Sebring - Chrysler :: 2006 - Horn Randomly Honks
My girlfriend's 2006 Chrysler Sebring is suffering from a horn that randomly honks. No action on the part of the driver is needed for the horn to blow, in fact it goes off by itself in the middle of the night sometimes, for minutes without end.
View 2 RepliesSebring - Chrysler :: Transmission / Airbag Light Comes On Then Turns Off Randomly
I own a 2007 Chrysler Sebring touring. I bought it used with 34,000 miles in 2009, and so far, haven't had too many real problems with it. Unfortunately, I'm rounding the ~65,000 mile mark and some weird things are finally going on. The transmission light comes on for a few days then turns off - for a few weeks one time, then it came back on for a day, and hasn't been back on for a few months. Also the Airbag light will bing on for a few seconds, turn off, then a few minutes later come back on, and this happens randomly. (It also recently threw a wheel weight it seems, but I'm familiar with how to fix that issue!)
A mechanic friend of mine told me that rather than paying money to repair this car, that I should get rid of it - he suggests Chryslers like mine become junkboxes right around 65,000 miles.
Sebring - Chrysler :: 2002 - Engine Shut Off While Driving / Apparent Grinding Noise
I have a 2002 Chrysler Sebring with 116,000 miles and over the past month the engine has shutoff as I am driving and once I park turn the key off and turn on it has started to run again. This has happened about four times and each time it has been difficult starting it after the car has stalled. The most recent time this happened when I went to restart the car, a grinding noise became apparent. The last few times that I have started the car the grinding noise would be heard only to ultimately fade away in about 15 seconds. The check engine light came on and went to get the code and it came back suggesting a problem with the camshaft position sensor, but I don't fee the noise is related to that.
View 1 RepliesSebring - Chrysler :: Blower Motor Will Not Stop / Error Code PO4091
Blower motor will not stop after engine is turned off. Is this a relay switch issue? Motor will run at very high speed. After a few minutes it would intermittently turn on and off. Battery was discharged two days ago. I forget how to test these relay switch, been a while since I've used my old DMM. Anyway, I've got an error code PO4091 (secondary air inj sys insufficient flow, bank 1). I lost the info on the two other error codes, but I will dig it up later and see if at all related.
Off topic. Found a vacuum line broken, reinserted the remainder of the tubing, so good for now on that end. It's by the TEE next to the battery. No wonder this one was stalling around 600 RPM and on low speeds around 600 RPM. New coils wires and spark plugs. Runs smoother now.
Sebring - Chrysler :: Check Engine Light Came On And Code Came Out As Catalytic Converter
2004 Chrysler Sebring Sedan, 4 cylinder dual-overhead cam. My check engine light came on this morning and the code came out as the catalytic converter. The car seems to be running fine, at least no recent changes. I'm debating replacing this vehicle soon, and I'm wondering if it's worth working on the catalytic converter. I recently replaced the cam shaft position sensor as well.
View 5 RepliesFord 6.0L Power Stroke Diesel :: Randomly Shut Off When Pulling Into The Driveway - P0341 Code
A Little Background, my FICM wasn't bad per se but it would dip below 45 volts when the outside temp was around freezing. I pulled it and sent it for repair at the same time the Atlas 40 tune was loaded into the FICM.
First few days of driving mileage was better, truck ran great. All of a sudden one day pulling into the driveway it randomly shutoff. Two occasions since it has acted goofy at started, bucking a little a low throttle. Mileage has returned to how it was before I had the FICM fixed and ATLAS tune applied. To this point I had no codes at all.
Now today it randomly throws P0341 - Camshaft sensor out of range.
So heres the question - do I replace the sensor or try to get at the harness for inspection? Out of range would usually mean the sensor itself is failing while open circuit is usually wiring related. I know its uncommon for this particular sensor to fail but i'm not sure which direction to go.
Chrysler - Sebring :: 2004 - Transmission Will Not Go Into Reverse
I have a 2004 Chrysler Sebring with a 2.4L dohc and automatic transmission with 115k miles. I recently had the timing belt and water pump replaced. Shop left the front 2 engine mounting bolts off and the rear one loose. Picked up car after business hours drove it that evening and kept hearing a strange metallic squeak.Returned it to the shop the next morning and as i was driving it began to smoke and stall with the temp gauge pegged. They had also left a hose to the heater core disconnected. Could the engine not being mounted to the chassis and/ or the overheating have damaged the transmission.
View 3 RepliesSebring - Chrysler :: Heater Blowing Cold Air
Got a bit of a problem with my car. Earlier this week, I got in and noticed there was heavy condensation on the inside of the windshield of my 2002 Chrysler Sebring convertible. The windows had been rolled up and the top up of course. I see this kind of condensation happen on the outside a lot in the mornings. You know, dew settling and all that. If I wait around until later in the day, it evaporates on its own.
Anyway, this time it was on the INSIDE. I wiped it clean easily enough and was on my way.
Today I noticed that my heater wasn't working. The temperature gauge goes up to about 1/3 of the way, so I know the car is warming up. I'm not sure if it normally goes up that high; I don't usually pay much attention to the temperature gauge.
