4Runner/GX470 :: 1998 - Low Fuel Indicator Light Stays On Even On A Full Tank

I have a 98 4 Runner the fuel light has come on, the fuel gauge itself is working fine. The low fuel indicator light stays on even on a full tank, would like to know if there is a reset button or is it attached to the fuel sending unit or is it a separate unit....

View 1 Replies

4Runner/GX470 :: Back Hatch Light Not Coming On With Door Open

WHen i open the back hatch, the light does not come on when the switch is on door but if i flip it to on it works fine...

View 2 Replies

Toyota - 4Runner :: 2005 - Charge Indicator Light Comes On

My 2005 Toyota 4Runner has the 4.7 V8 and in the last week or so, the charge indicator light on the dash has been intermittent and then suddenly on always. I started searching around and pulled the batt cables and cleaned the corrosion. The charge light has remained on and when I start it up, it almost gets to operating temp and then lights, radio, heat etc. all begin to shutdown. Then the dash lights up like a Christmas tree and shortly thereafter, the tach drops to zero, the engine sputters and then dies and will not start again until I disconnect batt cables and reconnect.

View 18 Replies

4Runner/GX470 :: 1998 Toyota - Check Engine Light Flashing When Driving Past 70 MPH

Some background. I have a 1998 Toyota 4Runner V6 2WD with about 150,000 miles. A few months ago the check engine light was flashing when I am travelling over 70mph. The dealership said nothing is wrong when I asked them to look into it. But I didn't get any codes from it. I read on-line that it could be a possible misfire so I changed the plugs and wires.

A few weeks ago, the check engine light came on and stayed on. I took it to a dealership to diagnosis the problem, they came up with Mass Air Flow sensor was shot. I replaced that, and reset the computer. It still comes on and flashes at highway speeds. I bought a low end computer to read the codes.

I got P300 (Random/Multiple Misfire), P302 (Cylinder 2 Misfire) and P305 (Cylinder 5 Misfire). Cylinder 5 has the coil-pack and Cylinder 2 has the wire coming off the coil-pack for Cylinder 5. So I replaced the coil-pack. The light is still coming on and flashing. How to stop the light from flashing. It comes on only when I am travelling past 70MPH. I have tried just rev'ing the engine up to the same RPM's as I am running when doing 70, but the light doesn't flash then.

View 9 Replies

Camry :: Door Open Indicator Stays Lit - Clicking Sound From Fuse Box

Recently purchased a 2004 Toyota Camry with only 58,000 miles on it. Only one problem has showed up - the "door open" indicator stays lit - does get brighter when an actual door is open and shows which door but never goes all the way out. Sometimes it gets slightly brighter and dimmer, back and forth.

Sporadically when I start the car there is an audible clicking (cycling) back and forth that sounds like a turn signal coming from the fuse panel to the left of the steering wheel. The only way I can get it to stop is by opening the door, closing again, open and close the locks, turn the engine on and off, etc.

Yesterday it continued while I was driving and eventually stopped on its own (and again today). Weird - I think it must be a fuse or a relay or something but I pulled all the fuses one by one and they all look good. Not sure where the relay is....The door open indicator never goes completely out though - sometimes it pulses all night long but doesn't seem to run the battery down or anything.

View 2 Replies

Toyota - 4runner :: 1998 - Grinding When Trying To Shift Into 4lo

I have a 98 toyota 4runner. Limited, automatic transmission, 4wd, 6cly. 3.4L. Recently my 4runner was towed and after picking it up from the impound lot I went to test the 4wd. This model has a separate shifter for 4wd with an on the fly button which you press to engage 4hi. Well, when I went to test it the 4wd the light did not come on and I felt no "clunk" as I normally do when engaging the 4wd, (this is even after driving a few feet.) So I went to test the 4lo. I put the transmission in neutral and pushed the 4wd shifter forward to the neutral position as I tired to go one more to the 4lo position it began producing a horrible grinding sound. I didn't push the shifter all the way forward for fear of further damaging something so I went to put it back into 4hi and again this horrid grinding sound. Basically the 4runner was stuck with the transfer case in neutral? It wouldn't even go into park with out making this horrible sound, so I had to shut everything down and put it back into park and hi mode. When I turned it on again I tried it again and still the same result.The 4runner works just fine in 2wd. And eventually the 4wd light came on after driving a few blocks with the button pressed although, I'm not sure the 4wd was even engaged because I never felt the "clunk." It is still grinding when trying to shift into 4lo. Fluids are changed regularly and it is very well maintained. It has 228XXX miles.

