Toyota - Camry :: 1999 - Automatic Transmission Won't Engage
1999 Toyota Camry. Suddenly gears failed to engage. When sfitinthe gear shaft does not go in to any gear- shifter moves easily but does not engage at any gear. Is it due to lack of transmission fluid?
View 3 RepliesToyota - Camry :: 1994 - Transmission Malfunction / Not Shifting Properly
I have a 94 Camry 2.2. When I am driving 45 MPH the transmissions acts like it is shifting into N or OD and then the RPMS fluctuate between idle and 1500 or so. Then when I it will shift hard because the car has decelerated. If I stay in the throttle during this it just jerks or lunges.
View 3 RepliesFord Transmission :: 1994 - Cannot Move Engage In D But Will Shift Fine If Started In 1 Or 2
I have a 1994 F53 Chassis RV that has recently developed a transmission problem. The transmission has been working fine then one day I went to move the RV and I put the transmission into “D” and nothing happens. It feels like it is still in Neutral and there is a slight metal on metal sound like it is trying to engage. However if you the put the transmission in reverse it works fine.
I then put the transmission into “1” or “2” and the RV moves with no problems. Then once it is moving I can shift it into “D” and the transmission will act like normal and shift into 3<SUP>rd</SUP> and 4<SUP>th</SUP> gear. That is until I come to a stop again. Then it feels like the transmission goes back into “N”. I then can shift back into “1” or “2” and get the RV moving I can shift it back into “D” and everything works again.
I have checked the transmission fluid and it could use changed but the level was fine. I have read about the MLPS could that be causing this problem? I have read about testing the MLPS, but I am not sure which pin is which.
Ford Transmission :: 1994 - Barely Engage - Grinding Noise In Park And Neutral?
I have a 1994 F-150 extended cab electronically activated 4x4, with the 302 V8 and an e4od transmission.
When the truck is running and it is in park or neutral it makes a grinding/whining noise and when it is in gear it doesn't engage, or occasionally will barely engage, but only enough to move it a little ways.
I've read a couple of post that suggested bad connections to the transmission could cause the transfer case to be in neutral which could cause a similar problem to this. I checked all the connection the best I could and the only thing I found that gave me any concern was one of the wires connected to the transfer case shift motor had some of the insulation melted or rubbed of and the wire was a bit corroded.
Is there any chance that this could be causing my overall problem with the truck not driving? Or what might be going on with it? Or any way I might be able to fix it without having to hand over a significant chunk of change for the full rebuild.
Toyota - Camry :: 2009 - Overdrive Shift Does Not Engage
I have a 2009 camry. My overdrive shift does not engage. Sometime when I push, the display shows and sometimes does not. I feel its a contact problem but if its the solenoids or some relays somewhere.the car is consuming excessively on gas.
View 7 RepliesToyota - Camry :: 1995 Will Not Start / Engine Turns But Does Not Engage
My 1995 Toyota Camry will not start, the engine turns but does not engage. I have had the fuel pump, fuel filter, and a relay switch replaced. After each repair the car runs for twp weeks and then will not start. I have had it towed and the mechanics start the car with no problem and they are unable to diagnose the problem. In a month and a half, I have had the car towed 3 times.
View 4 RepliesCamry :: 1994 Toyota 2.2L Car Not Starting - No Spark
I get a call from my mother saying their 1994 Toyota Camry 2.2L car won't start. I went over there today and the first thing I check was the spark. I hooked my spark tester and had my dad crank the engine over. No spark. So I removed the distributor cap and tested the resistance on the primary and secondary sides of the coil. The secondary side was low. So I went and got a new coil, installed it and it still wouldn't start. I checked the spark again and it had spark, but still wouldn't start. I then proceeded to check the fuel pressure. I hooked up my pressure tester to fuel filter, with the included adapter, and had my dad turn the ignition switch to ON position. No pressure. Then I had him try and start the engine, the pressure jumped up to 41 PSI. I then sprayed a little gas into the throttle and the engine would try to start. I'm stuck.