Chrysler - Sebring :: 2006 - When Stopped With AC On Car Tends To Surge
I have an '06 Sebring convertible, 2.7l, V-6, 58,000 miles. When stopped with A/C on, car tends to surge. When I put in neutral, surging stops. Also, I sometimes get a "thump" (with both sound and feel) like I've been rear-ended, but have not. Dealer did tranny serivce and replaced all plugs and 2 coils which they said were "arcing". Did not fix problem. What would be wrong with A/C so as to cause this?
View 5 RepliesSebring - Chrysler :: 2000 - Quit While Driving
2000 Chrysler Sebring Convt quit while driving. Tow truck drive and a mechanic at scene of breakdown felt itt seemed like it wasn't getting gas. Replaced fuel pump, fuel filter, 2 sets of plugs ans it won't start and when it did it ran rough and then fouled out new set of plugs. Seemed like too much fuel going to cylinder.
View 1 RepliesSebring - Chrysler :: Oil Light Comes On When Stop But Goes Off When Driving
My oil light comes on when I stop but goes off when I'm driving. I check the oil level and it was fine. What would cause this? It's a 2001 sebring 2.7L
View 6 RepliesChrysler - Sebring :: 2002 - Engine Is Blown?
I have a 2002 Chrysler Sebring that broke down. Unfortunately it ran out of oil, and I was told that the car has 2 sensors that detected the lack of oil and shut down the engine. A local auto repair shop replaced the sensors. I paid the bill and began to drive the car home but I only got 20 miles away when the engine blew. My question is, if the the shop told me the car was fixed and then the engine blew, aren't they somehow liable for this?
View 19 RepliesChrysler - Sebring :: Alarm Was Going Off At Random Times
I recently brought my 2000 chrysler sebring in because the alarm was going off at random times (3:00am). Also when I was driving the interior lights would turn on and off and the dash readout would say "DOOR" as if I had opened the door, there was a relay clicking sound under the dash and the car would also try to relock the doors. This was an intermittent problem, occasionally the car would be fine for a while then the show would begin. I took it to a local Chrysler dealer and they diagnosed the problem to be the BCM or Body Control Module.
My conclusion is that this whole problem was caused by a shorting door switch and that either they misdiagnosed the problem and when the new BCM did not fix the problem they found the real problem in the door switch or they just scammed me from the start. I think the "part exchange program" is a scam. Why don't I get the part back or why don't I get two prices, one if I exchange the part and one if I don't.
Could a faulty driver door switch damage a BCM? (I never heard of this before. In fact another dealer told me all he needed was the VIN to see if the part was in stock).
Sebring - Chrysler :: 2001 - Shakes And Jerks / CEL Came On?
My daughter's 2001 Chrysler Sebring began "shaking and jerking" last night. She described it as similar to when a person drives a standard transmission that doesn't know how to do so. (Her car is an automatic.) She had been driving it for about ten minutes without a problem and had luckily just turned onto a residential street to pick up a friend. She said the check engine light came on as well. She was able to limp it to her friend's and leave it parked there.
Recent work on the car includes the thermostat being replaced and a resistor related to the heater blower motor being replaced. What might be causing this. She's probably going to have to have it towed.
Sebring - Chrysler :: 1998 - ASD Fuse Keeps Blowing
ASD Fuse keeps blowing. I unplug PCM and fuse no longer blows. I plugged in pin 41-80 and the the fuse is still ok. Car just quit running and starter will not turn. Does pin 1-40 control starter and fuel?? Could I have a bad PCM??
View 2 RepliesSebring - Chrysler :: 2005 - In Hot / Humid AC Blow Hot Air?
I have the above mentioned 2005 Sebring Convertible (2.7L V6, Touring) and the AC will work occasionally, but when it is hot and humid, it is sure to blow hot. First up was to check the system pressure and top off if needed - not the problem. Also blew the bugs and junk from the radiator fins. The wires and electrical connections look good at a glance. Turning the car off and on again doesn't work. Why would the darn thing work part time and take days off when we need it most?
View 1 RepliesSebring - Chrysler :: Oil Light Comes On While Coming To Stop?
Oil light comes on when I stop and goes off once I move again. Oil is full and just changed. What causes this & can I repair? I have a 01 Chy Sebring withh 100K miles on it. I bought new & have changed the oil every 3K miles since I have had it.
View 7 RepliesSebring - Chrysler :: 2008 - Won't Start Intermittently
I have a 2008 Sebring convertible that has starting issues. Sometimes when I turn the key to start, it does nothing (no noises, maybe a small click very rarely). If I take the key out and put it back in, it may start. Usually, I have to turn the power on, move the gears, and try again. Sometimes, it will start immediately, or I may have to do this procedure several times. It has been taken into the Chrysler dealer twice. They said it was not the switch or alternator and replaced the battery that wouldn't keep a charge. It was a 5-yr battery with 3 years of use. I was told to drive more! I shouldn't have to charge the battery every day. Several diagnostic tests were performed with no results. It still did this twice after the battery was replaced. Could it be cables?
View 3 RepliesSebring - Chrysler :: 2006 - Leaky A/C Condensation
In May 2011, I got into the passenger side of my 2006 Sebring to find the foot area full of water, and it wouldn't stop pouring in. So I had work done on the AC unit to fix a broken plastic part on the firewall. I am a snowbird who travels to Florida every fall, and subsequent to that work being done, I have had to have a line (?) cleared because the water drips into the driver's side when I turn right. After clearing the line, it seems to be ok. This year, I had the line cleared and the problem persisted. My mechanic cannot figure out what's going on.
View 2 Replies