Saturn - Vue :: 2005 - Outlets Only Deliver Power When Ignition Switch Is In On Position
There are two 12V power outlets inside my 2005 Saturn VUE. They always have power available, whether the car is on or not. I'd like to change that. Is there an easy (or somewhat easy) way to make it so that the outlets only deliver power when the ignition switch is in the on position?
View 2 RepliesIgnition - Saturn - Sl :: 1999 - Engine Misses / Low Power - Ignition Control Module?
My 1999 Saturn SL1 was running well. One evening, I started it up to go home, and it wasn't running well, and barely had power to make it the half mile home. It still starts up, but seems to miss in park and in gear. We tried spark plugs, wires, coils, catalytic converter, cylinder pressure, crankshaft position sensor, and fuel filter with no change in engine behavior. I think the EGR valve was looked at and passed. I hope it is not the fuel injectors as I put a cleaner in the fuel every so often. Could it be the Ignition Control Module, and is there a way to test the existing module? What else could it be, and how could I test it?
View 6 RepliesSaturn - Outlook :: 2007 XR Key Will Not Turn To Off / Stuck In ACC Position In Ignition
The key will not turn to off, stuck in acc. I have no power to the windows, sunroof, seat and seat heaters, and no brake lights, and the mirrors have no power either. I took the car to the local GM dealer who told me the ignition was not in any recall and found that the Body Control Module was bad and needed replacement.
View 5 RepliesEscort :: Ignition Switch Replaced And Car Won't Turn Over
Had to replace the ignition switch. after I went to crank it after switching it out, there was a buzzing around the relay control module. Thought that maybe somehow the ignition tripped something in it so bought a new one. IT is still buzzing and car won't turn over. everything lights up on dash. tried to see if there were any codes and the scanner just reads "fail".
View 5 RepliesTouareg :: 1997 - Ignition Switch / Car Won't Turn Over
I was having all the tell tale signs of the almighty ignition switch. No lights, wipers, heater fan. But I didn't have time to change it. The other day went to start it and nothing. I changed the switch I have headlights wipers blower fan now which is sweet. But the car still wont turn over.
View 2 RepliesCelica :: 1990 - Key Won't Turn In Ignition Switch
When I put my key in the ignition, I cannot turn the key. I tried putting a small amount of WD40 in the ignition and turning the wheel back and forth while trying to start, but all that did was make my key greasy and my wheel lock up. I've tried getting a new key made from Lowes and Home Depot, but their keys are too wide and will not fit in the keyholes. The only thing I am down to is replacing the ignition switch completely but I'd rather do that as a last resort because my car has had a big problem every week (alternator gone, new wheels, new master cylinder, new rotors/brakes). I haven't explored yet? And also, if it comes down to replacing the ignition switch, how would I do that without being able to turn the key?
View 2 RepliesLexus RX 2004-09 :: Ignition Switch Is Locked / Would Not Turn
I put my LS 430 key in my RX330 yesterday, I realized as soon as the ignition would not turn. I put the RX key in, and ignition will not turn. I'm assuming that the pins may be locked so I tried a few options.
- I wiggled the key.
- I lubricated the lock.
- I tried rocking the car while trying to turn the ignition.
- I tapped the ignition lightly with a screw driver and hammer, but no luck.
- I turn the steering wheel while turning ignition to make sure its not locked.
I really don't want to get the car towed to the stealer/dealer.
Focus :: Ford 2003 LX - Key Will Not Turn In Ignition Switch
I have a problem with turning my key. It will not turn at all. I have taken the upper and lower part of the cover off to expose the switch and removed one screw from the ignition housing, but the internal part of the ignition switch will not come out. How do I completely remove this ignition switch. I have already removed the negative battery cable. It seems this is a continual problem with focuses. Oh, do I need a releasing tool to release the ignition switch.
View 7 RepliesGolf IV / Jetta IV :: Key Won't Turn After Ignition Switch Replacement
I am having a little issue with the ignition in my car. I had the typical no headlights/wipers/heater etc. so I ordered up a new ignition switch and when I went to replace it, the switch fit perfectly and had the correct part number but when I put my key in to try and start the car I couldn't even turn the key but when I put the old switch back in it would turn just fine. Also when I removed the old switch I noticed the red wire going to the switch was slightly burnt right at the terminal.
Here is the basic procedure I did:
-Unhook negative battery cable
-remove lower dash/ center console
-remove switch
-install new switch
Whats this little metal piece? I did not see that when I did mine...
Ford F-150 - 1997-2003 :: Ignition Switch Won't Turn
I'm having a problem with my ignition switch. It won't turn and I have to turn the steering wheel for it to finally work.
View 4 RepliesHonda - Odyssey :: 2004 - Hard To Get Ignition Switch To Turn
I have recently been having problems getting the ignition switch to turn. There seems to be a negative correlation to warmer weather (the warmer the weather, the more likely I will have a negative experience --- and I will get the switch to turn only with some difficulty). When I have such a failure (in which the switch does not turn), I take the key out, wipe it off with my hand, flip it over and shove it back in. Sometimes this works with one try. Sometimes it takes multiple tries. My fear, of course, is that one of these times it will never work, and I will be stranded. I should add that I do have another key, and that I have had the same experience with this key. I don't really want to spend hundreds of dollars on a new ignition switch... and I especially don't if that is really not the problem.
