Camry :: 2010 Toyota Blower Motor Stopped Working - Fuses Blown
I have a 2010 Toyota Camry 2.5L. Suddenly the blower-motor stopped working. I looked at the under-hood fuse panel and noticed a few of the fuses in the fuse bus-bar were blown, however I'm not sure how the bus-bar is removed. Is this most likely my blower-motor problem? If so, how do I replace those fuses?
View 6 RepliesPrius (2004-09) :: Won't Start - 3 Fuses Blown
My cousin's 2009 Prius won't start and jump starting did nothing for them. In fact, when they tried it, they got sparks when they hooked up the ground cable and the headlights came on and stayed on the entire time they were attempting to jump it. Try again, and same thing but now I know they didn't go about it incorrectly or anything. There are also at least three blown fuses, I believe she said they corresponded to the smart key system, electronic throttle control (both up front) and then one in the trunk for the hybrid system.
View 14 RepliesToyota - Camry :: 1995 Will Not Start / Engine Turns But Does Not Engage
My 1995 Toyota Camry will not start, the engine turns but does not engage. I have had the fuel pump, fuel filter, and a relay switch replaced. After each repair the car runs for twp weeks and then will not start. I have had it towed and the mechanics start the car with no problem and they are unable to diagnose the problem. In a month and a half, I have had the car towed 3 times.
View 4 RepliesToyota - Camry :: 1995 Stalls At Stop Lights And Signs And Then Will Not Start For Over An Hour
I have a 1995 Toyota Camry, 4 Cylinder that has just started stalling when I step on the gas after a complete stop. After that, the car will not start for over an hour and will last only a few miles after that. this has happened 3 times so far. I have changed out the fuel pump but that did not do the trick.
I also noticed that when it was cold this past winter and I was on the highway the temperature would decrease a lot. But regular city driving the temperature seemed fine. Well now that it's warm again, the car shuts off at just above the halfway mark. So this morning I changed out the Thermostat and now it's running hotter than ever, the heat does not work at all, and the car will not start. (it started up fine after the thermostat install but the engine temp was high and heat was not blowing warm) I'm hoping it's not a bigger issue.
Toyota - Corolla :: 1995 - Suddenly Mushy Brakes Like Foot To The Floor?
Feels like I can almost put my foot to the floor. From where it engages to where there's strong resistance is 2 or 3 inches. Seems strange, what do you think?
View 19 RepliesPrius V :: ECM Malfunctioning - Blown Fuses
A dealership is attempting to charge me several hundred dollars to replace blown fuses that they claim is a result of an overpowered attempt at charging a seemingly dead 12V battery. The interesting part is that after also replacing the air/fuel ratio sensor (which they initially claimed was the cause of a check engine light even after replacing the fuses) Toyota is telling them that the ECM should be replaced in order to extinguish the check engine indicator.
View 8 RepliesPassat (B5) :: Fog Lights - Multiple Blown Fuses
My fog lights were working perfectly but I got the dumb idea that I wanted to turn them yellow. I bought some Hella Yellowstar 55w bulbs and installed them. Fogs worked for a couple of hours then I noticed that they wouldn't turn on. I replaced the 15A fuse and once again it worked fine for a couple of hours before I blew another fuse. Now every time I replace the fuse it blows as soon as I switch the fogs on. Was I correct in thinking that 55w was the wattage of the stock lights? Also I understand that you're not supposed to touch the bulb itself as oil on your fingers will heat up once the light is on and cause this problem. Tomorrow I am going to reinstall the stock bulbs and replace the fuse again and see if they work.
View 4 RepliesSuburban :: 1999 - Turn Signal Fuses Blown
This morning everything worked on a 1999 Suburban 4x4. One hour later, my blinkers (turn signals) were not working. Flashers were.
I checked the fuse (fuse 16) for the turning signals - blown. I bought some fuses - replaced turn signal fuse. It blew immediately and then the hazards no longer worked. I replaced that fuse and the hazards lasted a few seconds.
Hazards & brake lights are on the same fuse (fuse 1) so I am left with no brake lights, hazards or turn signals - I am an accident waiting to happen!
I switched my cigarette lighter fuse for the hazards/brake light fuse - didn't start the car - and turned on the hazards. I heard the fuse blow immediately.
