Saturn - Ls :: Timing Chain Jumps Up Now Won't Start?
my car timing chain jumps up and down wen i try to start it.befor that i hard alot of clinking sound coming from the motor now the car wont start
View 7 RepliesSC/SL/SW :: Service Engine Soon Light On - 2000 Saturn SC2 Computer Won't Reset
I just bought a 2000 Saturn SC2 that had a "service engine soon" light on. I took it to the shop to get it inspected and they reset the computer and said that I needed to drive it around 100 miles to reset the computer so it would pass MO state emissions. After driving it 160 miles only two of the required have reset. I took it on the highway at 55 MPH steady for 2 miles. Actually did around 8 miles. as the shop suggested and that did not work.
View 3 RepliesSaturn :: Timing Chain - Notches Don't Line Up With Colored Links
I lined up all the colored links on the chain with the notches on the gears perfectly, the gears were all in the correct position also. Everything was done, then I rotated the crank by hand, and now the notches don't line up with the colored links. Is this normal ? does it have to go around a certain amount of times before they line up again?
View 3 RepliesFord Excursion :: Rust On Rockers And Wheel Wells / Shifting From 1st To 2nd A Little Jerky
My 2000 V10 Ex 4x4 (has 146,000 miles) with some rust on rockers and wheel wells runs pretty good. The exhaust needs some work. The transmission shifts pretty well I think, except sometimes from 1st to 2nd its a little jerky (like in a parking lot). I've put powerstop brakes on all four wheels, and have been maintaining it pretty well since I bought it almost two years ago.
Here's my issue. My 3rd son (out of 4) was diagnosed 2 years ago with ALL (Acute Lymphoblastic Leukemia). His End Of Treatment (EOT) date is July 8th 2018. This is relevant because to celebrate his EOT, we are planning on taking a 2 week road trip out west in our new to us hybrid travel trailer we just purchased this past February. We are taking the camper on a few weekend trips this summer and one week long trip to Michigan in July (we're from Ohio).
My concern is this: am I risking a ruined trip out west with such an old vehicle? I don't really trust it for such a long trip, I worry something would fail me and ruin a trip that's supposed to be celebrating my son conquering cancer. Am I being overly paranoid? I see V10 trucks and Excursions all the time with more miles than my own. I just worry that the rust will just be too much and the driveshaft will fall off, or the transmission will fail while we're towing up the Bighorns, or in Yellowstone. You get the picture.
Ford Aerostar :: Disassemble 4.0 Hydraulic Roller Lifters?
How to disassemble 4.0 hydraulic roller lifters? I have done this on sb chevy lifters, mine look squeezed together. They appear very high quality, no looseness, wear, etc.
View 8 RepliesNissan - Versa :: Roller Coaster Sound After Driving In 2nd Gear
The little window on my gear stick (the car is an automatic) is broken, and so when I shifted into Drive (D) I did not realize I actually shifted into "2" which is right below that. I drove on the highway for about 15 miles between 60-70 mph before I finally figured out that the source of the noise (basically it just sounded like the car was revving and straining up a hill the whole time. Since we just had the car worked on, I thought it was related to that). Once I realized I was in 2 I slowed down and shifted to D.
Everything seemed fine until I got off the highway. At the stoplight off the exit ramp, I went to turn right on red after coming to a full stop and nothing happened. It seemed the engine stalled, although I did not feel any shuddering or tell-tale signs that it was about to stall. The radio did not hiccup and the windshield wipers kept going without pause, but the car was essentially off, as it didn't even rev when I put my foot on the gas. I restarted it and drove home with no issues.
The next day when we took it out, we noticed a clicking sound. Not a single click, but a continuous sound, like an enhanced version of a playing card on the wheel of a bicycle. It doesn't seem to matter what rpm, what speed, the sound is present, although not necessarily consistently on. When we press the accelerator or ease off, we get a burst of the sound. Sometimes at higher speeds it is more consistent, occasionally when idly we can hear it softly in the background. No stalling occurred that day.