View 3 Replies

Toyota - 4runner :: 1998 - No Power / Really Bad Gas Mileage

I am all of a sudden getting really bad gas mileage on my truck and have no power. The "check engine" light was on and I changed the O2 sensor, and the light went off, but am still getting about 15 miles/gallon as opposed to the 22 I was getting. Changed my spark plugs about 1 year ago.

View 9 Replies

Toyota - 4runner :: Back Door Does Not Click / Move Or Open

I am trying to find out which fuse is linked to the back door motor because the window works but the back door does not click, move or open. There is a motor on it that usually pulls it fully closed and none of it is responding.

View 1 Replies

Toyota - Sienna :: 2002 - Rear Hatch And Passenger Door Lock Would Not Open With The Key

I have had that car, the best one I have ever owned, since shortly after Nine-One-One, a date some of you may remember.

I never open any door but the driver's door with the key. Several months ago, for some reason it occurred to me to try and see if they worked.

Nope, both the rear hatch and passenger's door lock would not open with the key. I assumed that the mechanism corroded up over lack of use over the years.

I thought, Well, crud. But, since I haven't used those door locks in over 12 years, I can probably get by.

I thought I had lost the spare car key when I was in Texas in December. To my surprise, I saw it on the key rack in the kitchen here in rural Mexico. I took it out to the car to check it out, and it opens all the doors.

I compared the keys, and one of the 'vanes' on the key I use all the time is a very tiny bit smaller than on the spare key. My guess is either that key never opened those two doors and I never noticed it. Or, it has worn over 12 years.

So, I guess when I get back to the States, I will have a copy made of the spare key. I am also going to post this on Sienna Chat for obvious reasons.

View 1 Replies

Golf/GTI VI :: Trunk Light Never Shuts Off With The Hatch Open?

I just noticed that even when switching the dome light off, the trunk light never shuts off with the hatch open.

I assume there is no way to turn it off other than taking out the bulb?

View 6 Replies

Accent LC (2000-05) :: Hatch Open Light Is On All The Time

My sister is having an odd issue on her 3-door accent. The hatch-open indicator light is on all the time. But when you press the brake pedal the light goes out. She has to disconnect the battery every night so it won't wear down.

Most of the suggestions were to check the sensor/latch at the hatch. But if the light is going out when you press the brake pedal - then the problem is nothing to do with the sensor. I think it might be a bad ground somewhere. I've taken the sensor/latch completely apart - the problem is not there.

She had this problem a few years ago. I wiggled and pulled on every harness under the dash, and I removed, checked, and reinstalled the rear bulbs. I don't think any of that worked, but eventually the light went out on its own. But now the problem is back. I think the problem might go away and come back depending on the moisture in the air.

View 1 Replies

Ford - Explorer :: 2004 XLT - Flashing 4x4 High Indicator / ABS Light Stays On All The Time

04 Explorer XLT, 4dr. 4wd, 4.0 engine - after replacing front rotors and pads the "4X4 High" indicator light flashes then pauses then flashes again. Did I brake something, what is the cause and how do I fix it. ABS light stays on all the time.

View 1 Replies

Honda - Accord - Sensors :: 2009 - Airbag Light Stays On / False Seat Belt Indicator

I have an 09 Accord (LX), one day the airbag light (SRS indicator) on the dash would stay on when driving, and the Seatbelt Reminder Indicator would detect the driver's seatbelt isn't engaged, even when it is.

A day later, the seatbelt indicator resumed normal operation, but the SRS light still remained on. I took it to two separate dealers and neither of them could connect to the SRS Control Unit to pull error codes from the onboard computer. They say I need to replace the SRS Control Unit to even begin troubleshooting this problem.

Can I replace my own SRS unit without accidentally triggering my airbags? Where do I order it? How do I make sure it is the correct part? Is it easy? Or I have a separate problem?

View 8 Replies

GTI 337/20th Anniversary :: Door Open Light Stays On

so i have opened and closed every door a million times and my open door light is staying on and when i lock it it doesn't beep like it should. i lock it and then whenever later my alarm/ panic horn goes off. it did this a few days ago but went away but now it won't. [URL]..............