My husband put a new radio in last year at this time and has fog lights wired to it - but that was last year not last week...
I know trailer lights are attached to fuse 16 (turn signals). I bought this car used, but it does have a trailer hitch with wires that I have never used.
Where to even start looking for the short... a short that would cause the hazards/brake lights to short out also.
Chevrolet :: Fuses Blown Gear Shift Locked
Just had car in for inspection/oil change. now car starts but can't shift out of park and no horn, brake lights, radio, gas gauge, odometer, etc.
View 2 RepliesChevrolet - Aveo :: Stuck In Park / Brake Lights Won't Come On - Fuses Blown
4 days ago, my '04 Chevy Aveo (89,300 miles) would not shift out of park and no brake lights were coming on. I had to use the shift lock release to start the car in neutral, and I took it to dealer. Dealer replaced the brake switch. One day later, the problem returned. I took back to dealer, and they showed me that the light blue "15" stop fuse (the right column of fuses, second one down) had blown. They replaced. It again worked for a day, and the problem came back. Each time I put a new 15 fuse in now, it works temporarily, but now fries either immediately or within an hour. In order to drive, I still have to use the shift lock release, which isn't great, because it means I have to drive without brake lights.
View 10 RepliesFord - Focus :: 2007 - Brake Lights And Other Electrical Fuses Blown At Same Time
A couple years ago my car got stuck in Park, in which I had discovered my brake lights and a few other electrical fuses blew at the same time. It has happened randomly about 4-5 other times since, in which I take it back to the dealership and they "fix it" temporarily. After about a 1 1/2 years of no trouble, it happened again, and the dealership traced it back to the GEM module, which they replaced for me. Electrical components I forgot I had (like automatic locking doors) came back- for about a week. I got stuck in Park again, lost my break lights, as well as some other functions. I haven't noticed this problem on the focus with other discussions. Now it has added to much time in the shop, multiple FORD dealerships unable to fix it properly, and lots of wasted money. Shouldn't a new electrical unit fix the problem?
View 6 RepliesFord Super Duty (1999-2016) :: Blown Fuses / Won't Shift Out Of Park
I did a bad thing last night, I put a jumper in the 20 amp cigar/data link connector and all kinds of things went out, will not shift out of park, no directional, power windows, power mirrors, no brake lights ,no hazards, no wipers, no interior lights and I don't know what ever else is not working.
View 3 RepliesToyota - Camry :: No Brake Light - Fuse Spark And Blown
I have a 1996 camry and the break light don't come on non of them. I change the switch under the break pedal and it didn't work. I change the fuse but when I did so it spark and blew the fuse. Is there a reason for this? where should i go next with this issue.
View 1 RepliesPrius (2010-12) :: Windshield Wipers And Cigarette Lighter Plugs Don't Work - Fuses Blown?
We have a fleet of Prius's with 11k miles on them. Windshield wipers don't work and cigarette lighter plugs don't work. I'm guessing this is due to blown fuses. Where the fusebox is? I'm getting fed up with this. Also, is there a diagram somewhere that shows which fuses are for which circuits? (IE Which number fuses protects windshield wiper circuit) so I can finally see in the rain...
View 8 RepliesToyota - Camry :: 2007 Car Suddenly Would Not Accelerate Above 20 Mph Or 2000 Rpm
2007 Toyota Camry, 4 cyl, automatic transmission, 147k miles. Was driving ab 60mph and slowing down as I approached a red light. Light turned green but car suddenly would not accelerate above about 20mph or 2000 rpm - ran fine as long as I stayed under 20, but when I tried to accelerate beyond that it started lurching like crazy and wouldn't accelerate. Pulled into a gas station and let it idle for a few mins while I checked the transmission fluid (has had a slow leak but I have been staying pretty on top of the fluid levels). Color and smell of the fluid was fine, but level was just a little low so I added some more fluid and let it cycle thru for a few minutes. Managed to get it home by staying under 20mph. Turned it off and basically ignored it for about 10 days due to being swamped at work. Went to start it up last night and the engine cranks but won't turn over and start. Lights, etc. all work. What gives? Praying this is not a transmission issue.