View 5 RepliesToyota - Camry :: 1990 Takes Literally 3 Minutes To Engage Reverse
A140E transaxle issue... I have what I surmise is a direct clutch engagement issue. It takes (literally) 3 or MINUTES to engage reverse. And obviously the 2 -3 shift is slow also. It acts like there is a restriction in the passage to the direct piston. I rebuilt about 5 years ago, so am familiar with the teardown.
View 2 RepliesToyota - Camry :: 2003 LE Would Not Start / When Key Turned In Ignition Engine Would Not Engage
My 2003 Toyota Camry LE has been running fine. Recently I parked the car somewhere for about 5 minutes and when I returned the car would not start, i.e. when I turned the key in the ignition the engine would not engage. I called the tow truck. The tow truck driver takes a look and tells me that she can hear the engine trying to kick in. She thinks the battery is fine, the alternator is fine etc. etc. So she pops the hood, takes a long metal rod, places it on the starter and gives it a couple of gentle taps. Then she asks me to start the car. I do and it works. She tells me that the starter was stuck and that what she did freed it up.
The car runs okay now but I am concerned as to whether this could be a sign of things to come. Should I take my car in the get the starter looked at or maybe replaced? The dealer says that a new starter will run me 350 bucks but also said that I don't need to come in unless it happens again. What does the community think? Do I have a problem or was it a one off thing that I can ignore for now? And I don't know if its important or not but the weather here has been starting to get colder lately. Could that be responsible in any way? I have about 81000 miles on this car.
Toyota - Camry :: 1994 - Still Won't Start In Cold Weather
In Jan my 94 Toyota Camry started having issues with starting- for instance, I would run an errand for 10 minutes get back in the car and it wouldn't start. However, this tended to be random. When this problem happened more often I took it in and they said I needed a new starter so I got one (Feb) and didn't have any issues for a month, but then began to have the same issue on and off again. I took my car back in for the second time and they said it must have been a bad starter. They gave me ANOTHER new starter (Apr) and my issues continued soon after. I took it back in and they didn't have an answer for me other than the starter was good. Took it to another mechanic and he had the car for two days and could not find ANY ISSUE with the car. I let it brush over during the summer months because I never had this issue (June-Aug) and now that it's gotten cold again I'm having this problem.
Few things to note: -Anytime I have this issue I'll hit the starter with a hammer and it will ALWAYS start. This has been the case since January.-It ALWAYS starts in the morning and when I get back in my car after working all day. However, if I were to run errands in the morning or at night it would not start with the stop and go. -This only happens in the cold months -They tested the newest starter and they say there's nothing wrong with it.-Within the past two years I've had MANY things replaced on this car and any shops I've taken it to say it's a great car with no issues they can find.
Camry :: 1994 Toyota LE - All Electrical Remains On With Key Removed From Ignition
I have a 1994 4 cyl Toyota Camry LE. For the last couple of years, when I parked the car after driving it and removed the key from the ignition, the air conditioning would continue to operate normally and blow cold air through the vents, and all of the other electrics would all operate for about 5 seconds, then shut down normally. Again, this was after driving the car, engine off, with the key removed and the ignition switch in the proper "off" position. I didn't think much of it at the time.
Recently, the problem has advanced to something worse. Now, when I turn off and remove the key, all electrical components remain on indefinitely (ie radio, air conditioning, wipers work, etc... )
I can physically power down each of the individual components using it's respective switch, but there is still accessory power on the vehicle. Basically, with the key removed, the vehicle thinks it is in accessory mode. All the dash lights are illuminated, like right before you start the vehicle. The only way to completely remove all electrical from the vehicle is to physically disconnect the battery.
Toyota - Camry :: 1994 - Fuel Gauge Always Shows Empty
My 94 Camry 4 cyl fuel gauge seems to be broke. It always shows empty. The "fuel warning" light doesn't come on however. The last time it worked, I had about 1/2 tank and filled it up. It took several minutes for the gauge to creep up to full. It worked for a few days and then when i started the car this evening, the gauge showed empty and tays on empty.
What is the most likely issue here? I've read that it could be the sending unit, bad wiring or the gauge itself. All other dashboard gauges are working fine.