View 8 Replies

Toyota - 4Runner :: Check Engine Light On - O2 Sensor Bad

1989 toyota 4runner. O2 sensor is bad and has the check engine light on. No need to spend $100+ on the sensor. Is there a way to disable it so the light goes off?

View 19 Replies

Toyota - 4Runner :: Check Engine Light Due To Low Compression

I have a 2005 Toyota 4Runner. 355,000 miles. No problems with it until now. About 2 weeks ago Check Engine Light came on. I replaced spark plugs (they were due), checked coils and fuel injectors and still have Check Engine Light on with code P0301 (Cylinder #1 missfire).So compression tests were done and cylinder #1 had 120 psi and others 170. I suppose 120 isn't terribly bad but is significantly lower than 170.

Question 1: If I reset the check engine light (turn it off), do you think it will pass California smog test?

Question 2: What do I need to cure the problem? Engine rebuild? JDM? or retire the truck?

View 13 Replies

Toyota - 4Runner :: 1997 - Randomly Stalling At Stop Light

I have a 1997 Toyota 4Runner SR5, 6 cylinder with 188,000 miles. I love my car, it's treated me well over the years. About 2 months ago it started stalling at stop lights, etc. Basically, any time I came to a stop and it was idling while in gear. I start it right back up and when my foot's on the gas, it doesn't stall. After 10 times or so I learned that if I took it out of gear the RPMs went up a little and it didn't stall. About 2 weeks later the "check engine" like went on so I figured, now it's time to take it somewhere. So I took it to a mechanic that I've been to before and trusted (here in San Francisco) and he said, "oh.. it's probably just an idle adjustment" so I think, great, no big deal.

After a few days he said wasn't the idle and that after testing he found that all 6 cylinders were randomly misfiring. So he needed to change the spark plugs cause they were down to a bare nub. I figured, ok, it's about time anyway. He said it could also be the ignitor?, he didn't sound 100% positive, but told me there's probably something wrong with it since it's pretty old too and that's all he could think of. So he changed all 6 spark plugs and the ingintor and the engine light was still on. It was stalling less frequently, but still randomly stalling.

He then said he was going to have his Toyota specialist friend look at it. His friend couldn't figure out what was wrong either. Then he sent to to the Toyota dealer, they checked everything they could think of, but couldn't diagnose the real cause either. Apparently they even checked the "Dynamic Balancer"? I'm not even sure my car has one of those. They might as well have told me it needed a new agonculator (totally made up word) for all I knew. So they had my car for 3 weeks and finally I said, enough is enough, these guys can't figure it out. After 3 weeks of hearing how much money they spent on other people to figure out it, I finally said, let's stop the bleeding. The car still runs and doesn't stall that much. The last thing they tried was 2 series of a fuel injection flush (decarbonize)? So they did that with not a whole lot of improvement. They also managed to run all the gas out of my car and by the time I picked it up, the fuel light was on and I took it immediately to a gas station. No joke, they burned about 1/2 tank of gas and didn't refill it.

After 3 weeks and $1000, they come up with "we don't know what's wrong, but use Premium gas and it might fix itself". In the end they told me they were down to only one misfire, cylider #4. Also, the "check engine" light is still on. Since I've gotten it back it hasn't stalled, so there's an improvement. But I'm no closer to figuring out what's wrong that's keeping the check engine light on. Needless to say, I'm not taking it back to these guys.

View 10 Replies

Buick - Century :: 1998 - ABS Warning Light Stays On

Ran scanner and it showed codes C1215, C1226 and C1233. We checked the passenger front and found the wire to the sensor hanging off. It was damp inside so we dried it as much as we could. We reconnected the wire and tested. The light still on. We ran the scanner again, Only one code came up C1233. The book says ( Right front wheel speed circuit open or shorted)

C1233 - Right Front Wheel Speed Circuit Open or Shorted

Read more at: [URL] .....

View 2 Replies

Toyota - 4Runner :: Check Engine Light Came On And Code Was P0420 - O2 Sensors?

I have recently had about $1620 worth of work done on my 2000 4Runner because the check engine light came on and the code was P0420.. My invoice says they replaced the exhaust pipe assembly. Now 2 weeks later the light is back on with the same code...are the 02 sensors part of the "exhaust pipe assembly" or are they now going to tell me I need a bunch (2-4) 02 sensors replaced.

View 3 Replies