Tonight I drove it to work, which is a 20 minute drive on the highway. What started off as the playing card/bicycle sound soon turned into a sound that is reminiscent of a roller coaster being pulled up the first giant hill. Sort of a faster cranking sound. Then again, without preamble or warning, it stalled when I came to a stop off the exit to my workplace.
I haven't checked anything under the hood. The oil was changed almost 4000 miles ago. I don't even know what to begin checking first. I just put $ into the vehicle to fix it after an uninsured driver hit me (fender bender) and am still waiting on court proceedings from that..
Ford F-150 (2004-2008) :: All New Timing Components And Now Loud Squeal Behind Timing Cover
My daughters 2004 f150 5.4 3v. 130k miles. Had a broken timing chain guide on passenger side. Changed phasers, solenoids, timing chains, crank gear, tensioners, and oil pump. Pulled pan and cleaned it and the pickup tube of pieces of the old guide. Engine had zero sludge. Very clean inside.
Put it all back together. Left crank sensor unplugged to rotate engine until it had good oil pressure which only took a few seconds. Plugged sensor back in. Truck started right up. Runs perfect. Drove perfect. Idles with no noise. But as soon as I rev it up a little, there is a HORRENDOUS squealing from the lower left of the engine. Pulled serpentine belt and squealing is still there. Used a stethoscope to determine its in the lower left behind the timing cover.
I haven't pulled the cover back off yet but what this could be? Everything went back together fine so I can't imagine what it is.
HOWEVER, I did notice that my new tensioners only had an oil hole in one of them. The two I removed both had an oil hole. So one of the new tensioners does not have an oil hole in the center of the plunger. I see online, that many did not come with an oil hole. But I'm wondering if this could be the source of the squealing? Maybe not oiling the chain enough and the squeal that I hear is the chain on the plastic guide?
Subaru - Forester :: 2010 2.5X Automatic With Timing Belt Or A Timing Chain?
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 RepliesCamry :: Engine Jerk In / Out Around 40 MPH When Touching The Gas
For a few weeks now, the '02 Camry has had the engine jerk in/out around 40 MPH and 60 MPH when touching the gas just enough to hold speed (only when engine is warm & car has gone to closed-loop mode). If you mash down more on the gas, or accelerate through these speeds with more pedal pressure, it will pull perfectly smoothly away from those speeds, and the engine runs smooth when it isn't doing this.
Plugs have never been changed, but I will wait and do that when it is warmer outside. They are not the problem.
The other night, it seems to have gone into limp mode - will not drive over 10 MPH or rev above 2200 RPM in park, throwing a code for a throttle position sensor (P0120). I replaced the throttle position sensor with Duralast part (that didn't fit), then another genuine Toyota sensor. Still no luck...even clearing the code, it immediately returns upon starting the engine.
Throttle body and mass airflow sensor were both cleaned - actually, neither were gunked up badly. The car won't even start or run without the MAF plugged in, and there was no MAF code. I can't find any broken vacuum lines or obvious air intake leaks (the one thing I haven't checked is the intake manifold gasket).
Prius (Gen 3) :: Coolant Touching The L Mark, Might Be Leakage?
A couple years ago noticed the coolant + inverter reservoir was on the low side. Took it to the dealer who pressure tested it and didn't find anything wrong, added a bit, and said good to go. Roughly 55,000 miles.
Today at close to 85,000 miles the coolant in both the radiator tank and the inverter is again touching the "L" mark. They were filled up to the middle/almost topped off after the dealer visit.
Just curious if others have had this issue and/or where to look. I haven't touched the coolant since purchasing at 42,000 miles in 2011.
This is the only issue I've had with this car so far. But it scares me, as coolant loss can be a big deal! Something as small as this isn't as concerning unless it's leaking some place I don't know about, or being consumed in the engine.
Camry :: Volume Drops On Touching The Screen
Whenever I touch the screen the volume drops down on the music playing. I know I have seen how to adjust that, cant find it
View 5 RepliesPhaeton :: Car Won't Unlock By Touching The Door Handle
I have found my"new" 04 Phaeton not unlocking by touching the door handle. I also noticed the trunk won't open when I press the bottom of the logo. Yes I do have the technology package so that isn't the issue. I was wondering if it is a software issue.