View 2 RepliesToyota - Camry :: 1997 - Power Dies When Turn The Ignition Switch
97 Toyota Camry 2.2l motor.
Sometimes, when I turn the ignition on I don't hear a sound and all the power dies in the car (the radio ejects the CD and all the presets are erased when I turn it out of start). This can happen once or twice in a row then generally the car starts up normally.
The battery is brand new (1 month) and is fully charged. My hope is that it's the starter drawing too much power when it tries to start? It's entirely possible it has the factory starter still on the car.
Accent LC (2000-05) :: No Sound From Fuel Pump When Turn Ignition Switch To On
In the mornings when I turn the ignition switch to on right before starting, I don't hear the fuel pump wining. I notice the wining on almost every other car that Ive drove. I don't know if its because of this I get a rough start. It usually happens only in the mornings especially on cold days. During the rest of the day I can hear it clear and it turns on right away with no problem. I have tried to turn the ignition switch on then off then back on to see if the pump would turn on but nothing. Also sometimes I have to keep the gas pedal down about half ways for it to turn on and not stall. Tomorrow I am going to check to see if any fuel lines are clogged.
Car is a 2000 accent gs 1.5l 12sohc ... With about 87500 miles on it ...
Anything I should replace with these many miles ... Planning to replace spark plugs and timing belt myself ...
Lexus RX 2004-09 :: Ignition Switch Stuck / Occasionally Key Would Not Turn To Start
'04 RX330: Starting about a year ago, occasionally when inserting the ignition key it wouldn't turn to start. Take key out try again and it would start. Progressively, it seems to be requiring more and more in/out cycles to get the key to turn. It's like the transponder is not recognizing the key FOB. I have two keys, one is a master and other is a sub key, both have the problem. What has to be done to correct it? I'm afraid the dealer will just change some expensive ignition part when there's an easier fix.
View 14 RepliesFord F-150 (2004-2008) :: Truck Won't Start - No Click Sound When Turn The Key In Ignition Switch?
I'm trying to get friend's 04 F150 4x4 started. I think it might be the ignition switch. Here's what I've done. Turn the Key and nothing happens. Not even a clicking sound from the battery.
-verified the battery had a good charge and that terminals were clean, connections were tight.
-checked the fuses in the passenger side kick panel, none were blown
-Determined there was power to the primary Pos wire going to the starter , but no power being sent to the smaller wire that goes to solenoid at the starter.
-Hooked a jumper wire to the starter solenoid and engine did crank (so starter is good and battery is making good connection)
This is why I'm thinking its the ignition switch.
1) Where is the ignition switch located?
2)How can I test the ignition switch?
3)Could it be the "cylinder lock and keys" that is faulty?
Saturn - Sl :: 2000 - Engine Shuts Down If Ignition Doesn't Complete Engagement
My Saturn 2000 LS1 has an intermittent start up problem. If the ignition doesn't complete engagement, the engine shuts down. After a 12-15 minute wait, I try to start again, it engages and starts. (I think it has a computer and the computer has to be re-set, thus the delay and re-start)
Nothing shows up on code except "security" but no fix.
I noticed using the remote caused this problem more often. So no longer use it. Also, got a new ignition key which worked. We think it has something to do with "security" as the light comes on....intermittently. Is there a replacement part for the "security" system? A fix.? Checking your site, no one else seems to have had this problem.
Windstar :: Faulty Range Switch Replaced - Still Not Reversing
I have a windstar 1998 model got into it not reversing was told range switch faulty because its drives and parks. Had that replaced still not reversing though reverse light comes on.
View 5 RepliesPassat (B5) :: 2003 Misfiring - Ignition Coil Faulty?
I have a 2003 passat 1.8 and I just started having a misfiring problem. I googled it and ran across a 2003 press release that VW had recalled them. I am going to call tomorrow, but I did a little testing myself. Probably not the best thing to do, but this is what I did. I had my wife start the car and I pulled off the coils until I hit the one that didn't make the car shake any more than it already was. It is the second one from the front. I pulled the spark plug out. It is the original, but didn't look too bad.
My question is: How do you test the ignition coil to see if it is faulty or if it could be the distributor? The coil that attaches to the plug looks a little burnt around the rim where it connects to the plug. Its not an expensive part, but I don't want to go buying another one just to find out it is the main distributor or something else...
Ford F-150 - 1997-2003 :: 2002 - When Turn The Ignition On Engine Will Turn Over But Not Start
My 2002 F150 Screw has been giving me issues when trying to start it for the last month. Sometimes it will start sometimes it won't. When I turn the ignition on the gauges all seem normal, the theft light turns solid then goes out, but engine will turn over but not start. Sometimes it will start if I leave the ignition on for 20 seconds then pull the key and try again. (this doesn't always work). I have disconnected the battery for about 2 minutes this usually works but not always.
Sometimes it will start first time with no issues. Once the the engine fires it runs fine. Another symptom is when I shut the engine off, pull the key and open the door, the chime telling me that the key is still in the ignition sounds. (but the key is in my hand)
I put a new battery in yesterday to rule that out and because the old one seemed to be getting weak. (starting issues didn't go away). I don't want to put 300+ into a fuel pump without being sure that's the problem.