View 8 RepliesToyota - Camry :: 2002 - Stopped Suddenly When Still In Drive
I've been having some problem with my 2002 Camry lately. It started when I was exiting off highway waiting at a stop light when my car just suddenly stop, while the car was still in drive. The battery light, engine light, and oil light came even though the music was still playing. So I put the car to park, turn the key to completely turn off the car and restart the car.
At first it sound like the car was going to start but as I turn the key and keep holding it for the car to start all the way, it just die again. I try again but this time I step on the gas pedal at the same time I turn the key and after two or three press on the gas pedal, the car work and all the light was off. Everything was fine. This would happen every other day and I would do the same thing to it but don't know why this is happening.
Toyota - Camry :: 1995 - Key Won't Turn At All In Ignition
1995 toyota camry 4 cylinder engine - My car was working fine yesterday, but today when I inserted my key; the key won't turn at all. I have try changing the shift control to neutral and jerk the steeling wheel. I have also went and copy my key. When I inserted the new key, it finally turn all the way, but then it got stuck in the ignition. After a few hour I got the new out of the ignition and try again. This time the new key can't turn all the way. My uncle believe that the key ignition sensory is the problem.
View 1 RepliesToyota - Camry :: 1995 - Making Clunking Noise
I have a 1995 Toyota Camry. I let my niece use it while on xmas break when I went to go pick it up it made a clunking screeching sound as i tried to back it out of the parking lot. I found it difficult to turn the wheel as well. I had to get it home so I drove from Orlando to St Augustine. Weird thing is that once on the highway going 70mph i didn't hear the sound anymore. I thought it was ok. I stopped in Daytona for gas and as i pulled away that sound began again. This lasted until i got to accelerated to about 50mph this time. I heard it again going through my neighborhood which is 25mph. It was very difficult to turn the wheel. My husband checked the power steering fluid which it was empty.
View 6 RepliesToyota - Camry :: 1995 - Power Loss Momentarily - Cause?
I have a 1995 Camry with the 4cyl 5sfe engine and a manual transmission with about 120K miles. It's been very reliable overall, but lately it's been exhibiting some strange intermittent behavior. When driving at a steady speed between 2-3K rpms, it'll sometimes experience a momentary power loss. There's no stalling, but it's as if I've hit a stiff headwind or the brakes have been applied and then release. It doesn't seem to happen when accelerating, but as mentioned above, it's most noticeable when maintaining a steady speed. Sometimes it'll be very quick like it's bucking and other times it'll last a full second or two. It'll do it in all gears at both relatively low speeds and highway speeds, so there's no pattern there. There is no check engine light when this happens, but I have not yet attempted to check codes just in case it might be storing any. It'll happen when the engine is both cold and at normal operating temperature. I've also tried to observe whether or not the tachometer drops when it bumps, but haven't really been able to discern that due to the usual momentary nature of the power loss.
The coil on this car is integrated into the distributor and I read somewhere that it's common for these to start to go as these Camrys age and accumulate a lot of miles. I also read that it's common for these cars to hesitate due to internally leaking fuel pulsation dampeners. The AC compressor makes a little noise, and sometimes it almost feels like what you would expect it to feel when the compressor kicks on, although the jolt or 1-2 second sustained power loss, depending on what occurs, feels stronger than that. Plus it'll do it with the AC off, so that doesn't seem to be a possibility. Other than this problem, the car has no issues whatsoever. It's quiet, uses very little oil, idles perfectly and maintains optimal operating temperature. The miles are about 75% highway since I've been using it mostly as an airport commuter car. Most essential maintenance items, such as the clutch, timing belt, water pump, oil seals, PCV valve, thermostat, radiator, motor mounts, etc. have been replaced within the last 15K miles, and most are Toyota OEM parts. Plugs, wires, cap and rotor have all been replaced within the last 10K miles, again with Denso plugs and wires, but aftermarket cap and rotor. I did feel up under the distributor and got some fresh oil on my fingers, so the o-ring might be leaking a bit. However, I don't know yet if there is any internal leakage inside the distributor itself.
I'm going to tear into it a bit, but I wanted to see which direction to look first. Would you suspect a spark issue (again, no CEL illuminates), or something more like a fuel delivery issue? I also wondered if it might be something like the TPS or perhaps a cam or crank position sensor on the way out.