View 1 RepliesDodge - Engines - Timing-belts - Pump - Neon - Belts :: 1995 - Squeaking Noise - Blown Timing Belt?
I've got my sister's 1995 Dodge Neon with the 2.0L SOHC. While driving it recently I heard a horrible squeaking noise then a ZZZZZZzzzzzz sound. I immediately pulled over. The check engine light came on, and I shut the car off. Coolant was all over the place leading me to believe the water pump failed. I had it towed to my house, and now I will have it towed to the shop to get fixed. I would like to have them repair the timing belt and water pump. However, I am afraid that the valves were beaten to a pulp and now I will need a new engine. I was only going 35 mph when it happened. What are the odds that my valves were smashed up, and is there anything I can do to check them before I pay for a timing belt/water pump repair?
View 19 RepliesCamry 2012+ :: Unlock SE V6 By Just Touching Door Handle
I have a quick question regarding the ability to unlock my SE V6 by just touching the door handle... Might be a dumb one so brace yourselves... If one were to go and say have the passenger of the vehicle tap the passenger side front door handle will that unlock the car in the same regards as touching the drivers door handle? For example if I were putting something in the trunk and had the FOB in my pocket and the passenger wanted to get in but I still had the FOB could they unlock the car the same way I would with the driver's door? My car does not allow the passenger to unlock the doors. Can it be programmed to have this work? Furthermore, is there a way to program the drivers door handle to unlock all the doors instead of just the drivers side door?
View 11 RepliesTouareg :: Front Brake Pad Sensor Touching The Rotor
Replace front brake pads, rotors, and sensors. the front brake pad sensor was touching the rotor. Car still has brake pad lite on. Replace front sensors again just in case one was defective. Replace rear sensors, still lite is on.
View 4 RepliesSonata I45 (YF - 2011+) :: Left Exhaust Tip Is Touching The Bumper
I just had my JUNBL exhaust installed over the weekend. Problem is, the left exhaust tip is touching the bumper. I was thinking of cutting the bumper part where it hits or changing the rubber mount to a longer one to bring the muffler lower (dunno if I can find a longer rubber mount) Everything was installed on the stock location of the stock exhaust with no modifications. Pictures attached. 2nd picture is on the left. Although not hitting the bumper, might have to modify that as well.
View 5 RepliesTiming-belts - Belts - Volkswagen - Touareg :: 2004 - Timing Chain Malfunction At 90,000 Miles Common?
I brought my 2004 VW Touareg V6(83k miles) to the dealer for a recall on the ignition call and much to my surprise, was presented with a diagnosis of a $6,000 problem! The dealer told me that the computer read some codes which say that the timing chain is stretched and needs to be replaced. They said it will take 4-5 days and should be done asap so it doesn't "go out", because if it does, it's an even more expensive problem. I took the car to another VW repair shop and they asked me if I heard any noised when I start it cold (like pebbles in a bucket). I have not had any problems like that at all, so they said I shouldn't worry until I start getting symptoms. They also said there is no recommended point (like 90,000 miles) when VW recommends the change, so it really shouldn't be a common problem. I want to do the right thing, but I don't want to rush into an expensive repair if it isn't necessary.
View 1 RepliesCamry 2012+ :: Touching Up Paint - Missing Clear Coat
I know it's a typical new car issue but every time I look at my car I see a new chip. None of them are major, usually just some missing clear coat but yesterday I found one that looked like it had been masked with fingernail polish. How do I remove this without damaging the paint underneath? Also, how do I level the repair after the clear coat?
View 2 RepliesLexus IS 2014+ :: Car Won't Unlock By Touching The Rear Door Handles
So when I first took the car home, I could unlock the car by touch the rear door handles and it would unlock all the doors for the car. However, my car wanted to update, and after doing this, this feature does not seem to work anymore. I can still touch the drivers side and front passenger side to unlock the doors, however, i am no longer able to unlock the car using the rear doors.
View 7 Replies