require replacing it.
Camry :: 2007 - Dashboard Is Sticky
I just purchased a 2007 Toyota Hybrid in excellent condition except for a sticky dashboard. All the posts I have read said Toyota is aware but doing nothing about it. There are products advertised like Sticky No More but I am afraid to use it yet. The bright glare from the dash is a safety hazzard and I have notified NTSB about this to see if a recall may eventually be enacted..
View 1 RepliesToyota - Camry :: Brake Pedal Is Softer Than Before So Have To Push Harder To Get Car Stopped
I have a Camry at 120K now. Front brake pads was placed at 85K and was told by the maintenance person at that time that brake rotors couldn't be resurfaced since they were close to the minimum thickness.
Braking seems still fine these days. I don't hear any high-pitched noise or feel obvious vibration/pulsation when the brake is applied. The brake pads are still within a good range of thickness as the last check was made a couple of months ago.
But the brake pedal is softer than before so that now I have push harder to get car stopped. It that a warning sign which indicates it is time to replace the brakes rotors and pads?
Camry :: 2010 Toyota SE - Vibration In The Steering Wheel / Seats And Gas Pedal
I bought a 2010 toyota camry se. I have the most annoying vibration in the steering wheel, seats, gas pedal. Have taken it to several places, including a Toyota dealer.. They seem to not be able to find the cause. I've had wheels checked, balance, aligned, rotated. There is also an annoying clonking noise coming from the front passenger assembly. It's very sporadic as in only goes away when trying to have a technician hear it.
View 8 RepliesToyota - Camry :: 1986 - Clutch Pedal Is Going Directly To The Floor With No Effort
I have a 1986 Toyota Camry. I drove it for a year with no additional problems than when I bought it. I replaced the clutch when I bought it. However, It recently has had a new problem. The clutch pedal is going directly to the floor with no effort whatsoever. When this happened in the past it was simply out of clutch fluid, I was aware of the leak when I bought the car. Now it doesn't seem to be using any at all and I can only put it in gear when it is turned off.
I have replaced the clutch master cylinder myself and it didn't seem to solve the problem. I have tried to bleed the new master cylinder but no fluid is being drawn into the master cylinder from the fill cup on the top of it. I'm not even sure that this is the problem. I noticed that the place where the MC is attached to the clutch pedal is adjustable. Could this be a matter of adjusting this to drive the plunger inside the MC all the way forward? I am also having trouble understanding the whole clutch system. The MC doesn't seem to have anything to do with engaging or disengaging the clutch. The only thing it attaches to is the clutch pedal. Where does the clutch fluid go? Is there another place to fill Manual transmission fluid?