Toyota - Camry :: 1994 V6 Starts / Idles Very High And Within 15 Seconds Will Die
I've got a 1994 Camry V6 that I am swapping transmissions from automatic to manual. Before the swap, the engine ran fine and started first time every time. Now that I have everything back together, the car will take many times of 10 seconds or longer cranking to be able to start. Once it does start, it idles very high and within 15 seconds will die. If, during the time it is running, you touch the gas at all, the car instantly dies. I've got CEL's for CPS and TPS. I have replaced both sensors numerous times, checking with a voltmeter they are within spec as are the wires, I have replaced the ECU and wiring harness.
View 5 RepliesCamry :: 1994 Toyota LE V6 3.0 Liter Dies In Drive / Engine Light On
I own a toyota camry le automatic that has the engine light on and dies while driving. I've taken it to a mechanic and he diagnosed the error codes p0500 and 720. we fixed the 720 by replacing the trans. speed shaft sensor and replaced the vehicle speed sensor with one we bought from ebay. The rpm will shoot up randomly whilst the check engine light is on. the speedometer works just fine now. car dies when it slows down or at a stop. the rpm goes far below 1000 and i smell gas then i hear it beginning to struggle just to stay on.
The dash lights dim and return to normal then dim again and repeat then it shuts off and the battery light along with oil light come on. turns on fine but when put in reverse or drive it shuts off. it cant go more than 3 minutes without it messing up. when the engine light isn't on it runs just fine but once it turns on i've got about three minutes to get back somewhere safe. also when it does want to die i have to give it gas for it to stay on. i feel a major lag also and the o/d light flashes along with the pwr light.
Toyota - Camry :: 1994 Will Not Restart When Turn Off Car After Driving For Short Distances
When going short distances, half mile to two miles, and I turn off the car it will not REstart. Dash lights come on but engine does not make a sound. No clicking, no engine trying to turn over, nothing. After the car sits for awhile and cools off it starts up with no hesitation at all. If on the road for several minutes the car does not have this problem no matter how far or how many times I turn it off and on. The battery checks out ok. Someone said it could be a ground wire loose. What do you think. Is this something I could do myself?
View 5 RepliesToyota - Engines - Camry :: 1994 - Engine Revving Too High Before Changing Gears And While Driving
I have a 1994 Toyota Camry. Took it to a shop to repair an oil leak. They had to dismount the transmission to get to the gasket. I got the car back and the transmission was messed up. Took it to a transmission shop and they told me that the transmission "cable" wasn't positioned correctly by whoever had done the work and they could fix it. They told me it was safe to drive it until my appointment. The engine was revving too high before changing gears and while driving home, I heard a loud rattling noise in the engine and my car stopped in the middle of the road. I'm told that a rod has broken inside the engine. My question is: can this in any way be related to the transmission cable not having been set/positioned correctly?
View 5 RepliesFord A/C :: 1994 - Compressor Clutch Will Not Engage
I just picked up a '94 7.3 IDI Turbo, and I can't figure out what ails the AC. It appears that there should be enough refrigerant (according to my recharge kit), but the compressor clutch will not engage. I have checked the fuses, and all are fine. All other HVAC functions are normal. Is there a way to test the compressor?
View 5 RepliesFord A/C :: 1994 - Compressor Clutch Won't Engage / Only Light Goes On?
I have a 94 Ranger with 2.3L motor. Last week my ac quit working. I push the in and the ac light goes on, but the compressor clutch won't engage. I changed the relay, but that didn't work. The fan still works, but the ac does not come on. I tried banging on the compressor pulley, but that didn't do anything. The clutch is not frozen -- it spins freely. The connector looks good and I haven't done any work in the engine compartment so I couldn't have accidentally moved any wiring. What I might try or is my compressor simply dead?
View 2 RepliesChevrolet - Suburban :: 1994 - Won't Engage The Front Drive Shaft
My 1994 Chevy Suburban will not engage the front drive shaft. It has an electric actuator and it will not engage. the transfer case engages but not the front axal. When I shift the transfer case into 4Hi or 4Low it will shift itself but the light will not turn on. I have heared rumors that you might have to manualy connect it to the battery and have a kill switch in the cab. What is the problem and should I connect it manualy?
View 6 Replies